Ford F-150 (2009-2014) :: Wind Noise Is Literally Louder Than Exhaust At 55 Mph
Dec 31, 2011
Ok, as promised I made a clip of my 2011 Ecoboost towing my 5-6K trailer with a 3" cat back MBRP exhaust. I gained over 2 mpg with this exhaust (MBRP) and intake (aFe) while towing. So far while not towing it only seems to have given roughly a 1 mpg increase over stock. I can barely hear the exhaust at highway speeds after the truck shifts into 5th and 6th gear. The wind noise is literally louder than the exhaust at 55 mph!
[URL]....
View 14 Replies
Advertisement
Having an issue with the 09 Platinum 5.4. Recently the air ducts to the passenger side have been routed straight to hell. The blow hot regardless of the setting, the driver side is fine. I can hear a clicking noise that gets faster/louder with the fan speed on the passenger side. I am thinking blend door motor? Possible location of this part and some replacement instructions? Wife and kids aren't digging this hot heat all the time, its a very uncomfortable ride in such a great truck!
View 4 Replies
I purchased a new 2011 F-150 Lariat, Ecoboost, SCrew, 4x4 last weekend. I love the truck. It is very comfortable, the Ecoboost has been incredible, and the ride is very nice. I am looking forward to towing my ATVs after I hit 1000 miles.
Yet, I have one problem. I get an incredible amount of wind noise and wind whistle from what appears to be the driver's door. I read other posts about wind noises and wind whistles (e.g., bug shield), but they do do not apply to me.
I'm planning on dropping it off at the dealership this week for them to take a look at.
View 14 Replies
Very loud sounds like bottom end/rod bearing and is about to go out with a bang real quick!
Truck is a 2009 5.4 3V ...
Will the motor from a 2005 5.4 3V work to replace it? As I have one of those sitting in a old work truck. I know the intake etc is different but using the 09 stuff will it work and be a easy enough install or do I need a 09-10 motor?
View 7 Replies
Just wanted a little louder sound. Was thinking about swapping the muffler for a flowmaster?
View 13 Replies
My F150 exhaust seems rather quiet when I first start it up, but after it gets warmed up good, the exhaust is much louder (which I like). I started wondering if I had a crack up front that widened out when it got hot, so looked under it when I got home today with it hot and still idling, but didn't see any cracks. Also I did not hear any noise like a leak. All sound was coming from the side exit pipe. So... what is the phenomenon that would cause this?
View 5 Replies
Leaking exhaust manifold? The truck has a much louder than normal "knock" when accelerating. At first I thought and had some bad fuel in the tank. I eliminated that with a full take of good fuel and some STP but the "knocking" continued. Then I thought that perhaps it wasn't firing on all cylinders but it felt like it had full power. I took it to my mechanic and he said it as a exhaust manifold leak. He said that he has never replaced the exhaust manifold but that it was a "nightmare" and expensive. He also said that it's not a safety issue but on the long run the leak would cause the truck not to pass its emission test. He said the problem was with rusted bolts that would be difficult to remove.
View 12 Replies
So recently (since Thursday morning last week) I noticed the exhaust noise of my prius has been louder. Today I experimented a bit and I'm pretty sure it's exhaust related. The car is pretty loud if there is any load on the engine, although still mostly quiet if it's idling. There are no errors presenting and mileage is still great.
Otherwise, it's loud and resonates at a few different rpm points, and I found that when the engine spins under breaking (foot-off coasting over 42mph or in B mode) it also makes noticeable exhaust noise of the same type.
I'm guessing the exhaust is leaking (the sound seems to be coming almost from the left rear seat area? Behind me when I'm driving at least).
View 3 Replies
I have a 2003 GMC Envoy with 76000 miles on it. I heard a louder exhaust noise than normal when I start the truck in cold weather. I had it checked and was told that the exhaust system was OK but that the noise was because the motor mounts needed replacing. I have never heard of this before. Before I spend this money I wanted to see what your reply was to this question. Is it common for motor mounts to have to be replaced on this type vehicle with this mileage and age?
View 2 Replies
I just bought a 2009 F250, I am getting a wind noise that I can't figure out where it is coming from. It only happens when I'm going at least 70 and into the wind. It is a short flute sounding noise that is intermittent.
View 6 Replies
I have had an exhaust leak under the hood of my 09' F150, XLT, 4.6 3V for some time now and decided to get it checked out. I took to the local stealer and as i suspected its the manifolds. There are 4 studs on the left and one stud on the right sheared off. Ford quoted $1400 for replacing both mainfolds and extracting the broken studs. This would give me the exact same manifolds that were on the truck from the factory and started leaking at 78,000 miles.
So I decided to take the truck to a local speed shop that I have used in the past for other things. The mechanic there said to just buy a high quality set of stainless headers, stage 8 locking fasteners, and copper gaskets. He will install. I went with JBA shortys from AutoAnything.com and the mentioned hardware from Jegs.
So basically for around $100 more I get headers that probably will last the life of the truck. I am quite displeased with the exhaust issues that Ford has had and known about for over 20 years. The service manager at Ford said they replace manifolds with broken studs on a regular basis. He also said it was a wise choice to go with the headers instead of the manifolds even though they will not install them. That says a lot about the confidence of the Ford service department in their parts and vehicle designs.
Its a little sad that a 6 year old truck with only 78,000 miles....
View 14 Replies
So after remotely starting my truck on a cold morning, I walk up to the vehicle and notice a small puddle of water near the middle of the truck (not near the engine where the A/C usually drips), and I can also hear a slight ticking noise that I never heard before. I stoop down and can see water dripping from the exhaust (I think off the back of the resonator?). I snap a few pics and decide I'll take a closer look later, but curiously when I return from my drive, the leak and noise are gone.
With 76K miles on the truck, is it possible I've developed a pinhole sized perforation or leak in the factory exhaust system (or maybe there's a loose fitting) that is only present when the engine is cold, but "seals" itself up once the engine is warm and the metal has expanded? I only see the water puddle and hear the noise when remotely starting the truck on cold mornings, never on warm days or after driving around town.
View 6 Replies
I have a 2012 F150 5.0L that I bought used in 2014. Apparently the original owner had replaced the exhaust with a dual exhaust (converter to muffler to two pipes out of muffler), but didn't spend a lot of money on it (?) and it rusted out. My dealer--we have a pretty decent dealership here, and they've done my service for years--sent me to a local exhaust/muffler guy, who recommended that I go back to a single exhaust, and happened to have an OEM setup that had come off of someone else's new truck. He put it on my truck, and so far all seems fine. (small town; bad service places tend not to survive, and both the dealer and the muffler shop are institutions)
I'm an older, single woman who has horses, so my truck is primarily for hauling one or two horses and hauling hay and feed and such. I want my truck to last--my previous one was a beloved 97 F250 7.3L diesel that I had for 17 years, but, while the engine will run forever, the peripherals were starting to worry me and it needed to find a home with someone for whom getting stuck on the side of the road was an adventure, not an major inconvenience. Anyhow--so, I'm a gentle drive, my truck gets serviced regularly, and reliability is my primary concern.
The new system is quiet. Really quiet. Coming off a diesel, I actually liked the bit of growl I got from the old system, and being able to hear my engine, but I didn't have the heart to say that to the nice gentleman at the muffler shop, and it's not a big deal. My concern is that I have no way of knowing what vehicle the thing came off of, and the guy said it didn't matter that much; it did fit on my truck, and he said it came off of a brand new F150, but it had a suspicious "CHEV" chalked on it ... (FYI, there is an additional resonator after the muffler--it was a bit of a tight squeeze between the spare tire, but it did fit)
So my question--should I be worried? How quiet should my truck be?? It is my understanding that the OEM exhaust on the 5.0L has a bit of growl to it, so I kind of doubt this rig came off of a 5.0. How generic are exhaust systems? What effects might it have on my engine? I trust my service guys, so I trust their recommendation of this muffler shop, but I'd like to hear other opinions, beyond "it will be okay ..." Are there any "buts" in this situation?
View 9 Replies
I currently own a 2009 F-150 XLT, ext. cab, 4X4, 4.6l, 6R80 trans. Surprise, Surprise I have just developed an exhaust leak at the manifold collector. After some careful investigation, I separated the pipe from the manifold and the sealing surface is totally rotted away. I cleaned it up as best as I could and slathered some muffler cement inside the joint to seal the leak. It is about 80% better but will get worse again I'm sure.
I visited my local Ford dealer and talked to a friend I have working there and he said Ford has known about quality issues with manifolds for years and he was surprised that the manifolds lasted 70k miles.
I am hoping to use the truck as is through the winter and in the spring I am going to install these headers:JBA Headers - Reviews on JBA Cat4ward Exhaust Headers - Stainless, Ceramic & Chrome Finishes
This intake:K&N 63 Series AirCharger High Flow Cold Air Intake Kits Best Price & Reviews
This tuner:Bully Dog Triple Dog GT Tuner (49-State Legal) - Bully Dog GT Tuner Reviews on Gas Programs for Dodge, Chevy, Ford & Nissan Trucks
I already installed a Flowmaster American thunder catback exhaust system about a year ago...
View 2 Replies
I was checking the oil in my truck yesterday. I noticed the passenger side exhaust manifold was flaking rust. I mean flaking bad, big chunks coming off. Even the heat shield was rusted bad enough that it is barely holding on. Looks like in a couple years will need replaced. I have never seen this on my other Fords.
View 4 Replies
Looking to put dual exhaust on my 2010 F150. Which muffler. Flowmax or Magnaflow. Do not want it very load. Looking a little smooth churn like the Mustang. As you know ford is very distinctive and I want it to be heard to some degree.
View 14 Replies
Recently, I've been doing a lot of road trips during the weekends. That's the only chance i get to explore the high-speeds.
The stability and handling at high speeds are excellent (140km/h or 87mph). However, the most annoying thing at that speed is the wind noise. Its gushing all over the car.
View 14 Replies
I bought a new 2014 Elantra last Monday. Around 100 miles (Wednesday) I noticed it was making a ticking noise when accelerating. The sound gets louder at higher RPMs and goes away when I get off of the accelerator. You can't hear it over the radio but it's embarrassing when my passengers do. It almost sounds like a puff of air escaping or something, similar to a go-kart engine lol.
Anyways, I took it to the dealer Thursday and they drove it and said the noise was normal during the engines break-in period and if it persists after 15k to bring it back and they would see if there was something that needed tightening.
View 27 Replies
Had clear bra installed on my car. They had to redo the mirrors and the hood pieces because they didnt install the self healing film the first time. After the tech installed the second pieces I noticed an annoying whistling noise from the drivers mirror. I taped it off and even wedged a piece of thin plastic in the gap between the base of the mirror and the car to see if it would stop.
Anyway did a little research and found to my dismay that guys with the 4GS and 3IS are having the same issue when installing paint protection film on the drivers mirrors. As far as they know the remedy is to remove the film. I am assuming it has to do with the positioning or thickness of the film because it did not make any noise with the basic film installed and where it was installed.
I just went down to the garage and peeled it off, took it for a ride, and BOOM .....silence . Crazy that a thin film on the mirror could cause wind noise .
View 14 Replies
I have lots of info these manifolds. Have gone through four including both sides twice. This last time it seems the manifold has a crusty residue on the inside. The mechanic says it may be a bad head gasket.
View 14 Replies
I purchased a brand new 09 LS 460 a few weeks ago - it is an amazingly beautiful car and a joy to look at.
Unfortunately, I think I have the dreaded wind noise problem, as there is very noticeable wind noise above about 65 mph - it gets pretty bad when it is really windy outside.
I love driving the car and have a long daily commute - however, this issue it starting to bother/annoy me and I find it takes away from my enjoyment.
View 14 Replies
