Ford - Fusion :: Pump Will Shut Off Every Couple Of Seconds When Fueling
Mar 4, 2013
I own a 2010 ford fusion, with a no cap fuel filling system. My son ran it out of gas. While he was trying to add some he could not get it to take because of the internal seal not releasing, it just spilled out the overflow. Ever since then , at the gas station when fueling,the pump will shut off every couple of seconds. I don't know if running out of gas caused this,but i would like to know how to fix it.
View 2 Replies
Advertisement
I went to fill up my Santa Fe's tank for the first time and was only able to get about 9 gallons in. The pump shut off when the car only had about 2/3 of the tank full. I let it be, but I really don't want to be dealing with this every week. Have issues put gas in? Any tricks/tips? I do live in California which requires a lot of equipment on the pumps to prevent gas fumes from escaping. I'm not sure if that's contributing to the premature shut-off.
View 12 Replies
I have a 2000 Hyundai Accent that just started not filling up. The pump kicks off every couple seconds. From reading other posts it sounds like its the evap canister (wife would often top off the tank). The question is, does the evap canister need replaced or do the hoses need cleaned? Is there an easy way to get the hoses off?
View 4 Replies
As I was driving home last night, and my 2010 Ford Fusion shut down. I was stopped at a stop light, and when the light changed I accelerated but nothing happened. On my dash board the oil light and battery light were on. I turned the car officially off, and it restarted. This has never happened before. I have about 38,000 miles plus. I am in sales and drive the car a lot during the week. What does this mean, and should I be concerned?
View 3 Replies
I have a 2003 ford explorer sohc 4.0l , that starts only with the gas peddle pushed to the floor and will only run for a couple of seconds at a time. Just replaced all the timing chains and tensioners. It has 145 lbs compression, and 60 psi fuel pressure. No codes on the computer.
View 8 Replies
00 XLT 4.6 4x4 135k miles - New problem, on accelerating, truck hesitates for a couple of seconds before rpm's pick up. There is no stumble or bogging. It feels like I'm not giving it any throttle at all. And then it kicks in and takes off. It does this from a stop at idle, or at a steady cruise. Its an intermittent problem. No CEL. Air filter and fuel filter are about 3 months old. Haven't done any work to it since. Also, when there is less than a 1/4 tank of fuel, truck sometimes stumbles slightly off idle. Fuel pump starting to go?
View 6 Replies
I've had a 1999 explorer for a few months. The transmission has always taken a couple of seconds to "catch" in drive and was then fine. Today, I had to tow another car a short distance and now going into drive directly is useless.
I must shift into 2nd and then back into drive. Then, for the most part, the car drives fine unless I have to put it in Park or in Reverse. Then I must repeat the procedure.
The fluid is fresh and the dipstick shows a slight overfill. Is there anything I can do about this or is this the death of the transmission. If I can run it another couple of years, I'd be satisfied.
View 7 Replies
Just installed a new jvc kd-s48 stereo and it cuts out for a half a second every couple seconds. Kind of like a scratched cd but it's with the tuner and mp3. The sound "stumbles" and then it very quickly raises back up. it sort of seems like if I wiggle the wires in the back it'll stop. I will check all connections, I use female and male spade connectors and then shrink wrap over each connection. Could it be a faulty deck?
View 5 Replies
This applies to a 2001 F-350 with 73,000 miles on the engine. Engine oil level is good, batteries charged, HPOP reservoir is full and passes Cody test with flying colors. Fuel pump runs for 20 seconds at key on. Start takes about 6 seconds. If I shut the key off and restart immediately it starts in under 2 seconds but if I wait about 30 seconds it's a 6 second start. Here is an AE that I ran on it, it has me stumped. FWIW it seems to start quicker when AE is hooked up. ?? An odd whir type of noise comes out from somewhere under the hood when I first turn the key on and when I clear the codes with AE.
View 14 Replies
I used the a/c for the first time this year on my 2013 F250 and heard some noises I don't remember hearing before. When the a/c(or defrost) is on every 12 sec or so I hear a hissing sound that lasts for a couple of seconds then goes away. Is this the compressor cycling and if so is it normal to hear it inside the cab?
I know it has to do with the a/c because if I shut it off as the hissing sound is being made the sound will instantly stop. Other than the noise the a/c works fine and blows cold air. Also, if it matters I have the standard control panel, not climate control.
View 8 Replies
Tried starting the truck, fired ran good for a couple seconds, then ran extremely rough for a couple seconds then died.
I did some research and changed the ICP because there was oil in the connector so even if it wasnt causing my issue i wanted to replace it.
Now I have the same issue but it will actually run a little longer and not stall. I thought it was fixed so i took it for a drive, after about 3 miles it bogged down and i was able to make it home with half throttle going about 30mph. Sounds almost like its running on half the cylinders. i unplugged the ICP and it continued to run that way.
I had done the 50cent mod a few years back with the peices from ford but i know the harnesses themselves can wear through so i checked the resistance between the center pin and the two pins to the right and left for both the injector harness and they had about 3ohms.
I am leaning towards an IPR but from the reading i have done it seams like most trucks will not restart after they die. I have AE so i am going to hook it up later today, just wanted some reccomendations on what to look at.
I also remember when i shut it off the unplug the ICP to see if it would clear up the needles on the gauges did a full sweep as if i disconnected the battery which i though was weird.
View 14 Replies
I have a '92 Ranger with a 2.3 liter engine. She starts and runs a couple of seconds and shuts down. I'm thinking maybe a fuel pump is not putting out thepressure needed. Gotta go to work tomorrow and gotta get the truck running today.
View 2 Replies
I have Warn hubs that I have to lock in. All works good. A/C goes to defrost at first when cranking but then runs fine after a couple seconds. So, I was thinking that maybe my pump is running all the time. Who knows. I'm sure all my vacuum lines are dry rotted. What exactly is the need for it exactly and what's the best way to cap? Hoping to do it at the unit itself if possible.
View 6 Replies
I just recently purchased my 1999 ford F-250 superduty V8 5.4 5 speed with 144,00 miles and I'm having a issue with the clutch pedal sticking in and then it will pop out after a couple seconds. It will stick more when I come to a light and have my foot on the clutch but the pickup drives fine and there is no slipping of the clutch. I have never experienced this issue before in any rig I've owned. so I'm a little lost at the moment.
View 2 Replies
So this morning on my way to work, open highway, late for work... I did what most chewbaccas would do. Turn of ESP, and punch it! Well that quickly become an issue. My CEL started flashing for a couple seconds. As soon as it happened I let off of the accelerator, turned ESP back on, and coasted... lil bit loud in the back, but it normally is. (HFC, 3inch EIP Comp exhaust) The CEL went away.. but I'm nervous about what could have happened. I just replaced my Haldex Pump a couple months ago, and the rear diff was replaced 3-4 years ago. I haven't scanned it yet, I'll do that when I get home tonight... I tried to do a quick search in the forums but didn't come up with anything significant .
View 5 Replies
I own a 2000 Ford F-250 5.4 Automatic. It tows my 5th wheel trailer very good. On our last trip it suddenly experienced the "check engine light" effect.
The light turns on randomly and either goes of after a couple of seconds or it doesn't go on when I restart the engine.It is mainly annoying, but when in towing it really hurts, because the engine switches into an emergency mode and stalls.
I read that the engine uses only 4 cylinders. I read many articles on the web about that light, but I couldn't find a solution. The thing is I brought the car to several repair shops but none read a code from the computer.
I think it's not a real fault but a misreading or maybe a cable that's grounding? The problem is, I can't bring the car to a repair shop, because there is nothing wrong with the car. How can I find the source of the problem?
View 14 Replies
I had the engine out of my truck (7.3 with e4od) to do manifolds. Anyway, I got it back in and started it up. Since there was air in th fuel lines it had to crank a couple seconds but started up. I looked and now fluid coming out, then it sat for a few minutes running and I took it for a drive. While sitting in the driveway it wa smoking a bit. But I thought it's from the oil I got in the exhaust while drilling two of the manifold bolts and soaking the bolts with ATF/acetone. After about half a mile I thought that maybe it's more oil then that would cause... So I went back. I looked and the inside of the exhaust is covered with oil, and the rear of the engine is also.
When it was out I capped all of the open ports so I could pressure wash the grease off. Also, I flipped the CCV so I could do the delete. During instal, I missed the cap on the CCV and it was not able to breath. I think that maybe it built up pressure and blew the valve cover gasket? It looks like it's coming from the right cover on the backside; I had not taken this cover off while the engine was out. How much pressure does it build? Is it possible that it could have blown the gasket out? I have done the oil cap trick to test blowby and it always passed the test. What it could be? For the leak on the engine and why it's in the exhaust?
View 13 Replies
I have a 2009 corolla with about 125,00. I bought it used about two years ago and it has been trouble free. This morning when I went to start it, about 29F with heavy frost on the windows, it would fire up run for a couple of seconds and cut off. I id this probably 20 times and gave up. I called a neighbor to take me to my bus and thought I would try it one more time. fired right up and stayed running. Also started right up when I tried it later when I got back from work.
View 2 Replies
Ok so about a month ago I went to the store got into my car turned on my car after a couple seconds it beeped about 3 times then turned off i turned it back on and it worked fine ... and now yesterday i was driving the car everything was fine till i was driving on the freeway and it beeped 3 times again and looked like it was going to turn off but didn't .... and about a half hour later driving doing about 45 mph the car beeps and turned off on me ... So I pulled over and just turned the car on and it worked fine again ...
View 4 Replies
I am having this weird issue that started from what I believe this weekend. I was doing 70mph and it was snowing. Not always but something like maybe 1 out of 5 times when I activated the washer fluid motor my headlights would turn off for like 1-2 seconds. Super scary when you are driving in the pitch dark on a highway.
View 8 Replies
It was pretty warm this afternoon, had the AC on full blast. Drove into a left turn lane and stopped for the red arrow, the engine began spurring for a couple seconds. Then it caught itself but afterward felt the whole car shake for like a minute, drove off once it was a green arrow and nothing else happened. Has any one else had this or a similar experience happened to them? My Camry just hit 30k miles, I wonder if it just had a "spaz" (or whatever you want to call it) attack.
View 4 Replies
