I have a 2005 f350 lariat 6.0. My horn, cruise volume, heat and fan controls on the wheel are not working. The airbag light isn't on. I am thinking that it's the clock spring. The stereo controls were intermittent for a while so I think it's the clock spring. I just want to be sure. Anything I could check?
View 2 RepliesI just picked up a 2005 SC LB 4x4 5.4 v8 6mt F-350 yesterday and drove it about 250 miles home. It is my first Super Duty, and I love it so far but... the steering has some issues. There seems to be decent amount of play in the steering wheel when I'm driving straight. Also, the truck drives straight when the steering wheel is turned about 30 degrees to the left, and I would like to fix that and bring it to center. When I was cruising on the highway (65-70 mph), there was also two 20 minute periods of time spaced an hour apart where the steering would get light and the truck would dart to the left (i do not think road conditions were a factor as it did not happen on the worst stretches of highway. The truck has 133,000 miles on it, and has had pretty routines maintenance done on it, as it was owned by a drilling business as a work truck to haul tools. The guy I bought it from said that it needed the steering shock/damper replaced, so I will do that, but what else to you think I need to do to the truck?
View 2 RepliesSo I just got my 2014, upgraded from a 2007, and one change that is bugging me is the steering wheel controls for the radio. In the old truck clicking the scan up/down buttons scanned to the next radio station, in the new truck it scans through the preset radio stations. I really don't like that. Can it be changed or am I stuck with it?
View 2 RepliesOrdered a 2015 f350 CCLB FX4 XLT 6.2 about 2 weeks ago.Tried to see if the control buttons on the steering wheel were lighted couldnt tell in the daylight.
View 5 RepliesBought a new touchscreen head unit to put in my 06 lariat f250. I have all the controls on my steering wheel for heat and radio and I don't want to lose them with a new radio. This head unit does not have the 3.5mm jack for the axxes unit but has 3 wires labeled swc1 swc2 and swc ground. It supposedly has the converter built in. any views on using a headunit with these wires?
View 3 RepliesI recently got a 2015 f450 XL service truck and was wondering if the factory sync system with steering wheel controls could be added or would I be better off swapping in an aftermarket radio? And the remote start, fog light and brake controller kits are the same from the pickups to the chassis cabs correct? Last question is that I found the truck has global window open but doesnt remotely close is that correct?
View 2 RepliesThe steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 RepliesYesterday while traveling about 30mph and starting into a slight left turn the steering wheel locked, when the brake pedal was applied it was rock hard and would not engage braking resulting in a single vehicle crash, no injuries. 8300 miles...
How would I make Ford aware of this incident and get them involved? Is it likely that such events may have been logged somehow in the computer? The truck is at our collision repair shop waiting for an insurance adjuster to inspect.
I have a 2013 f350 4x4 diesel. I bought used with 80,000km on it. Started getting a bad vibration in the steering wheel around 80km/h. went too ford and replaced the track bar ball joint and steering stabilizer. After that the truck drove perfect. The next day I went and put on my new rims and tires (used tires) 20" rims with 35x12.5 r20 amp m/t tires. They used beads too balance tires. I left the tire shop and the wobble was back, I went right back too the tire shop and they took the tires and rims off too inspect more and found that one tire had kind of a flat spot and uneven wear.
So they put it on the back as too take away a little bit of the vibration, idea is too wear down that bad tire till the flat spot is gone, when I'm driving it at highway speeds it wobbles a little bit and those goes away and then comes back every 20 seconds or so, will this go away or do I need too replace that tire, buddy of mine told me too do a little burnout and maybe even out the tire a little bit but amazingly that didn't work...or could something else be wrong? Factory tires were 275/65/r20 That I had on before. Also the worst vibration is at 80km an hour but like i said it comes and goes. Will it get better?
I have a tow haul problem with my 2008 F350 6.4L. It will not go into tow haul unless I tilt steering wheel up all the way and than slam it down and than it will engage. Than when I want to take it out, I have to shut off truck. Any wiring diagram and info on how to get at the wiring. Do I have to disarm Air Bag and pull Steering wheel?
View 13 RepliesI have an 04 lariat f350 and after cleaning the steering wheel it is a bit sticky.... What the material is?? Or how to resolve the sticky issue??
View 8 RepliesSo, I'm tired of this crap power steering. Since I just blew up my lpop on my 6 blow, apparently a thing with manual trans, replaced and she runs fine, I decided it is time to fix the screwed up worthless sloppy steering, and almost lack of any power steering at stop or slow drive. Picked up a rebuilt pump., and took out my old box with 220k.
I almost bought a cardone box, but frankly my input shaft had less play than 2 I ordered in. The only problem with my box is it has a tiny amount of play on the sectorshaft which translates to a lot of slop.
I've been looking into hydraulic ram assist steering, as I run 6" lift with 37s on a crew cab long bed. The thing has sucked at life since I bought it with wider 35s a few years back.
Is hydraulic assist worth it and if I go drop 500 on a redhead box, between this and the ram, am i going to be looking at decent steering on road in the future? I have no plans to offroad this boat anchor of a truck. I have a nice fun light 2 door turbo montero for that.
Do I do it, or just stick with a rebuilt box and pump?
So I have a 1999 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again.
Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again. I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal?
The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
Sitting in the house, heard a horn blowing and ran outside to find my F350's horn was blowing. When I pushed on the horn button on the steering wheel it quit. Couple of hours later, it started blowing again. Pushed the horn button to make it stop and removed the fuse so it would not start blowing again. Did a forum search, but didn't have any luck. Short in steering wheel?
View 14 RepliesI've noticed when I'm towing, on long down hill grades if I touch the brakes I get what feels like a rotor causing the steering wheel to shake. At first it was only mild, but today on a long 6% grade it got really bad. Never does it on a level road, I've tried to duplicate it, only on a long down hill grade, and I'm not getting a pulse in the brake pedal at all, only the shake in the steering wheel. It's probably time to replace the pads anyhow, and I'll check the rotors. What things to look at?? 2006 F350, 6.0 dually 4x4.....
View 2 RepliesSo I have a 2005 f250 Super Duty 6.0 diesel it is the xlt with leather. So I don't much care for the steering wheels on this truck so i purchase a 05 f150 steering wheel. The splines and everything match up but the plug for the cruise control does not, need a wiring diagram or have done the swap and can tell me what wires connect where.
View 1 RepliesOn my 02 f350 xlt my turn signals work but not my wiper speed switch, when i put the small fuze in, the wiper go full speed and wont stop unless i pull the fuze out... What could be wrong?
View 3 RepliesMy 2000 F-350 SD 4X4 V-10 has no cruise control, and the A/C controls are not powered. Is it possible that both these power option circuits are run through a fuse link, and better yet, through the same fuse link? A/C has been troublesome in the past, but the cruise quit one day without warning. All fuses are good. Tried jumping the A/C pressure switch to recharge it, but no power is present.
View 4 RepliesI have a 2002 f350 my horn went off in the middle of the night got up and unplugged the horn what is my problem. also, the cruise control won't work when it all happened
View 3 RepliesI have a 2004 5.4 power f350 that makes a fog horn pitched howling sound at idle. First instinct was a pulley. Started it with belt off and its obviously something else because it still made noise. Traced it down to a resonating sound from the intake. Specifically the hose from the IAC to the air cleaner.
From some googling, i decided to change the IAC. No real change. So I took off the resonator tube and thoroughly cleaned it, took off the throttle body and cleaned it, took off the top snout part of the intake and cleaned that put in a new air cleaner (the glue was separating on the old one) and reset the battery. Still makes noise at least 85 percent as loud as when i started. Am I missing something?
On a 2000 F-350 with 5.4 engine, where does the vacuum line enter the cab? I got a truck in with no vacuum signal to the heat controls, and it has a slight miss at idle. Both of these are signs of a vacuum leak, but i can not find the line going into the cab.
View 5 Replies