Ford Super Duty (1999-2016) :: 2006 F250 XLT - No Power At The Connector Of Under Hood Lamp
Feb 17, 2016
I have a 2006 F250 XLT 6.0 diesel. I bought last month to haul my fifth wheel. Looking for the wiring diagram for the "under hood lamp". I have no power at the connector of the under hood lamp. I have checked all the fuses in both locations (battery box and central junction box) and did not find a blown fuse. The under hood lamp is not listed on the the central junction box fuse and relay posting in the owner manual. Is it controlled by something else?
View 2 Replies
Advertisement
I have a 2006 F-250 5.4L (6spd manual). I would like to add a second battery. It would be a purely auxiliary battery for radio use, and would be connected to a battery isolator. It would likely be a 33AH SLA, and starting capabilities are not required.
Any clean way to mount a second battery under the hood? On the driver's side, directly above the wheel well, there is an adequate amount of room for a second battery, and there are even tapped holes that seem to have identical spacing to the ones for the factory battery tray.
This leads me to believe that some version of this truck is offered with a second battery (the Powerstroke, maybe?). The local Ford stealership was all but useless, which is pretty standard. They have a solid reputation of not giving a crap about you unless you want to purchase a brand new vehicle with dealership financing.
What is the part number for a second, driver's side battery tray? I really am NOT interested in any kind of solution under than under the hood (no frame rails, or relocation to the bed).
View 4 Replies
The #8 fuse under the hood was blowing on my '00 F-250 every time I turned on the healights meaning I would lose power to my park lights. The brown wire coming from the back of the headlight switch showed a dead short to ground that I traced to somewhere between the switch and the firewall.
Anyway, I got tired of trying to pinpoint the ground fault, so I cut the brown wires at the back of the switch and under the hood at the top bolt-on electrical plug and replaced the bad section with a new wire. It works fine now with the only exception being I do not get the park light flash when I hit the remote lock button the second time. I do still get the horn chirp.
My Haynes manual indicates there should be a relay box with a Park Lamp relay, Driver Unlock relay, All Lock Relay, and All Unlock relay. The park light relay looks like it sends the blip of power to the park light circuit. Where this relay box is? I'd like to splice into the brown wir coming out of it to restore the light flash when I lock the truck since sometimes it's too noisy to hear the horn.
View 10 Replies
I am in the process of rebuilding my front end and have found that the nipples that screw into the top of the knuckles for the ESOF system are rusted and need replacing. I'd like to keep the system as close to original as possible, but have had no luck in finding a replacement. What the appropriate Ford part number is or where I could pick up a suitable replacement. This would be for a 2001 F-250 4X4 with the V10.
View 2 Replies
03 f350 7.3L. Have no power for the trailer running lights at the connector end. No power when the end is split and no power at the next connector above the spare tire. I have power at the fuse (38) and the fuse is good. What is the best connection to check next? Is there a common culprit that might cause this problem somewhere? I know 3 more connectors are in the frame by the fuel tank but pretty much lose track of which one might have the wire for the trailer.
View 3 Replies
Battery tested good, tried jumping it as well with cables and with portable pack.
I hear two clicks under the hood (NOT a continuous type click you hear when the battery is dead). The first seems to be up near the passenger fender well when the key is turn to the start position, the second click seems to be down under the motor near the passenger side (near the starter I assume, couldn't tell very well) when the key is RELEASED from the start position. The motor doesn't budge, I don't see any belts flinch or pulleys move to indicate that the starter is engaging. I don't hear anything that sounds like a starter engaging to me.
If not, where the starter solenoid is on this thing? is it separate like the other older ford's I've owned or is it now on the starter? Is there any fuse-able links that could cause this? Wiring diagram? Is there a way to jump the solenoid like in the old school days (e.g. with a screwdriver or wrench)? would like to get this home without towing it or fixing what is really wrong with it in the parking lot.
It's in negative to single digit temps here in Indy now, I fired it up in the morning in negative temps, drove it work. Came out to go home, and now this. So something happened between this morning and now and it's not the battery.
View 5 Replies
03 F250. 5.4 2v ... I purchased it a month ago.
Squeak under the hood. It appeared to squeak in relation to the movement of the tensioner......simple right? Replaced Tensioner and Belt..... Still squeaking.
AC not working at all. Compressor never kicking on.....replaced compressor, accumulator, and orifice tube. AC works now!.....squeak still there....
Notice fan wobbling.....shut truck off.....fan clutch shot... replaced....STILL SQUEAKING!!
Obvious answer....sound still on that side of the engine....Idler pulley....I just replaced it and the dang truck is still squeaking!!!!!!!!!
All that's left is the harmonic balancer, alternator, and power steering pump.......What could it be?
View 3 Replies
Twice I open the hood of my SD and I see water pooled up around the intake manifold on my 2001 F250 5.4. This happen when we have heavy rain. My truck is sitting on my drive way that has some angle to it. When it rains, all the water from the roof flows down the windshield and somehow the water is getting into the engine bay.
I cleaned out all the leaves and made sure the rubber molding were in place near the firewall, but it happen again last night. Is there something wrong with my truck to keep the water out. I suppose I could turn the truck around so that the rain will flow from the roof to the bed. But, I like parking my truck the way I park it.
View 1 Replies
What is the best way to bleed air from the power steering lines? I just replaced the power steering pump on a 06 6.0 f250 and now I need to bleed the lines and refill the power steering. I'm just curious as to what is the best and easiest way to do this.
View 14 Replies
I have a 2004 Ford F250 Turbo Diesel, egr delete, headstuds, intake, dual stacks, etc and when i turn my wheel a loud whining noise comes from under the hood, I noticed it put tension in my brakes. When I accelerate it gets louder and when i let off the gas it goes away... i checked my fluid in my steering pump and it was low so i put some more in and the next day it was all sitting under neath the truck.... any quick fix or do i need to replace the whole pump?
View 2 Replies
I have a 2006 F250 Super, CrewCab 4 dr, 6.0 w/60K. Last month I tried the rear power window and .......nothing.
It tried to open 1/2 inch and then stopped, had to try to power it closed and it moved 1/4 inch and I pushed it the rest. Removed the rear cover behind the seats and I can see the motor and wires attempting to move but it does not move and I am afraid to burn the motor out or push too hard and break a cable or worse.
The track looks really dirty, I use that window maybe once every 2 months.
1. Can I replace the motor myself?
2. Can I put something in the track to clean/lubricate?
3. Should I try to open the window under power and some additional manual pushing?
View 14 Replies
2006 F250 and my passenger light was out. I thought it was a bad bulb and I wanted to upgrade anyway so I bought some Slyvania Ultra headlights. Pulled out the old bulb and it didn't appear to be broken, but I installed the new upgraded lights anyway. Still not coming on. I tried the hi beams and still nothing. Got an electrical probe to test the wires and still no juice. Where the wires run to so I can try to find the break in the line? I'm assuming there is not a seperate fuse for the passenger side...On a side note when I went hunting a few weeks ago I had some kind of animal make a nest under the hood, its possible a mouse/rat/squirrel ate my headlight wire, but the nest was in the top center of the engine by the turbo and oil filter.
View 6 Replies
I have a 2006 Ford F-250 5.4l the symptoms are when it's warm it has half power and it will stall at idle. What I have done with the truck is.
New cam phasers
new chain
new tensioners
new vct solenoids
new oil pump
new plugs
new ignition coils
new stock cam shafts
new rockers
new lash adjusters
new exhaust manifolds both sides
new muffler
oil change with the right oil
ran it with sea foam in the crankcase before oil change
new fuel pump module
new evap vent control
new abs speed sensor
I cleaned throttle body with brake cleaner ... Scanned it after a 15 min ride of having to use 2 feet to drive it. The engine codes that came up are p0022 iacv short to ground and p1000 readiness test not complete. I also got p1804 4 wheel drive high indicator circuit failure p1808 4 wheel drive low indicator circuit failure .... Not sure what else to try.
View 7 Replies
On my way home today I heard wind coming in around my drivers side power window. Its not seating itself straight in the weather stripping. The window is tilted toward the front of the truck. Do I need a new regulator? Or maybe re- epoxy glass to bracket? The window still operates, its just crooked. Also I haven't had those door panels off before..
View 1 Replies
CEL came on last night, OBD code PO420, truck is an 06 f250,5.4? Btw, truck running rough, no power on acceleration, in gear at idle, runs rough....
View 4 Replies
Ok I have 2003 F350 6.0 I am doing some work on it today on my egr valve. I pulled off the intake manifold and it was bolted to another spacer type thing that had 2 electrical connectors going to it but when I looked there was nothing for the connectors to go to they just plugged into this empty space. the part has a plastic cover on one side that has delphi on it but its all hollow what the hell does this go to and what are these connectors for?
View 2 Replies
Well, it seems the cover on my trailer connector got broken off. The cover locks the trailer plug into the truck side. The connector on the truck is/was supplied by Ford. Now the dealer say NLA, only 2005 and up. Truck is 99 F250 SD. Plug is 4/7 way. Where can I locate a direct plug-in replacement? I do not want to be cutting and splicing.
View 14 Replies
So I shorted wires out putting a new plug on my mirror, and now I have no turn signals, no backup lights and no overhead display that shows mpg and outside temp. All fuses are good, and I don't think it is my flasher relay just because I also have no park lamps or over head display.
View 3 Replies
Looking for a tutorial on how to add the fog lamps to an 06 f250 superduty? I have an xlt with the fog lamp switch just need to install the after market fog lamps they are leds.
View 4 Replies
Last week I flipped the fan switch on and noticed that only hot air was coming from the vents, even with the control set to AC. The vent control switch seems to work fine directing the air but only hot air. The temperature control does not work. The exception is when I put it on max AC I get cold air. I can't be the only one.
View 4 Replies
2006 F250 5.4 - While driving ac changes from vent to defrost on it own..let off gas and it will change back to vent. I replaced vacuum can under hood.. no luck.....
View 1 Replies
