I've got a 2008 f-250 extra cab. A small bump will cause the rear driver side door to pop open. What I have to do to fix it, I don't want the grandkids falling out.
View 2 RepliesHave a 15 250 diesel and my drivers side door has a rattle in it. Seems to be coming from around the area were the mirror buttons are. Removed that little panel and applied some silicone around the edges and seemed to work for a bit then back to noise. Seems to go away when cab heats up good or warm outside.
View 5 Replies99 F250 Lariat SC 5.4 with 98,980 miles. As the title says, I cannot open the rear drivers door. It seems that the cable has broken.
View 2 RepliesDriver's side rear door quit working today - opens about an inch or so. What is the remedy?
View 7 RepliesI have a 2002 f250 7.3, an my radio is staying on when I turn the key off and open the drivers door. Windows are also still working. But if I open the passenger door it shuts off. What do I need to fix this I am tired of leaning way over and tryind to open that door every time I turn the truck off. I have been told to spray wd-40 into the door catch are i used a whole can an it still isn't working...
View 2 RepliesThe doors on my 2005 crew cab are leaking water. Its happened once before, I fixed it by resetting the main seal around the doors. Now this tropical storm had them leaking again. The rear doors are leaking from the top and getting the head liner wet, and the front left door is leaking a little bit onto the middle pillar Guage and down onto my leg.
Is it time for new door seals? My 01 has never had this problem so im not entirely sure what to do.
Got off the freeway today, driving along about 40 or so thought I smelled something hot like something burning. Stopped in a parking lot and smoke was rolling out from drivers side rear wheel. Look under and oil is dripping from inside of the wheel. Figure the caliper was hung up and got so hot it took the seal out. I can't get to it right now and the shop says I can't get in until next week, need my truck now. How long could I get by the way it is IF I take it real easy.
View 9 RepliesI have a 2004 F250 Lariat Crew Cab FX4 6-3/4' bed.
What is the procedure to remove the Driver's side Rear Sway Bar Link upper bolt? - the link attaches to the frame. The nut is on the inside of the frame with about 1/3" to 2/3" clearance between the frame and the fuel tank. Of course, the frame's "C" shape faces towards the inside.
My front driver side wheel is making a clunk noise when I hit a bump. I replaced the wheel bearing hub assembly and discovered both axle seals were bad.
View 10 RepliesThe truck has 64k miles and has developed a small leak on the engine side of the radiator with no apparent damage. There is no variation on the pressure test and the dealer was able to find the very small leak with dye in the system. It has lowered by about 3/4 of a gallon of coolant over the last couple of months. There are no visible signs of a leak but you smell the coolant when you stop the truck.
View 11 RepliesI am experiencing what feels like a "bump in the rear" when initially starting from a dead stop. It feels like a car behind me tapped the bumper or that the truck "hunkers down" first, then moves. Tranny seems fine also. Once moving, there is no problem whatsoever. There atre no noises, leaks, or other symptoms. Also, when coming to a stop, it feels the same way just before the truck completely stops. If I drift forward a little, then apply the accelerator, it does not "slip" or hunker down.
Took it to the dealer and they claim that they can't find anything wrong and may just be the suspension releasing? The truck does this whether loaded or not?
2001 F250 CC Lariat SB 7.3
Vehicle: 2002 f250 xlt 7.3 powerstroke reg. Cab
Issue: door ajar light stays on, power locks on driver and passenger door don't work, radio stays on after truck is off an door is opened.
Events leading up to issue: went to temporarily hook up a wolo dixie horn to see if it worked. Wanted to do it fast so I took + cable, tied one end to the battery terminal and then connected other end to dixie horn relay. I then grounded both negative wires to the truck. One ground on the frame the other I temporarily wrapped around a one of factory ground mounts under the dash. Immediately after doing this the problems stated above started.
How can I fix this. I need to fix this by tomorrow. I have a guy from Craigslist coming to look at the truck. Now the 4x4 issue.
Truck has zf6 manual and the electric 4wd select ****. Just thought I'd list this if it was needed to be known for solutions.
4x4 high light stays on in while 2wd all the time. 4 low will stay on after switching back to 4 high and 2wd but it goes out if I ether stop the truck shut it off then restart it. or back up and slam on the brakes. Also when in 4 high the front driveshaft won't spin. However It will spin when in 4 low.
Another random issue I'd thought I'd just list while I'm writing this.... Cruise control does not work. And when I press the "on" button and the "coast" button at the same time the horn honks.
the driver/rear suicide door combo is rubbing at the top and thus rattling on bumps. Looks to me like it is actually from the rear door as the gap in the very back is very wide at the top. the driver door gaps look normal along the front. Before I dig into this I wanted to check and find out the best way to approach. Is there an adjustment inside the hinge? the bolts on the jam look solid and have never been adjusted. Perhaps there is a hinge pin in there?
View 9 RepliesI was just under my 2000 F250 7.3l crew cab truck and noticed a small diameter rubber hose dangling from my front drivers side brake housing area. It is attached near two other cables which are similar to cables on the passenger side. I don't see a similar hose on the passenger side. The hose is completely deteriorated and broke off up higher towards the engine. I cannot see where it goes. What it may be?
View 4 RepliesOn the F250 trucks, if I changed the mounting frame under the seat, will the passenger side seat fit on the drivers side? Basically, can I turn a passenger seat into a drivers seat?
View 4 RepliesAfter the years and 300k miles, the door hinge on the driver side door are getting some play. I wonder if i can replace just the pin on this hinge or the whole thing needs to be replaced. By the way, I am talking about a 00' F450 ...
View 2 RepliesJust came back from breaking in new brake pads. Instructions called for five moderate to aggressive stops from 45 to 10mph, then five moderate stops from 35 to 5mph, then cool down and drive as normal. Drivers side door opened fine when I got in to do the test. It's been opening and closing OK since I bought the truck a few months ago. Got back from my break-in procedure, and the drivers side door wouldn't open more than about 8". Had to crawl over and exit from the passenger side. Found that the drivers side door is binding against the front fender about midway down.
View 1 RepliesI have a '99 Super Duty Club Cab and the driver side door lock switch is not working. Passenger side switch locks and unlocks both doors just fine. Full disclaimer, the driver side actuator is wearing out and doesn't work all the time but I can always hear it engaging when the passenger switch is activated. So I know the driver side actuator is on it's way out and have plans to replace it.
That being said here is what I have done that leads me to believe the driver side lock switch is fine and the problem lies elsewhere....I just don't know where. If I swap the driver and passenger lock switches, the drivers side switch will work when plugged into the passenger side but the passenger switch will no longer work when plugged into the driver side. This tells me the switch is fine and my problem lies somewhere else. Where I should start to track this problem down?
I have a v10 ticking on drivers side when I first take off in it. It doesn't do it idling and stops after you drive about a mile. I just had ford tune it up before this started so I took it back to have them check the plugs and they said it was a rod! Didn't sound right too me but I did check manifold bolts and they all was in place. Also if it was a rod would the noise go away???
View 6 RepliesSo today pulling out of the gas station I turned my steering wheel to the left and I heard a high pitch squeal from the drivers side. It wouldn't do it again unless I was just creeping, nothing going down the road. I did a few searches on here but they all are if the truck is moving say 30 mph or better. I know I need to replace my ball joints. 99 F250, V10, 4X4, extended cab.
View 8 RepliesThe driver's side mirror on my '06 250 (tow, heated, power, signal) got cracked... and of course whoever did it didn't stick around!!! Two questions...
Is it possible to replace just the glass? Or am I looking at replacing the entire unit?
Would you have a part number, or a link to a good online catalog?