So I went to start my truck today (1999 f250 5.4), it hasn't ran in a couple days due to -38C weather. When I started it today, it started rough(understandable in this weather) but my abs light and brake light came on and will not shut off. It ran fine the last time I used it, but now the lights came on. What may have happened.
View 3 RepliesPurchased a new 2016 F250 Diesel. When you shut the truck off or open any door while the vehicle is parked, the interior, markers, and bed lights all come on. I know it is suppose to be a convenience but to me it is a pain. And to make matters worst, they remain on for a short period of time after you leave the truck and close the door. Sometimes you don't want the lights to come on, like when you shut the truck off and are waiting to pickup someone. Any solution for this problem, short of removing the bulbs, or reprograming the computer?
View 13 RepliesI have a 2002 f250 SD v10 4x4. I had a ground wire break fixed that know noon of my instruments work. Dash lights up but nothing moves. Pulse my parking lights stay on when the truck is shut off or when I turn lights on then off. I have to disconnect the battery to get hem to shut off.
View 3 Replies2013 F250 XL with factory towing package.
My camper and boat trailer do not have turning signal or brake lights when plugged into the round seven pin trailer connector. I have tried both the connector in the bed and under the bumper. I've also connected the trailers to other trucks and the lights work fine so I know the problem is in my truck.
I have 1999 ford f250 superduty 5.4 v8 I noticed that my tail lights were not working I replaced the fuse as it was blown break lights worked until i cranked up and applied brakes. I replaced fuse again an checked brake lights they worked fine until i cranked truck and applied the brakes i did notice the wires were hot at brake pedal switch when they worked while not cranked. I replaced the cruise control release switch I was told that may be the problem since cruise didn't work. it fixed the cruise control but as soon as i pressed the brakes fuse blew again.I replaced brake pedal switch didnt fix it.
I then noticed a little smoke under tailgate i looked and the wire coming out of connector was hot while brakes applied and not cranked. i disconnected that wire put a new fuse in and brake lights worked in center light and passenger side without blowing fuse driver side however does not work. Because I disconnected the brake light wire to driver side green wire. When I reconnected the driver side brake light wire fuse blew.
So I have it narrowed down to driver side brake light. here is my problem. I have checked all the wires that i can see for bad or frayed /worn naked places i have found none I can get to the wires beside gas tank running the rail to check but it is doubtful that it is spot as nothing is rubbing along there. Could it be a relay somewhere? can i just run a new wire from brake light? if so where to i connect to? Is there a wiring harness i can just buy and replace the brake light wires from brake light to power source I have ran out of things to check on my own...
2008 F250 - All of a sudden no back lights when headlights are on. What gives??
View 14 RepliesI have an 04 F250 with no brake lights. However the third brake light works. I've also noticed that my trailer brake lights don't work either. I do have all my turn signals and running lights. Another issue that could be connected is I have one out of four hazard lights. When I push in the hazards my front passenger blinker works but none of the others. Could this all be due to a relay switch?
View 14 RepliesI have a 2014 f250 gas engine that i was playing around under the dash and blew a fuse no dash lights or engine start. found a defective fuse on the passenger fuse box changed it engine starts now but no brake lights and cant get vehicle out of park. is there a fuse somewhere for the brake switch ? if not how can i test to see if this is the problem.
View 3 RepliesBought an 04' F250, looked good but definitely not well maintained. Have replaced tranny temp sensor, thermostat, fuel filters, air filter.... Etc. heads have been redone and new studs installed , Egr delete, new oil cooler, flushed cooling system. Now tonight coming home noticed the brake lights aren't working, all 3 are out... fuses are good. I've heard multifunction switch or brake switch.....
View 12 RepliesI just noticed a week ago that I don't have reverse lights. I check the fuses all good. I have checked the harness and there is continuity. So that tells me that the relays are good. I also read to check the neutral safety switch but where it is located. After trouble shooting last night I also noticed that I don't have my 3rd cab brake light either.
View 3 RepliesSo, before I noticed a problem, all I had to do was a slight touch to the brake pedal, and the brake lights would come on. Now, they MAY just quickly flash and won't come on unless I really push hard on the pedal, such as at a complete stop.
I've noticed some issues with trying to lock-in 4W-LOW now too, and I know the brake pedal has to be pushed to engage 4W-LOW. Never had problems before now. 1999 F250 Superduty ...
I have a f 550 that blew out starter cyl on inner fender.and starter, replaced both. Now I have no brake lights or 4 ways and no turn signals....
View 4 RepliesI have a 2005 F250 that the brake lights are not working when brakes are applied. The rear blinkers and flashers are working. what could be my problem.
View 2 RepliesWe have a 1994 350 ford dually. the brake light and the abs light came on and it has no brakes. replaced the master cylinder ... still no brakes. what next?
View 1 RepliesI have a 1999 Super Duty 5.4l Manual transmission 4x4 105,000 miles the cruise control stopped working a month ago, I didn't think much of it because I frankly don't use cruise as this vehicle is usually used to tow and I don't run cruise towing.
Long story short I went to tow my camp trailer and noticed my brake controller was not actuating the trailer brakes when I braked, the controller is showing connected and when I manually actuate the controller its working, so I knew I had a brake light issue, I checked the brakes and sure enough I have no functioning brake lights.
I bought a Motorcraft OEM brake pedal switch and replaced it to no avail,I have also checked the applicable fuses they are fine. I have a master cylinder cruise control switch to change but have my doubts this is the issue since the brake lights and cruise are non functional.
I recently got my truck back from the dealership 04 super d 4x diesel (wife put gas in).. Anyway my dash lights, running lights and brake lights are not working. I checked fuses already and I did not see any obvious problems. I also replace the switch but that didn't work. Perhaps a ground somewhere or a relay? Turn signals and headlights work.
View 1 RepliesI have a 2008 F350 Super Duty Regular cab long bed 4X4 I have no cargo light and no third Brake light, checked and even replaced bulbs. Still have no lights up top, what to check or how to fix this? Can I tie the cargo light into the dome light inside without screwing something up? I can't understand why they stopped hooking the cargo light to the dome light but this one seems to be wired separate. Would love to get these lights working again. When I bough t the truck the cargo light didn't work and I thought maybe the bulbs were burnt out, I never checked the brake light I tried to get the cargo light working and that's when I found out the brake light didn't work either.
View 3 Replies2004 f250, brake lights except 3rd brake light do not work. flashers also do not work. turn signals work on both sides. when you turn on the flashers only the right indicator on the dash lights. checked all fuses for brake lights and am at a loss. On a float trip this weekend with my toy hauler and need brake lights to get home.
View 2 Replies2002 f350 5.4L
No rear running lights or brake lights
No third brake lights
Headlights work
No signals or hazard.
I have power to the multifunction switch when I use a jumper wire to bypass the switch I can make the lights come on depending on which slot I put it in. I replaced the multifunction switch twice just to see if I got a new bad one the first time, but to no avail. I cant run my truck a night without the lights.
My 2011 f250 is stuck in park and the brake lights do not work. I have changed the brake switch but still wont shift out of park.
View 4 RepliesThe flashers and blinkers work, the taillights, brake lights and back up lamps do not.
The truck is a 2004 F250 4x4... Checked all fuses. What am I missing?