A bird and a rattle snake under hood, I've got a chirping when I turn, thus the bird. I've got a rattle on rough roads, thus the snake.
My guesses are... Power steering pump & front shocks. There's no other determinable problems with the steering or suspension on this 2WD.
230K on the ol' girl, previous owner took pretty good care of her.
I am getting ready to put new axle shaft u-joints in my 2008 F350 (they are shot, they actually rattle on my rough roads). While I am at it I figure I will grease the front wheel brg cartridge, replace the needle brg that is inside the cartridge. I am also afraid I will the axle shaft vacuum seal. I don't want to go to ford an get raped, diesel O-rings doesn't have parts for the newer pickups and I don't want to get junk from the parts houses. Where I can get these parts for a reasonable price? What the best brands are? Are they the same parts as the earlier super duties? I know the lock out is different.
View 2 RepliesJust noticed today, while taking slight right turns 20-40MPH, I get a really loud and angry chirping sounds? Its only right turns...It sounds like a forest of angry crickets.
View 4 RepliesI have a 2006 f250 lariat 192k no mods except k&n filter everything is stock. I have 2" pro comp level kit and a scan gauge 2 nothing fancy! Well the other day I noticed my truck was chirping like a Chirp chirp chirp...... Chirp chirp...... Chirp chirp chirp! It goes up and down with the rpm's but it's comes on and off only when the engine is up to running temps the belt does squeak during warm up but I don't think that's it, it's coming from the back of the engine I'm sure of it because I used a paper towel tube and listed right in the turbo hpop area on top of the engine but it's too hard to tell I can't find exactly where it's coming from, some people I've had listen think it's a belt or pulley or tensioner! But I'm not sure if it is because I've sprayed water, and wd40 on the belt and pulleys with no change!!! I'm afraid it's a lifter or something inside the engine yet it's too loud and pronounced to sound like it's coming from the inside! I'm just lost!
View 8 RepliesSo When driving around I'm hearing this squealing almost chirping noise and it sounds like its coming from the rear of the Truck. I greased the bushings and leafs but that didn't fix it, to me it sounds like a rotating noise. Don't think it's the brakes cause it makes the noise when driving not stop.
Also, a bad alternator would make noise while driving over 40+mph, like a loud whistle?
Drive a 2012 F250 6.2L 19k miles
2000 super duty v10 with 92,000 miles. Getting that common rattle around 2k rpm range that goes away if I give it gas or let off. I originally thought it was the inspection plate on the transmission so I removed it and went for a drive to verify. The sound is still present so the only thing I can think of is the catalytic converter is worn out??
View 10 RepliesSo I drive a 2012 F250 6.2L and recently I've been hearing this rattling noise, kinda like a bag of washers being tossed about. I thought it was the snap brackets for the fog lights cause I removed my fogs and the brackets were loose enough to jingle so I zip tied them and it seemed like the rattle stopped, however, coming home the other day I hit a pothole and the rattle jingle noise happened again. I've checked most of the front end making sure all is tight which it is
Update: There were some lose snap bolts and brackets I'd missed so I took them off but no luck. I have come to the conclusion however the noise only occurs when the suspension is compressed. I figured this out by having my 300lb friend stand on the bumper and then I hit the coils with a mallet and I could hear the rattling noise and no I was not mistaking the coil vibration for the rattle noise.
I was going to put new ball joints in but wimped out and had my mechanic do them. I'm too old to be doing that kind of crap. I just replaced the fuel pump with the correct one. That's enough under truck time for a while. 91,000 miles on the originals, stopped the rumble / rattle when I hit bumps in the front end. Getting the alignment Tuesday. Guess I got my money's worth out of them. Still has original brake pads too. Thinking of doing an upgrade to the brakes, drilled and slotted, I tow an RV and need it to protect the idiots that pull out in front of me. 2001, V10, CC ......
View 8 RepliesI recently purchased a 2000 F350 4wd, it's mainly used for plowing my driveway, and hauling larger items. I can truly say I love this truck. When I got it, it was in pretty rough shape, but slowly I've been bringing it back to life.
However, I have this loud front end rattling sound I can't seem to locate. Quick background the truck is 4wd with a v10 in it, and it has 215k miles on it, poorly maintained, so everything is suspect. Only new parts are all new brakes and new u-joints everywhere.
So back to the noise, it's most noticeable whenever I hit a small bump or dip at lower speeds, but the noise is still there at higher mph as well. It's loud and literally sounds like the whole front end will fall off, its a definite rattle, doesn't seem to be from one side or the other, best I can describe is in front of the firewall at it sounds like something is very loose.
But when I crawl underneath the truck, I don't see anything loose, the shocks, look OK, the sway bar links seem to be connected. IDK what else to look for, 4wd works fine and doesn't seem to alter the noise any when engaged.
Truck recently passed inspection, and no mention of anything being loose or worn was mentioned. I'm kinda at a loss, but the sound is so loud and noticeable I feel like it should be obvious as to whats loose underneath.
I was driving and i was doing about 60 65 and i hit a bump and i heard a loud rattle and it shock the hell out of me then it just stop...
View 2 RepliesThis is an early 99 f250 powerstroke 6spd manual 4wd, is it common or normal to hear a lot of transmission rattle at low rpm especially in lower gears under a load. Starting off from a dead stop it sounds awful until about 1500 rpm where it clears up (or load is reduced). I'm hoping it's just the power pulses going through splined shafts, gears, etc.
210k on the truck, just changed every fluid in it.
I've been a honda owner and mechanic for all of my driving years where shifting at 8500 rpm is common and now I'm having a hard time learning what this thing likes, rpm ranges to avoid, ect; even shifting I find difficult. At least you can heel toe with the pedal arrangement...
So loving my new to me truck. Only has 140K on it. But one thing that bugs me is that with the doors closed tight, when I drive over bumps, they sound like they are not closed. Makes you feel like they will fly open. But when checked they are closed all the way. Is there an adjustment or something that can correct this?
View 5 RepliesI have an 05 5.4 f250 that had a stuck injector. I changed plugs before I realized it was injector. After that the truck had a terrible rattling noise. I ended up changing timing tensioners and guides (guide was broken). Started it up and have the same noise, like timing chain is loose.
What I think happened is gas got into oil when injector was stuck. I had key on to pull codes. Then it lost oil pressure?
Could this cause can phases to go bad? Also can I just install lockouts or do I need to replace phasers as well?
Not sure if there's anything else I should check
Stop my Prius dashboard rattle on rough roads?
View 7 RepliesI picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 RepliesMy factory-ordered 2016 F250 CC SB 6.2L 4X4 3.73 is about 6 weeks old. Driver and passenger side door rattle noise (in upper back corner) at highway speeds (65-75 mph) has gotten progressively worse over those 6 weeks. See attached video.
Trying to determine if this is caused by:
Door seals: the temperature here in Iowa has dropped from a few weeks in the 90's to the now in the mid-60's.
Could the temperature change have caused the seals to change shape/structure and result in the rattle/noise?
The exterior seal between the front and back doors (attached to front of the back door): mine seems a little loose on top, but nothing that would cause this kind of noise.
I have a "rattle/knock" that I think is coming from the doors on my 2000 F250 SD extended cab. The rattle is only there when the truck is going over bumps....especially closly spaced bumps. My buddy has the exact truck and it does not rattle.
View 14 RepliesHave a 15 250 diesel and my drivers side door has a rattle in it. Seems to be coming from around the area were the mirror buttons are. Removed that little panel and applied some silicone around the edges and seemed to work for a bit then back to noise. Seems to go away when cab heats up good or warm outside.
View 5 RepliesI just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?
I bought a 2004 F250 super duty 4x4 with the 6.0 a couple weeks ago and have a few questions. Hopefully all of these things are normal, but I thought I would ask you experienced drivers.
1) Occasionally while driving when I lift off the accelerator pedal I can hear a sort of loud rattle under the hood. I assume this is the turbo shutting down? Is that normal?
2) 4x4 and locking hubs... I have the 4x4 hi and low switch on the dash. Do I need to also manually lock the hubs to go into 4x4? After reading the manual it seems like I can just turn the dash switch and they should automatically lock, but I'm not sure. The hubs are not marked, but going by the pictures in the manual I think I know which is "lock" and which position is "auto" or off.
3) Front wheels hop at full turn. I expected wheel hop in 4x4 or with the hubs locked, but even in 2WD with the hubs in the auto position the tires still "hop" or knock a bit at sharp turns. Is this normal?
My new Prius C is only 6 weeks old, but started hearing some annoying rattles from the dash area when driven on rough roads (tarmac or roadworks).
View 19 Replies