Ford Super Duty (1999-2016) :: F250 V10 Will Not Move In Any Gear
Aug 27, 2017
I have a 1999 F-250 V10, I went to get into my truck to go to Lowes and only to learn I forgot my wallet. Here is where my problem lye. I came back home and decided to wait until the next morning to go back to Lowes, so I go to get in my truck cranked it up and went to put in reverse and it didn't move. It is like it is in neutral; so I went and put it in drive and still, it would not move. It is like it is in neutral. I can not figure out what is going on with my truck.
View 12 Replies
Advertisement
Just had a question about my 00 F250 7.3. I recently have noticed that my tachometer needle will not always move the way its supposed to. Sometimes it will sit at zero until I drive it for a min then all of a sudden pops up to where its supposed to be. I also noticed today that while i was driving it just dropped to zero for a second or two then back up to where it was supposed to be again.
When it does this there is no drivability issues with it or idle issues what so ever. Which is strange to me and I cannot seem to put my finger on what could be causing the issue. As I have searched online for a while to no avail as most of the other issues include drivability and idle issues. Also not that it matters but I have recently replace the cps sensor with a new one OEM of course but i don't think that has anything to do with this problem.
View 6 Replies
I have a 2005 F250 King Ranch 4X4 Diesel and now experiencing an issue with the front seat belts
The problem is while being worn sometimes they will not let you lean forward- they act like you have a foot on the brake pedal and are locked-you have to lean back and forth several times to get them to let out if reaching for something on the dash etc..
I have searched the forum and found many issues where the seat belts stopped retracting- but my issue seems to be unique in that the seat belt will at times 'Not Let Out" when you lean forward.
View 4 Replies
Friend's truck started shifting wierd the other day, starts in second gear (maybe higher). The transmission is a fresh rebuild, the shop wouldn't warranty the rebuild and blamed electrical problems outside the tranny. Fuses are all good, engine light is on but the cheapo code reader won't show a code. Did a search and no answers. Had the overdrive light flashing from before, that code was for a wheel speed sensor.
1999 F250 (7 bolt) 5.4L 4x4
View 1 Replies
I have an issue with a truck I just bought. Sometimes, it doesn't go to Park when I shut it down. In order to start it I have to sometimes put it in neutral. Once in a while it will start when in the Park gear. What I should look into to fix it? It doesn't seem like a big deal.
View 6 Replies
Having trouble with the truck going into gear. It started by having to put the truck in first and manually shift until in drive, once it finally engaged and would drive normal. But now im having trouble with going into gear at all. What could be the issue????
View 8 Replies
Kevin here, and I'm a newbie. I recently purchased my first 4x4, a 99 F250 with ESOF. Last night I had put it in 4high for a rough road turn-around and then flipped the switch back to 2H, the 4x4 light didn't go off. Then when I got to the house (about 1/2 mile), it rolled when put in park and now it won't go into any gear.
View 7 Replies
Friend parked his well working truck and when starting it up after sitting a few days it won't shift into any gear. Lever moves as normal but the truck won't move. A soft clicking sound is the only difference to be noticed when shifting the lever. where to start? Temps are below freezing here if that matters.
View 11 Replies
I have an 03 f250 5.4l that I've been having some problems with. When the engine is cold it will drive fine and everything. When it warms up, if I go to put it in gear it just dies right away. Why?
View 1 Replies
I may be going to look at a 2001 F250, 4x4 with a V10 engine tomorrow. I think it is a shop truck for a business. The owner said that the mechanics told him that the trans won't shift out of low gear. It is an automatic. Maybe something as simple as a modulator valve (do they still use them)?
View 4 Replies
I just went from 3.73 to 4.30 gears on my 2007 f250 6.0. It has the standard Sterling 10.5 rear and Dana 60 front. My mechanic friend who did the swap said the ABS light came on during his test drive but the truck drove fine. I was of the understanding that the truck would not need to be recalibrated for proper speedometer and transmission function, but what about the ABS?
View 7 Replies
I have a 2001 F250 V10. It idles around 1k and when stopped at stop lights or when put in reverse it stalls. I have replaced IAC, fuel filter, tranny filter, oil filter, plugs, coil boots, tranny fluid, oil, air filter, and PVC along with the PVC hose. I'm totally stumped. It doesn't stall if I do a rolling stop.
View 14 Replies
I recently purchased a 00 F250 psd 4x4. Other than doing all of the fixes it needs to make it ride better I have been questioning the trucks "get up and go" and the EXTREMELY sensitive skinny pedal. Truck seems to pull very hard and puts out some black smoke under hard throttle but nothing like the really tuned trucks I have seen. But the skinny is so sensitive its hard to drive under 40mph in 3rd and once it gets up to 55 or so its real sharp getting on and off the throttle. Trans shifts great, TC locks and unlocks, truck runs awesome IMO but just a bit harsh. Is there a way to find out if it was tuned prior to me buying it other than inspecting for a chip, or is this the way they are and I just have to get used to it more...?
View 9 Replies
I recently purchased a 04 f250 with the 6.0l powerstroke. I drove it for about 3 weeks now, Ive put my trailer behind it with small loads and just today tried to use the tow/haul button. When you go to pull out the tranny never shifts from first gear?? Its pulls and runs fine until you push the buttan and no shifting........
View 6 Replies
When I "step on it" on the freeway or even a moderately inclined freeway ramp, it bogs down and actually takes a few moments to cover. Sometimes will leave me crawling at about 20mph for a few minutes. Engine revs just fine in neutral. If I very slowly build up speed I can cruise at 75mph, but forget passing. Also, this came along at the same time a severe shaking/shuddering spell started. Not always, but often it is shaking the entire body and certainly through the steering wheel. Was so bad the first time I stopped to see if I had a flat. Usually lasts until I slow way down and ease my speed back up. Had the front end steering structure replaced about two years ago, so I don't think it is that. What is the cause of the bog down and could the shaking be related? This truck sits for 2-3 weeks at a time and then I drive for about 50 miles and park it again. Can Michigan gasoline go bad that quickly?
View 5 Replies
I have a 1999 ford f250 5.4 2 wheel drive i believe its a 4r100 transmission. auto. I have reverse but no forward gears. Ive heard this is a common problem , and on my reverse it has to hit 3000 rpm before it even tries to move and D 1 2 i have nothing only thing i hear is the engine sound changes gets deeper. Do i need a whole new transmission or is this fixable.
View 4 Replies
Ok I bought this truck with a bad engine 5.4 3v had rod knocking. I rebuilt engine got it all back together and in truck. I did replace cam phasers and solenoids. After driving 20 mins or so it would start the phaser knock at idle in gear so I put a oil pressure gauge on it and cold had 55 psi after running 10 mins or so had 15 psi at idle then would drop to abought 9 psi. I am thinking I got bad cam bearings or something for some reason don't know why. I did it but I took oil cap off where you pour in the oil. Had to force it off it was pulling that much vaccum ones cap was off oil pressure jumped up to 25 psi. What could be causing this.
View 2 Replies
When passing or going up small inclines on freeway, my F250 seems to make the shift to the passing gear but then almost a complete loss of power. Jerks around for a few seconds and finally provides enough power to at least get back to the original speed. (It feels kind of like the lurching, etc. I used to get when those stinking GM diesel injectors would act up in the 1990's.)
It also stays in first/second as I punch it while entering the freeway and doesn't want to make the shift. I can put it in neutral and race the engine, so I don't think it is an engine problem, unless the transmission is electronically controlled. I have a lot of computer dashboard gauge resets after falling to zero and sometimes have to set and release the parking brake to get the auto door locks and windows to work. (That started after a car break in where the door electronics were apparently pinched, but that was a couple of years ago.)
Does it sound like the transmission or electronics? In the old days replacing an automatic transmission filter seemed to fix a lot of transmission issues. Not an option now, but would I expect to see any results doing a transmission flush and fluid change? It's probably been about 60000 since I had that done. (157000 now).
View 2 Replies
I have an intermittent problem with my 09 F250 Diesel. A few times now under hard acceleration I have had the trans seemingly get stuck in 3rd gear. The little service required wrench symbol showed up on info screen but after shutting off the engine no codes were present. A week or 2 later this happened again and I ran diagnostics through my Spartan tuner and got P0771 and P2704 for codes.
Again they cleared when I shut the engine off. Since this is an intermittent problem, only after hard acceleration, would it make sense to change tranny fluid, maybe do a tranny flush? Or am I off to the dealership for a rebuild?
2009 F250 Lariat Crew Cab Short Box
Spartan DashDaq
S&B Cold Air Intake
4" Flange-back w/6" Can
Package by Dirty Diesel Customs-Red Deer Alberta
View 5 Replies
I have a 2000 f250 superduty gas v10 6.8L . I bought this truck about 4 months ago. Now when I take off from a complete stop the truck shakes up until second gear, shifts fine all the way up until the last gear it looses power "loosing power" i mean i can put my foot into the pedal and it takes forever to climb speed meanwhile the RPM'S never skyrocket like it the transmission was slipping if anything a couple times the RPM's dropped are stayed the same then as i take my foot off of the pedal once i have my desired speed sometimes not always the truck will give me a little jerk Also Just the other day I was driving on the highway and decide to put her on cruise control at about 70mph, I set the cruise control and the RPM gauge was just over 2,000 and the tach was fluctuating up and down about 1/16 of an inch. I been reading alot of forums and what I got out of them is it maybe pointing me to a misfire maybe the coil packs? Plugs?It's not something major like a transmission rebuilt.
View 6 Replies
I have a 99 f250 with some procomp (325s) that are 12.5 wide with a 6in lift my superchip tuner can change the trannys shift points but I am pretty sure a new gear ratio is needed. I dont do a whole lot of off roading with it its mainly my driving around and highway rig whats a good gear ratio that would work for me
View 9 Replies
