Ford Super Duty (1999-2016) :: Front Driveshaft Leaking?
Apr 23, 2017
What would I need to replace in order to fix this leak ?
View 5 Replies
Apr 23, 2017
Advertisement
Ford Super Duty (1999-2016) :: Front Driveshaft Broke?
I was having a problem with 4wd and regreased/ cleaned hubs and when I went to test operation both fronts would engage and worked good. After a while.of testing in and out of 4wd I heard a loud clunk and looked under, the front driveshaft blew apart at the weld.the u joints dont seem to be bad so im at a loss as why this snapped. It was not a clean break and the edges looked like it had to started to tear at some part in the past due to rust build upon the inside.of the shaft and torn edge. Im lookin at 2 feet of snow expected here Tuesday, so im trying to find some answers as well as a.new shaft.
View 14 RepliesFord Super Duty (1999-2016) :: Bad Grinding Noise From Front Driveshaft / Differential
For starters I have a 1999 F-250 5.4l changed all 4 ball joints about 15,000 miles ago. I have been hearing a grinding noise coming from the front end for the last month only when I turn left and at slow speeds. I was servicing the TC so I threw it in 4 wheel to check it and it wouldn't engage until I started moving. When it did engage it was a bad grinding/ clunking sound coming from maybe the differential.
View 14 RepliesFord Super Duty (1999-2016) :: Vibration - Fluid Coming From Front Driveshaft At The Tcase?
On my way to see my folks and I started feeling a vibration like driveshaft or wheel bearing between 45-55 mph then at about 75 then BOOM! Pulled over and found a pool of ATF thought my stock 4R100 just bit the dust but looking at it the fluid is coming from the front driveshaft at the Tcase. My hubs are unlocked and my ESOF is in 2HI but I assume my tcase was locked. Also since the tcase is probably screwed I'm goin to do the 271 with manual hub swap, how hard that is?
View 10 RepliesFord Super Duty (1999-2016) :: 2015 - Alignment Of Front Spline On Rear Driveshaft?
Proper alignment and re-installation of the front spline on the rear driveshaft of my 2015 F350.
I removed my rear driveshaft recently (it slipped right out upon removal without any force or resistance), and I'm getting ready to re-install it again this weekend, but I've noticed that one of the grooves between the array of male splines on the shaft itself appears to be slightly different than the rest - it seems to be slightly wider. It even has a white-colored stripe of paint down the full length of the groove as if it were denoting it as being somehow different from the rest?
Problem is, when visually inspecting the splines on the inside of the receiving yoke (the part that the spline fits into), I do NOT see any such differences. In other words, it doesn't appear that there is only ONE way to properly insert the front splined-end of the driveshaft. What am I missing here?
Is the front splined-end of the rear driveshaft intended to be inserted into the yoke in ANY position around the dial? Or is there only ONE specific position or orientation that it is intended to be inserted or installed? NOTE: I've seen references elsewhere on-line that seem to indicate the need for proper alignment when there are multiple U-Joints, and maybe this is a part of it (?), but I'm not quite sure which U-Joints to consider or how to interpret such an "alignment".
Ford Super Duty (1999-2016) :: How To Remove Driveshaft To Replace U-Joint
Rear-most connection before pumpkin, need to replace the U-Joint. I got the four bolts out at the flange but the shaft won't drop. I beat on the connection a bit, not enough to hurt though. What am I missing? How the heck do I get this apart and drop the shaft to replace the U-Joint???
View 9 RepliesFord Super Duty (1999-2016) :: Rear Driveshaft Woes / Vibration At About 45 Mph
When I bought my 05 350 dually it had been wrecked, the rear diff was under the bumper and most of the rear suspension, including the back part of the rear drive shaft was in the bed of the truck. I have gotten everything back in place, and have driven the truck for a few weeks, but I knew I was going to have to replace the ujoints because there was visible damage to one of the caps. I have also had a vibration at about 45 mph. I had no way of knowing how the original driveshaft was oriented at the slip yoke so I went with best guess. Now in my research I read that if the driveshaft is not put back exactly in the same position vis a vis the slip yoke it will be out of balance.
Also if the drive shaft is dropped it is scrap, and if I have any lift on the truck {it had 4 inches when I got it} the whole thing will shake itself to pieces. Most of the answers to other drive shaft questions talk about taking things to a good driveshaft shop. No such thing here in the vast stretches of My state. I am pretty much on my own as far as building or repairing this thing. Is there any way to determine how the shaft was originally oriented? I also have some damage on the end of the yoke and will have some trouble getting the ujoint apart. Is the shaft now junk? And if I get an ebay replacement, how do I tell if that shaft is in the right orientation?
Ford Super Duty (1999-2016) :: 2015 - Front Axle Leaking A Lot?
I have a 2015 F250, cc 4X4 PSD. It has 22,000 miles on it. I notice a small quarter sized drop of oil after it is parked by the right side front wheel. It is coming from behind the dust cover and universal joint where the axle goes into the tube. I dont know how long it has been leaking. My issue is I am about 800 miles from home on a camping trip, have to go back to work Monday, and lcoal dealer here can't take it in till next week. So, if the hubs are not locked and the truck is in 2 wheel drive, the gears shouldn't be turning right? I assume it is ok to drive home. I didn't want to pull the plug and check the fluid because if any runs out and leaves a stain on the cover, I don't want ford trying to deny warranty claiming I messed with it first.
View 5 RepliesFord Super Duty (1999-2016) :: 2008 - Oil Leaking In Front Main?
Right after i got this truck it developed an oil leak which i thought was the front main. Turns out after a lot if degreaser and watching its not and its actually leaking from a small tube running out of the passenger side of the engine. I think its an oil cooler line but not sure. Its where the cross member is located and i cant get in there very easily or figure out how to load up pics to the site on my phone. What this line may be?
View 7 RepliesFord Super Duty (1999-2016) :: Front Axle Seal Leaking?
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 RepliesFord Super Duty (1999-2016) :: 2012 - Drive With Rear Driveshaft Removed?
I want to and went to buy a new 2012 F350 leftover - everything is good except that Ford.com says the truck was initially put into service In September of 2012 and therefore my warranty will expire in September of 2015 instead 2016.
Dealer says it's an error and will be corrected AFTER I buy the truck, so far I have been unable to get a straight answer from Ford.
Any information about being able ot change the original date a vehicle is put into service ?
Ford Super Duty (1999-2016) :: Right Front Axle Seal Leaking Continuously?
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 6 RepliesFord Super Duty (1999-2016) :: F350 - Coolant Leaking At The Front Seam
I recently did the water pump and hoses due to seeping around the water pump gasket. While there, I decided to replace the overflow reservoir as well - old and slightly discolored. I'm now on my 3rd overflow reservoir - they are all leaking at the front seam. I don't think I have a blown headgasket or injector issues - no signs of white smoke ever, and there isn't any oil or fuel in the coolant. I've also tried a new cap, but it's starting to leak before I build any noticeable pressure - I can back off on the cap and don't get much pressure released. So - just bad luck on parts from Ford? All were OEM from different Ford dealers.
Pics - hard to see on here but go to Imgur to zoom in. [URL] ...
1999 F350 7.3 CCLB Dually. Stock except for DP Tuner and Gauges.
Ford Super Duty (1999-2016) :: 2005 F250 FX4 Swaying While Driving - Front End Leaking
My f250 felt like it had a flat as in it was "swaying" while I was driving today. as I'm pulling into my neighborhood it felt as if i had a flat. There is fluid leaking from what looks like a control arm or possibly a canister that's part of a vacuum system. I'm a carpenter obviously by my terminology used in this post. Its dark so ill take another look in the morning but what I'm talking about..
View 14 RepliesFord Super Duty (1999-2016) :: Vibration On Takeoff And Other High Torque Situations - Unbalanced Driveshaft
We've gone through pretty much every other option as to the vibration on take off and other high torque situations and have pretty much settled on the the driveshaft as the issue. I added traction bars recently thinking that the old leaf springs just aren't up to the job anymore. That seems to have worked some but it's still there. We've gone through the rear diff also and that's good. I'm looking at options for replacement of the shaft. What are the current thoughts on one piece shafts? Is aluminum the better option?
View 14 RepliesFord Super Duty (1999-2016) :: 2005 - Water Leaking From Rear And Front Driver Side Door?
The doors on my 2005 crew cab are leaking water. Its happened once before, I fixed it by resetting the main seal around the doors. Now this tropical storm had them leaking again. The rear doors are leaking from the top and getting the head liner wet, and the front left door is leaking a little bit onto the middle pillar Guage and down onto my leg.
Is it time for new door seals? My 01 has never had this problem so im not entirely sure what to do.
Ford Super Duty (1999-2016) :: Oil Leaking On The Transmission
I am not positive where it could be but I have a good bit of oil on the transmission (i think) i was trying to replace the strarter and noticed it. Where the possible leak could be from? No oil on the ground under the truck.
View 3 RepliesFord Super Duty (1999-2016) :: Steering Gear Box Leaking
I'm might be needing a gear box rebuilt or maybe buy one already rebuilt.
View 5 RepliesFord Super Duty (1999-2016) :: Rear Differential Leaking
The rear differential is leaking on my 2000 f350, i am going to replace the gasket. When I take the cover off will all the gears pop out or are they held in? Also how much differential fluid does it take?
View 8 RepliesFord Super Duty (1999-2016) :: 2002 - Oil Pan Gasket Leaking?
my oil pan gasket is leaking on my 2002 f350 5.4l 4x4. I have read lots of threads on replacing this gasket on an f150 but haven't seen one for an f250/350. so what is the procedure to do this job on an f350?
View 2 RepliesFord Super Duty (1999-2016) :: Rear End Cover Has Been Leaking Oil?
My rear end cover has been leaking and I don't have time to fix it right now. I was going to check the oil and maybe add some if needed but I cant find anywhere to ad oil or check it? Am I missing something? The add plug is the one Id like to find.
View 2 Replies