Ford Super Duty (1999-2016) :: Fuel Gauge Slow To Respond After Fill Up
Feb 26, 2012
Yesterday went to fill up ($4.05 a gallon geezz!) and noticed that after getting back into the cab, the fuel gauge still showed almost empty. So after yelling a few expletives, I looked again and noticed the gauge starting to make it's way up the dial. It took almost 30 min. before it showed almost full. I'm not sure what the problem is, as the gauge seems to still function. I don't drive the truck much as I use it as a tow vehicle. However, I do try and take it for a spin about 3-4 times a month just to exercise it. I was wondering if the fuel has started to gel and that is the reason for the slow fuel gauge response. Should I add a fuel conditioner/cleaner now that I have a full tank?
View 9 Replies
Advertisement
I notice the gas nozzle clicks off all the time when I am filling my truck. Normally I just hold the nozzle up more and it seems to work.
F250. Slow fuel fill or fill nozzle keeps shutting off....
[URL] .....
View 2 Replies
My 2000 F-350 during fill-ups will spill out about a quart or more of gas from under the truck somewhere right when the filler clicks off. Also can smell fuel sometimes when between half and full tank. 2000 f350 SWR crew-cab 4x4, 5.4 gas.
View 3 Replies
Everything was working fine, getting down to about 1/4 tank. I do the usual, fill up, startup, reset the trip, and look at my level and it hasn't changed, neither has the 'km until E'. What would cause this? Failed Sender? No check engine light (yet). I guess I'll be watching the trip meter for a while.
View 8 Replies
2000 v10 f350 single tank...fuel gauge is stuck on full. I'm on the road so I don't have my drawings so I tried some quick troubleshooting. If I remember right 160k or so is full and 20k ohms is empty...so I unplugged the sender from the harness which should be open and the gauge should read empty. With key on its reading full. I then followed the harness and unplugged it near the brake booster...key on it reads full. Just wanted to make sure I'm not doing anything wrong before I rip the dash apart.
View 6 Replies
1999 F250 V10 gas. I changed out the fuel pump, and now the gauge doesn't work. Checked all fuses - they're good. Is there any possibility that I could have accidentally pinned the float under the pickup sock, or got it hung somewhere? Is this a common occurrence? Don't really want to drop the tank again - but looks like I will have to in order to check/fix.....
View 3 Replies
I have a 2000 ford F 250 with V-10 engine with fuel gauge stuck. The problem started in the winter a couple years back on a cold night when I fueled the truck with it running. The fuel gauge never went down. I assume this would indicate a stuck float? I dropped the tank and noticed a loose yellow wire. I can't see that the wire was attached anywhere though? A V-10 is not the engine to be guessing with on fuel...
View 1 Replies
On my 05 Super Duty, the gauge light for the fuel and oil pressure are out. The needles are still illuminated red but the backlight for the gauges are dark. Are these replaceable bulbs or are they a circuit board diode or something that can't be easily replaced?
View 1 Replies
Ever since January My fuel gauge has been acting up big time. I can have any amount of gas in my tank at any given time and the fuel gauge will fall to empty resulting in the fuel and check engine light coming on. The gauge will then return to its position (it still doesn't read correctly) and the check engine light will stay on. I took it to the ford dealer and they said to replace the entire fuel sending unit assembly. I bought the oem motorcraft fuel sending unit assembly and did it myself. The only problem is, I still have the issue. I'm currently checking fuses and relays, By the way, my truck is a 2004 f250 fx4 5.4
View 2 Replies
I have an 03 f350 4x4 cc long bed and I seem to be having a problem with my fuel gauge. It doesn't show the true amount of what's in the tank and because of that I have run out of fuel a few times.
sometimes when I'm driving the light will come on and the gauge will drop all the way to empty then a little later it will go to almost full even with only putting 10 gals in the tank.
Any fix for this or do I need to replace the sending unit?
View 3 Replies
I have a 2001 f250 with the 5.4. from what I have read i should have the 38 gallon tank. i have been really questioning the accuracy of my fuel gauge on empty with the light on 25 gallons and the fuel pump will click off and after i drive i can park and my fuel gauge will read lower than what it was when i pulled into the driveway with. me and the wife went driving yesterday and we pulled back into the driveway on half a tank this morning I went to go run some errands and when i started the truck the gauge was almost on a quarter of a tank my driveway is flat and after driving for about 35 minutes the gauge was still in the same spot and did not move up nor down.
I have a locking gas cap cover so i know someone is not taking gas out. I have changed the fuel filter and tried numerous different fuel system cleaners to try and see if maybe the contacts on the float in the tank are dirty nothing has changed or gotten any better. I have checked the wire harness from the top of the tank and followed it up under the hood and found no drop in voltage or cracked or damaged wires. I checked with my multi-meter I used my fluke meter not some cheap one. Don't know if the gauge is reading less or more from getting gas i am thinking it is showing less than what is in the tank. What could be my problem?
View 3 Replies
I have 03 F-250 with a 5.4 in it. Recently noticed the gas gauge is not moving much and seems like it will not go below half a tank. The gauge will go up however when i put gas in it. I just put techtron in it last night to see if this might work. Wasn't to sure if i did a battery reset on the truck if that may work as well.
View 2 Replies
I just replaced my fuel pump to avoid another tow truck ride and now my fuel gauge is off. I filled up the truck today and the fuel gauge is only showing half a tank. I turned the truck on and off several times to try to reset it, but that didn't work.
Truck is a 2003 with the 5.4.
View 1 Replies
As I was driving to work yesterday I noticed my fuel gauge going from half tank all the way to full going down the highway. I started looking at the rest and they seem to be in there normal spots. I looked up and watched the outside temp go from 40 degrees to 5. This morning the fuel gauge goes straight to full and the outside temp bounces between 2 degrees and 10. What may be going on to cause this?
The truck is a 2000 F350 crew cab with a 7.3 Power Stroke
View 3 Replies
I'm having an issue on my 2002 F350 7.3. Today I hop in it and drive off I notice my speedometer stopped working. My overdrive light on the shifter started flashing. The trans seems like its not shifting correctly. It will eventually shift into overdrive but not always. Also now when I start off my fuel gauge raises and when I come to a stop it drops all the way to E and causes the ding and fuel light to light up. I figured this was all due to the VSS being bad. So I drove over to Autozone bought another VSS and a cheap tool set and changed it in the parking lot. No dice. I do have a scanner to pull the trans code but its late and I just got home.
View 1 Replies
Recently had extensive work done on my 2005 F250 PSD. 4 injectors replaced, fuel regulator, and STC fitting on HPOP.
Got the truck back, and the fuel gauge, and "distance to E" display are working intermittently.
When the truck went in for repair, it was about 1/8 tank. After repairs, shop put about 30 miles on the truck.
I picked it up, and the gauge read E, and display said 0 kms to E. I filled the truck up, and the gauge still read E, and said 0 kms to E.
I then drove for a while, then powered down, and back up again, and gauge read below E (like when truck not running), and display had 4 dashes...no numbers, for distance to E. I powered down, and then back up, then it read 696 kms to E, and gauge working normally.
This morning, on a cold start, the 4 dashes, and empty reading returned. I shut off truck, and restarted it, and it started working again.
Could the shop have damaged the sending unit, while driving 30 miles, with so little diesel in the tank?
View 5 Replies
I have a 2003 F250, 4x4, 5.4L and today my fuel gauge stopped working. I don't know if it had anything to do with a stall, I was on an exit ramp and the truck cut off, I quickly restarted and no issues after that. Other than the fuel gauge not working at this point.
I looked at the fuse panel diagram and there is no fuse for just the fuel gauge. The only thing I see is #35, instrument cluster. The rest of my instruments are working, so what else would cause the fuel gauge to stop working? It had a little over a half of a tank before the stall, after the stall it went down to less than half. I filled up shortly later and it's just stuck at less than half.
View 1 Replies
Got to work this morning, sitting at idle for a few minutes in parking lot, all of a sudden fuel gauge needle drops to below 'E' and the fuel light comes on and beeps. I know I have at least 1/2 tank of fuel. What would cause this?
View 3 Replies
2003 F 350 gauge indicates water in fuel. Second hand truck, the hex socket in the plug has be rounded out. Removing plug
View 1 Replies
177,000 miles, fuel pump was replaced just before I purchased it a few weeks ago. Truck has been running like new until today when it started doing this completely out of the blue. If you watch the video, the sound is not off, the tach is moving independently of the sound of the actual revs. Occasionally when doing this, the fuel gauge drops to zero. Thinking this is an electrical issue somewhere.
YouTube.....
View 14 Replies
I bought a 2006 F250 6.0L a couple of months ago, from a dealership. It's been bulletproofed already, has an intake, coolant filter kit. Has 95k (mileage). Today, my fuel gauge dropped to empty from 3/4 of a tank for a couple of miles and set off the CE light. I hooked my scan tool to it, to clear the code (P0460).
After just checking other things out with the scan tool. I cleared it and went on... I had to run to the store, later on... I was pulling out of the neighborhood and the gas pedal was a lot more "touchy" and the truck, responded to it and it launched pretty good and blew a good amount of black smoke.
Do any of you think this has/or had a tuner on it and I may have activated it with my scanner?
View 6 Replies
