Ford Super Duty (1999-2016) :: Steering Wheel Shakes Back And Forth And Whole Truck Wobbles
Oct 20, 2014
I have a 1999 f350 7.3. I'm having a problem where the steering wheel shakes back and forth and the whole truck wobbles. It happens at all speeds, but shakes faster at faster speeds, slower at slower speeds. At first the wheel was just jerking randomly but then I made a right turn, heard a pop, and then it was shaking like crazy. I jacked up the truck and checked the ball joints, checked for and play in the tie rods, and turned the wheel left and right. Everything seems ok so I can't figure out what is causing to wheel to go back and forth.
View 2 Replies
Advertisement
I have a F250 SD with a 6.0 diesel. My steering wheel is loose. I tested and know for sure is not a problem inside the cabin. Fallow the line thru the linkage to the steering box by the left front wheel. I found an adjustable switch there. Just on top of the steering box. It has a lock nut that must be loosen to adjust what it looks like a hex. Very hard to reach. I have watch some Youtube videos but on different vehicles.
View 1 Replies
I have a 2000 Ford F-250 that I have just replaced the tie rod ends on both wheels. The hole where the tie rod attaches to the right steering knuckle getting wallowed out? When I turn the wheel I can see the tie rod end rocking back and forth.
Now if I keep tightening it down it would pull it down past the cotter pin hole exposing way more threads than any to the other tie rod ends. I've searched everywhere and can't find anything that refers to this problem.
View 6 Replies
So now, what I'm noticing is a bit of a clunk in the steering. It's minor, very minor... but like any problem they usually start that way. The sound is very faint, you can't hear it under the truck, only slightly in the cab but you can feel it in the steering wheel, not so much when driving but when sitting still in a parking spot it's pretty obvious if you rotate the wheel back and forth. You can also feel it in the floor. Sometimes I'll notice this if I hit a bump while I'm driving.
Here's what I know, if you grab the tie rod, either end, you get a slight bit of rotation. Not just one end moving, but the whole thing has a small amount of forward back rotation (I'm not sure if this is normal) I had my girlfriend turn the steering wheel while I checked different components and there didn't seem to be any left right play on the tie rods. The boots look good on the tie rods ends, pic included, looks of similar quality of drivers side.
Then the kicker, here's where I noticed the gobs of grease on the top end drag link, pic also included. This was the last link I looked at, and I guess least expected.
So I guess I'm thinking this drag link is bad, but this is my first stop on the advice train. I wiped off the boot that was covered in grease on the drag link and it looked like its in fine enough condition but I also seriously doubt the shop that added the leveling kit just decided to slob grease all over the outside of this drag link boot. I have my truck oil undercoated before every winter but, that was some bit ago, and this looked more like grease to me.
Truck background: 2012 F250 6.7, I'm at 42,000 miles, 34in tires for most of that, and more recently added a 2 inch leveling kit (40,000 miles) and replaced the suspension all around and added a dual stabilizer. I had some noise coming from the drivers side wheel-well a while back and found that one of the end links on the sway bars was simply loose. Tightened up and all good to go. At 30,000 I got some death wobble. Replaced tires, the stock stabilizer had also gone bad, and had an alignment. Everything good since, but I'm thinking some of these problems now might be remnant of the bad tires.
View 3 Replies
At center, my truck is able to turn 2 1/2 revolutions to the right and only 1 1/4 turns to the left. Making sharp left turns is not possible currently. What needs to be adjusted in order to get the steering centered and even?
View 4 Replies
I replaced the steering gear box in my 06 F250 CCLB 6.8 over the weekend with a reman Cardone. The old gear box had what I can best describe as a chatter/binding if you rocked the wheel back and forth, that's gone now. I sucked out as much fluid as I could, then filled the reservoir several times while the fluid ran out, what came out was very cloudy and gritty, guessing the old box was chewing itself up.
Can't seem to find a straight answer - what fluid SHOULD this have in it?
Sounds like I should have used Mercon, looks like I grabbed Type F instead. Could that cause the steering effort to be extremely light? I mean like ridiculously light, tip of your pinkie barely touching and turning the wheel light?
View 5 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
It's an 04 F350 6.8L This past winter when it was cold I would start it up and it would rock forward and bounce back as is you shifted in to park while rolling. Now that it's warmed up it won't jerk forward but the whole body shakes only at start up. As much as I like the idea of of the raw torque being so powerful the truck twists with power I don't think that's the case.
View 5 Replies
I have a 2004 SD with 5.4 that is running pretty rough both at idle and driving. Truck shakes a lot at lower rpms. I have a scan tool and had a misfire on cylinder 4 so I replaced the coil and the plug. Also replaced the idle air control valve. Plan on replacing O2 B1 S2. (One of my codes) even after replacing the coil and plug I'm still getting misfire detected from cylinder 4??? Other codes I had were misfire detected on he first 1000 revolutions. That hasn't come back though.
View 2 Replies
I purchased a '15 KR cc sb some time back love the truck! It came with a leveling kit and tires were changed to Michelin 35's on stock rims.
The issue is that on certain sections of concrete interstate the truck "bucks" back and forth...a lot.
View 4 Replies
2003 f250 crewcab 6.0 auto 4x4. I all of a sudden started feeling a vibration under the truck near the back when I accelerate and when I let off the gas no other time. No noises or clanking just vibration. I can wiggle the driveshaft inside the carrier bearing do you think that could be it or is it the rear end.
View 14 Replies
Ok truck shut down wouldn't start back. Put fuel filter o. Frame cranks but won't start. Was told has high pressure oil leak in engine?
View 8 Replies
I was towing a 16' Carmate Box trailer (empty), in tow/Haul mode, through the mountains on the PA turnpike. On an uphill section, 70 mph, suddenly blue smoke was pouring out of the back of the truck. I immediately slowed to about 50mph and pulled over at the next opportunity, about a mile. The bottom of the trans pan was coated with fluid, mostly on left side and the exhaust crossover pipe was smoking. Gauges were all normal. Ambient temp was 90F.
I drove another 40 miles, mostly about 60 mph. No problems. When I started climbing in elevation, and hit 70mph again, the smoke started again. I pulled over again and crawled under to fine the crossover pipe in flames. I grabbed a rag and beat out the flames. Fluid was red. Gauges were normal again. Once I disconnected the trailer, I can find no leaks. Snugged pan bolts. I cannot duplicated the problem without the load and speed.
Background: 2005 Crewcab, 5.4, 5R110 trans, 3.73. 416,000 miles, I have towed about 50K miles of that. Trans always ran great. Never replaced.
View 9 Replies
I recently bought a 2001 f-350 xl 4 door with the 8 foot box it has the 5.4L triton v8. I was heading to a job up in northern Alberta about 10 hours away from where I live. On the drive I lost control of the truck on some black ice I was doing about 50 miles I went into the ditch but nothing crazy drove right out after. Now my truck won't do over 30 mph the engine starts to sputter and back fire I loose all my power, what's going on. At idle she revs fine but as soon as I put her into drive it's like she wants to die what can it be?
View 6 Replies
I have owned an 03 Excursion that I have had since last November that has started to feel like the steering is badly broken for a few hundred feet some times and then goes back to normal. It will do it some times after taking a corner and then suddenly there is a 1/4 turn play in the front and its wondering in the lane as I correct it back and forth and then it stops and goes back to normal. I've checked it and it all seems good and tight. The truck is stock height and has stock size wheels....
View 14 Replies
the mechanism that locks the steering wheel is stuck. not the ignition key cylinder (already removed that). how do I release that mechanism to free the steering wheel.
View 3 Replies
Seems that after a sharp right turn, for instance turning right at a stop sign I'll get a loud pop that I can feel in the floor pan under my feet.
After the pop the steering wheel and whole front of the truck will shift left and right like someone is grabbing the wheel, sometimes violently. If I drive slowly it will cure itself and sometimes not do it again for several days. I've check ball joints and hubs and they are in great shape. I pulled the hubs and greased the needle bearings about 6 months ago. I checked all steering components and the linkage that attached to the steering arm had some play so I replaced it. Then I found that some idiot took the steel sleeve out of the bushing in one end of the steering stabilizer. I bought a new stabilizer and cured a pop I'd had since I got the truck, but the other issues were not solved.
Alignment has been checked too.
View 14 Replies
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 Replies
just bought this f250 seems to walk on the road alot, had it looked at has new balljoints, he says everything seems tight except there is lots of play at the gearbox, is it recommended to have it rebuilt or buy a reman, was told that even the reman seems to be the same way
View 14 Replies
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies
06 F250 6.0 CCSB 4x4 163K Truck was in a pass side wreck about three weeks ago. Aside from bumper, head light, etc I had to replace the track bar and then I had the alignment done. Mech said the steering was loose and was either the steering box or column.
PROBLEM: Truck drove and parked fine last night, I went to leave the driveway this morning and I had to turn the wheel full right while backing up. The wheel locked up and wouldn't turn back to the left to straighten out. Hood wouldn't pop either to check anything
I crawled under the truck, the belt was in place and I didn't see any power steering fluid leaking. Thinking it was a PS problem and the hood not opening, I basically floored it and yanked on the wheel and it broke loose. Also, for what ever reason the hood opened after that
Now the steering is heavy and the wheel doesn't center on it's own. It will stay turned when I let go of the wheel. Scared that it would happen I didn't try turning it full lock on the way to work. but it happened again exiting the parking lot, again full right lock and the wheel stuck.
I managed to yank the wheel to the left again and I heard a distinct pop from what I'm sure was the pass side wheel area.
The PS fluid is dark and I'll figure out how to change it. I've read issues from the U-joints, ball joints, Steering box, steering stabilizer, and failing PS pump could all lead to this. Being the truck had a pass side fender bender, and I'm pretty sure the pop sound came from the pass side how do I check all of these items.
View 13 Replies
