Ford Super Duty (1999-2016) :: Transmission Will Not Go Into 3rd Gear When Engine Rev Up And Speed Increases
Sep 5, 2017
2015 F-250 Super Duty, 6.2 L Gas with 6r140 Transmission. I have 13 K miles on my truck. While pulling my travel trailer up a hill the transmission kicks down thru the gears, which is fine, but as I crest the hill and in 2nd gear, the engine begins to rev up and the speed increases, the transmission will not automatically go into3rd gear. I have tried to let up on the gas pedal, but it remains stuck in 2nd gear. I have to shift to "Manual" and then put it in 3rd gear. Then it shifts up as it should. I have tried with the transmission in "TOW' and not in "TOW". I have even tried it in "Cruise Control".
View 3 Replies
Advertisement
I own a 1999 F250 sd 5 speed manual, v10. Looking for some specific details pertaining to swapping to a ZF650 6 speed transmission. Any prior example with this swap?
View 8 Replies
Ok so I went mudding this past week, and I put my 997 7.3 truck in 4x4 had fun then took it out of 4 wheel now it won't shift past 2nd gear top speed 35 mph.... It still has all the power revs up Rpms fine but it won't go faster then that.
View 8 Replies
Truck is slipping in/out of gear in 3rd gear. Shut it off and the problem may not come back for several days, but in general it is getting more frequent. No codes are registering for the transmission. Curious the wisdom of performing a simple fluid/filter change vs taking it to the transmission shop. Fluid basically looks/smells good, and is full.
View 14 Replies
I have a 2012 F-250 ccsb lariat and the shift from 3 to 4 seems to be a bit prolonged as if the converter is slipping and wont go ahead and push it into 4 gear. Also it will want to downshift from 3 to 1 and feels like the car behind nailed you. I have read that the early 2011 had some of this problem and the dealer reflashed the tcm and it did not do much good but as mine being a 2012 mine should have been flashed with the lastest tcm flash from the get go?? Egr fell off and am running Kory Willis tunes through ez lynk so the stealership is probably out of the question. I have also read that changing a couple solenoids( dont remember which ones) will fix the problem.
View 11 Replies
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 Replies
I have a delay when I put my truck into gear. It only happens when I have turned the truck back on. It happens in forward as well as reverse. What is causing this? Syncros?
View 8 Replies
2015 F 250, less then 5k miles. When towing travel trailer, weight 7500lbs, on occasion transmission will not shift out of gear. Happens in first, second, or third. Very intermittent. Take off from a stop engine goes to 6k rpm. Let foot of the throttle goes all the way back to idle, still no shift. Accelerate back up to speed still will not shift. After doing this a couple of times finally shifts. Have had this happen in second and third. Not a lot of fun with cars behind you or trying to merge on highway. No codes
First trip to Ford dealer they re calibrated computer. Still happened towing. Second trip to dealer they put a flight recorder on it and I towed again. Did not hang up in first or second ,but would not shift out of third on highway doing 70mph, even when I lifted from the throttle and coasted. I finally shifted to manual and shifted to fourth and was able to upshift After reading flight recorder mechanic said it appeared normal. I explained that having to shift the transmission manually is not really normal and they agreed.
View 14 Replies
Drove the wife to work this morning. The turn off into town there was a lady stuck so I pulled over in the drifts. After putting in back in gear I had to get on it to get out of the drifts. Snow was blowing over the windshield, and I imagine throughout the engine bay.
After that it felt like it stayed in 2/3rd gear. I'd hit the pedal and it would redline and sort of accelerate jumping in and out of gears. So i slowed down to a stop. Accelerated slow and it was ok but when I got more on the pedal it would feel like it was slipping. Once I got in the driveway, she idled for about 15 mins while I shoveled out my spot. Once putting in gear again I had to rev it up for it to move.
Also reverse, had to rev it up to move it.
View 2 Replies
I recently overhauled a 5r110w torqshift in an 03 F350. The trans is acctually an 06 trans. The original problem was that the truck was "tieing up" on take off. When i tore the trans down i found the Low/Reverse clutches were burned bad and welded together. Everything else looked decent. I replaced all the clutches and checked all the clearances, except the OD clutch because i could not find any specs, or a way to adjust it. The trans has been doing good for around 200 miles. Now it has an intermittent problem.
When you first start the truck its like the converter has to fill up. It has a delayed engagement, but only AFTER you shut the truck off. Also, after driving about 10 miles, sometimes it will feel sluggish. I put my Solus Pro on it and while watching the trans data noticed that the transmission is not downshifting all the way int first gear at times. It will down shift, and then try to take off in 3rd and sometimes 5th gear. I was looking thru my ATSG manual and i can see which clutches turn in for 3rd. It seems like a solenoid is sticking on and allowing fluid to "leak" and keep the wrong clutch turned at the wrong time.
View 12 Replies
When pulling my trailer away from a stop transmission shudders in first gear, feels like t c. Once it changes to 2nd, it clears up. Getting ready to take in for service. Any thoughts? Still under bumper to bumper warrenty. 2008 6.4 auto f 350. 26k miles
View 4 Replies
I recently had a thread going regarding my 1999 F350 2wd auto transmission slipping in/out gear. Tried to follow up on old thread but got confused so I'm trying to start a new one. Basic problem is that truck was slipping in/out of gear. Cleaned the solenoid pack electrical plug (as instructed on previous thread) and the truck didn't act up for 2 weeks. Today it started slipping in/out again and this time it registered a code of P0705.
View 7 Replies
I have a 1999 ford f250 5.4 2 wheel drive i believe its a 4r100 transmission. auto. I have reverse but no forward gears. Ive heard this is a common problem , and on my reverse it has to hit 3000 rpm before it even tries to move and D 1 2 i have nothing only thing i hear is the engine sound changes gets deeper. Do i need a whole new transmission or is this fixable.
View 4 Replies
Will an 05-07 5r110w transmission work in a 2003 truck? Some sites show same part number for each and some show different part numbers. I know the gear ratios are slightly different and that there is some other internal changes made to the 5r110w.
View 2 Replies
I have a 2000 F-550 w/7.3 and a 6 speed ZF transmission. My problem is that when you go to shift into any gear inc. reverse the transmission stays in 5th gear. I pulled the shifter and tried to do it from top of transmission it still stays in 5th. Any thoughts that I could possibly check?
View 1 Replies
I have been having trouble with my 2008 Ford F250 4x4, 6.4 liter diesel transmission. SCT tuner, 10" lift, egg delete and dp delete has been done. I have been losing power mainly in reverse but have noticed that the transmission hasn't always been going into the last gear on the interstate. Code PO741 would come up. The other day the shifter was stuck. So I played with it and found that the cable on the transmission had fallen off. After replacing it. The transmission wouldn't go into reverse but has been doing semi good in forward. Well I have been limping it around until today when I was going down the road and it completely stopped pulling. Now no matter what gear I place it in, it will on go in reverse. What could be causing these issues or where to even begin to start looking?
View 3 Replies
2015 F250 with 6r140 Transmission. I have 13 K miles on my truck. While pulling my Travel trailer up a hill the transmission kicks down thru the gears, which is fine, but as I crest the hill and in 2nd gear, the engine begins to rev up and the speed increases, the transmission will not automatically go into 3rd gear. I have tried to let up on the gas pedal, but it remains stuck in 2nd gear. I have to shift to manual and then put it in 3rd gear. Then it shifts up as it should. I have tried with the transmission in "TOW' and not in "TOW". I have even tried it in "Cruise Control". Ford dealership ran tests but could find no problem. However it was road tested without the trailer.
View 5 Replies
I bought this truck with 60,000 miles and have had about 3 months. I don't drive it very much but when I do I have noticed that when it sets for 4-5 days or longer the transmission makes a weird noise as you take off and does does shift into gear as it does when I use it ever day. The problem goes away very quickly (not even a 1/4 mile driving) and everything is fine after that. By the way I took it to the ford dealer who did a complete 60,000 mile service on it that was suppose to include changing the transmission fluid and filters-could they have screwed something up (I did not notice this issue until after the 60,000 mile service?).
View 7 Replies
I have a 2008 F250 SD 5.4L with 335,000KM's(200,000+miles).
The engine light came on a few weeks ago and I cannot seem to get rid of it. I have also noticed when I'm accelerating hard at higher speeds/RPM's the engine light flashes?? After when I get to the cruising speed and let off the gas pedal the engine light stops flashing and stays solid. Also when accelerating hard there seems to be a hesitation, almost like the engine is choking itself. Once it gets passed the hesitation point during hard accelerating it seems fine? I have ran about 6 bottles of Seafood through the engine and gas tank. It definitely worked out but still has the hesitation, flashing engine light syndrome...I have changed the following with still no luck...
-Spark Plugs
-Coil on Plug
-Fuel Injectors
-Cam Phase sensors
View 5 Replies
I have a tick in my 2001 V10, 190,000 (mostly easy) miles. I've changed oil/filter regularly at 3,000 mile intervals using Valvoline 5W20.
The tick seems to be on the passenger side of the engine, and is loudest when the engine is cold. It follows engine speed. The tick seems to be loudest as the engine transitions from acceleration to deceleration when I lift the throttle--I've NOT seen that posted before.
So, an exhaust manifold leak seems to be the most obvious? I installed a Banks Power Pack with Torque Tube headers in 2009 (about 90,000 miles ago) using thread lock compound on the supplied bolts and torqued to the instructions--I don't' remember the torque setting, but will look it up. I've listened to each exhaust port with a mechanic's stethoscope, all I hear is a smoothly running rotating assembly! Same result with the stethoscope on either side of the front cover (for timing chain slap.) NO tick through the stethoscope! I plan to check all the header bolts' torque this weekend, but don't really expect to find a problem. I will also scoot under the truck and recheck all the exhaust pipe clamps.
I've also listened to all the injectors--two of them (#3 and #4) were noticeably quieter than the other eight. But, none of them stood out as being particularly noisy. I've seen a couple of threads here that asked what a normal injector should sound like, but never an answer. How they should sound?
I've listened to each coil. I can hear a slight arc on #3. I believe the spring in the boot is not seated on the coil tab correctly (happened before.) I will correct that this weekend also. Nothing sounded like a loose plug, though I don't really know what that would sound like with the stethoscope.
What else could/should I check to avoid removing the valve/cam covers? (For cam follower or rocker trouble). I don't mind doing that, but don't want to go to the trouble and then find it wasn't necessary. I may spin on a Motorcraft filter (I'm just 800 miles into the last oil change now, I usually use Fram) but the tick stays with me until the engine is normal operating temperature, so I don't think it is from bleed back.
View 14 Replies
I was pulling my trailer this week with 2 horses in. I was going downhills in 2d gear, to avoid using my breaks too much. When I reached the bottom of the hills, and I was almost at 0mph at the round-abouts, my engine stopped!
This happened twice this week, for the first time ever. Almost like if the exhaust pipes where full of gas, and forced the engine to stop or an electronic issue.
Very dangerous, I lost my assisted steering-Wheel, and my breaks... Need to what may have happened ?
View 1 Replies
