Ford Super Duty (1999-2016) :: Way To Clean Chrome Wheels
Apr 18, 2017
I have the 20 inch chrome wheels on my 2016 Lariat. After this winter there is some buildup if some sort in the wheels that will not come off when I hand wash the truck. From what I understand, these are some sort of plastic covering and not true chrome. So my question is can use a really abrasive material or steel wool to remove heavy grime. I have a feeling it is from salt in the roads. I don't want to ruin my wheels.
View 3 Replies
Advertisement
I have after market chrome wheel and stock brake pads. The brake pad dust is corroding the chrome. Is their a brake pad I can use so it doesn't happen? Ive been told ceramic pads is the way to go.. The wheels are RBPs. Have a new set of RBPs coming in to replace, also what about pad covers? I tow a 29' boat and the rest is highway miles..
View 7 Replies
Winter is around the corner and I would like to remove the chrome covers off of my 04 factory rims, the rims are rusting underneath the covers which is forcing my center caps to pop off randomly. Also I was going to get new winter tires so while they rims are off the tire i figured I would Paint them black to match better than the chrome. How to get them off easily? Also a good paint that wont chip easy when i paint them.
View 6 Replies
So the other weekend I hooked up to my buddys landscaping trailer, everything was fine until I plugged in the harness, No Lights...no big deal cuz it wasn't much of a drive, but I gotta haul a boat tomorrow a little ways and Id like to be legal.
I need cleaning my trailer plugs. What is the best way to clean the terminals on the small 4 prong? The big plug is fine, just a little dirt inside the cover, but I am still going to clean the contacts and put di-electric grease on them.
View 13 Replies
Buddy is fixing his 6.0 2005 F450 with a blown turbo. Diagnosed by the dealer, but decided we could fix it ourselves. The dealer quoted a turbo and to pull the charge air cooler and clean. It looks like the turbo job is not too bad to do, but how big of a job is the R&R of the charge air cooler?
View 9 Replies
I am trying to get an extra set of wheels for my truck before we move back to Alaska to mount my studs on next winter. I have found a few used sets but then realized I have the tire pressure sensors on my truck. If I pick up a set, do I have to get ones with the sensors? Can sensors be added to the tire shop? I just really have no intel on this subject!
View 8 Replies
This is my dads f250 build date of 9/03. I know these wheels are not the factory xl wheels. I also think they changed something with the wheel back spacing somewhere around this time. He is running 285/70/17 bfgs and is rubbing the leaf springs pretty good. He ran this same size on his previous 02 model with no rubbing. Can he get away with 1/4 spacers? What years these wheels are from? And the backspacing differences, if any. His 02 had the chrome large bullet hole style wheels.
View 5 Replies
I just put new rims on my truck which are 18x9 with a -24 offset. I swapped my 35s over from my stock wheels (which they didn't rub at all). When I put my new wheels on, the drivers side rubs really bad but the passenger side doesn't rub at all! I'm extremely confused why this happens. I know negative offset will make the wheel rub weird. But why is it only happening on one side and not the other?
View 10 Replies
To tow a CASE 580L backhoe I believe a 1 ton should be just at its legal limit for towing. My question is do I need DRW's if I've got a gooseneck trailer total weight about 18K lbs (or will single rear wheels be legal)?
View 10 Replies
A few months ago I bought a used 2006 F350 superduty with manual/ auto 4x4. For the last few months I have had an intermittent moaning noise coming from the wheels. It happens when going at slow speeds (under 30mph) I have checked all calipers and made sure none were frozen. Brake pads have at least 75% life in them. I put the truck in neutral to spin all tires by hand and try to replicate the sound.
The front seem to spin easy. The drivers rear will spin but is hard to move and the passenger side I can barely move (I'm assuming it's because it's the drive tire? I believe it has something to do with the rotation of the tire because when driving it moans in intervals. Like it's at a certain point in the rotation something is rubbing. How to troubleshoot further? When going through parking lots it is quite noisy and I can feel the running in my brake pedal.
View 4 Replies
Have a 2008 F-350 crew cab 4x4 lariat with 20" wheels on it. Tire size is very limited/expensive. Can I replace the 20" wheels with 18" or 17"? I was told it depends on the size of the brakes. How do I check that, short of buying "test" wheels? I am old school and would rather have more tire and less rim, than the other way around.
View 14 Replies
1997 Super Duty 7.5 has a horrible "whine" when turning the wheels or hitting the brakes. Weird thing is, when I have the front end jacked up it goes almost completely away when turning the wheels. It is still there, and just as loud when I hit my brakes, but the brakes never were as loud as it was when I turned the wheels. I am guessing it is something to do with the steering gear or tie rod ends or something that I have absolutely 0 experience with....
More info on the problem: PS pump was always a bit noisy, but after the truck sat for a while (around a year, drove it every couple months for a few miles) it was ridiculous, so i replaced the pump, cycled all the old ATF out, made sure I had good pressure coming all the way back to the pump, several times. Never ran it dry.
The steering wheel (with wheels on the ground) kicks back on me and has a LOT of play in it before the PS pump kicks in and starts screaming. Jack the front end up, steering is nice and tight, no play, noise is there a BIT (with the hood up and cap off the PS pump) I would imagine under normal driving conditions i probably wouldn't even hear it much, if at all.
With my very limited mechanic knowledge I would assume that something is making it very hard for my wheels to turn, which is straining my PS pump, but what!?!?!?!?
View 4 Replies
I replaced the power steering pump on my 2000 f250 Power stroke. I bled the lines, and when the wheels are on the ground, I have no steering. When I raise the wheels off the ground, I have no problems turning stop to stop.
View 9 Replies
This is the first winter I'm driving my truck. I put it in in 4x4 HIGH the other night due to the snow (and I wanted to check out everything).
Seemed to work fine until I was backing into a parking spot doing a full lock turn. It didn't seem to move. I gave it a little more throttle and it "released" like it was stuck or going over an obstacle. Happened again when I did a full turn backing into my driveway (this time turning the opposite way).
It seems to work fine going forward with tight turns. Also and it doesn't "bind" in 4x2 mode. I haven't tried 4x4 LOW yet ... I guess I don't want to wreck anything if it's not operating properly. Is this normal?
View 10 Replies
My son has a 2003 Super Duty with auto locks, but the front wheels won't lock even when turn to locked position. Also when it's in two wheel drive the front drive shaft and axles still spin, are the hubs locked up or is it in the transfer case?
View 10 Replies
I have had the truck just under a year. It has 104k on it i only drive it on weekends. Last weekend going to Home Depot about 15 miles got out and could smell brakes burning. Felt the wheels and the right rear was very hot. Got back home no smell but still hot not as hot as earlier. Pulled the wheel off it looks as if the pads and calipers are fairly new paint is still on them caliper is a TRW. The pads were stuck in the carrier even the stainless clip ends look rusted.
Cleaned it all up both sides lubed the pad carrier with pin lube. Pushed the calipers back in some both sides went in easy. The right rotor has definitley been hot. Put it all back together and went for a test drive. Came back no problems checked the temperature with a laser type heat thermometer all wheels were around 140 f. Went out yesterday morning stopped and could smell the brakes again. Drove it back home and the right rear was 300 f. others 150 to 160 f.
Jacked it up put it in neutral and the you can spin the wheels by hand. Started the truck had the wife get in put it in drive wheels turning applied the brakes they stopped let go they turn freely again tried the parking brake it works fine also. So do I buy new calipers and brakes or maybe is the wheel bearing going bad causing the brakes to heat up?ied.
View 5 Replies
Can 2011 F250 factory 18" wheels fit on 2004 F250?
View 3 Replies
I have a 2000 f250 with auto/manual locking hubs and today the 4x4 quit working. The light comes on the dash and the drive shaft and u joints turn but the front wheels don't turn even when its locked in. I assume its the hubs? And when I am going down the highway about 75 the front starts making a hellacious noise but stops if I slow down is this connected?
View 11 Replies
I have a 99, F-350, V-8 &.3 Diesel, 6 speed with 2 WD. Is there a way to temporarily lock both rear wheels to obtain better traction in the snow?
View 7 Replies
I have a 2001 F250 SD V10 and when at a dead stop and with the brakes applied, steering becomes very stiff and almost impossible to turn the wheels. If I let off of the brakes and move a little the steering is just fine. I hate like hell to spend the money on a new power steering pump if it isn't going to fix the problem. Simply put, deap stop, brakes on, wheels don't want to steer. How do I fix it?
View 10 Replies
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
View 2 Replies
