Ford Transmission :: 1987 E350 Does Not Drop To First Gear To Accelerate
Jun 4, 2012
I have a 1987 e350 conversion. Recently the vehicle has been acting up. Once warmed up, the transmission does not drop back into low/1st gear when stopped at a light, when we go to accelerate the vehicle has no power as it tries to accelerate in drive. I have to manually shift into first which the transmission immediately kicks down. When it comes to transmissions I like to have some knowledge before bringing to a shop.
View 2 Replies
Advertisement
Our Rv makes a strange "clank" noise whenever we shift into drive. It is a 87 Ford Econoline 350 with the 460 7.5l. The noise is from the back of the Rv kind of near or in the rear differential. It just started over this past weekend.
We live in Alaska and the mechanics are 3 hours away - do you think we would be able to make it to the mechanics and not have to get a tow? How long we could go without fixing the problem?
View 3 Replies
How the auto gear shift works on a ford E350.Does it work by wires or does it have a steel column to change the gears.I have looked for pictures but with no luck. I have spent 2 hours looking.
View 4 Replies
I am just about committed to purchasing a 1997 Ford E350 extended cargo van with the 5.4. The transmission shifts through all the gears nice and firm (reverse also works). The only issue with the van is the column selector lever is very hard to move between the entire range of PRND21. It also does not "click" into the selected positions, you have to just line up the pointer to the desired gear selection.
Is this a complete deal breaker (internal transmission issue/replacement necessary) or, is it something relatively simple (such as a worn selector cable). The owner did admit the van has been sitting for sometime. It has 134,000 miles on it.
View 10 Replies
This is in an 87 crown vic( 5.0), the shop that rebuilt it is closed today. Before the rebuild, the trans would go from 1st to 2nd and that was it.
After rebuild, trans wont even come out of 1st. new torque converter was also put in. I've spent some time adjusting the TV cable and no matter where i have it adjusted, it doesn't make a difference. I am thinking its internal like stuck governor or shift valve.
View 10 Replies
I have a 1987 ford ranger 4x4 2.9l v6 but my transmission slips out of gear and its auto im not sure why but ive been told im missing a over drive gear is this a possibility or what???
View 1 Replies
I have an 05 corolla XRS. I just had a sport clutch put in about 1 year ago. Whenever I shift into 4th gear and accelerate, the RPMs drop about 500 and I lose power for about 3 seconds before it starts going back up. Other gears are acting normal. Best part is that I let my friend drive the car earlier and since he did it's been doing this.
View 7 Replies
I have a 1997 F-150, 2 wheel drive, 4.6L truck. Recently the transmission got to where it didn't shift properly. Then it got to where, after driving it about 10 to 15 miles the transmission would drop out of gear with the transmission selector in drive.
I have replaced the transmission sensor, the rear end sensor and it still does the same thing. Drive about 10 to 15 miles and, with the transmission selector in drive the truck will not pull. The motor can be rev'ed but the truck won't move just like it was in neutral.
What is wrong. The transmission shifts fine, the truck runs fine, but after 10 to 15 miles the transmission quits working.
View 1 Replies
I searched a lot but did not find these symptoms on my 1992 Aerostar 3.0 2WD with A4LD transmission.
In overdrive, accelerate to down shift, and the transmission goes out of gear. Engine revs as if it was taken out of gear. Manually shift to Drive, and it works fine.
Overdrive works fine if at speed, and works to shift up, but if going slow enough to drop to lower gear, transmission goes out of gear. Manually in drive, works fine.
I may have other symptoms, but this was on the way home from work, and I just parked it. I checked fluid level, and it was fine, still in the cross-hatch area of the stick, light colored oil, no smell.
I will replace the modulator and replace the filter, and see what that will do. If the overdrive works at overdrive speed, I do not see how that could be an overdrive housing failure that I have seen in many posts. I am aware of keeping track of the pin for the modulator.
I also have read that band adjustment is not a good idea. If they are worn that bad, they should be replaced. I don't think it is a band or clutch problem. I think it is a shift control problem. We will start with the modulator and filter and take it from there.
View 4 Replies
I have a 2008 Elantra GLS. I am getting a code of P0750. Seloniod A fault. I have checked wiring harness for critter bites all looks good. If I clear the code the transmission shifts normal until it is shut off like overnight. I also have been noticing that it idles around 1100RPM to 1300RPM and it does drop into gear harder (reverse or drive). This high idle started before the P0750 code.
View 4 Replies
I have done everything I can think of to this car. New; plugs, wires, distributor, battery, fuel pump, fuel filter, relay, and electrical lines to fuel pump. The timing belt is fine. The car has a rough idle and when I am stopped the RPM's drop below normal. Now it won't start. What can I try now?
View 1 Replies
Hot or cold car always starts,Idles perfect , then RPM drops, Idles rough and stalls. Econometer moves to Red area.car will easily restart and drives well,it also idles well. Once engine is shut down, even for a short while, It does the same thing again. Car is used for short trips. Ambient Temperature 80 degrees. Once running car is perfect at all speeds and idles smoothly. Hero 1987 MB 560 sel ....
View 19 Replies
We recently purchased a 1991 Minnie Winnie (Winnebago) which rests on a 1990 Ford E350 chassis. It only has 58k miles. While driving on the freeway or highway, the Overdrive starts to go in and out; downshifting and upshifting willy nilly. It has a manual button for turning off the Overdrive and when I do this, it stops jerking and drives smooth. But, of course, this effects the gas mileage significantly. I took the Minnie to a garage recommended by the company I purchased the Minnie from. They replaced the manual Overdrive switch and replaced the transmission with a rebuilt Ford transmission.
We got it back and it was okay for one trip but by the second trip, it was doing the same thing again. I took it back to the garage and since it was under warranty, they put in a new rebuilt transmission, another new Overdrive switch, a new fuel sensor and checked the wiring but it still had the same problem. So they sent the onboard computer board to Ford who rebuilt it. The guys at the garage thought for sure this would resolve the problem. It didn't. They have exhausted their ideas as to what is causing this problem. We love the Minnie Winnie and other than this problem it is in beautiful condition.
View 19 Replies
Noticed an ATF leak on my van on crossmember/tailpiece mount awhile ago. Not the driveshaft seal but near mount. Checked tightness of bolts on case and mount and found the one mount bolt that goes into transmission case loose- about one whole turn.
(other bolt is on an "ear" of tranny case) Checked again after a couple of weeks and leak is worse, same bolt is loose again.
Is there a gasket or O-ring on this particular bolt? 1998 Ford E-350 with 6.8L - trans code E on door sticker. I believe it is an E4OD as the tranny pan says "Metric" (?) 324,000 miles on this and runs/shifts fine. Occasional vibe issue at highway speeds... I've added 1 quart of ATF over this time period.
View 3 Replies
I just came across a deal on a 93 E350 motorhome for dirt cheap. It has a whine at 50 mph and believe its the rear end. The whine is under throttle not coast.
There is a tag on the axle housing that reads :
4:10 a diamond shape 2US AC
760553
Is this a Dana 60? Looks like a Dana.
View 11 Replies
I have a 1989 tioga 460ford and the trans appears to be slipping when i get around 50mph. The engine revs up but it won't go more than 50. The engine again revs up but there does not feel like the power of the engine is being transferred to the trans. the coach runs fine up until i try to go beyond 50. I have 34000 miles on the rig. Some one suggested that I check the catalytic converter. what else should i look for?
View 2 Replies
Quick question. I have a 1992 Ford E-350 Box Truck and during a recent highway trip the transmission slipped and I lost Drive (3rd). The van drives fine in 1st, 2nd, reverse, and overdrive. When it's in D, it wont move at all from a stop. I'm able to get it in to overdrive by starting in 2nd, accelerating to about 35mph, then shifting it in to D. If I accelerate enough after shifting to D, I can usually get it to shift in to OD. The fluid is full and clean.
View 1 Replies
Started having an issue with my '92 E-350 box truck. I noticed a slight hesitation while driving which I thought was a miss from perhaps a plug wire jumping or something. It didn't do it all the time, just occasionally for a few seconds then would clear up. I looked for a bad wire at night but couldn't find anything so I said hell with it and changed plugs and wires, cap and all.
That didn't fix the problem. Progressively the problem has gotten worse. Then I started hearing a pinging, almost tapping noise as the truck was stumbling. Now I've noticed that the motor seems to be running fine as it does it which has led me to think it may be in the trans.
A little background on the trans. About 6 months ago the van started randomly conking itself out coming to a stop after a few minutes of driving. It seemed the trans was bogging the motor down as if it were locked together. If I put the truck in neutral coming to a stop it wouldn't do it. I went ahead and had my uncles shop flush the trans and he put some sort of synthetic fluid in it.
Since then the van has never done the cutting off thing again. All seemed well. Then this started. It does it from take off through all the gears even in OD. It almost feels as if someone is rapidly hitting the brakes. I thought maybe malfunctioning brakes however soon as I'm not pressing the accelerator it doesn't do it.
Today I had about 4000 lbs of wood in truck and it was a horrible trip. The truck would barely get up to speed. I unloaded the wood and on the way home it only seemed to do it going up hills so it seems any load on the truck makes it happen.
Does it seem I'm in the right area thinking transmission?? Being it happens in every gear would a torque converter seem to be a possibility. When I was having the cutting off problem I was told it sounded like the converter wasn't unlocking but the flush seemed to fix that issue.
I haven't pulled the pan to see if there's any surprises in it and I did the diagnostic check and there wasn't any problems found. Any other manual diagnostic checks?????
View 1 Replies
I have a 94 E350 with a 7.3 diesel. I took it to the Ford dealership to have a new fuel filter and oil change when I got it back the OD light was flashing and transmission shifting hard. They tell me they cannot find a problem could they have possibly knock a wire off of something to make this happen...
View 3 Replies
Looking for your collective expertise
2007 E350 with 5.4L and 4R70W trans. 107K miles and the fluid has probably never been changed ( my mistake - thought it was 100K interval - finding out from my reading that is def not true ). Anyway, following is recent development (last couple days):
Symptom #1: In Park/Neutral there is a whine. As soon as you put it in P or N, the whine 'spins up', stabilizes, and does increase with engine RPM.
Symptom #2: Hesitation (albeit minor) when starting from stop in D and R, with _very_ minor shudder. Sometimes feels like it's struggling a bit to move its own weight just until it's rolling.
Symptom #3: Shudder when accelerating in OD. No shudder when I turn off OD. It does not stop when applying brakes (a test suggested elsewhere). Also, the shudder does not happen when applying gas while braked in D at standstill. Only at highway speeds (enough to be in OD).
This all started at the end of a trip (90 miles or so in 85-90 degrees) when I was pulling a utility trailer (maybe 2000 lbs loaded). Not sure if related, but traction control warning went off a couple times. I think I have a axle seal leak that may be triggering that.
Otherwise shifts fine (no change in shift behavior or smoothness). Things seem to be worse when it has heated up. Should I start with a fluid change? Wasn't sure because there are comments out there saying don't do it or the tranny will just fail faster (I am skeptical).
View 3 Replies
Vehicle: '99 E350, V10
Symptoms: speedometer bouncing, O/D flashing, harsh shifts. Symptoms do not present until the van has been driven at highway speeds for about 20 miles. Then, the speedometer starts to bounce a little. Then, after another 5 - 10 miles, the O/D light starts to flash. Then, with a few more miles, the harsh shifting begins.
Parts replaced: neutral safety switch, rear ABS/speed sensor (twice), instrument cluster.
Each time after I replaced a part, when I drove the van, all was fine until it had been driven at highway speeds for about 20 - 25 miles, regardless of whether the engine was warm or cold. Where to go next with it?
View 4 Replies
