Ford Wiring/Electrical :: 1999 - Wipers Only Works When Off?
Feb 8, 2013
I have a 99 f450 and the wipers work when not on. it's this an electrical issue or a bad wiper motor.
View 2 Replies
Feb 8, 2013
Advertisement
Ford Wiring/Electrical :: Wipers Won't Turn Off
Wipers work in all modes, but won't shut off. I was told there should be a shut off in the wiper motor that's not working. Would I be able to splice in a shut off switch, where is the best place?
View 1 RepliesFord Wiring/Electrical :: 2006 - Wipers Doesn't Shut Off?
I have a 06 f350. Out of the blue my wipers will not shut off without pulling the 30 amp fuse in engine compartment . Even with ignition off.
View 7 RepliesFord Wiring/Electrical :: 2000 - Speedometer Works Over 40 MPH?
I have a 2000 Winnebago RV on a Ford F53 chassis. Recently, I turned the vehicle off and found that the speedometer was stuck at 40. After opening the dash in an attempt to investigate the instrument cluster, it dropped back to 0. However, upon moving the truck again, it jumps back to 40. Once I accelerate up to highway speeds, It begins to work properly above 40. Now it sounds just like every other broken cluster post I've seen, but here's where it becomes different:
When I stop somewhere, and its still at 40, I can flip the dash up and it immediately drops to 0 and stays normal until I move again. It then works until about 10, then shoots up to 40 again, and stays there until I hit 40, at which point it resumes working. Once I get below 40 again, it stays at 40 until I stop and flip the dash up.
I assume there must be a wire crossing that I am pulling apart by lifting the dash. However, there is a mess of wiring down there, and I don't have a clue how to find where it is crossing, assuming that's the problem.
Before the problem was discovered, I made three electrical changes, though I can't imagine why they would affect the speedo.
1. I rewired the trailer plug. I wasn't sure why, but I had no power coming to my running light wire in the towing harness. I couldn't figure out why that wire was dead, so I just tapped one of the tail lights and wired the trailer plug.
2. I replaced my backup camera. The old Sony began to flash, so I just ran the new camera wire under the frame and behind the dash. I wired the monitor to the existing cables that the old one was connected to.
3. The chassis battery somehow died while driving. It was slow to start in the morning when we left, and about seven hours later, I shut the vehicle down at a camping world and when I went to leave, nothing. Somehow the battery was down to 6 volts, which I have never seen before. Long story short, new battery and it started up and has been fine besides that speedometer thing.
Ford Wiring/Electrical :: Right Front Turn Signal Light Works But Hazard Doesn't
1994 Econoline E350. All the other lights work but on the front right the turn signal light flashes but the Hazard lite will not flash. I check for power at the wire at the light and there is none.
View 6 RepliesJeep - Electrical-wiring - Wrangler :: Wipers Don't Always Work / Quit Without Warning
I have a 1999 Jeep Wrangler Sport 4.0L with a kind of serious problem. My wipers dont always work. Sometimes they work fine, sometimes they work fine to start with and then quit without warning, other times the only way to get them to turn on is to turn them on high and then go to the speed that I want to use. It has the intermittent option but I am not yet convinced that that has anything to do with my problem. They will quit working some of the time while using the delay but they also quit on low sometimes. I have been through and checked all of the plugs, and even went as far as to grease them up so I know they are making good connections. I'm at a loss, I would think if it were the motor or the switch it would just go out all together. And if it were a broken wire, wouldn't it come on and go off if I hit a bump in the road? They shut off on smooth roads so bumpy or smooth does not matter.
View 1 RepliesFord Wiring/Electrical :: 1999 F250 - Door Courtesy Light Wiring Diagram
I am trying to add courtesy lights to the existing reflectors in the front doors of my supercab. I can't find a wiring diagram that shows where to connect the light sockets. 1999 F250 SD...
View 2 RepliesElectrical-wiring - Ranger :: 1999 XLT Electrical Power Lost When Turn Key To Start Position
My 1999 Ford Ranger XLT, 6 cylinder, auto trans, with 134K miles has an electric problem. When I turn the key to the 'on' position, all dash lights show normal, headlights work, radio plays, etc. But when I turn the key to the 'start' position, all electric power is lost. The power remains lost until I disconnect and reconnect the battery ground wire. After reconnecting, I again have power until the key is turned to the 'start' position. I was able to jump start the truck, so I assumed I needed a new battery. I bought one a week ago, and was back to normal until today. The truck started, I drove 4 miles to the grocery store, and then I found myself back to square 1 (i.e., the no-start situation).
View 3 RepliesFord Super Duty (1999-2016) :: Electrical Malfunction - Power Windows / Horn / Wipers / Beeper Not Working?
I was driving my truck and my power windows quite working I figured it was a fuse so I wasn't to excited about it I stopped and unloaded some scrap metal and then when I started my truck back up I couldn't shift it out of park unless I unplugged the brake pedal sensor or turned the key just out of the off position then shifted to neutral then started then I could put it in gear and go so I got home and started looking checked all my fuses all good then I realize the windshield wipers are not working either and the door beeper, if you have your keys in the ignition also isn't working the horn, isn't working the lights on the window and lock switches isn't working either so I'm kinda lost now gonna barrow a relay tester in the am but I'm kinda thinking maybe the computer ?? For all this to happen at one to,e doesn't make any sense to me that's a lot to all go in one shot it makes more sense to me
No horn
No power windows
No accessory lights on the window and lock switches
No wipers
No buzzer/beeper (like when you open the door and leave the keys in the ignition
Won't shift out of park without doing it with the engine off or the brake pedal position sensor unplugged
I've gone thru with a test light and got power to the fuses for everything but still nothing
Ford Wiring/Electrical :: 1999 - ABS Light On With A/C Off And Vice Versa?
my 99 f250 sd ABS light comes on and the A/C stops, when the ABS light goes off, A/C comes back on. Any clue as to what is happening?
View 5 RepliesFord Wiring/Electrical :: 1999 F250 - Seats Are Not Heating?
I have a '99 psd f250 crew cab lariat, I just purchased seats from a 2005 F350 that are lariat heated and power. My seats are power but non heated is there a way to hook everything up.
View 3 RepliesFord Wiring/Electrical :: 1999 F150 - Battery Light Came On
I have a 1999 Ford F150 6 cyl. 4.2, 2 WD with 160,000 miles. Replaced the battery May 2010.
Today battery light came on. Battery gauge did not look like it was discharging. Had battery checked they said it was a little low but OK. Then they continued test and tried to check alternator, test stopped and they said something wrong with alternator most likely.
I took alternator out and had it bench tested. They said it was OK, putting out 98 amp on 95 amp alternator. They said check wires, grounds, harness, connections. Checked connections and wires as much as possible, reinstalled alternator, light still on.
Have not checked fuses yet. Was told to start vehicle, disconnect positive battery cable and if engine continued to run alternator was good, if cut off alternator was bad and to replace. Should I try this and is it true?
What is the part on the fire wall that is between the alternator and the battery that the wire connection runs through? Can it be bench tested/checked?
Ford Wiring/Electrical :: 1967 F100 - Instrument Cluster Gauge Wiring
I am a beginner when it comes to anything involving wiring. I am looking to re-wire all of the wiring coming off of the instrument cluster gauges. Once I have completed all of the wiring on the gauges, I may feel confident to move onto something else. As of rite now, it appears as though my truck is still running on all of the original wiring, and over the past few weeks, I have been having many wiring related issues. I found a schematic that includes the wiring for the gauges that I am going to go off of. I have a couple of questions before I begin.
1.) On the schematic, it shows connectors such as "Connector G" which is moving all of the gauges wires to there locations. Do I need to use a specific Ford connector, or could I purchase a new connector at any hardware store that carries them? As far as I am concerned, connectors do the same thing as all other connectors. (Let you connect and disconnect for easy instrument cluster removal.)
2.) I am not looking to purchase one of those expensive wiring harnesses. I would like to just purchase some wire that I can cut / use myself. What brand / type of wire should I be looking to purchase? I do not care if it is striped / colored as I will use wire tabs to name / label each wire.
Other than that, I feel confident enough to attempt something such as this. Here is the wiring schematic I am going to use.....
Ford Wiring/Electrical :: 2002 - Complete Headlight Switch Wiring Diagram?
Any COMPLETE headlight switch wiring diagram? Everything I find online only shows 2-3 wires in each sub connector, nothing with all wires and colors, and what they do. and of course the factory service manuals no longer work on my new computer. the switch and associated wires went up in smoke 2 hours ago, and this truck is my only means of transportation rite now. what i need is headlight wiring with colors so i can temporary hook up a toggle switch to have lights until the new switch and connectors come in next week. I went to pull the switch and connectors out of the parts truck, but of course that does not have fog lights so it uses different switch and connections.
View 14 RepliesFord Wiring/Electrical :: Moving Engine And Ignition System - Wiring Harness For Further Use?
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
Ford Wiring/Electrical :: 1997 F250 - Rear Tail Lights Wiring
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 RepliesFord Wiring/Electrical :: 2004 - Instrument Cluster Wiring Diagram?
Looking for a source for a wiring diagram for the 2003/4 f350 instrument cluster, specifically the wiring/connectors to the gauges? A link to a PDF file would be nice. I would like to try and disconnect the PCM control to the transmission temperature and engine temperature and drive the gauges from my own sensors to bypass the non-linear behavior that ford decided was in our best interest. I am NOT interested in installing any more gauges, just want to control the ones already present with my own signals. It is possible that these gauges are all addressable devices on a common bus, instead of individual controls.
View 8 RepliesFord Wiring/Electrical :: 7 Pin Trailer Wiring - Running Lights Not Working
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 RepliesFord Wiring/Electrical :: 2004 - Installing Seat - Wiring And Functions?
Im installing a set of 04 lariat seats into a 00 truck. I need to know how to hook up the heat. The power part is no problem. What I thought was right which was a separate constant 12v and a switched 12v for the module and ground apparently isnt right. If somebody could ohm out their harness on a 01 truck that would be great. As I have it right now the light on the switch comes on but almost instantly turns off.
View 14 RepliesFord Wiring/Electrical :: 1987 F150 - Wiring Diagram With Carburetor?
Looking for a wiring diagram for a F-150 XLT LARIAT 5.8L 4BBL, all the books I have looked at show the wiring for this year with fuel injection and this truck came with a 351W with a Holley 600 4BBL, I have a few wire's in the engine compartment that melted away all the insulation, they are located close to where the harness passes the firewall before the ignition module. Is this a common problem on old models ?. Need a clear copy of the correct diagram for a f-150 1987 with carburetor, how I can get a copy so I can fix this problem before it gets worse.
View 3 RepliesFord Wiring/Electrical :: Wiring 2008 Seats In 2001 Model?
Let me start by saying electrical is something I really have no knowledge of....(never used any kind of an elec meter and don't have one) simple, Pos-grd and fuse, NP. I really don't want to fry something in these expensive new seats w/my normal trial and mostly ERROR!
The 08 (drivers) seat has 4 wires in the input clip.
GRN-RED (heavy gauge)
BLK-PURP (heavy gauge
BLU-RED
BLK-WHT
and my 01 whip out of the floor has a 3 wire setup.
GRN (heavy gauge)
BLK (heavy gauge)
BRN-BLU
I can wire PS side seat from fuse box and ground it NP. It only has a 2 wire set-up in the new seat.