Gen 2 Prius :: Bumper Lower Lip Loose?
Mar 31, 2015
When I was spray painting my bumper lower lip. Wiggled it loose so I could tape better but it came loose. This is what it looks like after gluing back together. The issue is with the little rubber trim not wanting to stick and looking ugly. Had a few ideas.
1. Replace with factory parts and repaint.
2. Wide pin striping along the line,blue or black.
3. Reflective tape square.
4. Euro fog lights
5. Long LED strip,either red or white
6. New blinker/reflector
7. Putty/bondo the bumper to look like one piece then paint.
View 2 Replies
Advertisement
Just wondering if it's possible to loosen one side of the bumper to remove the passenger side headlight ass'y?
View 1 Replies
2013 Prius IV.... I just noticed that my right side rear bumper cover has a 1/4 inch gap between the bumper and the quarter panel. I think it's from me sitting on the bumper while tying up my shoes or something. When I apply downward pressure on the rear bumper, the gap widens. The left side is tighter, but does gap out when downward pressure is applied. In any case, the gap is annoying.
View 19 Replies
i was looking to get the front lower bumper (fascia) from the SE
i have a 09 LE,
my question was does it just attach clean onto the LE? or do i need a se front bumper.
[URL]
View 3 Replies
The front bumper on my L is a bit loose. It looks like there's suppose to be a clip there that may have broke off. What this part is? I'm assuming I have to take the entire bumper off to fix it?
View 7 Replies
One of my reflectors is cracked in the lower front valence. The part is $30 but labor to replace it is $50-60. How easy it is too do. I am fairly mechanically inclined as long as I don't have the take the bumper off...
View 4 Replies
I got the new ones, (as mentioned in another thread) and they're the same as the old ones. Well, the one that's still in one piece.
I guess I'm missing something very simple, but as easy as it would be to cut the old one out...how do I make room between the lower leaf and the other leaf pack to get it out?
I about hung from the lower leaf and it didn't move quite enough to give the room to remove the bumper.
View 5 Replies
I have a 2012 SE v6 with 1600 miles on it. About a week ago, I noticed my bumper cover pulled away from the corner of the headlight and there was a noticeable gap. I pushed on it, and heard a click. The bumper stayed in place. After a couple days driving, it came loose again. I didnt touch it so the Service Writer would see it first hand. Of course, his first instinct was to puch on it, but I got loud quickly, so he kept his hands to himself, and heard me out. I knew if he clicked it back into place I would be SOL. He admitted something needed to be done, not just click it back.
When I picked it up, he said it was a known issue, and there is a TSB on it. He claimed they replaced a bracket. The invoice reads, "ADDED FELT TO TIGHTEN FIT". Yeah, Im sure that will hold just long enough for them to wash their hands of it.
View 14 Replies
I noticed today when I was washing the car that the rear bumper feels loose to me compared to other cars... If I grab the bottom the bumper, just aft of the rear wheel, there can be significant movements of the bumper, and its the same on both sides... I don't see any loose screws.
Tried it with other model cars, the movement range from very small to nonexistent...not sure if it's just my vehicle or if they are all like this by design(or the lack of). The top of the bumper feels rigid enough. Now I kinda want to know if this looseness is causing my bumper to be flapping in the wind at highway speed...
View 3 Replies
Just got the 2010 and put 100 miles on it and found the front bumper loose on the passenger side. Difficult to see but it looked loose right by the headlight housing, a little pull and it popped up. Looked like the fastener was never there.
View 14 Replies
I just picked up my new 2011 last night. Noticed today it looks like the corner of the rear bumper on the passenger side is not flush with the car and seems loose. Its not to noticeable but when compared with the driver side there is definitely a difference.
View 10 Replies
So I recently bought an '09 Elantra for 52K miles. Car's a beauty except the front bumper cover is loose under the headlight on the driver side(got it that way). The first two pics are from the driver side whereas the third shows it in comparison to the passenger (which is totally fine). The gap seems to be getting bigger ever so slightly. What would be the cheapest and easiest fix?
View 1 Replies
The front of the rear bumper on the driver's side is loose from the main body. The clip on the bumper is ripped from where it tore. I've gone ahead and bought the clips and everything from Lexus near me, but need to know the best epoxy or glue to reconnect the clip area on the bumper so I can apply the clips.
Is the bumper on that spot (the back side of it, not the painted exterior, if that makes sense) fiberglass.
View 6 Replies
I recently discovered that my lower side molding on my front passenger side door was loose while cleaning away some of the salt stains from the winter storm . how to fix it or do I need a replacement.
View 11 Replies
I have a right front lower ball joint very loose and wonder if that ball joint press fits into the lower "A frame". And how is it removed ? What size fork tool needed?
View 8 Replies
After an oil change I noticed my lower engine cover hanging loose in the middle. Much searching has not found the part number. Underbody engine shield fasteners. Any quick reference for these? 2009 Camry 4 cyl XLE.
View 11 Replies
How to remove/install a reflector on the right rear side of the 'lower' rear bumper? I don't see any screws. So, can I pop it out with a screwdriver? Or, is it attached from the inside?
View 2 Replies
Ok. I wanted to pick the minds to make it easier. In the photos the lower steering linkage is loose (bottom bar with ring on the end connected to knuckle) and needs replacement. To fix this is it just a bushing inside? Is it unscrewing the end like replacing a tie rod?
2008 F350 CC DRW
View 6 Replies
How to remove front bumper?
View 1 Replies
I've had my 2010 Gen III for about five months. I play in a folk band and we do a lot of gigs in DC and Northern Virginia. We have to haul a lot of stuff, and my Prius holds it all.
But in just a few months my rear bumper has gotten all scratched up moving stuff in and out of the car. I looked around for something I could cover it with to protect it from scratches. The dealership said they could put a non-skid decal on the flat part, but I wanted something that covered a little more.
View 4 Replies
I want to install a large screen just in front of front bumper with enough height to protect windshield from rocks thrown up on the gravel sections of the road. I can weld a frame (or use a window screen frame), but how to affix it to the front of the car? Are there solid attach points I can use?
View 4 Replies
