Golf/GTI VII :: Clunking Noise While Pulling Away - Suspension?
May 20, 2015
After doing reading I think my issue might be suspension related. Whenever I engage the clutch at a normal rate I get a rubbing/clunking noise coming from the driver side. I can feel it thru the gas pedal and it sounds like a card in a bicycles spokes. If I engage the clutch extremely lightly I don't get the noise at all. This only happened AFTER I had my H&R Sport Springs installed. Could it be a strut mount? Engine Mount? The car only has 4500 miles on it. I'm extremely confused.
View 4 Replies
Advertisement
I am trying to find origin of clunking noise, but it is difficult to do as there is no visual signs and no excessive movements in any components.
Little bit of details and video. Noise occurs when moving rapidly steering wheel on stationary car with running engine. Not noticeable when at speed. Wheel is not vibrating and cv joints not clicking. Very tiny free movement in steering wheel about 1mm, but I am not sure if that is related maybe a completely different issue there. Mot tester make an advisory note that steering system slightly rough, but its not that useful to find an issue.
[URL] ....
View 8 Replies
How to diagnose this creaking/clunking noise in my 03 Jetta TDI. It's only coming from the passenger side, and I primarily notice it at low speed on relatively uneven roads. I can replicate the noise by pushing up and down on the front passenger side corner.
For context, this started after I just recently replaced my front and rear suspension, plus some steering parts. I replace all four struts with Koni yellows, front CA bushings (with R32/TT), ball joints, tie rod ends, front strut bushings and bearings, and passenger side CV axle. In response to the noise, I also just did the front sway bar bushings, which definitely needed it, but didn't change the noise. I also removed the CV axle and re-greased the inner CV joint--to no avail.
Also, when I have the hood open and push up and down on the front of the car, I can see the cup where the top strut nut goes into will go up and down separate and apart from the body. The driver's side stays in line with the body when I try to the same on that side. Also, that cup is tight on the passenger side, whereas it will spin fairly freely on the drivers side. So, this has lead me to think that perhaps I didn't torque either or both of the top or inner strut nuts on the passenger side.
Here's a (fairly crappy) video of the noise/strut cup .....
View 2 Replies
I had to raise the car a bit to clear the apr turbo outlet pipe. Raised a little too much and was hearing a clunking sound pulling into my driveway or speedbumps, etc. Contacted HR and they said the coilovers have an operating range and to lower them a bit. So.. i have about 3/8" of thread left on both fronts and my (not so scientific measuring method) fender/ground is 24" vs 26.25 stock as measured on a stock gti on my dealer lot. I still have a ton of thread to drop the car (about 1.5") as seen in the picture below. The issue i have is what the spring looks like. It rides fine in my day to day commute so its not noticeable but looking at it, it looks collapsed??
View 13 Replies
Aside from the clutch and gear changing noise, recently I've been noticing something that sounds almost like a rattle when going over bumps, say a series of filled potholes on a highway where they just slightly bump to move your wheel around, it's not that deep thumping you would expect to hear but it sounds like something is loose in terms of the suspension.
Happens on the front and seems like its coming from both sides. To me it sort of sounds like they forgot to tighten something up when they removed the shipping "blocks"/spacers, but I am not exactly sure what to check. I really do not want to visit the dealership at only 600 miles on the clock ...
View 5 Replies
So I got a steering problem and it's got me going crazy. I have a 06 g35 sedan lowered about an 1.5 inches. It's been about 5 months since I lowered it, lately I've been herring clunking noise in front suspension, not all the time but only sometimes when I turn. The other day my steering got really stiff and when I turn the steering won't return to the center. My Power steering isn't making any noise and I'm good on fluid. A lot of people say my ball joints but don't they usually make a lot of noise when they go bad ?
View 18 Replies
So a few months ago I started hearing some clunking under the vehicle so I got under there and sure enough the control arm bushings were shot. Took it in to Lexus for service and had them look while at it to confirm that is indeed the issue. After replacing all 8 of the front end control arms and 2 of the ball joints the clunking is still there. Seems to only do it while turning. Regardless whether giving it gas or braking.
What it might be? Its fairly loud and definitely coming from the front suspension (I can feel it through the steering). The control arms are brand new. The ball joints are brand new. Just checked the tie rods and they're are in good shape. What else should I check for?
View 2 Replies
My 2002 Passat Wagon (2.8L, FWD) has started developing a clunking noise at 67,000 miles in the front right suspension. Based on forum search here, it sounds like a common problem with the control rods, tie rod ends, ...
I looked at the control arm kits available at ECS Tuning. Is this a DIY job for someone with only moderate mechanical skills? I have never performed front end suspension work before. How difficult is it? Special tools needed?
If I had it done (both sides, upper and lower) at an independent repair shop, how much might I expect to pay?
Lastly, is it best to replace all the parts (as provided in these kits), rather than isolating the part that is currently causing the clunk and just replacing what needs to be replaced?
View 14 Replies
I have a clunking noise from the right front suspension when going over bumps. I've replaced the Strut bushings that were collapsed, the control arm bushings that had play and the noise is still there. There is no play in the links. There is a slight noise in the sway bar bushings when struck with a rubber mallet. I hate to keep replacing parts chasing down this noise.
View 9 Replies
I have noticed since I got the car( 6 months ago), when ever I have passengers in the back seats i hear a clunking noise coming from the right rear suspension area.
( I don't know if this is from the suspension or not and I only notice this noise when there are passengers in the back). The clunking noise is really annoying.
View 3 Replies
I have been frustrated with my Elantra's handling from the time I purchased. I feel that the car is setup poorly and has design/OEM part issues.
I have improved the rear-end "hop" issue by replacing the OEM rear shocks with the KYB Gas-A-Just's -- a big improvement in handling the bumps. But the rear-end solid axle on such a light car is just crap...
I have developed quite a bit of 'clunking' noise in the front suspension.
I am considering replacing the front-end shock-strut assemblies with KYBs -- I'd love to hear if it made a big difference. Also wondering if I should change-out the 'sway bar link' while replacing the shock/struts.
I'm just so frustrated with the way this car handles (I've driven Subaru's, Honda's, and VW's) compared to other cars. I feel it's a combination of low-quality OEM suspension parts, rear solid axle, light weight, crappy electric steering settings, and tires that are too wide and too low-profile for such a light car. (I have the limited with 17 wheels).
View 2 Replies
Installed fk coils about 5k miles ago. I replaced the strut mounts and the bearing with new oem. I am not "slammed" by any means but a very mild drop. I noticed the strut caps are raised a little under load, can this be the cause of the clunking sound? The strut cap going down on bumps etc? Or could the strut mounts have already failed. Seems a bit premature to me. I guess I'll have to take it apart and take a peek.
View 2 Replies
I have a 2005 NF V6 Sonata Elite - for some time now there has been a sporadic clunking noise in and around the suspension or front drivers side wheel of my car. It got a lot worse a week ago when I took the car off sealed roads for a short distance, almost sounding like a CV that had gone. However a mechanic checked the car over a few days ago and found the CV was fine, as was the driveline. It seems to clunk more when turning, and when I put the power on or off. I also detect a slight vibration or hum coming from the area concerned when taking gentle bends at moderate speed on smooth roads. I can assume the wheel bearings are fine, although the mechanic I went to perhaps isn't very familiar with the make/model of car. They went around the suspension and tightened some of the struts, which made a small improvement I think, but the car is still making the noise. What was the cause of the noise if known?
View 4 Replies
Noticed this rear suspension noise on their RX330's. Every time I go up a slanted driveway (driving into a driveway at an angle, not head on), there is a clunking noise coming from the right rear of the car. The sounds it makes is almost as if I the spare tire is lose hitting on the right side of the car. This only happens if I am driving into a driveway coming from the right side, the sounds does not happen if I am entering my driveway from the left side.
View 1 Replies
I have a noise in the front end that is only happening during suspension travel. It is really bad on bumpy roads. I thought it was my sway-bar end links but they are a year old and tight. I have checked the shocks and they are tight. It sounds like a clunking noise. Could the front drive axles be making this noise while not locked in?
View 14 Replies
I have a 2009 Escape that has developed a clunking noise in the right rear. On any bumpy roads it sounds like the shock tower lost it's top bushing but it could also be coming from somewhere lower. It also seems like the truck drifts to the right on bumpy left hand turns, kind of scary.
View 1 Replies
I recently got an MK7, coming from a MK5, and I installed the VWR springs 8 days ago. Since then I've noticed an intermittent clunking sound coming from the rear suspension. I installed springs on my MKV without any issues and again on several other cars, soIi'm familiar with the process. Everything was torqued to spec after the install.
My best description of the sound would be a clunk, not any rattling, clicking, or squealing. The sound is greater in the passenger side rear than the drivers side rear. No issues with anything up front. Sometimes it occurs when I'm turning the steering wheel while backing out of parking spots and driving slowly, other times when I hit bumps in the road, but it is not constant nor does it seem dependent on the size of the bump/pot holes in the road.
What may be causing this? My plan was to give it a week for everything to settle before I tore everything apart to look for any culprit.
View 1 Replies
We have a 1999 Passat GLX 2.8 auto. I recently put on a new inner and outer tie rod as well as a lower forward control arm. The issue that we are experiencing is that when accelerating or braking hard there is a popping/clunking noise coming from the driver front area. When accelerating or braking normally/ smoothly it is fine. But, as I said accelerate or brake hard it will make a single pop or clunk and that is it, just once when braking hard or accelerating quickly.
View 2 Replies
I just purchased my first VW, a 2012 Tiguan SE in Night Blue Metallic. The level of fit and finish, handling, and general feel are miles ahead of my old '04 Jeep Liberty.
Anyway, I've had the car for about 250 miles and have noticed a clunking/rattling noise coming from what sounds like the front passenger side suspension arm. The noise is fairly quiet but seems to consistently happen when turning left over uneven pavement.
I plan on taking it to the dealer this weekend and it is only a minor annoyance, but a shame since the rest of the vehicle is so quiet and refined.
View 3 Replies
I have 2012 sentra with CVT transmission & 60,000 miles. I just got 60,000 miles service done. Service adviser called me to let me know that I need to have replaced upper strut bearing on the front (left & right) replaced because they are making clunking noise when turn wheels or parking. When I asked for the reason why they should go bed he told me that it's normal, some sand other debris could clog there or water could have damaged it.
View 4 Replies
2012 truck, started making a noise today. I cannot tell what it is, but seems to be coming from the passenger front suspension, its a crunching/light clunking sound, happens when going over bumps, when the truck pitches one way or the other turning, and coming to a stop....
Truck has 6k miles, I did a quick visual inspection this afternoon, didn't notice much, but the sway bar endlink looked a bit odd though, not sure if normal, its gota little bend too it and seems to just contact the vac line mounted behind it, seemed unusual...
Maybe its its just one of the crappy rancho branded shocks is junk?
View 6 Replies
