I've ignored it long enough and dont remember if it was like this when I bought it from the second owner...guess I had too much fun during the test drive. Any ways would it be an alignment issue up front or what?
View 8 RepliesTook delivery of car and alignment is way off. Steering wheel is turned left when car is straight. The dealership is trying to charger me for a alignment. Car has 2500 miles on it and came from factory this way.
View 8 RepliesI have a 1992 Olds Cutlass Ciera S. Just fixed it running with a tuneup, but now I noticed that when I turn the steering wheel slightly left at all, I get a sort of small roar and it may just be me but the car seems tense. It feels and sounds like a bad power steering pump, but it turns right fine, no noise or anything. I do not think it's a wheel bearing. Could this car have rack and pinion steering and that is going bad?
View 1 RepliesMy car has a little bit of a shimmy between 65 and 80, can feel it more when changing lanes slowly, after 80 slows down to almost nothing and by 100 is gone. Road force and high speed balanced, new set of tires (Mich. PS2) still does it. One more detail, the steering wheels is slightly tilted to the left when driving straight, anything to do with this? I'm suspecting the rotors too, but I only have 3,400 miles on my car.
View 8 RepliesIs there any quick fix for this? My steering wheel is slightly turned when the wheels are pointing straight. I thought a wheel alignment would fix this, but it didn't.
View 3 RepliesI had a friend do an alignment on my truck yesterday. Afterward, we tried to center the wheel the best we could in the shop. But when I drove it home I noticed that when going straight, the steering wheel is ever-so-slightly turned to the right. Is there and easy way to adjust this without me going back to the guys' shop and bugging him again? I know the alignment is dead nuts, but the wheel is just a tad off.
View 4 Repliesjust had 2 turbos replaced on v10. 4 wheel alignment checked twice. car pulls to left. Steering wheel is also not straight. have to put slight pressure down on right side of steering wheel to stop veering to left.
View 17 RepliesThe leather on my steering wheel was peeling off and I brought it up to the dealer and out of their goodwill, they decided to replace it with a completely new one. Props to the dealer. However this is where all the problems start to occur. I drop off the car This past Sunday and pick up a loaner. I get a call the next day saying my car is ready. So I get there and everything seems good.
There's an open road that I like to take home but this is where I noticed something weird. When my steering wheel was level, the car was veering right.. I had to tilt the steering wheel a little left to go straight . I call the dealership right away and they tell me to bring it back. So I do that and pick up another loaner.
Following day , I go back to the dealership and they tell me they fixed the alignment. Now everything is good! I was yet again wrong. When I got home, I noticed my steering wheel was weird.
So taking the car back tomorrow to get this fixed! Still props to the dealer for giving me a brand new steering wheel..
I have a new 2 week old Prius 4. So far I love it. I've put about 600 miles on it. This past weekend I spent a decent amount of time on the freeway and noticed an issue with my steering. I'm pretty sure it is an alignment issue.
The car tracks straight. When I let go of the wheel the car goes dead straight but...the steering wheel is a bit off center turn slightly to the left. If I hold the wheel and turn the steering wheel right to exactly straight the car will go right. It's like they they aligned the car with the steering wheel slightly off center.
I'm getting this weird sound when i turn on my car and turn the steering wheel left and right not even a full lock just left and right really quickly or slow there is this annoying clunking coming form both of the front wheels atleast thats what i think it is and it feels as something is loose but i checked most of the bolts.. Recently i changed my front wheel bearings inner cv and outer cv joints on both front wheels.. i changed my ball joints and tie rods everything was change within a 4-5months..
Also the other day as i was driving and i could only hear this 20mph and up this weird clunking and vibration in the floor.. no vibration in the steering wheel just the floor and clunking sound.. i know for a fact i need an alignment and possibly new tires.. but what would the clunking be coming form when driving or just parked in place while moving the steering wheel...
So, I put my RCs with Eagle F1 DSG3s back on and now I have noise. I thought there was some rubbing, so I spaced them out tonight, but the noise is still there. I thought it could be my alignment, so I got an alignment, still noise.
It happens when I'm going straight and when I turn left, but not at all when I turn right, things get quiet. It sounds like a a rubber rubbing noise but i took the wheel off and I couldn't see any wear... Could it just be tire noise??
Only had this car for about a month and 1200 trouble free miles. Really in great shape but with 276K miles on it. Really runs great and feels like a new car inside and out.
Yesterday, a cool morning, 38 deg.. Started at the Ready, backing out of my car port and cut the wheel partially to turn 90 deg. to enter the street. Came to full stop and shift lever is still in Rev, before I could shift to Drive. The steering wheel shutters like I was going over a rough. Jerking slightly from left to right about 2-3 degrees. Stopped within about a second and I still had normal steering response. I continued onto the street and made a ran a 300 mile round trip on freeway and surface streets without any further problems.
I know the power steering is electric assist over mechanical linkage and can only imagine that there was a power glitch in the power convertor and I was feeling pulses from the feed back in the power steering drive. No hydraulics to blame, I don't think.
I just picked up a 2005 SC LB 4x4 5.4 v8 6mt F-350 yesterday and drove it about 250 miles home. It is my first Super Duty, and I love it so far but... the steering has some issues. There seems to be decent amount of play in the steering wheel when I'm driving straight. Also, the truck drives straight when the steering wheel is turned about 30 degrees to the left, and I would like to fix that and bring it to center. When I was cruising on the highway (65-70 mph), there was also two 20 minute periods of time spaced an hour apart where the steering would get light and the truck would dart to the left (i do not think road conditions were a factor as it did not happen on the worst stretches of highway. The truck has 133,000 miles on it, and has had pretty routines maintenance done on it, as it was owned by a drilling business as a work truck to haul tools. The guy I bought it from said that it needed the steering shock/damper replaced, so I will do that, but what else to you think I need to do to the truck?
View 2 RepliesRuns into a problem with steering wheel not wanting to return back to straight after a turn...spray wd40 on u joints on steering shaft ( under hood)....
View 2 RepliesOn my way to work this morning guy pulled a left turn from a side street while I was in the rightmost lane. He pulled wide and forced me off the road. In dogging him, I hit the curb, went up on both wheels. Did not catch his plate (I go to work at 5AM, it was very dark and I was distracted because my car would not drive straight). I noticed I had to turn my wheel 35 degrees to the left to keep the car going straight.
All said, they are at 2k already on the estimate to replace most of my front right suspension and wheel. Probably going to replace the back one too. They have not even taken the thing apart yet. The only good news is my deductible is only 500 bucks and there was no cosmetic damage.
My 2005 RX330 has 140,000 kms...and I am now witnessing frequent periods of hard steering. I even sometimes find that after I turn a corner, the steering wheel doesn't return back to straight as I move through the turn - I have to forcefully return the steering back to straight steering. There is plenty of power steering fluid, and there are no abnormal whining noises from the power steering assembly. And since the ease of power steering does still work...I suspect that a ball joint needs looked at.
View 14 RepliesMy brakes were terrible and finally got roders and pads for front yesterday ... well the pad on passenger side was like not there anymore almost metal on metal and driver side was not close to being that bad but like driving down road there was a slight hi pitch tick that only occured when steering wheel was slightly tilted left (counter clockwise).
We redid front pads and roders (did bad not to long ago) and now there a terrible rubbing sound and it only occurs when again wheel tilted left or making a left hand turn cant figure it out thought it was the wire clip to hold caliper in place but that's clearing rim .... it sounds like metal on metal and driving me nut was driving last night and after awhile it did go away but i have feeling it going to happen again when i drive it today ...
I have a '07 RX350. My steering wheel recently started having a squeaking noise when you turn it right, or left. This has nothing to do with the motor to extend or retract. You can hear the noise when you turn it ever so slightly back and forth (whether car is running, or not). I have seen other threads that talk about a grommet needing greese between the steering wheel and column, but not enough detail for me to determine what they mean. Also, if that's the case, I am not sure how you get to tha area?
View 4 RepliesA while back as I was driving, I heard some sort of clunk, and the steering wheel locked and would not turn left. It then unlocked after a few seconds. Ever since then, it has been very hard to turn to the left (and right, at slow speeds and on sharp turns, but much easier than turning left). This happened a few days after I replaced both front end struts and inner tie rod ends, and got an alignment - they were cheap quick struts (entire assembly), but seem to be of fairly good quality.
Initially after some consultation I thought it was the power steering pump, so I replaced that. It became easier to turn right, but still very hard to turn left. I took the front end off the ground and turned the wheel all the way left and right, no problem or resistance. I am nearly certain it is not the pump.
At this point, I am fairly certain it is either the steering gear or some part of the rack and pinion. I am planning on getting the assembly replaced. The fastest and cheapest way is apparently to just buy the entire steering gear/r&p assembly. Would bad strut mounts ever cause an issue like this? Any other possibilities besides the steering linkage?
Having issues with Gen3 Prius steering column? I suddenly developed this clunking noise when I rock my steering wheel from left to right. It's steering correctly but I've never heard this noise before....
View 7 RepliesLately my 2007 Camry (2.4 L, Auto) has developed a bit strange problem. When I'm driving on highway, even slight left turn results in a grinding noise and sort of resistant steering wheel. It happens only when I turn left. As soon as steering wheel gets back to straight, the noise and steering wheel resistance/hardness goes away. I don't really feel much when I'm driving slow on the city streets. Although some time when I am little bit fast, I feel slight grinding noise and steering hardness. No problem in turning right at all.
View 5 Replies