Golf IV R32 :: Transmission Noise / Louder Whine In Lower Gears And Slight Knock At Idle
Jan 18, 2011
My friend has tortured my R32 which he was supposed to buy. I had the motor replaced while i was gone as he blew it , again , dumb. I have been driving it and it has a terrible whine in the tranny I brought it to my mechanic and we took a sample to find metal shaving in my tranny.
He says the tranny is gone but I am lost on how it shifts perfect except the whine. It does this louder in the lower gears and has a slight knock at idle and disappears when I press the clutch in.
I bought a used tranny already to put in. I also if this is the case and the tranny needs replacing I was told to also do the clutch , should I go stock to save money or go with a different clutch and possibly a LW Flywheel , is it really a drastic power difference?
View 9 Replies
Advertisement
New to the R, and recently the transmission seems to be making some noise throughout lower gears at low speeds, when the clutch is engaged the noise goes away, I figured it was the throwout bearing, but now my transmission now refuses to let me into 2nd gear and also reverse.
I changed the transmission fluid hoping it would eliminate the noise a bit, and saw very small metal shavings in the old fluid. I'm now worried I have a serious transmission issue... Are these signs of major transmission issues or should I be checking linkage? Any common transmission problems with the R I might be experiencing?
View 3 Replies
The video below IS NOT my truck, though my truck makes the same sound. Mine isn't nearly as loud as the truck in the video at idle, but gets much louder when under load at about 1700-1900 rpm. If you take it easy accelerating it doesn't get any louder than at idle. At cruising speed in third it isn't audible. The trans in my truck is a 1979 C6. Again, not my video. Same noise though.
Transmission whine - YouTube....
View 2 Replies
I have a 2002 Accent with a manual transmission with just over 100K. It has for some time had a low whine, which is getting worse. Not wheel bearings. The whine increases with speed, and seems a little louder when decelerating. Makes the sound in every gear and when in neutral (coasting at speed). Brought it into a mechanic and he thought bearings in the transmission (though I don't know why it would make the same sound when in neutral . . .). Shifts through all of the gears fine, no other odd sounds. Can't find any information out there that sounds like my situation.
View 4 Replies
(2000 F-350, 7.3L, 205k miles) Over this weekend, I noticed while driving mostly in the lower gears, that there was a slight hesitation with the throttle pedal depressed about half way or less. Seem to get worse as the day went by, but no lights or anything came on. Changed the fuel filter and added a fuel injection cleaner to the tank. Checked the oil and it was low, so I filled it to the correct amount.
Drove it around the next day, and it seemed to be good, until it warmed up some, and continued to hesitate. The hesitation seems as if it's not getting constant fuel, and the truck jerks a little. Once you get up to over 2000 rpms, it goes away. Looking up other reviews on similar issues, most have pointed to the throttle pedal sensor and just changed out the pedal assembly. Before I take it that far, I wanted to see what was the corrective action.
View 3 Replies
I have a 2001 GMC Sonoma Highrider Edition it has the 4.3 Vortex and its 4x4 my transmission has been whining slightly it has 169,000 miles on it runs and shifts great it when's when ever its in park and whens threw 1st gear from what I can tell but it doesn't whine in Reverse from what I can tell. This is my first truck and I love it so far and Id hate for the transmission.
View 2 Replies
Lately I have noticed (when driving with my windows down) that there is a very distinct "whine" coming from the transmission area when accelerating through the low gears. Best I can describe it as is a quieter version of the sound a car makes in reverse. I can't hear it with the window is up, only when the drivers side is down. The car drives normal, and I haven't noticed an issues except I can hear this noise in the low gears. Has it always been there, it's normal and I am just "tuned into it" now, or is it a sign of problems to come?
View 14 Replies
Lately I have noticed that the transmission is not shifting smoothly in the lower gears. I have 114K on there. Spoke to my service manager and he mentioned that it may need calibration. Doesn't sound right after all the miles?
View 5 Replies
I have a 2012 Sierra 1500 SLE with a 5.3 liter engine, 6 speed transmission and about 7700 miles. I have noticed that at times the truck does not seem to be performing efficiently and will not seem as smooth and transmission shifting is sometimes not so smooth in the lower gears. I have noticed that when I let the truck warm up for about a minute before putting it in gear, that all seems to go much more smoothly, but if I crank up cold and take off right away, then it tends to run not as smooth. I have even heard a slight "slap" type noise that I think is the transmission shifting when slowing down to make a turn at about 15-20 MPH. When I go to accelerate after the turn, it will sometimes slap as if it is hunting for the right gear. Obviously, I now let it warm up for a minute before I drive it. I have not talked to the dealer, but I probably will when I take it in for its 10K checkup.
View 1 Replies
2015 Outlook 2.5 CVT - Regardless of engine temp/or oil temp, transmission will stay in low gears (relative - its a CVT) such that the car is always doing approx. 2100 RPMs. When it occurs, 35mph is 2100 RPMs; when problem is not present, same speed would be approx 1200 RPMs. Same for higher speed. 45mph would be 2100 verses approx 1400rpm. Gear indicator does indicate a '4' or '5' when it would normally be '6'.
Outside temps in excess of 30 degress - no evidence of problem. Below 30, may or may not happen. No check engine light and it does affect MPG significantly.
View 7 Replies
This is an early 99 f250 powerstroke 6spd manual 4wd, is it common or normal to hear a lot of transmission rattle at low rpm especially in lower gears under a load. Starting off from a dead stop it sounds awful until about 1500 rpm where it clears up (or load is reduced). I'm hoping it's just the power pulses going through splined shafts, gears, etc.
210k on the truck, just changed every fluid in it.
I've been a honda owner and mechanic for all of my driving years where shifting at 8500 rpm is common and now I'm having a hard time learning what this thing likes, rpm ranges to avoid, ect; even shifting I find difficult. At least you can heel toe with the pedal arrangement...
View 1 Replies
Have a 2006 Sonata GLS with a 2.4 mileage has rolled over 207k .... I started hearing a slight ticking noise from the top of my engine and it has slowly gotten louder, now it can be heard inside the vehicle and more so when revving the engine...it also has 2 stored codes P0011 and P0456, I'm not too concerned with the evap code at the moment, I have decided to replace the oil control valve and clean or replace the lash adjusters...here is my problem, I have mechanic experience but only on Honda, all the youtube videos I have found for valve lash adjustment or replacement are for Mitsubishi and chevy engines, so I am not sure what the adjusters actually look like on this engine and if I can even do them without removing the timing chain.
View 14 Replies
I bought the car about a week ago, whenever the auto tranny shifts gears there is a slight jerk that old honda autos are known for, my wife's car is a 01 celica gt which I bought 2 months ago and went through castrol import ATF 3x drain n refill method suggested by honda for their auto trany, I attempted the same thing in the gts and the shift jerk went down a little but not by much, the gt auto tranny is so smooth I can't even tell whenever it shifts up or down other then high rpm engine noise when it gets there. Is it the engine being much more powerful then the gt to cause that jerk? Should I try a different fluid? Need to know if theirs is smooth across all gears in any rpm range.
View 4 Replies
I get a whine when I'm driving hard under low speeds and accelerating (only when really aggressive). Is this cause for concern? Haldex whine I'm assuming?
View 3 Replies
So today i got my first check engine in the .:R. I was merging onto the freeway and i shifted into third rather enthusiastically (didn't redline in 2nd but i was probably at 6k rpm) and put it into 3rd gave it the gas and the tires squealed and I got the traction control light. Has me a little worried since the traction control light didn't go off afterwards. Got off the freeway and pulled into a parking lot and turned it off for a minute and when i started back up I got the check engine light also. Went to schmucks and pulled the codes and the only code I was able to pull up was P0102 MAF circuit low. I highly doubt my traction control light has anything to do with the MAF circuit. I notice when in 1st and 2nd gear (can't really tell about beyond 2nd because there is too much road noise) there is a slight whine. I cleared the codes and the check engine came back but the traction control light never went off.
View 9 Replies
Braking down a hill and a sharp turn (in either direction) around 10mph results in a slight knock (1, not multiple). Is it normal? I have some suspension goodies to put on but i don't want to do that before getting any repairs done if necessary...
View 5 Replies
I have an 03 wolfsburg and sometimes when i have the heat on ill hear this weird noise coming from the vent, i turn the heat off and wait a bit and turn it on and its gone. its very random, what might this be?
View 1 Replies
I got my car in November and I just did a scan and got this code. I don't have a CEL on. I do feel a slight vibration from time to time. It's very light.
Should I clear all DTCs and then run a scan a couple of days later to see what codes I truly have? Or should I address this code?
If yes, what should I do about this code? Do I need to buy a new knock sensor or should I check the wiring first with a voltmeter?
View 15 Replies
Took delivery of my 2015 GTI a few weeks ago. Overall the car is great, but I have a feeling the tires that came with it just plain suck. They are Pirelli P7 Cinturato A/S. According to Tire Rack, these are grand touring tires?! Not exactly what I'd expect to be put on a GTI. Anyway, I've noticed that at almost exactly between 60mph-70mph there is a "whine" sound coming from them, also just the slightest vibration in the steering wheel. At every other speed they are relatively quiet and the wheel is absolutely dead solid, no vibration. Could these tires just be of relatively poor quality? Should I have them put on a balancing machine to see if everything checks out? I'm assuming these were balanced on a Road Force machine at the factory since that is the OEM for VW/Audi, but I'm not 100% sure obviously.
View 16 Replies
I have a 2001 f 350 7.3 diesel r 400 tranny 320000 miles. . Im having transmission issues. It makes a slight whine/ grinding noise only in first And reverse. And it surges. Sometimes its fine though to. Check engine light came on. Only codes i get are #4 glow plug out and a low boost pressure. Checked boost before fixin Running fine at the normal about 20 psi. ive read a bad or dirty map or iat sensor can cause transmission issues along with the low boost error code. But in my experience and some reading it sounds like a stall converter.
View 9 Replies
3.5 has engine knock coming from oil pan, gets louder when engine fully warmed up. Suspect connecting rod bearings. 99 Intrigue has 203K on it and otherwise in excellant condition. Is it possible to replace connecting rod bearings with engine in car. What is involved in removing lower crankcase after oil pan is removed. Car has been trouble free so far and would like to get another 60K out of it
View 5 Replies
