Is there any way I can raise or lower the temperature without turning on the fan speed? For example if I want to raise the temperature from 68 to 72, I literally have to hit the "Lo" speed and then raise the temp.
View 1 RepliesI changed the mass air flow sensor. And ordered a throttle position sensor I have check engine light with code p1505. This only started when I had the muffler pipe fixed and had a patch put on a leak now idle jumps up&down.
BMW ICOM A2 Wifi solution comes with Dell E6420 laptop, software preinstalled ready to work, software version will be 09/2014. ISTA/P Expert mode for single module programming is added in this order for Free.
- See more at: BMW ICOM A2 Wifi with Dell E6420 Laptop V2015.03
I changed the mass air flow sensor. And ordered a throttle position sensor I have check engine light with code p1505. This only started when I had the muffler pipe fixed and Porsche Piwis Tester II a patch put on a leak now idle jumps up&down.
View 1 RepliesI have a 2001 ford ranger xlt 2.3L and the temperature gauge has been staying a cold. And my heat doesnt heat well. I'm guessing I need to replace the thermostat. Before I do that could it be anything else?
View 9 RepliesIs it possible to slightly raise the Idle speed of our R32s?
And if so, how is it done?
Is there a procedure with Vagcom?
I have a switchback in my driveway, which it pretty steep. I've noticed that when I'm turning right going uphill on that switchback, with some accelerator applied to get up the hill, I get a vibration through the steering column and floor.
Not super-noticeable, but noticeable. I've also tried it on the flat. If I turn the steering wheel maybe a little more than halfway towards the "stop" at the very limit and then accelerate a little bit, the vibration is there too.
I don't think my old land cruiser or my current fj exhibit this vibration. Don't know if it would be originating from the transmission or cv joints. Doesn't seem completely right in an "off-road" designed vehicle.
My wife drives a 2013 RX 350 AWD. During this winter, when she turned right (once from a standstill, once without standstill), the car went out of control at a very low speed. The vehicle has around 12000 miles on the odometer. The Lexus dealer could not replicate it. He said it might have been snow on the wheels. I too experienced it once and was very scared to use her car after that.
Here is what happens: Turned right at slow speed, suddenly the car sort of accelerates goes left, right and kind of rocks and then after 15 feet or so steadies itself. My wife has reduced her own usage of the car due to the freight she got twice.
My 2010 LS 460 had the Control Arms replaced at 45,196 miles. Now, I am hearing a clicking sound at low speeds when I am turning in either direction. I can hear it with the windows rolled up and the radio on, it is fairly pronounced. The vehicle now has 51,350 miles on it. What this could be?
View 5 RepliesI know from what I've read that this tsb should have been addressed on my vehical (04 V8 early vin). The car has had two previous owners and the 2nd purchased as vw certified. I bought the Treg when it had been certified again 18 months later, so why does this "binding" due to the stepper motor software still exist after all tsb's have been performed
Its happened twice in three weeks now........when you shut down and start again everything is ok.
I have noticed that recently my engine seems to be coming on when I accelerate from a stand still even with very slow acceleration.
For example today: battery over 50%, foot off break and onto gas very gentally, 0 to 10 in about 4 seconds at about 8 mph I feel the engine kick in.
Over the last few days it has seemed like the engine has been running a lot in town or when moving slowly in heavy traffic.
If I press the ev button I can accelerate quiete aggressively before the engine will start.
I have a 2004 2nd generation Toyota Harrier (Lexus model RX330). The A/C blowing hot air if temperature is not set to Max Cold. This happened no matter whether turn on the A/C with Auto or Manual setting. This case also happen no matter whether setting the A/C system to Dual mode or not, no matter whether turn on or off the air intake control button.
As long as A/C on, cold air only come out when temperature set to Max Cold, even if set to 18 degree, full hot air come out. Another thing is, say I have the A/C on, set to max cold, cold air came out from the front vent, but after I try to increase the temperature to say 18 degree, the hot air flow will change to Floor/Windshield mode.
Could it because due to the change of the battery? Is there anything need to reset after replacing the battery?
There has been below freezing temperatures here in NYC and I noticed that the air suspension is disabled when left out in the cold.
The fist time I noticed this was when the temperature was 15 degrees and while driving the ride was very bouncy. I noticed I didn't hear the air compressor coming on. I tried raising the suspension from "N" to Hi or Lo but nothing happened when I pressed the button, not even the light, it just remained on "N".
I parked inside the garage and after about 20 minutes I heard the air compressor running and felt the car leveling itself. I was also able to adjust the by using the height control switch.
I have come to the conclusion that the cold weather is causing the air suspension to be disabled. I'm thinking the suspension should work at these temperatures. Is there any DIY for removing moisture from air suspension?
When taking our 2007 RX out of say a 72 degree garage to say a 90 degree day, it takes at least 10 minutes for the outside temp gauge to finally creep up to the ambient temperature. The gauge feels very sluggish at all other times.
View 14 RepliesSeems like I'm having to crank the temperature up higher and higher (numerically) to avoid freezing myself out in the GX in the summer. Used to be ~72-74deg was a comfortable setting, regardless of outside temp. Now it seems like I'm running a 77-78deg setting on the climate control in order for things to feel right. Any lower and I just get frozen-out.
Oddly, if I have the rear AC on (if it's super hot outside, or if the kids are in the back) things are a bit more normal.
Problems getting an alignment AFTER lowering. seems no one in my area has the old fashioned machine where it clamps on the wheel edge,they have the ones that clamp on the outside of the tire,which limits the rotation of the wheel if the body is too close. I am on rsr downs with Vossens,which wont work at all, so hoping the stock wheels will.
View 6 RepliesGoing to lower the SC tomorrow with some pbm coilovers, thinking 1.5 inches. Wondering if I can go lower without having issues. Wondering how much other members have lowered there's, and how it rides
View 14 RepliesThis is a 2004 RX330. Unable to adjust temperature on driver side.
Symptoms - may appear to be defective heat or defective A/C on driver side only (depending on the position of the mix damper).
Solution -- replace mixer damper assembly servo (this controls the mix of hot and cold air on the driver side). This is a dual climate control, so each side has dedicated dampers.
So, if unable to change "where" the air coming out, the damper with the red arrow would require replacement.
If unable to control the temperature, the damper with the blue arrow would require replacement.
I will post pictures, after I repair my own. I'll be replacing the damper with the blue arrow.
This photo was taken with my feet on the drivers head-rest and my head pressing the accelerator.
It was a cold winter in Boston in the last two months. And since then almost every time I started my 2005 Prius, the temperature was default to 75F. Also, the first time I start the car in a day, it almost show the outside temperature as Celsius instead of Fahrenheit unless I press the screen to display something else and then come back, then the Fahrenheit will come back.
View 9 RepliesSo I installed the RS*R lowering springs last week and noticed my lights are aiming low. I searched about how to adjust the auto leveling arm and crawled under the car. The rear arm has no slide to the bolt like I have seen in pictures of other Lexus cars. I don't really want to adjust the lights themselves I would like to level the arm back like stock angle.
View 11 RepliesI just installed my lowering module. 2008 LWB
I played with the buttons and followed the info I found by city. But I could follow them I guess. Some of the information mentioned I couldn't see on my module. My module isn't new so maybe I need to do a full reset.
How do you hook up the speed option and what is it for?
I have just installed my data system lowering module.
I bought a used one and it appears to be lowering and raising the car.
It does not seem like all 4 corners are even. I don't have the instructions on how to reset or play with the settings.