Lexus RX 2004-09 :: RX330 Tail Light Bulb Sockets Melted
Jul 17, 2015
I have a RX330 and recently noticed that both the RH and LH outer tail lamps bulb sockets are melted.
View 2 Replies
Jul 17, 2015
Advertisement
Passat (B5) :: 2002 - Replaced Burnt Tail Light Bulb But Only 3 Sockets Were Filled
I just replaced a burnt out tail/brake lightbulb and found that I had sockets for 5 lights yet only 3 were filled....two were empty. How could this have happened and shouldnt they all be filled? I replaced the blown one but I feel like I should get 2 more per side to make it a full housing. I also am not certain what kind I need . The turn signal bulbs are fine....it's just the tail/brake light bulbs. Why were they not filled? 2002 V6 Passat.
View 7 RepliesLexus RX 2004-09 :: 2005 RX330 Head Light Bulb Low Beam Replacement?
The passenger side HID bulb of my 2005 RX330 need to be replaced, how to? Also there is condensed water in the assembly. I am going to replace it later. Where are other screws beside two on the top?
View 14 RepliesLexus RX 2004-09 :: 330 / Tail Light Bulb Replacement?
Lexus IS: How to Replace Your Tail Light Assembly
Step by step instructions for do-it-yourself repairs
Browse all: Lexus IS Lighting Guides
Lexus RX 2004-09 :: Changing Bulb For Fog Lights On RX330?
How to change the bulb on the rx330 fog lights. It doesn't say it in the manual.
View 14 RepliesLexus RX 2004-09 :: 2005 RX330 Headlight Bulb Replacement?
Recently my 05 RX330 had the driver side low beam bulb go out. I took it to a few places and they said take it to the dealership as they have special tools to change it. Of course I took it there and they were ready to charge me an arm and a leg to get 1 little bulb replaced. My question is do you have recommendations as to what I should do to get this fixed and not have my wallet get destroyed?
View 8 RepliesCamry :: Melted Backshell That Holds Low Beam Light Bulb
I recently melted (due to my own ignorance) the backshell that holds the low beam light bulb in place. I can see that the backshell is removeable since there's it looks like there's 3 screws that hold it in place. The headlight would have to be baked apart, but I already know how to do that. My question is: is there anywhere that sells this part, or does the housing assembly have to be bought whole? I was also looking at the spyder lights that claim they are projectors, but I'm wondering how they compare to regular OEM output. This is for a hybrid btw
View 1 RepliesLexus RX 2004-09 :: RX330 ABS Light On At Very Low Speed Or Just Stopping The Car
Hard to fix? Only happens when going under 5 mph either in slow traffic or slowing down to park in parking spot or just stopping the car. Doesn't happen at high speeds. It's like I'm driving on snow or ice or wet pavement but there is dry pavement. Brake pads and rotors were cleaned with no success. Guessing that a sensor is dirty or broken or such.
View 4 RepliesLexus RX 2004-09 :: RX330 SRS Warning Light Stays On - DTC 23
I have a 2004 RX330 that all of a sudden had the SRS warning light come on as well as the passenger airbag OFF light being constantly lit up even when someone is sitting in the passenger seat. I put the SRS system in diagnostics mode with a jumper clip to determine I am receiving a DTC of 23. Documentation I have found for this online states for Lexus it is a occupancy classification system issue which I know means it's something on the passenger side.
This seems like it would be related to the occupant seat sensor itself which I am first of all wondering if it is bypassed like the BMW guys have done on their cars when this issue happens.
Secondly, I'm wondering with this specific code of 23 could it be anything other than the seat/weight sensor? My passenger seat belt has tons of slack and doesn't retract as it should so I'm thinking maybe pre-tensioner sensor but not sure because it also seems to stick when trying to unbuckle it as well which leads me to believe it could be the fastener sensor.
I feel very unsafe having any passengers in the vehicle right now and the car is well beyond its warranty of course so bringing it in to the dealer is really a last resort option for me since I know at minimum they'll charge $1000 for SRS wiring issues based on what I've read.
Lexus RX 2004-09 :: RX330 AWD Beeping With A Light In Dash With Icon Of Car With Curves
I have a Lexus RX 330 2004 which I recently made some changes to the front end suspension, since then, my car beeps whether i turn or I drive even in straight line beyond 40MPH. The beep comes along with a light in dash with an icon of the car with curves.
I have read something referring to a zero calibration. Which pins to short to perform the calibration? Since I don't have the lexus diagnostic tools, I heard its the CG and TS pins but What pin numbers are the on my 2004 AWD RX 330?
Lexus RX 2004-09 :: Check Engine Code P0442 On 2005 RX330 / VSC Light On
where best place to start looking for what's causing p0442 code on my 2005 rx330? and its not the gas cap... also have a "c" code identified for the VSC light, states that its wheel speed sensor. evidently wrote the wrong code down, i had it listed as a c1290 but in looking them up i couldn't find that one.
View 6 RepliesLexus RX 2004-09 :: RX330 TPMS Warning Light Came On / Water Temperature Gauge Dropped To Zero
My 2004 RX330 which has gone many years without a problem suddenly has instrument panel gremlins.
I started the car a couple of days ago (it had rained during the day), and the airbag light did not turn off. Then the TPMS warning light came on, the water temperature gauge dropped to zero. The AC controls stopped responding. Since I needed to get home, and the car seemed otherwise fine, I drove home, after a few minutes the transmission "D" drive light went blank and the instrument back-light went to full brightness.
A few minutes later, all the warning lights went off and the back-light went back to normal. The AC controls still seemed to be off. A few minutes later the airbag warning light came back on, followed by the TPMS light and the back-light went to full brightness again. This cycle kept happening all the way home.
The next morning, hoping the problem had been some errant water getting into something, I started the car, opened the driver's door to get something and got back into the car, closing the door. The light showing the door was open stayed on. I put the car into reverse, the doors did not automatically lock as they usually do. I turned off the engine and restarted it, most of the other lights were off, the doors would lock; airbag & TPMS light came back on.
It has stayed that way, except I also get the A/T temperature warning light coming on periodically, and after some cycle it goes off.
I borrowed a car code reader, it does not seem to show any error codes. In reading some other postings it has been suggested that the Brake light switch is the cause, but the brake lights come on/off without any problem.
Lexus RX 2004-09 :: 05 RX330 Starts Pinging At Part / Light Throttle Once Engine Fully Warmed Up
My wife's RX is really starting to give me a headache. The first problem I'm having with this car is detonation. The car starts pinging at part/ light throttle once the engine is fully warmed up. The is no CEL or codes pending. After scanning the car it seems that fueling is right where it should be and nothing else seems out of order. The pinging stops when you hit the gas harder. So far the only way to rid the car of this problem is to fill with 93 octane and that gets expensive with a daily driver. Shouldn't the knock sensors be handling this? Is there a way to test them?
The second problem I have is the heat won't turn off. Hot air always comes out at what seems to be low fan. I can move the area it comes from ( dash vent, floor etc) but I can't turn it off. With the fan set to off and no settings chosen I still get heat.
The car currently has 78k miles on it
Avalon 2005-12 :: Tail Light Bulb Replacement
My wife has a 2012 Avalon Limited. I also see that it comes with a side marker light as well. What is the bulb for the side marker light and how to replace it as well.
View 3 RepliesTouareg :: Rear Fog Bulb Melted Into Red Lens And Exploded
About a month ago i installed the rear fog in my 06 TDI. I used all the proper stuff ( VW wire, 1156 bulb)
Well yesterday i finally got to use it while driving on the interstate during the reminisce of tropical storm Barry. well all remain good until i stopped off at the mall with my wife, got back in the truck and proceed back home when MFI prompts me to check lights and little icon lights up... well today i check it and its the rear fog. The bulb had melted into the red lens and exploded.
Passat (B6) :: Headlight Bulb Socket Partially Melted
I was changing standard halogen headlight bulbs last night and as I was getting the drivers side bulb out the metal part came off with the bulb and I noticed the black plastic part of the socket was partially melted. Sketchy. Far as I know these bulbs have never been changed I bought the car w 3500 miles back in 06. Is there anything I should do besides replacing the melted socket? A part # would be awesome too...
View 2 RepliesCamry 2012+ :: 2013 SE Headlight Bulb Holder Melted
Unfortunately my HID bulb wasn't secure in the headlight assembly and melted the part that holds the bulb in place in the headlight assembly.
My question is if that part that retains the bulb is replaceable or I will need to replace the whole head light assembly? ( The wire connector is fine.)
If the part is replaceable, What is the name or part #...
Prius (2010-12) :: Cable Melted Next To Headlight After Bulb Shattered
About a month ago I replaced both of the main headlights in my Gen 3. I've noticed since that the light from both seemed a little skewed and thought maybe I didn't lock them back in fully. i finally checked them today and was able to get the left side light straightened out, but when I went to check the right hand (passenger) side one (which isn't working again), i realized that it must have come out.
Essentially the light bulb is shattered/exploded and it melted part of the cable next to it, and is now stuck to that cable. Besides being partially melted, the cable also has some exposed wires. i don't know what those wires do, but I can't imagine it's a good thing to leave it exposed next to a live circuit from the headlight.
See the attached picture. What that cable is that melted and if it's possible to replace it myself, or do I need to take it in?
Ford 7.3L Power Stroke (1999-2003) :: Electrical - Tail Light Bulb Out No Rapid Blinker
Passenger tail light bulb went out who knows when, but was alerted about it today. Every other time this has happened, in multiple vehicles, the turn signal blinks rapidly to let you know the bulb is out. Mine blinked normally.
In the past year I've had to change my multi function switch and more recently the flasher relay for the blinkers. Just a standard relay from the parts store, not the heavy duty one or anything. It did say it was LED compatible, so I wonder if that is why it didn't pick it up? Why I didn't get the rapid blinking?
Golf V R32 :: Passenger Headlight Bulb Melted Into Igniter - Blast Control Defective?
So a couple weeks ago my passenger headlight started flickering. After a couple days the bulb was out. I bought a new bulb and opened up the headlight to install and found the bulb melted into the igniter. Ok, bought a new igniter. Installed everything. And still nothing. Checked the fuses and wires, nothing loose. Headlight still didn't turn on. Went to my mechanic and he said it's the ballast. I buy a new ballast and he just called and said the ballast I bought was defective. The light was turning on, but no high beam.
Does the ballast control the high beam? If it's not the ballast, what could be the problem?
Lexus RX 2004-09 :: Moisture Inside One Of Tail Light
This may be related to some posts I've studied but I'm still at a loss. My wife observed moisture inside one of the tail lights on her 2006 RX330. Upon further inspection, I noticed water standing in the lower section inside the outer cover over an inch high. After reviewing all of the posts about bugs in them, moisture in them, how to remove them, and whether the outside cover can be removed, I pulled it out looking for any cracks, etc to figure out how that much water is getting in since it hasn't been wet in over a week at least and no downpours, major things like a car wash...nothing. I'm still at a loss. I know that I could rotate it carefully 360 degrees without water escaping which meant the out cover was still sealed pretty good. I then rotated it to flat and the water poured out thru the electrical circuit board/bulb area. Could this be related to the same cause behind the headlight pseudo recall/replacement? Which way to go as I can find no signs of how the water got there.
View 2 Replies