Lexus RX 2010-15 :: Reverse Camera Won't Engage - Check Engine Light Came On
Nov 4, 2014
I got in my car this morning to drop my sister off to school and when I put the RX in reverse nothing happened for a second or two and then all of a sudden it jerked back. I continued to reverse off the driveway thinking what the heck just happened. When I put the car in drive the reverse camera stayed on as I drove off.
When I noticed this, I pulled over to the side and put the RX back in park and turned it off. I then turned it back on and the area on the dash that shows what gear your in, never turned on. My sister was getting late so I dropped her off and came home.
I turned the car off and waited 30 seconds before turning it back on. This time the reverse camera didn't engage in reverse and the small screen that displays what gear your in, displayed no image. Then a few seconds after that, the check engine light came on and so did the symbol of a car and squiggly lines under it. My RX350 is a 2010, and has just under 85k.
View 8 Replies
Advertisement
Where is the camera for the back-up screen located? Occasionally we have gotten splashed and when I put the car in reverse, it is very difficult to see because the splashes are obscuring the view. If I knew the location of the camera, I could try to clean it.
By the way, had my first opportunity to drive our 450h In the snow. The snow was coming down hard, it was night time, back roads in New England, taking our daughter back to boarding school. The roads were very dark, not yet plowed. I was so focused on seeing the road ahead that I didn't even notice how steady the car had been (no skidding or 'fish-tailing') until we got back to our hotel.
View 3 Replies
My backup camera stopped turning on when I put the car in reverse. Why? I'm thinking it might be a fuse issue, but I can seem to figure out which fuse from the information in the manual.
View 9 Replies
I have a 2010 rx350 and had a big oil leak recently because the car shop didn't install correctly the oil filter seals. It didn't leak right away and my wife drove till the check engine light came on, but it was late... no oil in the dipstick... I think no oil at all but the car didn't display low oil level warning. only a beep when i turned the steering wheel.
I had it towed and luckily my wife stopped the car when the light came on, no harm done the mechanic said. But I think it has less power and the engine noise is a little louder than before..., so maybe the engine has a Little wear. but there is no smoke. Should I continue to use the same thin oil.. 0w20. or use a thick like 5w30??
View 4 Replies
Filled up my 2012 Lexus Rx450h in NJ. They don't have self-service there, so I don't blame myself, but gas cap not tightened. Check Engine light is on, I tightened gas cap, light still on. Is there just a fuse I can pull to reset the warning light? There seem to be a few fuses labeled ECU. Exactly which one should I pull ? If I don't, how soon before it will it reset on its own?
View 6 Replies
My wife's 2010 RX350 with 75K miles on it , the check Engine Light came up with code P0303 (cylinder misfire). Since the warranty is out already so I went to my mechanic and had the spark plugs and the back ignition coils replaced. After a week, the light came back on. So I went to the dealership and they said the engine needs to be taken apart because of low compression and valves could have carbon build up already.
View 11 Replies
Started up our 2010 RX 350 and there was loud knocking. This smoothed out after several seconds. I stopped engine and started it again. This time the knocking was less severe, but now the Check Engine light is on. Engine seems to be running a little rough as well. I have a feeling I have a bad plug or wire maybe.
View 2 Replies
Where the this ecu is located. I believe it's behind the glove box, but I want to be sure before I take it out again, wasn't sure which connector it belonged to. 2006 GS300.
View 2 Replies
Is there anyway to view the backup camera when the car is not in reverse? During driving, while stopped, etc.?
View 14 Replies
Just bought this 11 gs350 and car is great except that the reverse camera does not activate when the car is put in reverse. The side mirrors tilt down and the rear shade will lower when put in reverse but the screen just stays on the navigation screen no flicker or black screen.. What could be the problem?
View 7 Replies
Is there a way to take the rear view camera input and add a DVD player and " trick" the screen to think it's in reverse so I can play a DVD on a no ml system .? But I can up on a great black on black 08 with low miles and decided to get it and try to figure out a way to do this later.
View 2 Replies
I was driving home and all of a sudden my rpms are at 3.5 4k rpm wont shift to next gear. I put in in tiptronic mode and shift it to 8 it works fine. Then about 10 minutes later check vsc shows on dash traction control light is on check engine light is on and the light next to the check engine i think it is the abs light. I havent pulled the code yet.
View 1 Replies
Two random times I put the car in reverse and the back up camera showed a blank black screen. I have to turn the car off and restart It for it to work.
View 6 Replies
My 06 Sonata 120k 3.3L Does not go into reverse. (automatic) Took it for a short (1/4 mile) ride. Shifted fine at first then check engine light came on and it seems to be stuck in 3rd? What this may be, I don't want to get ripped off on a repair I don't need.
View 4 Replies
I have a 2006 suzuki forenza (automatic) with about 90,000 miles on it. Five times this summer, it seems to get "stuck" between reverse/ neutral (both letters are displayed on dashboard) and the check engine light goes on. I turn the car off/on and the the problem seems to resolve. The check engine light stays on for about 24 hours. The car drives "fine" (its a relative term, has some other quirks) for another 2-4 weeks until it happens again. My question is: is this a serious problem or can I just ignore it?
View 1 Replies
A few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
View 8 Replies
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
View 7 Replies
I have run into a bit of a dilemma with my recently purchased 2010 Camry SE.
Whenever I shift into reverse, the car jerks or shakes for a moment. The engine light is also on.
Before, when I put the car into reverse,there'd also be a knock sound along with a vibration, but the engine light was never on.
Now today, when I put the car in reverse, the vibration/shake/jerk is VERY noticeable and the car almost rocks back and forth for a brief second when this happens and the Engine light stays on.
note that this only happens when I put the car into reverse.
View 4 Replies
So I did a fairly hard 1st to 2nd gear pull on my way to lunch today. Got to a stop light and I had to slam the shifter to get my car in first. Same with 2nd and reverse. Third, fourth, and fifth seem fine. With the engine off all gears select fine. With the engine running at idle, when I engage first the engine jumps. I can definitely feel it engage. I have the ecs ra4 stage 1 kit with about 40,000 miles on it. The clutch doesn't slip when driving. This seems to be the only symptom. I'm going to bleed the slave cylinder when I get fluid. Fork? Synchros? Worn pressure plate spring thingys?
View 3 Replies
When I use Side view and backup camera , the screen shows SYSTEM NOT READY. After this issue, I go to service menu, I found check for HANDLE and DEST. Any solution for HANDLE and DEST check in service menu? Is there anyway to upgrade firmware of INTUITIVE PARKING ASSIST ECU?
During driving, some buttons are not working. Sometimes work and sometimes doesn't work!
View 7 Replies
All of the backup camera systems I have seen (which are in Chevys) have superimposed guidelines on the camera view to align the vehicle into the proper spot between the parking lot markings. I road tested a 2014 RX350 with Nav system (with backup camera) the other day and it did not have these guidelines. It just showed a nice rear view picture but offered no assistance in aiming or aligning the vehicle when backing into the parking spot.
Is it just possible the guidelines were turned off in the Nav menu somehow? On the other brand cars, the guidelines actually curve as the steering wheel is turned -so you can use those line to perfectly back into a space. It would be a big oversight IMO if Lexus didn't build this guidance feature into their backup system.
View 14 Replies
