Passat (B5) :: 2001 1.8t Overheating After New Water Pump
Jun 2, 2013
i just did a new timing belt water pump kit on a 2001 1.8t (aug engine code) the new pump has a metal impeller. i ran it in the drive way for mots of an hour off and on. figured it was good. took it for a drive and at 5 miles it overheated. Temp Went straight to 260 and stop light came on. coolant could be heard boiling in the system. when i let it idle and ran the heater i got the temp to go back down to 190. but after idling for couple minutes it started going back up. I don't think the stat is bad considering that the heater works which shows that the system is flowing.
View 5 Replies
Advertisement
Ok, I just bought myself some problems in the form of a '93 Celica GTS. (5S-FE)
Well, alright, that's a little dramatic. it just overheats. but here's my issue. it's got a new water pump, new radiator, and is still overheating. The guy I bought from says it's in the block, cuased by an attempt to plug a radiator leak with stop leak. He said it just had a minor leak in the radiator, so he put stop leak in it, and after that it started overheating. he's replaced the thermostat, water pump, and radiator since then.
My first question is, could he (and I) be overlooking something? could there be a clog somewhere easier to access? and then if there isn't, how should I go about cleaning out the block? are there areas I should check? anything I should do to try to unclog it? my current plan is to put cooling system flush in (he has some) and drive it home (about 55min. drive) with the flush in it, then empty it and hope for the best.
View 14 Replies
1995 Isuzu Rodeo. Replaced water pump, thermostat, timing belt & components. Now it over heats & no heat in cab. I was told to "burp" the cooling system but can't find the bleed valve. Is there even one on the V6 engine???
View 3 Replies
My aux water pump was acting up and started leaking a year or two ago. I replaced it and it seemed to be doing fine. Recently it has started buzzing very loudly right when I turn the car off and keeps buzzing loudly for a few minutes (5-10) after the car is shut down. I know that is when it is supposed to be running, but why would it be so loud? Is it being over-heated or something?
View 1 Replies
My 1995 chevy camaro has been overheating. at first i thought it was the thermostat sticking because there was no spewing or smoking so i changed the thermostat and my car was still over heating. I finally found out that the water pump was leaking fluids. so I changed out the water pump and filled it full of coolant. i turned on my car and within 10 minutes the gauge went up to 260 degrees and went down a little bit but stayed around 260, there was no spewing or leaking or smoking again. I was thinking that maybe now it could be the sensor but im not sure.
View 1 Replies
First off new jetta owner. I changed the thermostat. There is no heat coming into the car upper radiator hose hot lower hose is cold & seems there is no pressure. I bought the book to repair the car but it doesn't give me troubleshooting directions other than it might be the water pump or a blockage in the radiator.
View 9 Replies
I had a leak in my water pump so we had it replaced and a new thermostat. Now it is overheating in just about 2 minutes and my heater is now not working. I was told that it is most likely an air pocket in the coolant. I have let the car heat up, not to the point of hot but over half way and shut it off, taken the cap of let it sit for a while and then trying it again. No luck so far. Is there another way to get it out of there? and would the cap have anything to do with it? it has been hard to take off in the past and now its coming off easy. It is the plastic kind. I am at the end of my rope here . the car runs like a dream, its just this one thing.
View 12 Replies
Ok so my car kept overheating and I saw I had a small leak from the gasket on the water pump. I replaced the water pump and gasket but then it would zoom straight to overheating. I then assumed it was a stuck thermostat and replaced the OEM with a fail-safe thermostat. After topping off fluid and leaving the radiator cap off until I saw fluid running through it took it for a drive. The temp began to climb to overheating but dropped just as it was getting to the red and then began to fluctuate. Finally heat came through the car climate system and all was good until I had to come to a stop. It seems that whenever I have to stop at a light the temperature rises to overheating.
View 9 Replies
My son has a 2002 Jetta, we just changed the water pump and the thermostat. The car will sit at idle and the temperature will stay around 190. When you drive down the road the temerature will rise and when you let off teh gas the temperature goes back down. What this could be, I have tried everything I can think of to fix this car.
View 13 Replies
We had my son's water pump replaced in his 97 F150. It is now occasionally jumping to completely hot. If you turn it off and back on it returns to normal. The power to the engine is cut when it shows to be overheating. The check engine light has now come on.
View 9 Replies
I have a 2002 Intrepid ES with a 3.5L V-6 with 264,000 miles on it. I have recently had the timing belt and water pump changed. Three weeks later I am driving home and the temperature gauge starts climbing. This is the first time this car has ever overheated. Well, I call my buddy who is a certified mechanic and he tows the car to his shop. I have him check the water pump to make sure it hasn't prematurely failed. He tears the front of the engine down and inspects the pump. He finds nothing wrong with the pump but he discovers the timing belt tensioner has failed and it has caused the engine to jump time, I tell him to go ahead and replace the tensioner.
After he put the engine back together he started it and it ran cool while it was sitting at idle for about 45 minutes. Then he took it for a test drive and it overheated again. He checks the thermostat and finds that it has also failed; he replaces that also, still overheating. New radiator hoses, upper and lower, new radiator, new thermostat, new water pump and it still overheats. He put dye into the coolant to check for a blown head gasket and it tested negative for a blown gasket. The exhaust doesn’t smell of burning coolant or producing white smoke. My mechanic friend and I both have run out of solutions…
View 12 Replies
have a 2006 f250 with the 6.0 Powerstroke diesel started overheating yesterday the ECT and EOTcheck fine with the scangauge always ran with in 8 degree's of each other. Thought maybe water pump impeller may have been slipping so it is new with no change. Fan kicks on like it should. Heater works good so don't think it is a thermostat.
View 13 Replies
I have a 76 f250/460 engine. I have replaced the hoses, belts, water pump, fan clutch, flowed the radiator and it still overheats.
View 4 Replies
my 2001 Ford Explorer has started overheating but there is no steam or water running out and when I turn the heater on I get slightly warm water what can I do? the temp gauge will go to hot and after a while will drop down then go back up to hot what kind of damage am I doing to my car?
View 3 Replies
This is what its doing... Im starting to feel lost about whats wrong. I start it up and everything is fine. With in about 10 minutes it starts to bubble and spit out a little water then shuts its self off. And the gauge on the dash never reads above 190. And the fans don't come on unless i turn the ac on. And the ac still blows cold. The lower hose stays cold. I just replaced the thermostat and the water pump. But it changed nothing. Im thinking maybe its clogged somewhere. Maybe in the heater core or the radiator.
View 1 Replies
I have an 2002 which I bought new. It's got low millage, just over 92,000. I took it into the dealer for a free state inspection and was told that the water pump is leaking. Given the age I'm not too surprised although I don't know what the reliability is like on that part.
I want to verify myself that the water pump is actually leaking before having it replaced but don't know where it is or what to look for. Googling hasn't been too useful - I get lots of hits about the inverter pump, not the water pump.
I have not seen any signs of leaking on the ground under the car. There was no mention of the water pump leaking when I took it to the dealer at 90,000 for an oil change, with my original service advisor.
Is the water pump something that I can fairly easily inspect? Where do I find it and what do I look for?
View 6 Replies
My girlfriend has a jetta and I work at a DODGE dealership in service. I recently replaced the water pump and flushed the coolant twice and replaced the coolant with G13 coolant from the local VW dealership. After I finished burping the coolant system of air bubble. After I finished I took it for a spin and being the speed demon I am, I don't hold back on the throttle. I noticed immediately the engine lagging and being extremely sluggish. I ran my shops snap on code scanner on it and I came up with cylinder 1 fuel injector open circuit. Cylinder 6 fuel injector limited power. And last but not least o2 sensor 1 open circuit. If your facing the motor I undid the left motor mount from the frame, lifted the car on a hoist and took the bottom side motor mount off of the motor. I took the cv shaft off of the transmission and lowered the car and jacked the motor up by the oil pan to expose the water pump for removal and replacement. I'm wondering if possibly the o2 sensor could cause the ECU to seize power to two of the cylinders to ensure no engine damage or if its 3 separate problems.
View 3 Replies
2002 Prius with 94K gave me today P3130, after I tested the Inverter Water Pump I found out that it bad but until I go to the dealer in order to buy the part $147 he was closed. the question is can I drive with the car like this bac home (65 miles) and if I turn on the A/C the Engine will work all the time right? And also after replacing the Inverter Water Pump how can i tell if the problem solved?
View 14 Replies
Just finished installing a new water pump on my 2002 Elantra GT when...
I went to start it, and it started for half a second and died. Further attempts to start were strained.
The battery is showing 12.58 volts on the multimeter so this was likely not the cause. I checked the fuses under the hood which all looked good. I don't know if it could be a relay or anything else electrical.
Other than the electrical side, there are two things I can think of that may be the cause.
First, being in a hurry to finish(which is probably the biggest mistake of all) I reconnected the battery too soon and wound up connecting the ground(I thought) wire to the alternator for a second causing an arc. I immediately removed the wire and followed proper procedures to reinstall it.
The only other thing I can think of is that one of the water pump bolts required removal of the idler pulley. The idler pulley demands the loosening of the timing belt tensioner in order to be reinstalled. Before removing anything I marked the position of the timing belt on the camshaft sprocket as well as the crankshaft sprocket so I'm really hoping I haven't lost timing.
Could it be something electrical? Did I over-tighten a belt or pulley? Is it timing?
View 15 Replies
After tracking a howling sound from my 02 elantra gt pulley are, I figured it to be the water pump bearing. I replaced the water pump less then a year and a half ago and was wondering if its common for aftermarket pumps to go fast? Or is there anything I did wrong installing?
View 1 Replies
How to remove the water pump pulley on a 2003 W8? I removed the 4 bolts but I don't want to go crazy and end up ruining it.
View 1 Replies
