Passat (B6) :: 2006 - CEL Coming On And Off After Fueling / Code P2293
Nov 23, 2010
Well my car is listed above it has 99 k on it now.. For the last few months the check engine light had been coming on and off.. It usually happened after I put gas so I figured it was the gas cap... Till yesterday I had it scanned at auto zone and gave me the code listed above... Don't know how to go about it.. I've searched some and found that it could be a cam sensor of some sort or a follower ( spelling) ... Is it a easy fix .. Like I said light goes off and on.. Doesn't stay on always.
View 13 Replies
Advertisement
My car is throwing this p2293 code which means fuel pressure regulator performance 1 had towed twice this week my mechanic replace the fuel pump in the tank but yesterday I died again with the same symptom ...
View 6 Replies
So here's the backstory, Couple of months ago I Cold started my Car. During the fast idle the car started to misfire, but no flashing check engine light. then after the cycle, it smoothed out and was fine. Now it's happened maybe 3 or 4 times since then. So Today it hasn't done it but I decided to Scan it and check the OBD codes.
As I sit right now I'm APR Stage 2, I'm in the process of going K04, just waiting on the turbo to come in. Now the too high of fuel pressure one I've had for a while. I was told it was a software thing nothing to worry about. But the P2293 Code has me stumped. I've had the HPFP Fail at 16k miles so I know what the symptoms are. I also replaced the follower at the same time when I did the HPFP. Now the thing that has me stumped is, The car is running fine. No issues what so ever. No problems with fuel cuts or anything. Is it possible that the Pump is going on its way out? Or am I just paranoid?
View 4 Replies
I've been having this code come up for a couple weeks now off and on. Currently I am stage 2 Giac. I have the autotech HPFP upgrade and was installed a couple months ago. Recently It threw the code and lasted for a couple days then went away. I notice that if i get on it pretty hard for a while the code will come back, im guessing due to lack of fuel. I pulled the fuel pump and checked the cam follower and it looks almost good as new still. Thought it would be the sensor but doesn't seem like it as the CEL turns off after a while of not getting on it.
View 10 Replies
Only thing I've noticed is the idling is a little rough but the car has 88k on it so that's expected. I haven't checked the cam follower yet and know I'll probably need to change it so that's going to happen in the next week.
I had a code for P000A & P2293 for a few months that would throw a MIL and I would reset it and it would come back after a while. I finally replaced the cam sensor and I didn't see a MIlL for about 6 weeks and one day it came back. Once I scanned the car it showed P000A again. I cleared the code and everything seemed fine until yesterday. I went to start the car and the car wouldn't turn over.
I pulled the key out and tried it again and it worked. More and more I think about it, the car doesn't turn over smoothly over the past few months but maybe I'm just looking for things. I ended up scanning it last night and it had a code for P2293 & P0011. I cleared them both but what could be causing all this and cannot afford to bring the car in to the mechanic. It's out of warranty and I'm broke and X-Mas is around the corner.
2006 Passat 2.0T
View 2 Replies
2007 2.7 GLS ... I like many have encountered the P0441 code and my Santa Fe stalls after fueling and requires constant revving for a bit to stay going. Previous threads seem to point to the Purge Control Valve.
View 10 Replies
Probably 20k ago the check engine light came on and was related to the "purge" valve as best I can recall, every mechanic I took it to kind of blew it off as just an emissions thing and not really necessary to fix. so whatever just let the light stay on as the car ran identical to before the light came on.
Fast forward to a few weeks ago and my wife was filling up between classes and after she was done and went to start it, it would turn over but wouldn't start completely, luckily a guy there pump the gas and revving it out as he turned it over. then it ran perfectly fine afterwards, started up perfectly after every time....until we got gas again.
Took it to a local guy a few people I know used, told him about the check engine light and maybe the purge valve thing had finally gotten bad enough to need replacing (this was my guess after some internet digging for the same issue), he troubleshooted and came to the decision to replace the front o2 sensor. Ok I said, your the mechanic not me, do it. did it and next time got gas....same thing.
he had it for another 2 days and "couldn't figure it out", refunded me completely for the o2 sensor & labor, while throwing in the towel today. Next up , Hyundai dealership I suppose. Car is throwing NO CODES whatsoever now, have put several hundred miles on since new o2 sensor.
While he had it he had to replace the master brake cylinder. So that's new as well. I've had to replace all the coils already between 75-85k they started acting up one by one so I said screw it and did them all.
OH and another problem is the airbag light has been on the dash for about the last 6-9 months as well.
The car has just over 111k on it and I've about had it, bullshit problem after another and another. What's next??! I've owned probably 7-9 cars in my life and nothing has given me the aggravation of this car.
Cliffs:
1) car won't start when putting in gas
2) starts if you rev it up for a short while, then will start every time afterwards til next fuel up.
3) o2 sensor is new
4) no more check engine light, no codes, yet still have issue
5) car is starting to wear down my patience with repairs
6) if not a cheap fix, bye bye Hyundai
View 16 Replies
The car doesn't struggle to start at any other time just when fueling. I have a 2011 Accent and I am looking for the locations of the various components involved so I can test them to see where the problem is.
I know the purge valve is mounted on the rear of the intake manifold below the air hose. Now is the solenoid and the valve the same part? I see various diagrams pointing to the valve and labeling it solenoid. The other part is the EVAP canister. I know it's some place near the gas tank but not sure where and I can't find any diagrams online.
I am comfortable with minor repairs. I've replaced spark plugs and ignition coils and a purge valve before so would this repair be something I could do myself or would I be better off taking it to the dealership?
View 7 Replies
This is weird, im having problem starting the car just after filling up my tank, this is the third time it happened to me, i have the engine light on, i want to scan it but im unable to cuz my abs module is bad, i drive a 98 passat 1.8T, Just clarified I'm only unable to start the car right after I fill my tank aftert that the car starts with no problem
i always use SUPER, the only way to start it is while turning the key hit the gas pedal making it go brum brum lol. But like i said i only have difficulties starting the car right after fueling after the car starts the car is fine, it starts every morning untill i visit the gas station again...
View 9 Replies
After getting to about 1/4 tank, I fuel up and fill the tank but when I try to start the car, it cranks for a while and then finally starts. It will idle really low so I have to rev it until the engine starts getting gas at a steady pace.
View 9 Replies
I'm having an issue with my 08 Accent GS. It is very difficult to start, but only after fueling. Any other time, the car starts without any problems. I have tried to simulate the issue at home by taking off the gas cap and replacing it, but it didn't have the same result.
View 8 Replies
Dealer says the "gas cap" code keeps coming up. Won't share the number with me.... I've tried two new OEM gas caps, fuel & air filter replacement. I keep paying to get it reset. It keeps coming back on. Clueless VW mechanics... What else it might be?
View 3 Replies
Code p205b? 2012 TDI with 52k miles. Cleared code the other day and it came back on this morning (I have had luck clearing 2-3 codes in the past without them coming back, most likely due to condensation or similar on various sensors). Looks like it has to do with the AdBlue system with some other searches but I am looking for specifics like PNs to replace and whether the emissions warranty might cover this. I only purchased extended powertrain and it looks like it would only be covered under the highest tier extended warranty.
View 3 Replies
I have a P0406 code coming on and off on my 2006 Dodge Grand Caravan (EGR). I had the EGR replaced last year and then the cat shortly thereafter (at only about 48,000 miles). Right now, the car tends to make a rattling sound at low speeds, especially after a lot of stop-n-go driving, and it sometimes produces a strong exhaust smell. . The car has always burned/consumed a lot of oil (which Chrysler said was normal when I reported it while under warranty). Is there any chance this is not the EGR but something else producing a faulty error message? I was told by a Dodge service tech that the bad cat might have falsely triggered the EGR code when I first had it replaced.
View 3 Replies
Ok, I just bought this car a month ago, and I get this code coming up intermittently. I reset the code, and it will come back after driving a while. 2002 passat 1.8t 5 speed. It seems like it comes back when I roll backwards a little bit (like from a standing start on an incline) right before taking off. Could this be a leaky throttle body to inter cooler hose? Seems like the engine might move more while taking off from a backwards rolling start due to the torque. Also, I hear a lot of noise while on boost coming from the drivers front corner of the car, although it doesn't throw a code while on boost.
View 5 Replies
What is a 7e8 and 7e9 code on a 06 passat 2.0t?? Check engine just came on..scanned it and got those.. I am lost.. What it means?
View 12 Replies
From time to time, the engine lights comes on with error code P0365, it usually disappears within two days (it disappears by itself), but it appears once per month and stays for two days.
The code scanner says :P0365 Camshaft Position Sensor B Circuit Malfunction (Bank 1)
Do I need to change the sensor? and where is it located?
my Sonata is 2009, 2.0L (Korean imported) 4 cylinder ...
View 8 Replies
EPC light coming on intermittently on the morning causing loss of traction control and cruise control, occurred 4 times in 6 months. No fault code logged in, no CEL in dashboard. The dealer checked for logged codes, none. Also had one time the low coolant level display in dash all during one ride to work (30 km) the coolant tank was full and even if I was cycling the ignition switch it was still displaying it. Back from work it was disappeared and never came back on. all EPC light coming on at morning, and ok when coming back from work 9 hours later. Any clue on this?
Car is 2007 Passat Wagon with 2.0T FSI 6 spd manual
View 2 Replies
I just purchased my 2006 Passat 2.0T FSI and she just broke 100,000 miles.
So yesterday my car popped the P0171 code, STOP Low Coolant light flashing, and Tire pressure very low, so today i will be removing my cold air intake and forge diverter valve adapter and bring her to the dealer for warrenty work. I will keep this thread updated with whats wrong with her.
Tire Pressure Low: all tires looked fine.
View 19 Replies
At any rate, Scan at the store brought up P2101 throttle actuator control motor circuit range/performance. Car has been stalling occasionally while idling. EPC and trac control lights will come one. Including an exclamation point in the cruise control area. Restart and drive and the lights will go off and it will act normal. It is, however, starting to becoming a regular thing.
I have had the TB calibrated several times when the coil recall was done because it was giving a similar code. Apparently, they didn't set them when the car was warm and they would "pop up" when I got to temp. Haven't had this problem for several months and it never stalled before.
I'm hoping this isn't as bad as I have read about the TB, but I'm guessing it needs replaced.
View 12 Replies
I currently have a 2006 B6 w/ approx. 95k miles on it. A couple months ago I had my catalytic converter replaced at the dealership and then about a month ago my car started having issues with stalling.
Symptoms:
-Car drives normal - no loss of power or anything, but then will randomly stall when coming to a stop or slowing down, taking my foot off of the accelerator. After it stalls the red alternator light comes on. Check engine light comes on and off - lately on most of the time.
-The issue has gotten progressively worse recently, but for the past month it has been inconsistent. Sometimes I can go an entire drive and not experience it and then other times it will stall nonstop. Lately, there have also been a few times where it's taken a few tries to start it, though this is recent as before it restarted perfectly fine.
-Recently, the car has started exhibiting symptoms at highway speeds as well, occasionally brief episodes where it will begin to jerk and shake. Usually stops as pressure is applied to the gas pedal.
-Also, have issues with the parking brake... the switch seems to have randomly broken in the center (no clue how) and I keep getting a parking brake fault. Not sure if this is related or an entirely separate issue.
I took the car to a very reputable independent VW/Audi shop and after several days they still have been unable to locate the issue. Based on the codes the MIL was sending the first visit, they replaced the low fuel pressure sensor and the cam position sender. Neither fixed the problem. So, now I have to decide where to go from here... They took off the labor and only charged me for the parts.
View 4 Replies
