Passat (B6) :: Metal Part Of Front Wheel Scraping When Driving At Slow Speeds
Jun 23, 2008
When driving at slow speeds and when I go over a bump in the road, I'll hear something like the metal part of the wheel scraping something as its turning. Only comes from the front drivers side wheel. It's audible enough that people usually turn to look when I'm in a parking lot.
Took it to the dealer, they 'test drove' it. Said they couldn't hear anything. Then said that whatever I'm hearing is 'normal suspension noise'. So after leaving it a full day at the dealer, nothing has changed. Since when is ANY suspension noise normal? But I don't think its the suspension. What to do? Take it back? Take it to another dealer?
View 4 Replies
Advertisement
So... Took my car into a tire shop (tire pros) to get a screw pulled out of my front left tire... And after they finish the job - the guy comes up to me and says "your front brakes don't have much life left." I said, "I know I'm planning to change them in the next couple of weeks"...
He then said, "well I think your sensor just went off, when I pulled the car around.." I said "okay", got in the car and drove off - no brake light what so ever.
Anyways, A few hours later when pulling my car around the corner on the way home - I noticed that I am all of the sudden getting a random scraping sound from the front-right rotor anytime I turn the well all the way to the left at slow speeds...
I'm not too worried about it - just want to make sure these guys aren't trying to sabotage my car! The only thing that kills me, is that I didn't have the sound before and no all of the sudden I do? I'm assuming they somehow slightly moved the pad, causing it to somehow squeal - I'm just not exactly sure what they did...
View 13 Replies
Some of you may have seen my thread on my new car: [URL] ....
Its got just over 500 miles on it and I have noticed that at moderate speeds(40-50), if i turn, I hear a noise in the rear part of my car as if there's a metal ball rolling inside. I've already checked and there's absolutely no loose objects or any objects for that matter.
I checked the spare wheel bay, removed the spare, and found this beauty just sitting. Where it came from or why it was there.
View 10 Replies
I have a 2003 Jetta Wagon with 49000 miles on it. I noticed that when turning at slow speeds (like taking turns in a parking lot) I hear a klunk coming from the area of the left front wheel, and I think I feel it through the steering wheel. Yesterday I was going around a hairpin turn at a shopping mall and heard two clunks. Driving straight it doesn't happen.
View 8 Replies
Background: 2003 jetta; just changed rotors and pads on rear wheels a month ago, they are disc brakes
So the other day I was driving in a school zone at about 20 mph when I heard a VERY loud sound, like I'm dragging metal. i might also describe it as two rusty metal plates being rubbed against each other, but really really loud.
The noise is related to speed, it sounds cyclical and speeds up as the wheel turns faster. It occurs when I am NOT braking.
I parked the car and came back to it a few days later move it and the sound disappeared for the first 100 feet and then came back.
We did 2 things - we changed the caliper, and we also noticed that a caliper bolt was missing. I am pretty sure the noise was coming from that missing bolt - i think the caliper became dislodged and was making contact with the rotor. The caliper also seemed to be dragging a little bit so we went ahead and changed it too.
View 10 Replies
Metal on metal rubbing sound when starting off from a stop at slow speeds? It seems like it is brake related because putting on the brakes stops the noise. The noise also seems to go away when you get a little more speed, and maybe when the it shifts from 1st to 2nd ? This also is intermittent.
View 2 Replies
I picked my R up three weeks ago tomorrow. I took it in this morning because there has been brake noise from day one. The noise was a scraping, metal on metal sound that diminished a fair amount when the brakes were warm. I only got a very brief conversation with the service agent at the dealership this afternoon, and all he told me is that they had to order in new brakes. I don't know if it's just pads, or calipers or rotors or the whole deal! I'll get the whole scoop tomorrow.
View 5 Replies
I have a question about my C Four with 16" wheels. When the steering wheel goes all the way to a stop there is a thunk that feels like metal on metal. It is like there is no rubber bump stops. If this is normal. I am used to cars that have a nice cushioned bump at the steering limits.
View 1 Replies
Honda Accord 2005 ... Just bought a new used car. All seems ok, but I have two problems.
(1) when not moving, i have slop in the steering and I can hear metal on metal contact when I turn the steering wheel. I pulled the tire and with basically no force I can move the rotor back and forth by hand. what it is and how to fix it?
(2) when braking, it appears that the front left pad sticks. Pads are not excessively worn down. Can't figure out how to get to the caliper pins ( thought they might be sticking).
Could the two be related?
View 2 Replies
Replacing front wheel bearings on my 99 Passat? There is a gentle 'wahwahwah' grumble at speeds over 40mph. The car has done 130,000 miles and is otherwise in nice condition.
View 3 Replies
I noticed coming home from work that my 2010 prius is making a scraping noise as I drive. I don't have far to drive and i drove slow but I did notice it. I see the rim of the wheel is scraped and the tire is too like it got hit somehow.
I can't seem to figure out what is causing it and i'm afraid to drive it anywhere because the nearest toyota dealership is about 20 miles away via highway.
Its like part of something is scraping as the wheel goes around. its not a constant scraping. That and I notice the steering wheel is pulling to the right.
View 7 Replies
My front right tire has been squealing when I turn. It also makes a high pitch tone when driving on the Interstate or at faster speeds. (It might be the wheel barrings - is that the same thing as a CV joint?)
Is the power steering fluid found under the green cap, under the hood? Cause I checked that and it was filled. What do I do? I don't like the squeak when I turn, nor the high pitch constant sound when driving on the interstate. Also I just posted a report about really poor gas mileage. Could these problems be connected??
View 3 Replies
After driving our 2013 Passat for 215 miles, we noticed that there was a rattling noise coming from the left front wheel area but only at slow speeds (under 10 mph). The noise disappeared at higher speeds. Today, we took the car to the dealership but they could not find anything wrong.
View 4 Replies
Ok so 11 days into ownership and only slightly over 800 miles the car started to act funny. First the common DVD nav issue (no disk in drive message).
Second issue is a strange metal on metal rubbing noise when turning at low speeds (i.e. in parking lots). When I make a big turn (either direction) it sounds like either the brake calipers aren't releasing fully and is causing the pad and disk to rub, or something else is rubbing.
This actually happened once yesterday on the highway as well. going 75mph, a very loud metal on metal rubbing noise.
Seems to only happen when temps outside are below 40. It warmed up yesterday afternoon and the noise went away, but after it got cold again last night, the noise came back.
View 6 Replies
For several days I could hear a scraping sound from the right front side. I thought it was snow packed in the wheel well at first, until there wasn't any snow there. Today I was driving on the Xway and the scraping became a buzz like a Cessna airplane. On the way back home I turned the steering wheel back and forth and sure enough the buzz came and went. That made it sure to me the wheel bearing was bad.
View 19 Replies
2000 Mercury Villager. Noise in the left front wheel area only. Listened to both sides and zero noise on the right side. It's a metallic scraping noise. It's increase frequency as you speed up much like a train does as it speeds up. And stops when you push on the brakes. Doesn't seem to be related to steering.
View 2 Replies
2000 Explorer 2WD. I had tons of front end issues that I have been working through. So far I have done upper control arms, upper and lower ball joints, tie rod ends, got an alignment. The steering/suspension system is in good shape now.
Now the only thing left is a scraping/grinding sound coming from the driver's side brakes. I mostly hear it at low speeds (taking off from lights, etc).
When I was doing all of the other work, I observed that the rotor is in great shape, brake pads look great. I am wondering if it is a caliper issue, maybe the caliper isn't releasing enough or something. What to check?
View 9 Replies
I noticed that the driver side front wheel makes a metallic scraping noise while the car is turning right. It sounds like something scraping the rotor or shield behind the rotor ( a rotational/moving kind of scraping noise)
This only happens on a relatively sharp turn (wheel is turned 70~80% to the right). I don't suspect the power steering as there is no noise if the car is not moving even when wheel is turned to extremes. The scraping noise happens at any speed, as long as the car is moving. does not happen when car is turning left.
Note that I am 90% certain it is from the front... my ears may be playing a trick on me (kind of hard to listen precisely while driving). Where to start looking?
View 9 Replies
Was about three blocks from home when the front of the car started making a horrific metallic scraping sound as the front wheel turned. I mean LOUD. Did a quick look for something stuck in the wheels somewhere but nothing. It's not like a branch stuck in the wheel sound, but scraping a shovel on a steel beam kind of sound. Braking seems to change the makeup of the sound, but did not stop it. Parked it in the garage.
I pulled the left wheel off, looked and looked, and looked. Nothing. Fear and sadness setting in. Everything looked normal....except....a faint line on the rotor very near the inside edge. Got a mirror and looked some more, and there, wedged on the inside edge of the pad's metal part and the rotor, was a rock the size of a bb. At most. Got a small screwdriver and hammer and popped it out. Done. Sheesh.
Seriously it was so loud it was amazing. So store in file folder for future reference if needed.
The line can be felt barely with a fingernail and is half the width of a pencil lead, and goes under the innermost 1/8" of the pad. I'm thinking do I want the dealer to pull and turn it, or is it going to affect my braking at all. Pretty much gonna leave it be I think.
View 11 Replies
I have a scraping noise which sounds like it is coming from the front end but only around 10 to 20 mph. It can only be heard when driving down a quiet street, next to a building (mcdonald's drive through) or in my parking garage at work. Always makes the noise, it sounds like it something was scraping on one of the rotors.
Purchased car in August with 26,000 miles from a non VW dealer --- first mistake. Two days after signing papers showed signs of valve body issue. Took it to VW dealer near work and after two days they finally got OK to replace valve body and all is good. About 5K to 6K miles later started hearing the noise. At 36,000 the tranny started shifting hard and having problems up shifting occasionally, would rev up really high and then finally go into gear. Took 3 service visits for the same dealer to be able reproduce it and then they finally figure out they left out 2 liters (their calculation) of fluid when doing the valve body, so it got driven 10,000 miles while 2 liters low. They basically acted like they were doing me a favor by adding the fluid they left out in the first place and said only time will tell if there is any damage.
Took it back to the same dealer again for the scraping noise. Supposedly 3 people drove the car and never heard the noise. CEL came on yesterday and I decided to try a new dealer and have them look into the noise while it was there. Did a ride along with the service writer and tech. Writer is pretty sure he heard the noise and tech wants it back after the holidays to road test more and try driving in some quiet areas.
It has been determined that the car does not make the noise if there is no weight on the front end. I have jacked it up and spun the wheels and first dealer claims they had it on the lift in drive and could not hear. New dealer is thinking bearing noise that is only heard when bearing has weight on the front wheels or something to do with the CV axles or something in the tranny. If it is the tranny well we know who's fault that is.
View 1 Replies
This summer I replaced the inner and outer tie rod ends on a 97 Nissan Altima, had a bent wheel replaced, and had an alignment done. Everything worked smoothly for the last 5,000 or so miles. I had my tires rotated and balanced recently which created a new problem, a shaky steering wheel most noticeable at slow speeds. I've had a similar problem before and had it fixed by balancing the tires. I took it back in to have them rebalanced, thinking they may have forgotten to do it the first time. They rebalanced them and the problem has not changed at all.
View 3 Replies
