When I start the car and get the Ready light, I try to shift into P or R, or anything, it doesn't shift. Then it beeps once. I've tried turning everything off. Exiting, locking, unlocking and retrying.
I get the Ready light and the gas engine even starts, it just won't shift. But beeps once after I try to shift into any gear.
2nd time I've had this problem. With the car turned on "ready light" on, the car will not shift into D. It just stays in park, and yes my foot is on the brake. I've tried to reset by turning the car off, turning it on again and shifting into D, still no luck. By retrying this over and over it finally goes into Drive and away I go. I've had the car for 3months and 5k miles, and this has only happened twice.
The second time occurred when I was stopped by a flagman at a road construction site. Instead of shutting down, I just pushed the park button. The lights were on, the radio playing and my garmin was plugged in and the AC was on, would the high load have caused the problem? When I pulled the plug on the Garmin, the car went into gear on the next try, but I don't know if there is a cause and effect. I finally got it going after about 25 cars had to go around me and the last car was passing me when it finally went into D.
Everything was working fine until I started messing with camera settings in the service menu today . Now when I shift into reverse, it says "system not ready". Will not let me parallel park or reverse park now. I tried to reset the settings but maybe I don't know how to "save" settings.
View 5 RepliesWhen I put the car in ready, the car will beep 3 times. It's like, foot on brake and press start button, then car shows ready, at the same time it goes chirp-chirp, then beep beep beep. I'm just wondering if the 3 beeps can be turned off? I didn't find any thread regarding this beep. I did find many about turning off the seat belt beep, reverse beep, etc. and I already turned off those beeps.
View 3 RepliesI have a problem with the ipa on my Prius, it used to work fine and I admit I hardly ever used it, I tried to demonstrate it yesterday and when I press the button all I get is 2 quick beeps, nothing on the screen comes up.
View 1 RepliesAbout once a week our 2011 Prius will start, but the "Ready" indicator does not come on and the car cannot be shifted into drive. Once this happens it takes several attempts, turning the car on/off, until it finally comes on "Ready." I cannot create the problem, but it may stem from pushing the start button before the brake is fully depressed.
Last night it took more than 5 minutes to get it going. I "reset" the car by exiting, locking, and re entering the car. Then it worked, that procedure caused it to work.
Today, I was parking the '05 Prius and noticed the gear shift stuck in the drive position instead of the usual "pop back" you experience when you put it in drive. The park button woud not engage. The same thing happens in reverse.
The dealer said they have had to replace the gear shift on a bunch of cars with this sticky gear shift problem.
I have a 2004 prius that sat for 2 years, I just replace a cell, worked on the HV battery and made sure it was balanced. I got the battery back in and I can't get it to go into Ready mode, I can get it to ignition on and charge the battery and into acc. I've checked several components to see if they were causing the issue.
- 12v battery is good
- brake light switch seems to be good as the lights come on when the brake pedal is pressed (but ready mode does not)
- I've checked a number of fuses
- used and obd2 adapter with torque and it is not coming up with any codes
-Edit-
- 12v battery was replaced last spring and has been maintained
My 2005 Prius won't go into READY mode. This has been happening for many times now almost a month. Up until today if I let it sit there for a while (sometimes a couple of hours) it would work eventually, however, starting today it just does not want to go into READY mode. One thing that I have noticed is that when I press the brake pedal the brake lights do not turn on. I have been suggested that it could be the Stop Light Switch that causes it, and one way to check was to perform the following procedure:
(1) Push the P position switch.
(2) Parking brake pedal is depressed.
(3) Turn the power switch from off to on (ACC)
(4) Brake pedal is depressed.
(5) Press and hold the power switch for 15 seconds or more.
According to Vincent if this starts the car then it is the Stop Light Switch but I was not able to start my car even with this procedure (may be I am doing it wrong.
Note: I have checked the 12V battery and it is not the problem.
I measured battery on my 2007 Prius by MDF, it's only 11.9V, charging is about 14V. When I turn on ACC mode, and Radio is on, I think it shut down the radio after about 15minutes; I cannot put the car in ready mode after it shut down. I have to jump it in order to put in ready mode. Is it my turn to replace this auxiliary battery?
View 19 RepliesI have 2004 Toyota Prius 110k miles on it. New auxilary battery on it. VSC, Brake and Red triangle lights are on. The car wont start. System comes on, but ready light doesn't not appear.
If I discoonect the battery for a minute and connect it back, I am able to start and drive it. After a minute VSC, brake light comes on. I still can drive the car and it drives perfect. As soon as I shut it off, I won't be able to restart it again. I have to disconnect the battery for a minute to get it started. Inverter pump seems to be working fine.
I got the codes with the paper clip VSC 43, Brake 36. After resetting the codes, I drove the car and now it throws VSC 51 code.
Check engine light is not on. When I checked with OBD scanner, it does not show any codes. When we checked with shop's scanner, there was a code smth "LOST COMMUNICATION WITH HYBRID..."
I replaced the HV Control ECU on my 2007 Prius, because my coding scan read POA1D. Now the lights on the dash all light up, but the Ready light does not come on.
View 1 Replies3x in the past few weeks it has taken 10 minutes or so to start the car. the ready signal just doesn't come. All the dash lights come on too.
View 5 RepliesIm having some issues after swapping the engine on my 05. The swap went well and i hooked everything back up the way it was. I have triple checked every connection. If I am missing one then it is hidden extremely well.
I reconnected the HV and Aux batteries but the car will not go into ready mode. All the warning lights come on and the screen shows problem!
The inverter coolant pump is running, my basic obd2 scanner shows no codes.
I recently changed out my 2006 blown gas engine with a great running 2008 engine and also replaced the hybrid battery. After connecting everything, my car won't start. All the lights come on except for the ready light. Does something have to be reset?
View 13 Replies2007 Prius
I just replaced the 12V battery with an Optimus yellow top. The car still will not start. All dash lights come on, READY light does not. Car will only shift into Park and Neutral.
Battery reads 12.6 volts when not hooked up and 12.3 when cables attached to terminals.
Thursday afternoon I drove about 120 miles total in my 2004. At about 40 miles I left my wife to shop and drove on to 3-4 other stops for myself and then came back to pick her up for the 40 mile drive home. When she got into the passenger seat, she found that the carpet & mat on the floor were sopping wet, so we put some heavy towels over the wet area to protect her shoes. When we got home (with NO operational issues), I removed the passenger floor mat, put several thicknesses of more heavy towels on the carpet and placed 2 concrete blocks on the towels to soak up the water.
On Friday, I changed the towels and did not use the car. Saturday, I removed the towels, concrete blocks, and went to start the car so I could see if there was water dripping from under the dash from a plugged condensate drain, since I had not driven in rain or water on Thursday. The dash displayed every warning light imaginable including "check engine", hybrid system warning, slip indicator, brake system warning, Master warning (!), VSC, Maint reqd. Now it is Sunday and I still cannot get to the "Ready" light so I can start the car. My traction battery condition was solid green yesterday, solid blue today. The radio, interior lights, A/C fan, door locks, etc. all work.
Could there be anything under the passenger carpeting (or behind the dash which might have gotten wet which could be causing these problems/codes?
I have a 2006 Prius that is giving me fits. The car is equipped with the smart key but it seems to be working normally. I insert the key, press the brake, and then press the power button like I am supposed to but the "ready" light doesn't come on and the car won't start. I checked the brake light switch and it is working correctly. 12v battery is charged and shows 12.35 volts. I have been tinkering with the car for the past three days and have only gotten the light to come on and the car to start twice out of the numerous tries.
The last time it started the dreaded "triangle" and check engine light were on so I plugged my scanner in and got code P0A1F, I had a spare battery ECU so I replaced it, while I was at it I removed the battery and cleaned the terminals, there was only a very small amount of light corrosion on a couple of cells. All cells tested good and had uniform voltage. I haven't gotten the car to start since putting everything back together. I have a small amount of experience with these cars but I've got alot to learn.
We just replaced the Traction battery in my 2004 prius. The car has 242,000 miles on it and was running fine when we pulled it in. The battery was purchased used from a 2005 prius with just over 80k on the clock. The replacement battery was removed from the wrecked prius less than a month ago.
The problem is that after installing the new traction battery, every thing looks great except the Ready light will not come on. There are no warning lights except the little red light that indicates there is no key in the car. The key will remotely lock and unlock the car so I'm sure the battery is not dead and the no-key light stays on even if I insert the key into the key slot on the dash. The shifter will only move from Park to Neutral.
What am I doing wrong? Is there some special procedure to go through to make the car recognize the key after replacing the battery?
At times my 08 will beep when I open the driver's door and I have the keys in my hands. The only thing I can assume is that it thinks the key is still in. On occasion this has caused my battery to go flat.
To stop it I just go through the sequence of putting the key back in, put it in D then P then foot on the brake and the off/power/start button, it took me 5 goes to get it back to normal tonight.
Receiving three outside beeps while driving. Happen about every 3-5 minutes. No warning lights are on. All doors are closed. Keys batteries were replaced a few months ago.
View 3 Replies