I got in the car (2010 Prius IV, 170k miles) this a.m and the brake, ABS, & stability/traction control lights all just lit-up. Can run & drives just fine.
View 19 RepliesEvertime I turn left the brake light, traction control and stability control lights come on and the car starts dinging. Mechanic says it could be front wheel bearings because they are tied to the ABS system??? But I have been seeing alot about wheel speed sensors?
Second, everytime I brake suddenly, a cloud of smoke comes from the front end and there is a burning oil smell. The oil is fine and no leaks. Again mechanic says it could be a cracked CV boot throwing grease?
Lastly everytime I put in reverse or when I lightly put pressure on the brakes when driving I get this noise like a humming (errrrrrr) noise. Its not the grinding/squealing noise you would get when brake pads needs replaced. I only have 60k miles on this.
When I am at a full stop, such as waiting at a stoplight, and I press hard on the brake pedal, the stability control light flashes on the instrument panel.
View 6 RepliesI had not driven the Prius in a few weeks, and even then, that was for less than five miles, and had the low tire pressure indicator come on late last week when the temperatures cooled down, which I fully expected given my opportunities with the Toyota Dealer properly inflating tires. We were away for another week and returned today and I decided to check the tires and add air, and in addition to the tire pressure indicator, the ABS, Traction Control, and Brake Indicator lights were on. As soon as I filled all the tires to the specified PSI, that indicator disappeared but the brake related ones all stayed on.
View 10 RepliesStarted my 2010 Prius the other day and the traction control, brake light, abs light and a yellow Astrix light came on and wouldn't go off. The car drives and handles just fine, brakes feel normal. I have tried resetting the lights with a trick with a paper clip someone else posted, but it didn't work for me.
View 7 Replies2006 Camry LE 4cyl ABS no stability control, rear drum brakes. The brakes stop the car, but the pedal does go to the floor and it doesn't brake with confidence.
Prior to the repairs everything looked normal (aside from one wheel cylinder, see pic) and there was no leakage. The fluid was at the proper level though dirty.
I replaced the master cylinder and did a complete fluid flush and bleed. I also changed the front pads (it was time anyway) and the passenger side brake hose. I was going to to both hoses, but I wound up snapping the steel line on the PS and spent most of the day dealing with that. I decided not to press my luck with the DS.
I might change the DS hose, since I already bought it. At this point the only thing left is a weak caliper or wheel cylinder seal, or a bad hose (though I don't see any visible bulging when brakes are applied).
My wife was driving on the freeway last week and she applied brakes but they barely stopped the car and the brake light came on. She was able to limp it home without incident but the brake light stayed on and the car was braking poorly. The next day I inspected everything and found no leaks, and the fluid was not low but it was dirty. I drove the car and noticed braking performance was lacking (though it was never great to begin with) but I never saw a brake light. The brake light isn't on at this point.
2009 F-150 FX4 SuperCrew 4X4 5.4L
My ABS and stability control lights are on. I had the codes pulled today (listed in order):
1) C1298 (Right Rear Wheel Speed Sensor Input Signal Fault)
2) C1165 (Right Rear Wheel Speed Sensor Input Circuit Failure)
3) C1963 (Stability Control Inhibit Warning)
4) C1299 (Left Rear Wheel Speed Sensor Input Signal Fault)
5) C1175 (Left Rear Wheel Speed Sensor Input Circuit Failure)
I'll ignore the stability control code for now since I'm sure it is tied to the speed sensor errors. Anyways, I decided to inspect the rear wheels and I found this sucker just hanging beneath the right rear brake caliper:
Is this a speed sensor? Where does it plug into? Diagrams would be extremely useful! I am planning on ordering 2 new sensors for each rear wheel but I don't know where to begin.
I have a 2009 Pontiac Vibe with 43,000 miles. Recently the check engine light, the vehicle stability control light and the traction control system light all came on simultaneously. Since then they have all come on or all gone off several times. Usually once they come on, they stay on for the remainder of the trip. Sometimes they will still be on when I next start the car, sometimes they will be off. What might be causing this?
View 17 RepliesYesterday, my vehicle stability control light came on along with the ABS symbol. I stopped the car and turned it back on and the car would not come out of Park.
I restarted the car and was able to shift into drive but, both symbols remained and the MFD showed no regenerative braking and the brakes were clearly mechanical only by sound and feel.
I think I took a rather short trip with the parking brake partially engaged, I was talking to my son who was home for the weekend.
I set and released it several times with no results. I finally parked the car, set the brake and checked for codes in my Scangauge-none. But, I did a "clear codes" anyhow.
I've only driven home yesterday and this morning to work. So far, nothing unusual, I have my fingers and stubby little toes crossed.
We started having problems first with the car dying at stops, and having to be restarted. We had the oxygen sensor cleaned, and it stopped that problem. Then my ABS lights came on, and my cruise control stopped working. When the car was cold and I tried to take off (forward or reverse) the rpms would not go above 1000, and the car would only move like it was idling. I read in a closed discussion on this forum that it was the stop light switch under the brake pedals so we got one and changed it out. Same problems.
So we thought we had a bad one, so we exchanged it, and the tech at the Auto Parts store said "Maybe you have a fuse out." We changed the stop light switch again, same problem. We found a blown fuse marked "stop light." It is a $2.70 fuse, 10 amps. We put it in, and the brake lights worked. I planned to put it in the shop the next day, having read that it could be the air inlet sensor, the throttle body needing cleaning, the transmission, the transmission fluid....anyway, I had to go to the store this morning, and the ABS light was out, the cruise control was working, and the car no longer ran in "limp mode."
Before you do anything else, change the fuse!
My 2010 Prius (130k miles) has recently started beeping on curves, turns and braking on occasion. The red triangle also comes on. There is no problem otherwise. It is a bit annoying. What is the cause of this? Could I have the beep turned off?
View 5 Replies2010 Prius 98,000 miles - No Accidents
I was driving on the freeway cruising about 65-70mph.. Not using the brake at all. All the sudden the car starts beeping loudly with the Brake light going off, traction control light going off, and the ((!)) light as well. So I wanted to pull over to the side and realized my brakes were not working . It was the same as if you're trying to brake the car when the car is turned off. I slowly pulled off the freeway. Tried to reset the ECU, battery, everything, thinking at the traction control is just going crazy.
I have recently had a problem with my 2004 Prius - the brake lights came on while I was driving (both the red exclamation mark and the orange exclamation mark to the left of the speedometer) ...
The Toyota service center told me that I need to replace the skid Control ecu - the part number that they quoted is 89540 47050.
No cruise control, ABS, Brake and skid light on (Prius 2010).
View 12 RepliesI cant find any info on this for the B6..
Is it just a standard LSD?
Is there any way to completely disable traction and stability control. I know pushing the button is supposed to disable stability control but I was told that you can't actually completely disable it.
View 5 RepliesMy college son's 2014 Charger V6 has developed three issues since he purchased it used in late May. The cruise control has stopped working and the anti lock brake and traction control lights are constantly on. Any possible cause?
View 15 RepliesSo four lanes, divided, with a left turn lane, five lanes at the intersection. I'm down ~15 mph, maximum turn speed and one car is just clearing intersection and and +100 yards from next approaching slug of traffic. Keeping the speed, I make the left turn confident no problem then halfway through turn:
feels like a soft tuck
traction light flashes
already to straighten out
everything normal
This is the second time I've seen this in a year. Pavement dry, 48 hours since last rain; ~8:00 AM so rush hour is on. Before doing some parking lot tests, any clue about how to replicate?
My dashcam SD card did not play.
VSC, VCS OFF and Check Engine Light .... all came on a few minutes ago while out for a Sunday afternoon drive. Depressing/releasing the "VSC OFF" button multiple times did nothing. All 3 lights now stay on. Checked the manual which said to take in to Lexus dealer asap but could continue driving....something about vehicle stability control system not activating.
View 8 Replies'13 Sonata GLS w/ 4100 miles - when snow was on the ground 4 days ago, the ESC symbol would occasional flash indicating loss of traction (I was sort of pushing it around some corners for fun) and it seemed to correct throttle, etc. - everything working as it should.
Then yesterday on the commute home with nothing on the ground the light came on and stayed on while driving local & highway. This morning's start-up it was gone. Commute home and it came on again 5 minutes into the drive. But again another restart the light doesn't stay on.
I tried reading codes with an OBD scanner but it says NO CODE - the light is currently off, but was hoping it stored something. Manual says possible ESC malfunction if the light stays on, but it's been erratic.
Ok well I am not much for roasting the tires anymore but like to wheel a little, but how in the heck do I turn off the traction and/or stability control? Never done it before.
View 4 Replies