Prius (Gen 2) :: Error Code C2310, C2318 With Warning Lights Appeared
Feb 8, 2016
I actually just bought a used 2004 Prius with 207,011 miles on it from out of state. I had a car shipped to me by a flatbed trailer. I just got the car the last weekend. However, It has a yellow engine light and a big red triangle with an exclamation mark (!) on a dashboard, and a red car with ! on top left of a display screen.
I drove it to a DMV to get it registered and took it to Pep Boys near my place since I have to get it an emission inspection within 10 days of registration anyways.
They ran a diagnostic test and found 2 current error codes (C2310-open/short in battery circuit & C2318-low voltage error) and 1 history code (P0A80-hybrid battery pack needs replaced), so they didn’t perform the inspection; otherwise, it would have a failed record). They told me that the car has had problems before and the problems are about a hybrid transaxle and a hybrid battery pack. They also told me that I need to visit a Toyota dealer to get them fixed in order to pass the inspection, and they warned me that is going to cost me a large four digit probably . So, they suggested me to just trade it in because it is not worth repairing. They also told me that a dealer who sold me the car probably would have done something to the car, that’s why it didn’t illuminate any warning lights before.
I tried to gather as much information as I could, so I asked the shipper if he noticed any warning lights but he didn’t think so; one thing he noticed was the hybrid battery isn’t charged because the engine started every time he moved the car.
I plan to take a car to another auto shop near my place as well in order to have them double check the issues and give me a repair estimate before taking a long trip to Toyota dealer.
View 6 Replies
Advertisement
Bunch of warning lights appeared and the dealer said it's code P0a80 and they recommend replacing the battery. I'd like to try to fix this myself and would like to hear your thoughts...
Plan is to check the traction battery for corrosion and use a voltmeter to test the cells and replace if needed. Prius 2004, 158,000.
View 15 Replies
I just bought a used 2008 Prius. I had my Prius inspected after buying it, and the error code C1378 appeared, which I have discerned refers to the Skid Control ECU.
There is apparently a recall for this part in 2010-2014 models, however as a 2008 I don't think I apply.
View 6 Replies
My partner drove the Prius with 54,000 miles to work this morning as he always does. So he is on lunch and sent me a text saying some warning lights appeared on the dash while he was sitting at a red light. I asked if he had any loss of power, if the battery fan was running, he said it drove normally. We bought it last summer with 44,000 miles from a Toyota dealer. They said it had a new inverter pump. It has the original 12v battery however. Though it doesn't act weak at all. No issues this winter at all.
Note, the battery in the photo is at 1 bar. I asked him about it and he said he was driving aggressively to work today, which includes a 2 mile 6% climb he said he made at a high rate of speed... Though after the exit, he has another mile to work.. So the battery should have built itself up before him parking it.
View 19 Replies
2005 Gen2 with 216k miles
Driving on highway and accelerated to pass a vehicle, sudden slow down and all warning/error lights went on. Pulled to side of road and used Autel 539 to get codes P0A78 + P0A90. Scan code reader does NOT display the INF codes, so I can not get them.
Turned off vehicle and restarted. Put into drive and it appeared that I could move forward (and reverse) and was apparently running strictly on the ICE - no power coming from the DC motor for assist. HV battery would charge as driving down road.
It was slow moving, but as long as I was accelerating (very sluggish!) was able to move forward. If I took foot off gas pedal then ICE stopped running and would not restart when pressing on gas pedal.
View 19 Replies
As far as the owner can tell, the car is running fine. He hasn't driven it aside from getting home after the light came on. It seems to give a very informative error message. What it's saying?
View 4 Replies
Car is a 2000 Passat Wagon 1.8T ATW FWD
I get the P1128 code and Emissions Workshop warning most of the year, then it cycles off in the summer. It went off yesterday, back on today, and I imagine it will go off again for weeks/months as the weather heats up.
Things I've tried so far:
Replaced MAF sensor
Replaced MAF wiring harness
Replaced front 02 sensor
Replaced air filter
Replaced cracked vacuum tubes, at least those accessible from the top. Some of the hidden lengths theoretically could be at issue but a mechanic said they were ok.
What I've not replaced is the secondary air pump. (Mechanic told me it's dry and checks okay.)
View 5 Replies
Today I had the joy of covering 200+ miles on my W12 today. While I was out and about there were 3-4 times I went around a right hand turn somewhat quickly and a "check please lights" warning appeared on the instrument cluster. At the end of the day I inspected the exterior lights with all working or so it seems. I found it odd that this only appeared during sharp turns to the right.
View 10 Replies
Have been having cascading problems since installing PIS 10kWh system in April. Early system shutdown, failed BMS boards, then triggering of Prius warning lights. The latter required disconnecting the 12v battery to 'reboot' and cancel them per Robb of PIS. But then, when attempting to do an electrical load test using air con & other accessories, we triggered several yellow warning lights that do no go away with a reboot. Have been told that we need to have a dealer read the codes to troubleshoot.
Read more: [URL] ....
View 11 Replies
2003 Prius. Situation as follows:
Malfunction Indicator Lamp lit on start-up during sub-freezing weather for failure to start (P3191 and P3101 codes loaded). Occurred twice (so far).
Dealer diagnosed as possible fuel pump problem, though fuel pressure nominal and held pressure after engine shut-off.
Independent mechanic (using EG011-03) diagnosed following:
Diagnosis codes: P3191 (engine does not start) and P3101 with information code 205.
Circuit opening relay was fine.
Fuel Pressure was normal (~45 psig) and held after engine shut off.
Coolant temperature - 9 deg C
Engine RPM - 1200
MG1 Torque value - 0
Installed ECU Part Number - 89661-47053, calibration # 14705301, 14705302
EG011-03 decision tree leads to replace Engine Control Module with newer part number.
Took back to dealer, who indicated still possible fuel pump problem (and reluctant to replace ECM).
View 4 Replies
My car is a Prius Plus 2012.
One day, I decided to go to a mechanic to clean the EGR pipe. Only the pipe, not the whole EGR. It was an extremely simple operation a mechanical one, not electrical etc. Starting from that day, when I go with the car, from time to time, check engine lights up. For a fraction of a second to up to 2 seconds then it disappear.
The car behave itself without a problem. But still the on-off check engine is really annoying.
So a went to the dealer. Put the car on tester.
Result: no code error !
I went to another garage , put another tester on the car, no error..
How can I actually see what the error is if nothing is stocked in the ECU of the car?
View 4 Replies
My car was working fine except for occasional no dash lights. Unfortunately where my dash lights don't work sometimes I can't see my gas gauge and I ran out of gas today. I manage to make it to the gas station on battery power I presume. Filled the tank up with 11 gallons and the car seemed to work fine for the remainder of my trip(about 5 miles). So I parked at my destination and went inside for 30 minutes and then I went back out and started the car. I attempted to clear the out of gas error code and all of a sudden a whole Christmas trees of lights popped on my dash. I rescanned and these codes were read out
U0293
u0100
u0111
u0293
p0a1d.
History : I had the coolant pump inverter changed 2-3 months ago by a mechanic and hybrid battery and battery ecu changed 2 years ago by myself.
View 9 Replies
I recently replaced my engine water pump at 164,000 miles on my 2007 Prius, the car sat for 3 weeks while waiting to gather needed parts, i.e., water pump, coolant and Airlift system for adding coolant fluid. After installing the new water pump the car ran rough for 5-10 minutes upon initial crank (parked for 3-weeks). I took a 20 minute test drive around the neighborhood that evening, outside temperature around 65 degrees F, and car ran fine. SOC looked ok, bars moving between Blue and Green, everything appeared normal.
The next morning, I backed out of my driveway and the Red Triangle of Death appeared on the dash so I parked the car.
That evening I hooked up OBDII ELM327 scanner using Engine Link and picked up 2 separate P0A80 error codes, 1 of them was pending. I disconnected the Aux battery for 3-5 mins to clear the error's, Red Triangle of Death was cleared, then drove the Prius for 20 minutes with no errors or alarms. SOC seemed to be normal. OBDII ELM327 scanner showed the HV batteries were charging at same level, 16.8V and Aux battery was registering at 14.0 Volts.
The next morning, after 20 minutes of driving the Red Triangle of Death appeared, and shortly after I experienced loss of power, with sporadic engine idle and interior traction battery fan was on. Luckily I had made it to work and was able to pull into a vacant parking lot.
I did notice that around the time the Red Triangle of death came on this morning the SOC dropped quickly to 1 Purple bar and was slow to charge then shortly after came the loss of power and sporadic engine idle followed by interior battery fan.
View 16 Replies
My 2007 Prius with 176k had the warning lights on the dash. I finally got the code read and it is the P0A80 code. The 12 volt battery seems good, it is about a year and a half old or so. That was the only code.
View 10 Replies
I have a 2005 Prius with 240,000 miles. About 4 months ago the triangle warning symbol appeared. A friend and I decided to pull the big battery out of the car and find the bad cells. We did that, replace two and the car worked fine for 4 months. The triangle warning has returned. We have done several things but the triangle remains. We pulled the big battery out and checked all of the cells. We replaced one that was probably OK. The latest reading was 8 volts on cells all but one at 7.9. We cleaned all of the bus contacts. We went into the maintenance mode on the MFD and found the aux battery to be 12.6 volts and under load it dropped to 11.8 with the lights on.
The aux battery went up to 14.1 volts with the car on. The inverter cooling fluid has movement and there is a slight humming which I believe to be the inverter pump running. The inverter fluid was topped off. The MFD showed the battery bars start at about three fourths full, drop down to one bar. With the engine running the battery bars climbed to the top purple. The engine turned off and the bars continued to climb to all green. All of this occurred in about 3 minutes while the car was parked. There were codes on the MFD while in maintenance mode. I understand that these codes are for the navigation system and the audio system.
View 17 Replies
Gen II Prius, 151000 miles, HV battery died (rapid charging / discharging, cooling fan on high constantly, etc) Installed remanufactured HV battery. Connect it all back up, test drive, get the triangle of death, VSC, amber (!), and MIL on MFD. Car continues to drive normally until shutdown, upon next startup lights still present and won't shift into D or R only N. Pull codes, POAA6 is showing.
Code doesn't reset with car in ign on (not ready) after 60 seconds, make car ready and shift immediately to N. Code resets after 30 sec. Have done this trouble shooting 4 times and code always resets with ready on and in N. This points to the HV 'leak' being either in the wiring harness or the inverter. What I can do next in order to figure out which one?
View 5 Replies
Driving home today, my prius threw the triangle and all the other warning lights. Scanned with my scan gauge got code u0100. I was only a mile from home so attempted to drive it. Car made it 1/4 mile and then died. I had it towed to the house and checked the grounding wires going to the engine and transaxle. The Tranaxle grounding wire was loose so i pushed it together tightly. The car now runs on main battery only, the ICE does not fire up. All warning lights are still present. Nav screen says problem. 12v is good.
View 15 Replies
I bought an '04 prius about a month ago and it has already been at Toyota for over a week. It get's the red triangle, the yellow brake light, and the hybrid red car on the screen and says Problem! I took it to the dealer and he pulled the codes P3009 and info code 526. When you open the hood, the inverter overflow tank is boiling, so it must be overheating. I have read about the pumps going out and when the engine is cool there is turbulence in the overflow tank.
The guy I bought it from did say he had replaced the water pump recently. Toyota kept it for a week trying to replicate and couldn't, and even had the regional rep look at it.
View 19 Replies
I am a technician and my boss owns a couple of prius taxis.
One of them had the code to replace hybrid battery pack. After checking all the cells and they were all in spec the code came back every single day so he bought a new hybrid battery pack. After installing the new battery pack The car won't go into ready mode with the message check hybrid system.
The code that comes up is P0A0D about the service safety plug. It is plugged in properly pushed all the way to the right and so on. The 120 amp fuse inside of it is good I have tried everything I can think of.We had another 2010 in the shop I tried changing the service safety plug, engine ecu, hv ecu, all to no avail with the same problem.
View 8 Replies
My 2006 prius has the Master warning light(red) and the braking system light (Yellow) on while I am driving, and I went to the dealer.
The technician told me that he could not verify any warning lights ON at that moment, and he performed health and diagnostic checks on it. He inspected connection at auxiliary battery and junction box 1. All checked OK at this time. No repairs recommended at this time.
However, the master warning light came on when I pick up the vehicle. The dealer told me that they will inspect it again tomorrow. And they found that there a P0A08 error code. They suggested me to replace the hybrid converter/inverter.. My car can still drive while the lights ON.
View 18 Replies
I keep getting the C1344 and all the lights. I checked and changed the rear shoes and the light keeps coming back, although not immediately. It takes just a little while.
I didn't notice any signs of leaking fluid, though I was able to squeeze the LH wheel cylinder in pretty easily by squeezing on the top of the shoes. The drums were not scored and were in spec so I didn't turn them. I never cracked any brake lines loose.
View 9 Replies
