I have a 1999 Dodge Ram 1500, 5.9L. My problem is it will not idle until the engine is fully warmed up. When I first start it, I need to keep my foot on the gas, if I let it go it dies.
View 1 RepliesThe car: 1994 toyota celica GT 2.2L automatic
Here's the problem: car starts fine when cold. When fully warmed up, if i stop to go to the store or something, and then start it after like 20 - 30 minutes it will start and the idle will be fluctuating between 800 and 400 for a few minutes and then even out. sometimes it will actually start up and die immediately, in which case i can save it by giving it gas for a few seconds and then it's fine.
What I've done so far: plugs (NGK), wires, cap, rotor, fuel filter (toyota), (checked air filter. still clean), tried cleaning the throttle body and IAC with some deep creep spray while on the car (not much effect).
2005 F250 6.0L ... My truck is running really rough when the engine isn't all the way quite warmed up. once the truck is fully warmed up to normal running temp it runs good. I am getting four engine codes. P0672, P0673, P0674, P0676 These codes say 2,3,4, and 6 glow plugs have a open circuit. Can this be the cause of my problem?
View 7 RepliesAbout a week and a half ago I took my 2008 ISF to Lexus to have them check out the ticking noise. My car has 63K miles on it and I notice the ticking noise after it is fully warmed up. I normally have just been driving it in Sport-Manual too. The sound seems to come from the driver's side fender well area and I hear it best when it is in drive in my garage or at a drive thru.
At first Lexus couldn't duplicate the sound even after driving the car. So I went to the dealership and drove the car about 10 mins for them to hear. The service advisor and a technician heard it this time. They had to call the regional Field Technical Service rep for direction on how to proceed. The FTS person recommend swapping the driver's side high pressure fuel pump to the passenger side to see if the noise followed the pump. I guess they've had problems in the past with the high pressure pumps on the LS models. I again went down to the dealer to drive the car and the noise stayed on the driver's side.
OK--2001.5 1.8t Tip, 85k, nothing but Mobil1 since day one religiously. At around 81k miles the t/belt tensioner seized & let the belt jump and bend a few valves. Had VW do the repair under the p.t. warranty. Engine now runs very well again except there is a knock noise that sounds an awful lot like a crank or rod bearing. The noise is worse with the engine fully warmed up and in drive or reverse. Took it back to VW, they said it's a bearing in the a/c compressor. Sounded like B.S. to me, since the noise is no different with or without the a/c on. I picked up the car & removed the a/c belt at home & found the noise was exactly the same. I've about had it with VW on this issue. Been back 3 times with the noise complaint, & the noise is getting worse!!
View 1 Replies3.5 has engine knock coming from oil pan, gets louder when engine fully warmed up. Suspect connecting rod bearings. 99 Intrigue has 203K on it and otherwise in excellant condition. Is it possible to replace connecting rod bearings with engine in car. What is involved in removing lower crankcase after oil pan is removed. Car has been trouble free so far and would like to get another 60K out of it
View 5 RepliesOver the past few week my truck has developed a knock once it has fully warmed up. At first I thought it was possibly injector knock and kind of got excited about the prospect of upgrading to larger injectors. Well, my short lived optimism came to an end today once I got ahold of my father's mechanics stethoscope. So today I let it fully warm up and like clock work the knock came back. After going over nearly every inch of the top end, nothing was producing what I was hearing.
So I crawled under the beast and located the source. Right where the bellhousing mates the the engine block is where the knock is definitely loudest. At first I thought it was louder in while in gear but today it didn't matter if it was in gear or not. I removed the bellhousing cover and inspected what I could see of the flexplate. Couldn't see and cracks or breaks but from what I see through google searches is that it cracks behind the spacer. Now my first thought is that it's the flexplate but I'm hoping more experienced people can tell me what they think.
[URL] ....
So, about 6 months ago, I bought a 1999 Dodge Ram just to keep around the house to do odd and ends jobs. Not a daily driver. I might have a need for it every few months. Well, a few months ago, I went to start it and the battery was dead. I have a battery charger that tests the battery. It said the battery was bad. So, I bought a new battery. A few days ago, I went to start it... again with the new battery, it was dead.
Put the charger on it and it said again that there was a shorted cell in it. So, I returned that one under warranty. Now went to start it, dead again (a week later.) So, I guess it's obvious it's not a bad battery (or at least the bad batteries are a cause of something else wrong.) I'm guessing there's a slow drain somewhere in the truck. How to find it?
I don't know if this has anything to do with it... Ever since I've owned it, every once in a while when driving the truck, all the gauges on the dash go to 0. Then it will just randomly start working again. Don't know if that has anything to do with the battery dying problem.
My wife's RX is really starting to give me a headache. The first problem I'm having with this car is detonation. The car starts pinging at part/ light throttle once the engine is fully warmed up. The is no CEL or codes pending. After scanning the car it seems that fueling is right where it should be and nothing else seems out of order. The pinging stops when you hit the gas harder. So far the only way to rid the car of this problem is to fill with 93 octane and that gets expensive with a daily driver. Shouldn't the knock sensors be handling this? Is there a way to test them?
The second problem I have is the heat won't turn off. Hot air always comes out at what seems to be low fan. I can move the area it comes from ( dash vent, floor etc) but I can't turn it off. With the fan set to off and no settings chosen I still get heat.
The car currently has 78k miles on it
'92 Dynasty is a good runner, but, once the engine gets warmed up, I shut off the engine at my own risk. If the car sits for a while with the hood open, it will start again, but attempting to start immediately after shutting off will result in the engine spinning over but no sounds of attempted ignition. It seems that once the coil is cooled down to slightly more than body temp the engine will start like nothing was wrong.
View 3 RepliesAbout two weeks ago i had a ton of work done to my W100: clutch, freeze plugs, valve seals, body mount bushing, headers, x-pipe dual exhaust. The shop did tell me before i picked it up that it had a lean pop and the carb needs to be rebuilt.
as of now, it idles fine and drive fine when cold, as it starts to warm up it starts to become problematic - it feels like the engine stumbles any time you try to maintain a constant speed (slight throttle engagement), it accelerates fine, but that's about it. You have to drive it in a constant state of accelerate and foot off gas because it does not like you foot on the gas pedal just a little. if you do keep your foot slightly engaged it will stumble and the exhaust will pop - not so much a backfire as there's not at jerking.
-both coolant sensors are new
-spark plugs are FSM spec champion copper 404/rn12yc
-plug wires are a year old (msd cheaper line)
-timing seems fine (around 8-10 BTDC)
-watched at night to try to see if any arcing was happening, none that i could see or hear
-finagled some exhaust restrictors on the exhaust tips out of rubber plumbing couplers and big lag bolt washers to try to recreate the backpressure from the old exhaust, no difference
-went around the vacuum lines with carb cleaner and propane, couldn't find any distinguishable leaks
Fuel filter about a year old- new fuel pump installed while at shop.
Have a heavy steering feel on their 2010's with the 215 45/17 tires? It seems much heavier than previous Prius's and also have noticed that mine when it is really cold the steering wheel gets a little twitchy until it is fully warmed up.
View 12 RepliesI've got a1994 dodge ram 1500 with a 318 cam bearings are good new oil pump new oil pump drive pin getting oil to the filter and that's as far as it gets no oil pressure and no oil to the top end? Me and a couple engine builders are stumped!
View 1 RepliesMy Uncle has a 2001 Dodge Ram. He has bled the lines and the calipers have released. But still ABS light will not go out?
View 10 RepliesI have a 1998 dodge ram 1500 5.9 the ac blows hot I've replaced the ac compressor the evaporator and the accumulator I even did a ac vacuum on the lines their are no leaks.
View 13 RepliesWhen car is fully warmed up, I notice in Sport+ (manual mode) when accelerating in 2nd gear right around 2000-2200RPMs, I get a slipping/hesitation before it corrects itself and is fine. Mostly with slow acceleration...fast acceleration doesn't really trigger this.
Also when decelerating and coming to slow stop, sometimes it jams/jams into first gear on its own. Doesn't happen all the time but sometimes.
Overall, I still like the tranny and finding which mode works best in which situation like bumper2bumper traffic, light traffic, slow driving, etc...
I have a 99 dodge ram i was driving it home the other night and it stalled out on me and will not turn over. When i try to start it it just clicks once and that's it. I just replaced the fuel pump and have already checked the starter, alternator, and battery and have still found nothing.
View 1 RepliesI read a similar post but no resolution. My '05 Equinox starts fine most of the time, but when I make a quick stop before its fully warmed up I have to slightly depress the accelerator to get it to start. Now I know with fuel injection this should't be happening but its been the case almost since the day I bought it. GM changed out the software in the computer and that seemed to work for a while, at least long enough for the warranty to end. It doesn't bother me but my wife wants the car now. What's up?
View 1 Replies2002 Dodge pick up constantly gives me this warning when the park lights are on and then use a turn signal. All lamps do work and the front control module has been changed.
View 4 RepliesWhat is this noise? Video included... [URL]... This noise comes up after the engine gets warmed up and only when the car is decelerating or idle. That is, as soon as I take my foot of the gas pedal the car starts making this noise and it is very loud. No error codes.
View 3 RepliesAfter its 2.3 liter engine is warmed up, our '87 Ranger has intermittent problems of idle dropping to nearly dying altogether and then overcompensating to recover. Normally, after throttling up to 1500rpm or so, it will idle steady for 15 or 20 seconds then start the process again.
After normal tuneup part replacements (i.e. plugs, wires, cap, rotor and fuel filters=there are 2), I spent over $100 on replacing O2, throttle position and EGR sensors but symptoms still occur. Was advised to consider replacing the Mass Air Flow sensor but that part doesn't exist for the '87 model. Was told the equivalent part is "Idle Air Control Valve" at approximately $80.