I just bought a 2010 Santa Fe with 52,000 miles. The car looks great and runs fine once warmed up. Problem came after I got it home. I have found that it shifts rough when first started for about 5 miles. After that it runs great. From a quick search I have found 2 TSB's that may apply, 10-AT-006 and 11-AT-011-2.
View 36 RepliesOn my 2.5 SE auto, it feels like the car shifts into neutral at stop lights. Is this the case? If so, is this cause for concern. I know on my old Volvo S60, they removed this feature because it was causing premature wear with all of the extra shifting into and out of neutral.
View 1 RepliesI have the p0734 and p0732 codes. Thing is it shifts hard into second and wont go into overdrive when first started. After about ten minutes of drive time you shut it off and turn it back on and the thing shifts perfectly. No hard shifts and overdrive works then check engine light turns off. The pulse generators have been replaced when i purchased car. It is an 02 accent with 90,000 miles.
View 3 RepliesI have had my Santa Fe for 3 months now and have just noticed recently (due to the cold wet weather) that when it is raining my windscreen fogs up when the climate control is set to auto. This never happened in my previous car (VW Golf GTI). I always drive with climate control set to auto and temp set to 23 degrees C. When the windscreen fogs up I have to set A/C to on to demist it. The temperature is then totally different. I can only get a clear windscreen with A/C on, no matter what mode. E.g. If I just have front demister with no A/C then I fog up. If I have blowers set to windscreen and no A/C I fog up. Having A/C on with any mode is fine! When the windscreen is clear and I set the climate control back to auto then the windscreen fogs up almost immediately again.
This seems a bit rubbish to me. I would have thought that having the climate control set to auto is all that is required (like my previous car). I don't want to drive with A/C on when it is raining and auto when it is not. I just want to keep it in one mode.
2007 escape 4wd 3.0. I've notice some random hard shifts for the past month and today the trans has trouble shifting out of 1st. If I get the rpms between 3,000-4,000 and ease off the accelerator pedal it shifts into 2nd without drama. It will not shift at lower rpms with the same easing off the pedal. The trans light is steadily blinking.
View 7 RepliesI have a 2004 Hyundai Santa Fe, has 99,000 miles 3.5L. After changing the alternator (alternator did die and drained my battery, the shop recharged the battery) now it seems be stuck in 3rd gear and does not wont to shift (it is a automatic). Fluids are good, transmission was flushed between 50-60,000 miles.
View 3 RepliesJust experienced something new in my less than a week old 2.0T. This morning was the coldest day since buying it (-15c). I had the block heater plugged in and it started up well. Let the engine run for my usual 30-40 seconds before putting it into gear. Reversed well, but was a bit slow shifting after putting it into 1st.
For the first 5 minutes or so of the drive, the shift were pretty rough. Mostly the shift between 1st and 2nd gear. Things got better after that and were fine for the rest of my trip and also an hour later when I came home.
Is this just a case of a very cold transmission and fluid, or is it something else? I've never owned a car that had such rough shifting in cold weather. Sluggish shifts yes, but not violent like these were.
I have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 RepliesWhy my 2010 auto trans 4cyl Camry often feels like someone is applying the foot brake when I take my foot off the accelerator? Is it the auto trans downshifting? When I feel it occur and slip it into neutral, it releases and I coast freely again. It's really annoying sometimes especially as I've been driving a 1995 Camry auto for the past 15 years which does not do this.
View 14 RepliesMy transmission started jerking into 2nd and out of 2nd when it shifts. It only has 20k miles on it and has not been driven hard at all. I heard of some people doing resets on the transmission,.
View 3 RepliesMy 2010 Ford Escape Shifts hard, but only first thing in the morning. After it warms up I doesn't seem to do it. It has 66,000 miles on it and and when this started I took it to a transmission shop and they flushed out the transmission fluid. There were no warning in the computer for the transmission. I'm thinking it may not be the transmission, but an acceleration problem. Could this be true?
View 5 RepliesI have a 2010 corolla le with approx 54k miles. Should I have the trans serviced/flushed? Can I just do a drain and refill? Is it true that replacing the fluid will cause the trans to fail later on?
View 1 RepliesI have a 2010 S with an auto trans and 68,000 miles. I've never replaced the fluid or filter. Over the last 10,000 miles or so, I've noticed the following in regards to shifting.
I will being on a merge ramp to the highway rolling along and waiting to pull out into the flow of traffic. I'll be traveling along at a constant speed, say 30 mph, with constant pressure on the throttle waiting for my opening in traffic. I will see my opening and floor it. That's when (sometimes) the car seems to get very confused. It doesn't shift back right away, it lingers in 3rd (or OD) and picks up a tiny bit of speed. Then, it hesitates with no acceleration, and then roughly shifts to 2nd or 1st. It feels more like it forces itself into gear and, once in gear, it accelerates like it should.
The biggest issue for me is that this whole process takes about 3 or 4 seconds. That's not very long, but when you're trying to merge onto the highway or cut into traffic, 3 seconds is the difference between being safe and a close call.
Transmission fluid appears to be full, is a nice red color, and doesn't smell burnt.
We have a 2010 Santa Fe AWD LTD with about 140, 000km on it. It recently came back from front suspension work. The suspension is fine now, but we notice harder shifts in the transmission. Also, there seems to be a vibration just before shifting gears and when under load (like going up hill) seems to slip (like on ice) about once every second until the shift is made. Once the shift is made it drive smoothly until put under pressure again. Even stepping down a bit on the accelerator will cause this slipping feeling (or maybe its loss of power).
View 4 RepliesFor a few months now I have been hearing a tap clunk type noise coming from under the car when I shift the auto trans into drive and reverse. Also sometimes when the car is slowing when driving I hear the tap sound as it shifts into first. I drove in by my local dealer and they listened to it and said Elantra transmissions can get noisy there is nothing wrong. They told me I have plenty of Warranty left so if something happens I will be covered.
View 2 RepliesMy 2009 Santa-Fe AWD Limited is sick! Starting from a stop, the vehicle has abrupt shifts with the transmission slipping (RPM revving). Seems worse when cold. Checked the fluids, and found ATF fluid in the engine oil and engine oil in the ATF fluid. Quick internet check suggest a leaky vacuum modulator valve. (There is no way the fluids went in the wrong holes, the vehicle only has 69k kilometers on it, so it still has original ATF fluid, and I recently changed the engine oil myself.) So, do you think this is the correct diagnosis? How hard is it to change the modulator, and where is it located?
View 3 RepliesSince a couple of days whenever I turn the T-reg on even in bright sunshine the lights come on (for night driving and the DRL goes off) when the light switch is in the "AUTO" position. I can turn the lights off by placing the light switch in the "OFF" position and then the DRL lights up (correctly).
View 1 RepliesI found two times the cruise control auto on by itself while I was driving on the road.
View 2 RepliesSantafe 2008, Manual Climate Control Switch. Can i disable AC "turn on" when i switch to front defrost.
in modern Hyundai cars, they can disable this operation by pressing 5 times on Intake (recirculation) button.
Randomly, on my way home from work yesterday, the ECS light turned on, and stayed on for about 10 miles.
I got home, turned the car on and off, even drove around for 10 more minutes, and the light never turned back on.
Now this morning, on my way to work, the light popped back on and stayed on.
I have a 2011 Santa Fe, 4 cylinder.
I have a 2009 Santa Fe, v6, and the check engine light and "ESC OFF" lights are on consistently.
I read the check engine light may be the gas cap so I replaced it but the light is still on. Took the car to Advanced Auto Parts and they said it was related to the cruise control.
I also read that the ESC OFF light may be due to alignment issues. I had an alignment done last Saturday but the light is still on. When they checked the check engine light they said it was related to the emissions. This was at a Firestone shop.
Any common cause for these lights to be on at 30,000 miles? I changed the transmission fluid also recently which the manual says to do at 30,000 miles.