Santa Fe (CM - 2007-12) :: Truck Stalls As Accelerating
Jul 4, 2015
I've got an issue with my 2007 Santa Fe.... At the first drive of the day, the truck stalls as accelerating. Happens like clockwork and sometimes the stall is so hard that the truck stalls. I've noticed a few things... It happens when there is medium to hard acceleration from stop (1st gear) until when it shifts to 2nd. I noticed the battery and seatbelt light flash during the stall (prob cause truck just died) and then it regains power. If I put the car in manual, it rides 1st gear no problem. If I accelerate very slowly, it shifts normally and continues to drive. This only happens from 1st to 2nd gear. I've replaced the TPS, plugs, cleaned the TB and intake tube.
I have not yet took it to the dealer for the PCM update for the new TPS. What should I try next??? Crank sensor? MAF sensor? Replace throttle body? I also wondered if maybe it was an electrical issue. I've noticed when I drive into a tunnel and the auto lights come on my lights dim and the seatbelt light (no chime) begins to flash. I replaced the alternator about a 9 months ago due to failure. Or is this maybe a tranny issue? This only happens the first drive of the day. As the keep driving and come to a complete stop and continue, it does not stall from 1st to 2nd.
I pulled codes a few months back and it had about 4 codes related to the TPS. I replaced both fuel tank level sensors yesterday and my CEL is gone (truck still stalls).
View 15 Replies
Advertisement
Something I haven't seen yet. 2007 2.9l is hard to start and stalls after filling up with gas. After it runs a minute, no problems. Is it something with the gas cap maybe????? The catalytic converts have been changed, maybe something with the O2 sensors???
View 20 Replies
I have a 2009 Santa fe 3.3L V6 (live Montreal, Canada), since the past week when I start it up, I've noticed that after 1 minute or so while the it is idling my rpm's drop from 1000 to about 650 for split second and it seems to want to stall. The same thing happens when driving for a a small distance when ever I have to make a stop my Santa fe rpm's drop (split second) so low it seems to want to stall. Could it be related to Throttle Sensor Position?
View 2 Replies
I am the proud owner of a 2010 AWD Santa Fe with 1,600 miles. Over the weekend, I noticed a weird "humming" noise coming from somewhere in the vehicle (it sounds like possibly from the passenger side and from the interior of the vehicle). I only hear the noise when I accelerate. When I brake, the noise stops, and then picks up again when I hit the gas pedal.
View 46 Replies
Just owned a 2011 hyundai santa fe AWD(48002 miles). At 50,100miles I start hearing this banging noise from the rear (quite loud) when accelerating. Usually occurs after 80km/h. Also occurs at low speed when you let your foot off the accelerator.
View 9 Replies
I'm noticing more and more on the highway when i accelerate that my car seems to pull to one side then when it shifts it snaps back. I'm not really sure if I'm even describing a transmission issue or a power steering issue. Basically, it just seems to pull and snap back fairly strongly, enough to cause a slight swerve as it shifts during acceleration. Where to start on something like this? (no error codes or check engine lights. Also no vibrations or other sounds).
View 11 Replies
I have a 2008 Santa Fe LTD, and just recently started experiencing a strange noise when I am accelerating, and I cannot pinpoint it. Here is some info on the noise.
-2008 Santa Fe LTD AWD, about 25,000 miles
-Sounds like a little higher pitched hum, not very loud
-Seems to be coming from somewhere near the passenger side backseat area (first found out about it when someone was sitting there and asked what the noise was)
-Cannot tell whether it is coming from the interior or exterior of the car, but I think exterior, but it is definitely somewhere along the passenger side, from the back half of the car.
-Noise occurs when accelerating from a stopped position, only when accelerating, never when braking or idle.
-Noise occurs only when car is in gear (hitting the gas pedal in park does not cause the noise to happen)
-Noise doesn't occur at high speeds or when accelerating at high speeds
-Noise only really occurs for a 2-3 seconds while accelerating, then seems to go away as I continue to drive.
-Noise doesn't seem to always happen, but very frequently.
View 3 Replies
My wife has had her 2010 3.5 Santa Fe since new. Over the past year it's been having a clunk develop when accelerating, happening a few times from a start until highway speed. The clunks almost feel as if one is driving over bumps - that's what I thought at first. The power doesn't seem to be there anymore either. I have been driving her vehicle the past three years and it was fine when I first started driving it. But the past couple years I first noticed a problem and it seems it is getting progressively worse. My wife now notices it quite a bit too.
View 1 Replies
2007 2.7 GLS ... I like many have encountered the P0441 code and my Santa Fe stalls after fueling and requires constant revving for a bit to stay going. Previous threads seem to point to the Purge Control Valve.
View 10 Replies
2011 SE leased in December 2010. I Now have 14,000 miles and my trans has started to slip.
First slip was yesterday on a a fully warmed motor while I was accelerating at a normal rate of speed. I am guessing the car was in 2nd gear (25mph) and the rpms shot all the way up to redline. I let off the gas, coasted for a few seconds and the trans engaged the gear and I kept driving. No cel
Today the same thing happened under the same conditions but this time when the trans re-engaged the gear, the car jerked forward pretty violently.
About 15 minutes later this happened again but at highway speeds (65mph) while cruising. Again, violent jerk and a thump when the trans caught the gear.
After all this I have no CEL. I know if I bring the truck to the dealer they are going to give me the old, "we cant reproduce the problem." Once the trans starts to slip like this the damage has already been done and its just a matter of time before I am stranded on the the side of the road.
View 9 Replies
Have a 2007 and everything was running fine all day today. Stopped at home for a few hours and went back out to run a few more errands and my truck started running poorly, dashboard lights were dimming, and the ESC OFF & ABS dummy lights came on as well as the red battery light. Managed to turn around and make it back home. Sounds like my battery needs replacing? Hopefully its just the battery and not the alternator.
View 22 Replies
I have a 2010 Santa Fe with only 8k on it and the suspension sounds like a 10 year old pickup truck when I drive on any uneven surface under 30mph. I took it to the dealer who said that sounded normal. After going on a test drive with me he said that he did hear something on the passenger front clunking. He replaced the end link on that side and said that they normally wear out at around 15k. He checked the torque on all the other suspension bolts and said that was all he could do. It seems a little bit better, but it still sounds horrible at low speeds. I don't hear the knocking at highway speeds when I hit any bumps. What it can be? It feels like the struts are hoping or crashing over the bumps instead of absorbing them. My 10 year old Ford Explorer drove nicer than this. When I told the tech that my cheapo 2010 Nissan Versa doesn't make this noise when driven on the same roads he said that the Nissan was a much better car than the Hyundai. Did we make a horrible choice buying this thing?
View 41 Replies
Any way, my 2000 Pontiac Sunfire will randomly not accelerate while I am driving. I was initially rolling up to a red light so took my foot of the gas at about 20 mph, then the light turned green so I tried to hit the gas but nothing happened for about 5-7 seconds. So I was just coasting, but then I hit the gas and everything was fine. It did this a second time on the way home. Two days later I went to start my car and it wouldn't start. Nothing was happening--no noises, nothing. So I got my battery tested--Autozone tested it and said it was bad, but after replacing the battery nothing happened still.
Then a "mobile mechanic" came and stuck a screw driver into the starter to short circuit it so it made a sound like it was trying to start, but didn't. Then after a few minutes he looked and my radio was on and it started with the key. Since then it has not started only one time when I used a screw driver to start it myself, but when I was on a steep incline last night it kept not accelerating if I made it work too hard. I would be at ~65 mph and it would just quit so I'd pull off the side of the road and it would drop to ~40 mph for ~5-7 seconds, then I'd hit the gas again and it would go just fine. It did this about 3-4 times. One time all the lights on the dashboard flashed on when it wouldn't go. One time it just completely stalled on me when I was driving. I pulled off the side of the road and started it again and it was fine.
View 1 Replies
my 88 camry will start and idle fine however whenever you attempt to accelerate the vechicle the car trys to stall and hesitate badly and will not move. i have changed the fuel filter the spark plugs and plug wires i cannot figure it out. also this started out of nowere the car was driving i had been driving for about ten miles stopped at a red light and that is when the car started doing this.
View 9 Replies
I just purchased a 93 escort sedan 1.9 ltr engine. Car runs great when idling but bogs down when accelerating to the point it almost stalls out but doesn't stall. the car sat for a while 6 + months. We thought the gas might be bad so we drained the tank filed it with premium to run thru the line but that didn't work. thought maybe o2 sensor, changed that but didn't work. getting error codes 412 and 538 but can't find any info on these codes.
View 7 Replies
My 2012 ford F150 Eco boost 3.5 l stalls when I am accelerating. What could be the cause? I have replaced the, Spark plugs, coils, air filter, oil, and cleaned the injectors.
View 2 Replies
I have a 1990 chevy K2500 5.7 350 tbi with 255000 miles on the body and engine. transmission replaced at 200000. When I drive long enough for the truck to get hot (i.e., 10 minutes or so) if i put it in reverse to back into a parking space or my driveway, it just shuts off. i have had fuel filter and fuel pump replaced but what could cause this? it will stay on if I don't drive long enough to get hot.
View 1 Replies
2000 Sierra 2500 pickup truck. What would cause my truck to stall randomly and not start? Then after waiting a while it will start.
View 4 Replies
My 1995 Chevy Silverado 1-ton diesel stalls with no warning at various times while driving, such as at intersections, on the freeway, coasting, idling. It may go days or weeks without doing it, then all of a sudden stall eight times in one day. My husband says it has sediment, such as rust, in the fuel tank causing it to clog the fuel line. We've replaced the fuel filter twice, and we keep the tank topped off with gas, but it still does this out of the blue at times. I no longer trust the vehicle and will not haul the horse trailer using it, which is why I have the vehicle in the first place. By the way, the problem began after the truck sat for several cold winter months due to drained batteries. After we replaced the batteries to get it running again, it began stalling like this on a semi-regular basis. If it is rust or sediment in the fuel tank, what can we do to fix that? Could it be something else causing the problem?
View 2 Replies
1994 FORD RANGER stalls while driving - differant speeds ...differant miles ...no rhyme or reason to it - cranks right back up ...can even pop clutch and cut it back on. Already replaced Ignition Start Module - Dpes sensor - temp sensor - and scan shows all codes are clear and truck passes. We are clueless to whats causing this. 4 cyl 2.1
View 12 Replies
I have just swapped a new Vortec V-8 engine into my 1999 Chevrolet Suburban K1500 4*4, now when I start the truck and put it into reverse (foot still on brake pedal), I let off of the brake and the next time I step on the brake pedal the truck stalls. What would be causing this? I have no error codes on the computer, my fuel pressure is good, I just replaced the fuel pump. I think that it might be a sensor somewhere, but I am not sure where to look.
View 2 Replies
