I have a problem that my Treg makes a terrible grinding noise when starting in the morning. It sounds almost like a bad bearing or something. It lasts anywhere from 3 to 8 seconds.
View 5 RepliesWe love our Treg, but I am not happy about the clatter (like not lube for a second or two) when starting in the morning. Temps are warm this time of year. Otherwise, everything OK.
View 1 RepliesI have an 07 v6 3.6L (50Kmi) that makes screeching sound upon startup for 15-30 seconds. Not belt/pulley noise, more like valve lifters without oil noise. Trying to decide whether to go to the dealer before the power train warranty expires or to leave it alone.
View 1 Replies2011 Santa Fe 3.5 L
I've isolated this rattle down to the cam phaser( CVVT) in the right cylinder head. It rattles bad for 2-3 secs on cold start or after it sits for 3 hours.
I've put in 5w20 synthetic oil and synthetic Lucas additive and it cleared up the noise for short interval start ups.
I changed the cam phaser in the right head with a used one ( 40k ) but it didn't make a difference. I should change out the attaching cam as well.
My vehicle has 113 k and when I start it cold there is a whining sound for about 20 seconds and then increases in pitch and then slowly winds down to a stop. Does not do it when motor is warm. What it might be?
View 1 RepliesI just bought a 2006 Sonata LX V6 a few days ago and in almost every way it seems like a great car. My '08 GLS V6 which gave me 150k great miles got totaled in November, which really sucks, but I wanted to find another '06-'08 V6. I noticed when I started it for the test drive that the car made a bit of a grinding noise on start up. I didn't think much of it and figured that the warranty from the dealership would cover any problems.(I probably should've checked earlier, but the dealership's warranty only covers cam and lifter noise and engine failure) After I looked into the issue more, I found out that it is a fairly common problem on the early 3.3's with the timing chain tensioners. I'm pretty concerned based on just the nature of the repairs and the cost I've seen for them.
I'm the third owner so the 5 year/60k warranty is expired, but I know there is a TSB out for the issue. I can't find the TSB anywhere but I've heard to have it repaired the car has to make the noise on start, sit 10 minutes, and make the noise again. If it does, the oil needs to be changed and the test repeated again. Since I'm running Hyundai 5W-20 and an OEM filter already, I tried the test on my own. It made the noise on start, sat 10 minutes, and made it again. It is only for a couple seconds, but it's still concerning to me. I guess what I'm trying to ask is if what I've described is covered under the TSB. I really don't wanna have to worry about something like that right now, so my next question is whether the issue I have is detrimental to the motor. My worst fear would be to have the chain jump a cog on the cam gear and slam valves into pistons.
My engine every now and then makes a lot of noise at startup for about 5 to 8 seconds at that same time the idle is very rough seems as if it is running on 2 or 3 cylinders instead of 4 after that it runs perfectly and is very quiet the car has almost 198000 miles on it
View 1 RepliesMy 2011 sonata rattles when starting. It sounds like noisy lifters and quits after 2-3 seconds. It does not do it on the first start-up of the day, but on subsequent starts when the engine is warm.
View 7 RepliesI've noticed recently that on startup I'll hear a minor grinding noise after the engine has kicked over. Seems to happen more when the car is really cold.
View 24 RepliesNeed to determine the noise before I took the vehicle in to be serviced. I don't know if I would necessarily describe this as grinding...to me it doesn't sound like metal on metal..but it's not normal.
Only happens on a cold startup, and even then it hasn't been 100% of the time...probably 80% of the time though.
2007 Hyundai Sonata - Startup Noise - YouTube
I found this thread, Grinding Sound On Statup but not sure it's the same issue. This just started. Vehicle has 150K miles on it.
When I turn my key the car makes an awful grinding noise and then starts up fine. What is this and should I have it looked at?
View 4 RepliesI have a 2003 Subaru Forester with 240K miles on it. When I start the engine in the morning, there's a squealing noise under the hood that lasts for a few seconds. (Usually goes away as soon as I pop the hood and look at the engine.) I think it's one of three things: AC compressor, alternator, or power steering pump, but I haven't been able to isolate the noise to one of the three. I don't want to wind up replacing all three.
View 4 RepliesMy G1 prius (2001) started making a grinding noise when I start it up in the morning. There are no warning lights (yet) and it drives fine, but that noise can't be good -- something will fail shortly. I've searched the internet quite thoroughly and there was one similar problem reported, which ended up being linked to the ABS pump. The noise seems to come from the inverter, or somewhere under the inverter. I took a video of it and posted it here.
View 19 RepliesI start noticing a weird noise upon cold start up. It sounds like something is grinding. First goes starter sound and then engine noise together with this grinding noise. Grinding noise goes away within sec. or so. It is not really loud, but it definitely not engine or starter sound.
It happens only on cold starts when engine is completely cold. If I start engine, let it run for few minutes, shut it down and restart again, it starts without grinding noise. Don't remember if car was doing it from beginning, never turned car while I was outside. Few weeks ago when temperature dropped below freezing point, I turned ignition through passenger door to warm up the engine.
After that I begun listening every start up. Every start up same noise. Every morning and every time after work I hear this noise. No noise if car been driven recently or engine is still warm.
Not my car, but sound is identical : [URL] ......
I have a 2010 S with 70,000 miles. At 60,000 miles, just after the warranty ran out on me, I started to get a gear grinding noise for approximately one second immediately following a cold startup. It doesn't happen all the time, but I'd say once out of every eight starts on cold mornings after it's been sitting. I researched the issue pretty extensively and it seems to narrow down to the cam timing gear being the issue or a bad starter relay. The 2009's had a TSB for the issue being a cam timing gear, but the dealer assures me that my vehicle is not one of the ones covered by the TSB.
I'm inclined to try the relay fix, since a new relay is only $60. The thing is, I would hate to install the part and find out that the issue remains and then be out $60. Any identical relay elsewhere in the car that I can swap it with to see if that work. Of course, if the relay is bad, I'd be breaking something else possibly. Or, even better, is there a way to test the relay to see if is the cause of the problem?
It was -35 degrees Celsius (-31 Fahrenheit) this morning. My Prius v was parked in the driveway. When I started my car the engine produced a grinding sound. The sound lasted between 30 seconds to a minute, then it went away. I was able to capture this in a video:
I have an inclined driveway, I'm not sure if this matters or not.
I've got a 2003 f150 with the 5.4 and 128,000 miles with an engine tick. Its not an exhaust leak I know that for sure. It has came up in the last 20,000 miles. I've used motorcraft 5 20 w/ motorcraft filter. I've tried a kreen engine treatment with no change. Heres the description/syptoms:
-Slight clatter for 2-3 seconds upon cold startup (happens very rarely)
-top end ticking that is loudest and most noticable when warm (quieter when motors cold)
-not timing chains/tensioners etc because the noise is coming from the top end and most noticeable on the passenger side.
-at idle the tick is present-when you rev at idle, the noise goes away.
-Driving (or having the engine under any load for that matter) the noise gets louder.
-Anytime I accelerate, tow/haul, go up an incline the noise gets worse
-Sounds like a "whirring" sound from within the dash.
With all that said I am thinking the lash adjusters are getting noisy. I had a certified gm tech that has 40 yrs mechanic experience under his belt and builds prostreet muscle cars on the side look at it. He listened to it to it and that was his diagnosis as well as its not that bad so just live with it. The noise at idle doesn't bother me, its when im driving with the windows down. The noise drives me crazy and is a little annoying to me.
Heres a link to a video of the sound and keep in mind it is much louder now : Triton engine noise/tick - YouTube
I'm at my place in Florida 1,000 miles from home, and when I started the car in a mall parking lot, there was some grinding metallic noise for a few seconds and I couldn't get it into first or reverse and the clutch pedal was way down. I was able to get going in 2nd and eventually the clutch was back to normal and I could get 1st and R. What happened? Broke some fingers in the pressure plate? Seems to run fine now but have a 1,000 mile ride ahead in the morning.
View 1 RepliesI recently sold me 91 F-250 and got into a 98 F-150. It's a SuperCab 6.5' bed, 4x4 off-road, 3.55 gears, 5.4 v8 auto. I love the truck, but I am having an issue with a noise at startup.
Every time I start the truck it fires right up but it makes a grinding noise AFTER it starts for about 3-5 seconds. I thought the starter wasn't disengaging in time so I replaced it. The starter I took off was fairly new. It's teeth had just a little wear and the flywheel had no visible wear. I put in the new starter and there was no change at all.
I also changed the oil and filter using Motorcraft 5w-30 oil and a Motorcraft filter. I also started it without the serpentine belt to rule out a pulley bearing. What the noise could be? The truck runs absolutely excellent, by the way.
I have the po411 code, not sure which problem it is but when I first start the car it sounds awful like almost a grinding or rattling noise then stops after a few seconds.
View 3 Replies6.2L F250 truck is just shy of 60k runs good however on cold startup there's now a pretty loud ticking noise for a short period (30 seconds) until it warms up then it slowly goes away. Once its warmed up there isn't much of anything.
Did these have exhaust manifold gasket problems like the 5.4? Hoping that's it if not, any other common problems that would make that ticking noise and then go away quickly once the engine is warmed up.