My car is in the garage, been having a bunch of issues with the check engine light. This is my current problem, Check Engine light is popping up because the catalytic converter is sending an error. However, there is nothing wrong with the converter, it keeps sending the same error. My car has been in the shop for exhaust issues and valve problems, but this has got them stumped.
View 24 Replies105,000 miles on my R32, starting to get check engine light for catalytic converter. Any cheaper options to VW originals that won't harm performance?
View 1 RepliesThe check engine light on our 2005 Honda CRV (146,000 miles) came on and stayed on. After a week of driving with the light on we brought the car to the dealer to have it checked. The dealer diagosed a faulty catalytic converter given a P0402 diagnostic code and didn't think the P1078 code for the intake manifold a problem. The dealer also stated that the oxygen sensors were fine. We declined the dealers offer to replace the catalytic converter for $2,170 and the check engine light was reset. After two weeks of daily drifting and 1000 plus miles the engine light is still off. Did we actually have a problem? Why hasn't the light come on again?
View 8 RepliesI live in CA and recently my car passed the smog test, but failed inspection because the check engine light on the board was on. When the diagnostic test was done, it said there's a problem with the catalytic converter. It's so frustrating because the car's emissions are within limits. , I was thinking... Is there a way to get the catalytic converter to run cleaner without replacing it? If it can run long enough to pass the diagnostic test, my car could pass inspection.
View 3 RepliesI had my local garage do their electronic check when my check engine light came on. They said the code they got indicated a failed catalytic converter and quoted me $720.00 for a California compliant replacement, including labor. I live in Connecticut. I'd like to take a few days to get a second opinion and second quote, but the garage manager said that driving it in this condition would risk fouling the oxygen sensor, which I recently replaced for a couple hundred bucks.
Should I be concerned about fouling the oxygen sensor by continuing to drive the car? 2000 Toyota Camry...
I looked under the car and the rear attachment bolts to the converter are rusted beyond recognition. I'm tempted to try replacing it myself but it may be a bit beyond my skills.
2004 Chrysler Sebring Sedan, 4 cylinder dual-overhead cam. My check engine light came on this morning and the code came out as the catalytic converter. The car seems to be running fine, at least no recent changes. I'm debating replacing this vehicle soon, and I'm wondering if it's worth working on the catalytic converter. I recently replaced the cam shaft position sensor as well.
View 5 RepliesI just moved to Colorado with my 2009 Prius and on the fifth day here the check engine light went on and the dealership said my catalytic converter failed. Luckily I was still under warranty. Is this related to the altitude or just a coincidence?
View 3 RepliesMy wife's car is a 2002 Prius, 149 k miles. Lately the check engine light has been coming on. I took it to the dealership, and their assessment is that the catalytic converter needs to be replaced. They are recommending about $2,000 + of repairs. While I am contemplating the practicality of investing that much in keeping this car going I'm wondering if it harmful or dangerous to continue operating this vehicle.
View 12 RepliesMy check engine light has been coming on and off and it seems to show P0420 for catalytic converter. The light stays off for about a week and it'll come on for a day or two and off again.
Wouldn't a failed converter stay failed? Can P0420 be triggered by loose/bad gas caps?
My cat converter is rattling on driver's side and check engine light is on. Rattle is the inside of the converter, not the heat shield. How much $ and what kind of converter replacement is recommended?
View 10 RepliesThat Car Grand AM 2000 2.4L SE
The current problem with the car is that it is not accelerating fast, for example i would push the petal to the metal and only go 25 mph and my RPM would be 3000-4000. Initial my brother and cousin though it was the Catalytic converter because it was getting hot but that has recently been change along with the fuel filter and spark plugs. but the catalytic converter is still gets red hot so i forbid myself from driving it till i fix what every causing the slow acceleration and the temperature of the Cata when i took the error code think P0300 random misfire to the local Autozone they printed me a long list of things that could be a issue my question is what is the likely culprit so i can fix those 1st before shelling out cash to rebuild a engine. may just have to get rid of it at that point. so i guess what am asking is a list maybe top 10 so i can fix them one by one as my money comes in.
Before the accelerating issue the car would randomly stop when i slowed down or stooped that when i replace the spark plugs.
The wife's 1997 Mountaineer, 5.0 with all the bells and whistles, Every time she stops, wet, dry, snow, any type of surface, the ABS brakes activate just as she comes to a stop. Heavy pressure, light pressure, doesn't matter. She says it sounds like a cow mooo-ing. 138,000 miles. New pads and rotors were installed 40K miles ago (about 3 years ago) she doesn't drive much but the noise is aggravating. No check engine light, or ABS light. Seems to come on when it gets below 10mph consistently. The Engine light comes on occasionally with a catalytic converter fault, replaced the converters but still get the light. I don't think it is related.
View 9 RepliesI have a 2000 Lincoln Town Car with a single exhaust system, part of/attached to the frontal area of the exhaust "Y" pipe are two lumps with heat shields, the muffler is obvious in the mid-section of the car, but are those "lumps" the catalytic converters, and if so, why two when the older cars had only one?
View 2 RepliesMinis are renowned for oil burning. They're replacing engine due to excessive oil burning. Are O2 sensors and Catalytic converters also effected, and should they replace them as well?
View 2 RepliesI own a 2004 Ford Escape, auto, v6. I bought the car in 2007 and have had trouble with my check engine light ever since. It is usually on, but will turn off shortly after I wash it (then back on a week or so later). When mechanics test for the code, they say that my catalytic convertor needs to be replaced. In addition to the on/off strange behavior, I have been driving this car for 4 years now with no major mechanical trouble that I can only assume would result from not replacing the CC. This would be very expensive repair, one I am not interested in doing if this is possibly just an electrical problem. I am ready to get this problem solved and start driving check engine light free.
View 3 RepliesWhat would cause both Cat converters to fail at 20,000 mi.? Mine went out and the back pressure caused the engine to knock under acceleration. Also blew out an injector and plug. Luckily it was under warranty but wonder what could caused it.
View 8 RepliesA few days ago my "Check VSC" warning came on along with the check engine and traction lights being on. I left my car in a parking garage for a week when I was on vacation and the lights came on once I started the car after getting back from my trip.
I have had the "Check VSC" warning before and I fixed it by replacing my gas cap. My gas cap seems fine this time around so I got my codes scanned and the only one that came up was P0300. Having this issue with the 2007 Lexus GS 350? I still feel like it's my gas cap because I bought a cheap replacement last time around.
My Lexus was working fine till yesterday, but today when I started (button press) it, it started giving me a Check VSC error and Check engine light along with Slip Indicator started showing up
Took it to Autozone for the codes and got
P0015
P0304
C1201
B2799
This car has been giving me quite a bit of trouble lately. 04 Ford Taurus SES, about 97,000 miles on it. Just last weekend, it broke down on the highway. Found out the torque converter failed and needed to be replaced. I was suspecting that something was wrong with the transmission for a while now, because it would stutter sometimes when accelerating, and sometimes start shaking in the front when I turned it on. (It still stutters after having the torque converter replaced.)
Well now, a day after shelling out quite a bit of money to the dealer for this torque converter, the check engine light is on. I went to Autozone to check the codes, and they found P0300, P0305 (cylinder misfire) and P0316 ("crank sensor condition"). Is it possible the transmission is failing?? I found a bunch of complaints online about the transmission failing on the 04 Taurus. I'm trying to avoid more expensive repairs, but I don't want the car to break down on me again....
Also, a couple months ago, the check engine light went on a few times, but always went off within a day or two. Never did get it checked out because it didn't stay on long enough.
Check engine light came on. Just over 100,000 miles. Car running fine, no new noises or rough running or lack of power. Wife took to get oil changed next day. Dealer diagnosed as a sticking valve. Personally I would have cleared it and seen if it reoccurred but dealer already special ordered valve. Searching on the p0012 code I see nothing like this.
View 3 RepliesCurrently I haven't been tweaking anything to my car after driving to go and home I left to go get something to eat and after driving for a few min out of nowhere the engine light, brake and abs comes up. So I freak out a pull over to the nearest gas station and turn my engine off for 2 min and turn it back on and this time only the engine light come up. So I drove to autozone to get it scan and error p0500 comes up. Which means short circuit, vss and poor electricity something I am not exact but is it serious? Like I am freaking out right now.
View 1 Replies