Ok I have a friend with this car and said it kept over heating. I went and looked at it and found the source of the leak. It's right after the heater core. The hose comes out and into the engine. Where the hose slides onto the engine has a leak . It looks like the piece can unscrew and be replaced but I don't know what it's called.
View 1 Replies1996 lincoln towncar wont start intermittently. Started doing this yesterday, was troubleshooting and my friend jumped the starter to check it and he said it was good. I messed with a few fuses wires and it started up fine. Drove today with no problem, parked and it won't start again... same as yesterday... turn key and all u get is a clicking sound from the inside sounds like under the glovebox in the dash...
View 12 RepliesI have a 94 lincoln towncar and the air suspension is not turning on and I am dragging over the smallest bumps. I have checked the fuse on the main fuses but it is fine.
View 1 RepliesI recently purchased a 2002 Lincoln Town Car with 204,000 miles but it runs like a champ. The Problem Is It burns too much gas i filled the tank up and2 days later I'm at a 1/4 tank without driving very much. My fuel economy states that i'm getting 8.5 miles a gallon this number goes up and down. I changed the oil and air filter still having the same problem. I need to know what I can Do to fix this I have heard the plugs and possibly the coils but I would like to know if there is more or perhaps something else I will be doing the work mostly myself.
View 14 RepliesGears won't shift from park. What's wrong? Is it the neutral safety switch?
View 5 RepliesI have a 1997 Lincoln towncar with the air suspension. After parked for overnight I found the car sagging in the rear so I thought a air bag went out so I thought I would take it in to get fixed but the next few nights nothing happen the car stayed level then the next night it went down then the next few nights it stays level.
I took it to the dealer and they told me they see nothing wrong and kept it over night and it did not go down. It is like a roll of the dice if it stays level or goes down. I sprayed the air bags and the lines to them with soap water to see if I could find any leaks but I did not see anything.
The compressor is buried so unless I know that is the problem I am not going to rip everything apart to not find a leak or is that where I should be starting. If the car is running everything stays level and no light is on. I do not want coils in the car I like the air suspension.
I replaced the Air shocks with regular springs from a conversion kit I purchased on EBAY. The instructions to disable the "Check Air Suspension" light were included in the kit. I followed these instructions without success. I disconnected pin #11 from the wire harness under the dash, behind the glove box. I then telephones the company and was told to cut the black wire to the air compressor under the hood - below the air filter canister. How do I TURN OFF THIS LIGHT? I own a 1997 Lincoln Town Car signature.
View 14 RepliesI have a 1996 BMW 328is and recently it overheated on the way to work which is about 20 miles i pulled over let it cool down and now when i drive the car after about 5 minutes it starts overheating and is loosing coolant but i am pretty sure its burning out the exhaust now the person i had bought it from had replaced the head and head gasket no more than 8000 miles ago with thermostat and housing and water pump and radiator so now i get no heat in the car both upper and lower radiator hoses rock solid and burning the antifreeze.
View 13 RepliesI have a 95 Lincoln Town Car Signature Series that is not automatically locking doors whenever I shift the car out of the Park position. I am wondering if the door locks have to be programmed or if there is somewhere else to check or both.
View 1 RepliesHad overheating issue with the wife (she doesn't monitor fluid levels like she should). Now you can't operate it for more than a day or two before the reservoir is super low to empty. Mechanic coolant is going into the engine, probably through the intake manifold. Says investigating further will cost a ton. What can I do cheaply to figure out what's going on before I give up? I followed her when the engine was started from cold & could see water vapor (more than I would expect) in the exhaust until when I figure the engine reached full operating temp. It has about 225k and is the 6 cyl engine, btw.
View 1 RepliesI recently have purchased a 2001 Lincoln town car executive edition. I'm having some issues with the brake lights. My running lights blinks and everything work perfect but when I press the brake nothing will light up I've checked all the fuses in the manual and all bulbs seem to be fine.
View 1 RepliesI noticed my 2002 Camry XLE was overheating and discovered that I had lost a lot of coolant. I topped off the radiator with pink 50/50 and went for a little drive, after parking I noticed a slow coolant drip that would eventually stop.
I took it into a shop, and they did a pressure test and found the leak was from SOMEWHERE behind the intake manifold. They also told me that it may be a "common" problem in my year that the threads in the cylinder block are pulling out, causing the cylinder head to lift and coolant to leak. They claim that they have to pull of the the valve cover gasket and inspect the torque for the headbolts, if they're loose I'd need to replace the engine block (!!!)
My thoughts are that it must be coming from somewhere near the intake manifold. I just had it replaced five months ago and am thinking something went wrong in the process.
I guess my questions are, is the bolt loosening thing legit? I'm not burning off coolant (have checked exhaust and it's clean, not white or anything). And what if anything could have gone wrong in replacing the intake manifold to cause said leak?
My 04' GTI, 24v VR6, all stock, @ 107,000. I had a coolant leak from the t-stat housing. I installed all new housing, seals, and C-Pipe from GruvenParts. Already had a green CT sensor installed and the kit I got didn't come with one, so I didn't change it. Found out the leak was from the t-stat housing o-ring didn't fit the old housing. The new one fits perfect. I put coolant on the seals and burped it. Doesn't leak a drop. But still overheating, all the hoses have pressure and are hot, so no blockage....I noticed the fans were not coming on at all. The fans used to engage every other minute and run for 15 secs on high ONLY. Longer times, if not constantly w/ A/C on. I was wondering how to test the fans, sender, and/or fan control module to see which one of them isn't working. And which pinouts are what?
View 2 RepliesI have a 2005 Hyundai Elantra GT Hatchback, and it is not going so well with me at the moment. My thermostat works perfectly fine, but my car is overheating. I've taken it to the shop multiple times but still doesn't seem to get fixed. My coolant seems to be fine, and stays at its level, but what doesn't seem to be fine is that it doesn't seem to be sucking strong enough into the radiator so that it can go to the engine! On the lower level coolant cap (one with the hose attached), it seems to be leaking out of there when the car is hot, as if the coolant is trying to suck into the radiator but not strong enough but yet leaks out of it since it isn't strong enough. My theory is, the cap with the hose isn't on tight enough to fully let the coolant suck through the hose, and so air leaks cause the coolant to leak out of it and not into the radiator.
View 7 RepliesI was driving my 2008 Santa Fe last week (before I went on vacation) and noticed the the A/C wasn't coming through quite a cool as usual (almost felt like the vent was on w/ no AC). Then after about 10 minutes of driving I noticed the thermostat on the car get to about the 3/4 line pretty close to the red lines.
Luckily I was home so turned the car off and popped open the hood. I noticed the reservoir tank was empty and there was some coolant that dripped down on the fans & a small pool of coolant on the engine block right under where the oil is poured. (nothing has been dripping under the car)
I added a little coolant to the reservoir tank and the next time I turned it on and let it run for ~10 minutes, it was the same thing.
Anyway, I came back from vacation and opened the hood to try and identify exactly where the leak was, and ran the car for ~30 minutes, with A/C on full blast and the car didn't overheat or leak anywhere. Coolant tank was still full from when I filled it the first time.
What could have caused the leak/overheating in the first place?
I've been driving a 2006 Liberty with 110,000 miles and have had no problems for about 6 months. I didn't get a tune up at the behest of the previous owner who had showed me records of the last time he had it tuned up. I didn't notice that he hadn't flushed the radiator, however. Since the cold weather started, I've been very cautious and making sure not to cold start. On my way home from work, I was stopped at a red light, started to accelerate and heard and felt a POP that felt like the transmission slipping or something to that extent.
I noticed the car started to overheat. I pulled over, and being the rushing idiot that I am, I decided to open the radiator cap. I didn't hurt myself but coolant leaked everywhere and along with it were chunks of rust. I had a lot of trouble turning it over to get it home but ended up doing so and it didn't seem to run any worse, sans the overheating and cloud of coolant. I'm so nervous to take it to a mechanic and see the monetary damage. From the description, what I'll be in for? Did I damage it further by repeatedly trying to turn it over??
My poor old jeep is having some issues. Here's the stats: 94, 4.0 engine, 240k miles (jeeps am I right?). It started overheating on me so I start with replacing the thermostat. No dice. I noticed it was "weeping" coolant, so I replaced the water pump. No dice. It's still running hot and throughout the process of replacing things and test driving it is now struggling on accelerating/giving it gas to switch gears. It even out right died a couple times. (Air filter was gunky, replaced it.
View 7 RepliesHave a 2000 subaru outback 2.5l, automatic, with about 245k, I replaced the thermostat,water pump, the radiator and the car is still overheating. both fans are working. no leaking coolant. Maybe this is related- over heats mostly when driving on the highway. But if a shift the gear to neutral and coast for a minute the shift back to drive the temperature gauge goes down. Whats wrong, running out money fixing the car, but love it driving it in the snow.
View 2 RepliesSo a couple weeks back I'm on expressway home and I look down and and temp gauge is pegged out overheating I immediately pulled off and shut it down and towed to a buddy of mine's shop he flushed it filled it up w antifreeze and checked for leaks and couldn't find one. I drove it for about a week and got out to for a quick stop , Ex parked on a slight decline and came out to prolly half gallon of coolant on the ground..I limped it to my buddies shop as it was not running hot .. he has checked it out but can't find any leaks, even after having it run 30 or so minutes..
View 6 RepliesI have a 1996 Honda Accord 4 cyl. with 150 K miles. Had a coolant leak that the shop fixed. About 60 days later, same problem. I have to refill radiator every other day. What I noticed is a brown soft muck buildup at the radiator cap area. Also the car seems to run rough on and off. The underside of the oil cap is clean, no carmel color ( oil and coolant mixture) buildup.
View 5 RepliesI have a 1996 Explorer with the 4.0 motor. Today coolant started running out between the Freon compressor and the block at the front left corner. I cant see behind the compressor. Compressor hose seems to be short and stiff so removal of the compressor is questionable? I look from the front and does not seem to be thermostat or temp sensors. It appears to be behind that, like the bottom of the intake manifold? I wonder if there is a known problem in this area or how to go about disassembly. Don't want to take off compressor and steering pump if the problem is intake manifold. Have a problem ? Where to start disassembly to look?
View 6 Replies