Car is a 2000 Corolla with 62k miles. My rear brake light (driver side) went out (pretty sure it is the bulb). 2 months ago the blinker relay went out and I replaced it.
Do most mechanics have the bulb on hand?
I own a 2000 Toyota Carolla, in reasonably good shape (95,000 miles) with no rust on the body (it was a Texas car until last year). This problem happened in Texas, on the unusual times that it froze, and in Michigan, obviously very often. The car freezes: the doors edges, locks, latches, wipers, wiper fluid, windows, and trunk freeze solid. I've tried using the lock de-icers, hand sanitizer, WD-40, hairdryers, special fluid for the wipers etc. all to no avail. I live in an apartment complex so I do not have a heated garage at my disposal. This is a very annoying problem, which often means I cannot use my car, even though the rest of it works perfectly. I've searched the Internet for more answers, but find none. Clearly, there is moisture inside the car that freezes up in cold weather... but I can't imagine how or why. I've never spilled anything in there, and it's had a long, hot summer of drying out if there had been something there. But on the first freeze of the year, viola: no frigging way can I get into my beloved little auto.
View 11 RepliesI have a 1996 Toyota corolla base model,my dome light stopped working a bout a year ago,I clean the contacts and bulb with sand paper,light would then work for about 2 weeks now When I clean contacts light will only work for a few hours. Have tryed new bulbs many times does not make any difference, don't know what to do.
View 1 Replies1996 Toyota Corolla base model 1yr ago dome lite would stop working,I then would sand contacts on dome lite and sand bulb it would then work for about 1 month now I do the same thing and lite will only work for about 20 min.(tried new bulbs many time) was told could be corroded or a bad relay, dont know what to do????
View 3 RepliesMy Toyota Corolla 2000, 123,000 miles, Mass license plate, still getting 34 miles per gallon, has had check engine light on and off for a year.Failed inspection this June.
First garage in Somerville, without doing more than getting the three readings above, said catalytic converter was needed $350 plus labor.I was unable to do the work then and returned to NYC and job. Took to another mechanic recently to get fixed (as I wasn't returning to Mass for a while)and got only PO 171. I mentioned the other readings; they kind of scoffed it off.Trying to save me money (I guess), they cleaned the MAF filter and fuel ejectors for $200. Looked like it was fixed. A week later check engine light came on again and when I brought in found the PO 420 reading. They did not tell me if other computer read-outs were coming up as well.
Now they want to leave the oxygen sensor in front but change the one behind. Put in a newcatalytic converter $539 {they had quoted me $238 but it wasn't an OEM one I guess and they said they wouldn't warranty anything but this expensive one), charge me$137 for the oxygen sensor190 laborplus taxfor a total of a whooping $946!
I am afraid they will do this very expensive job and the check engine light will come on and htey will say o its something else.how can i be sure? also I was reading for a catalytic converter to go bad, something has caused it...what would that be? how to find out. Do they need to do the diagnosis with gas analyzer etc?
Why I spend a huge amount for an old car that is running well, not losing gas mileage, but perhaps is a bit slower on power.
i have camry 2000 xle and my problem is rear light indicator turn on although all rear light work ok.
View 2 RepliesI own a 2010 Toyota Corolla S the 1.8L 2ZR-FE engine. Today after work I started the car in a sheltered car garage and as soon as I started the car the after the initial start up sequence the check engine light stayed on and the traction control light stayed on and right next to it on the left side the "VSC Off" light kept blinking and flashing. I turned off the car and started it several times to see if that did anything and to no avail nothing happened.
While I was driving those lights stayed on and the VSC off light kept on blinking.
I also checked the brakes and the brake fluid and they all seem to be fine, I even checked the fuel door as well.
I am not sure what is wrong. I was looking at some of the complaint sites and most people say it happens when you drive through a deep puddle or if it is cold and wet outside. But that didn't make sense because I drove in the snow and those lights never turned on. The only time I used the ETS button is during the snow storms and I drive at low speeds.
I need to know why this VSC off light is blinking? Is it a bad sensor or is the ABS/ETS brake system broken or is it an ECU issue or is it because of an alignment. Since I was told to get an alignment soon.
See also: 2010 Toyota Corolla Question: Check engine light on and "VSC off" light blinking with the ETS light on.
I have a 2000 F-350 Dually. One of the rear fender lights is not working. Is there a way to check the bulb without pulling the inner liner to access it?
View 5 RepliesMy 1994 Toyota Corolla's speedometer just stopped working while I was driving this morning. Does this mean that there could be something worse going on than just my speedometer?
View 4 Replies2000 toyota corolla feels like it has no brakesI had the brake master cylinder replaced a few months ago - so that's not itThe mechanic also replaced the shoes - so that's not itAfter I told him it still feels like the is low etc. he adjusted them or something - so that's not itIt still feels the sameWhat should I do?
View 7 RepliesI have a 2000 Corolla with 51k miles that I bought a couple of months ago.
Things I replaced:- both front ball joints- both front CV axles (half shaft)...previous left front one was leaking- all struts (complete struts that included coil, strut, mount)- all sway bar end links- 4 new tires (only put 200 miles on them)- balance and alignment - Firestone checked for bent rims - none found- Made sure all 4 PSI levels are 30
Before the new tires, there was a vibration at 60-70mph, after the new tires, there is a vibration at 40-50..seems to go away at 60-70mph. When braking, the steering wheel shimmied (turn left/right short distances rapidly)...replacing the ball joints fixed that....the mechanic also tightened the front control arms..that could've fixed it too.
When going very slowly over a flat road, I can feel the front left tire "hop" very slightly. By hop, I mean that it is not round like (seems like a high spot). I jacked all 4 wheels and checked for any amount of play - none.
Could this be an out of balance (even though I put 4 new tires) or control arm issue? Maybe the control arm bushings are gone and it allows vertical movement during load?
When turning the steering wheel left, it also makes a "pop" sound which is definitely coming from the strut mount area...might be related.
My 2000 Corolla CE does not have ABS, I've heard the correct way to brake is to pump the brakes. Should I press the brake slowly and then depress fully and then press again OR should I press the brake, depress half way, and press again? How fast should I pulsate it? My commute involves a lot of braking and I don't want the rotors to become warped.
View 10 RepliesI have a 2005 Toyota Camry that we purchased 14 months ago. When purchased it had bad brakes so the dealer replaced the rotors and calipers at their expense. A month ago I took the car in for a routine oil change and was notified that my rear calipers were stuck open and that my rear brakes were not working and rusted. The rotors look hardly worn, the one on the passenger side has some deep grooves in it and the driver side is pitted. We feel that we had poor work done when the brakes were replaced and that the back never worked. After the brake job was done we would get some "chinging" noise in the back brakes and I had them inspected twice and they said everything was fine. But now we find out they weren't fine.
View 8 RepliesSo I took my 2005 Corolla this morning to get it detailed at a Eco Detailing place. They use steam instead of water. When I picked it up it looked good and I left. On the way home I went to turn on the radio and nada. No lights, no sound. The rest of my dashboard was working fine. So I called the place and told the main dude what happened. He said this happens sometime when the doors of the car are left open for three - four hours. He said give it a couple of days and the radio would reset. I'm pretty doubtful. I have all the windows down in the car to dry out any left over humidity.
View 3 RepliesBrake and Revers lights not working on 1999 Toyota Corolla? I have checked fuses and wire connections with no results. My brake and reverse lights just stopped working yesterday and I don't know what else to check.
View 1 RepliesAll lights and wipers just stopped working on my 78 corolla. Replaced fuses did not work. Where do I go from here? I am an absolute novice but want to figure this out.
View 6 RepliesThe air conditioning blower motor stopped working this past summer (worst timing ever). I took it out, put it back in, and it worked again for a day before dying for good. So, I ordered a new one and replaced it. The replacement was working fine for about 5 months, but it then began exhibiting the same problem as the original: it wouldn't come on until after I'd been driving for a while. The new unit never made any unusual noises while running (the old one got noisy just before I replaced it), but now it isn't coming on at all. I find it hard to believe that the replacement blower motor has failed after only 5 months. What else should I check?
View 5 RepliesI have a 2000 Toyota corolla with about 170,000 miles and it is using about one quart of oil every 500 miles. The last couple places I took it to said the compression was bad in the number 4 cylinder. Another place said it was a leaking head gasket. Which is most likely, and is it worth getting it repaired given its age and mileage?
View 13 RepliesI have a 2000 toyota corolla, with 1.8 16 valve. 105,000 miles, manual trans.. Just bought this veh. says misfire cylinder 4. So here is what I have done.
I started trouble shooting. swapping coils from cylinder 4 to other cylinders to see if the code follows after clearing it. No, stayed at 4..
So I moved on to the fuel injector. I did the same thing to see if it followed.. no stayed at cylinder 4. I changed the plugs, stilll misfire..
I did a compression check, I have 170 on 1,2,3, and on cylinder 4 I have 0. Yep, none...
I have some black smoke when the car is under load, as in acceleration, shaking and constant miss. lack of power... Trying to determine whether it is the rings or valves or what.. I took valve cover off and checked for broken spring, and they all seem ok. No oil in my coolant or vise versa.
I drove my car to the store today without any problems. When I started it back up again, I noticed a clicking sound. At first I thought that maybe I had turned on the turn signal or the emergency blinkers, but neither was on. I turned off the car and restarted it. The clicking restarted when I turned the car back on. I tried turning off my headlights, and the clicking got louder. I turned them back on and it got quieter.
At that point I decided to just drive home. The clicking stopped and restarted several times during my trip. I checked the oil, and it's fine. What could be making the noise?
I inherited my Mother's 2000 Corolla CE with low mileage. I know that since the car was knew, she had the dealer check on why the horn did not blow every time she pressed it. I do not have those repair papers, so I do not know what they did to the car. Again, after each of 3 visits to the dealer, the horn would work for a few months. Finally, she gave up. Arizona does not test the horn, anyway. So, now, I am having the problem. (Also in my V90 Volvo post). Two cars with no horns.. Short of pulling out the air bag and the wires? Bad ground somewhere?
View 3 Replies