Buick - Parkavenue :: Check Engine Light Flashing?
Sep 2, 2011
Get in my car, try to start it and BAM it hits me. As I turn the key, the engine cranks up quick, kinda too quick, if you ask me. As I go to adjust my radio, I feel my car start to jump around and shake pretty rough. As I look at my gauges, I see my check engine light start to flash. So instead of trying to drive away, I turn it off and try to start it again. Same thing happens!! So I try it again and finally a normal start. Whew, I thought that was close. But oddly enough my check engine light comes on and stays on this time, no more flashing and the engine feels fine. What the problem could be? Is it safe to drive my car?
2000 Buick Park Avenue 3.8 auto....
View 13 Replies
Advertisement
Now I know I'm having problems when I go to start my car, and the check engine light starts flashing and my engine is idling really erratic. What could this be? I have a 2000 Buick Park Ave. I went to start it today.... problems. I have had this problem before and it seemed to correct itself.
I started my car. It was kinda rough when I started it. My engine started trembling and check engine light started flashing. I turned my car off and back on and it went away. No check engine light...no trembling..nothing!! Well, at least til now. I went to start it up and the same thing happened...really rough idle and my check engine light started flashing.
I was recently told it could be a misfire, but I was also told by a family mechanic that it could just be a faulty plug or shorted wires. Also, recently when I have been driving, my car has been feeling a little sluggish right around the 2nd gear mark, and I have watched my voltage gauge on my dash jump around a lot, anywhere from 11v to 13v. Could this be a symptom? Or the effect of something else? I don't want to get ripped of for something as simple as changing some spark plugs or wires.
View 19 Replies
I changed plugs wires and car started drove 32 miles to work started loosing power fuel pump seems to b fine check engine came on then started flashing worked 10 hours and car won't start 98 Buick v6 3.8....
View 3 Replies
I have a 1993 Buick Park Ave Ultra with 127,000 mi and it has a rattle like noise in the engine. I took it to the mechanic and he said it was the supercharger and that if that went out the car would not run. I would like info on the supercharger, eg. is it critical for just riding around town and exactly what it does, and how expense is it to fix/replace.
View 5 Replies
I own a 1999 Park Avenue Ultra. Recently it's developed a problem where the engine just stops when I'm driving. It happens at all speeds--on the highway, on local roads, in parking lots, or just idling. Starting up the car after it stalls is not problem; it always starts right up. The car stalls at least once a day after it's all warmed up. Additional stalls can occur, but there is no quantifiable interval between additional stalls. This car has spent most of its 148,000 miles in the upper Midwest. This past winter I drove to car to Arizona, and that's when the stalling started. One mechanic looked at the car, but couldn't find anything wrong and couldn't get it to stall when he took it out for an extended drive. What the problem might be?
View 3 Replies
Most cars have either an idiot light or a volt meter. This 1995 Buick Park Avenue has both in the same pod. The customer complains that the red light comes on intermittently, but the voltage continues to read just above 13 volts. Sometimes it's dim or flickering, others it's bright. It seems to be more prevalent when the headlights are off, rather than when it is under a heavier load with them or the A/C on. I have not had an opportunity to see the car. It has not failed to start.
View 4 Replies
I first thought my issue might be the ignition switch or maybe the neutral safety switch but through some info I've come to realize that my issue appears to be from the anti theft system. I did a test where I turned key to start and backed off to run and then leave car for 10 minutes. I did this 3 times and it was supposed to go around the security system and then try to start but it didn't. I went through two trials with the same result. On the first of 3 times in each of the two trials the security light was not on but the 2nd and 3rd times it stayed on. I've heard this problem can be nearly impossible to trace and repair.
View 10 Replies
I have a 2000 Buick Park Ave, and recently since the cold weather is coming around I am starting to hear a slight squeaking from under my hood around the engine pulleys. It doesn't make noise upon start ( no screeching or clicking) but after its started and starts to idle I am hearing a slight chirping, and I have notice that as the weather has gotten colder that chirping/ squeaking is starting to get a little louder. After The car warms up the chirping/ squeaking seems to go away but is this a problem I should Be worried about? Is this a major issue or a minor issue?
View 3 Replies
I am told I am possibly having some engine misfires and I need to get my error codes read. The problem is I don't want to drive the car to an auto parts store to get read because the engine is really rough and bumpy. So what kind of code reader to get, OBD I, OBD II, CAN..etc??? I have a 2000 Buick Park Ave. I have a mechanic coming over tomorrow, and it seems he doesn't have a code reader off hand, so I gotta pick one up...
View 4 Replies
2006 Buick Lacrosse, CXL, 78K miles. 6 months ago, the check gas cap message came on. The gas cap was replaced. The message is still on. Soon after, the engine light came on as well. The Buick dealer said (without running a diagnostic or looking at the car) we needed to replace the catalytic converter and it would be expensive! Had 2 diagnostic tests run - one at a garage and one at an auto parts shop. No codes were detected.
Whenever the car is close to its 3k oil change, an "'oil low" message appears. The oil has never been low, it's an annoying message to get the oil changed. As the gas cap/engine light came on shortly before its 75K mile check, could this be the same case?
The car runs great and there has been no change in gas mileage.
View 11 Replies
On 12/30/14 my car had 6 spark plugs and a gasket replaced by a GM dealershhip in response to the check engine light being on. An air induction service and a fuel injector cleaning service was also performed at this time. On 01/26/15 I had to replace the battery in my car. After replacing the battery the check engine light was on and has stayed on. I read elsewhere online something to the effect that when a car battery is changed your car has to relearn the emissions system and the check engine light might possibly come on but should go off after driving awhile. I have driven approximately 300 miles since the battery change and the car is running fine. However, the check engine light is still on. The GM dealership is in another town and I hate to make the trip to have it checked if I don't really need to.
View 6 Replies
I am having a hard time getting the low EGR flow check engine code to clear. The EGR valve and tube from the exhaust manifold were replaced, the wiring harness verified, the passage channel between the EGR valve and the intake manifold cleaned out...but the check engine light remains... what to try next?
View 12 Replies
I was going to look into getting a replacement EGR valve from AutoZone, which I did. After installing the valve and on my way to reset the check engine light, it went away and has not come back.
View 1 Replies
I have a 1998 expedition 4.6 4x4 check engine light on od light flashing sometimes checked it and got p1747 code i was told epc solenoid or short on trans wiring. I already dropped the trans pan, looking for a step by step easy way to diagnose and find the short or if i need to replace any of the solenoids. I have voltmeter and taste light....
View 3 Replies
I've got a 2006 B9 with about 64,000 miles. Just a bit ago my check engine and ABS light came on, along with my cruise light flashing.
After researching a little bit on the forums and couldn't find an answer, I took it into the dealer, to which I was told that there was a bad oil pressure sensor for the right-hand side of the motor. I had them replace it out, and less than 20 miles down the road, the same lights appeared on my instrument cluster, and I took it back to the dealer. They informed me that there was now a bad sensor on the left hand side that would be another $380. I scheduled an appointment for later next week, and had them reset the error.
On the same day, about 2 hours later the lights reappeared on my dash, and I took the car over to a local parts store, where I used their scanner and the car now spit the following errors:
Camshaft position actuator A - Bank 1 timing over advan.
Camshaft position actuator A - Bank 2 timing over advan
Cam/crankshaft pos. correlation sensor A - Bank 2
Cam/crankshaft pos. Correlation sensor A - Bank 1
Camshaft position actuator A bank 1 timing over - advan
Camshaft position adctuator A bank 2 timing over -advan
Cam/crankshaft pos correlation sensor A - bank 1
I reset the codes, and waited another day for the lights to reappear on the dash. Again, I rescanned the errors, and found the same top 5 codes that I listed above.
Is there something more major going on here with the computer?
View 5 Replies
Had an issue with "check" engine light turning on and "cruise" control light flashing, intermittently. Dealer said we had dirty oil contaminating some solenoid valves in the system but we had just done an oil change and do so every 3-5K (car has 170K). They recommended switching around the sensors and doing an "oil flush" with another oil change. The warning light problem hasn't recurred, in the past month, since we started giving the gas cap a few extra turns after a fill-up. We're getting ready to buy a new car and don't want to give what might be a serious problem over to the next owner.
View 6 Replies
I have a 2007 L.L. Bean Edition Forester. The cruise light is flashing and check engine light is solid. I am well into my retirement age and nearest dealer is about 2 hours away. Is this something that local mechanic can fix? He is very good, but not Subaru schooled. I'm afraid to drive it now.
View 2 Replies
Have a Volvo XC70 and LOVE it! Recently ETS light came on and Check engine has always been on, mechanics did not seem to worried in past. As of the last month seemed to be issue with thermostat... Car would warm to normal when idling and driving below 25 mph... once I accelerated needle would drop and thermostat would go to baseline... Could feel faint warm air, but was only getting cold air coming from vents... Thought it might be thermostat stuck open?
Called my trusted mechanic and he recommended going to a radiator specialist, felt he might not be able to solve. Went to new shop today, after dropping off at 8am when they opened and not hearing from them until 4:45pm, 15 minutes before they close... Car is fixed, or so they say. Hot air is indeed coming out of vents and needle is staying where it should without falling...
BUT, now there is a strange smell (sulfur"ish") coming from the engine, and the car is shuddering and vibrating, bucking almost when car comes to a stop and then accelerates. ETS light is back on and check engine is now flashing!?! Tried going up hill on the way home and could not go faster than 20mph? None of this was happening before I took it in to the new shop today? They changed oil and oil filter and flushed radiater?
View 8 Replies
I have recently been having some movement in the rear of my car...I can mainly feel it when I am going under 20 mph. I have had replaced the two rear tires with other used tires cuz my original tires were going bald. Can this be the problem? Can Broken belts on the tires or "BAD TIRES" can cause this or is it another problem I should be worried about i.e sway bar links/ sway bar, etc.? 2000 buick PA 3.8
View 5 Replies
I have a 2004 Audi A6 wagon that's got 105k miles on it. A couple months ago, the check engine light came on while I was driving it. While it was on, it was flashing and the car felt like it was shuddering, like there was not enough gas getting to the engine. Then the CIL stopped flashing. It happened several times during my short outing that day, but then it never happened again. Now the flashing CIL is back and the car feels the same way when it's happening. I took it to an auto parts store to get the trouble codes read and the guy said P0300 (random cylinder misfire) and P0305 (cylinder 5 misfire) came up.
View 18 Replies
As the title says, my CEL goes on and flashes too.
I've read up a bit on why the CEL comes on/flash and it says it has something to do with the exhaust system and if continue operating will damage the catalyst converter (which I don't understand since I'm a car dummy.
In addition, the engine vibrates like crazy. I can feel the engine vibrating when I'm inside the car as well.
I already got the car tolled to the dealership and they kinda just told me it might be misfirings and then they said they couldn't locate the problem. So my car basically has to stay there until they open again on Monday and hopefully they will figure out the problem/fix it under the warranty and call me back.
The problem arise late Friday night and I just did a 30K maintenance on Thursday. (but the car already has 43,000 miles on it).
View 35 Replies
