Subaru - Legacy :: Check Engine Light Turning On And Cruise Control Light Flashing
Apr 14, 2013
Had an issue with "check" engine light turning on and "cruise" control light flashing, intermittently. Dealer said we had dirty oil contaminating some solenoid valves in the system but we had just done an oil change and do so every 3-5K (car has 170K). They recommended switching around the sensors and doing an "oil flush" with another oil change. The warning light problem hasn't recurred, in the past month, since we started giving the gas cap a few extra turns after a fill-up. We're getting ready to buy a new car and don't want to give what might be a serious problem over to the next owner.
View 6 Replies
Advertisement
My mechanic can't find the problem. Engine light comes on. Along with the flashing cruise control. His diagnostic doesn't show him the exact problem as the voltage changes. He has checked everything related, changed out the bank 2 sensor 1 oxygen sensor, but can't find the problem. I don't know the diagnostic code. But he says that it doesn't give him an exact code. Can only the dealer do this? Car runs fine.
View 10 Replies
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 Replies
I've got a 2006 B9 with about 64,000 miles. Just a bit ago my check engine and ABS light came on, along with my cruise light flashing.
After researching a little bit on the forums and couldn't find an answer, I took it into the dealer, to which I was told that there was a bad oil pressure sensor for the right-hand side of the motor. I had them replace it out, and less than 20 miles down the road, the same lights appeared on my instrument cluster, and I took it back to the dealer. They informed me that there was now a bad sensor on the left hand side that would be another $380. I scheduled an appointment for later next week, and had them reset the error.
On the same day, about 2 hours later the lights reappeared on my dash, and I took the car over to a local parts store, where I used their scanner and the car now spit the following errors:
Camshaft position actuator A - Bank 1 timing over advan.
Camshaft position actuator A - Bank 2 timing over advan
Cam/crankshaft pos. correlation sensor A - Bank 2
Cam/crankshaft pos. Correlation sensor A - Bank 1
Camshaft position actuator A bank 1 timing over - advan
Camshaft position adctuator A bank 2 timing over -advan
Cam/crankshaft pos correlation sensor A - bank 1
I reset the codes, and waited another day for the lights to reappear on the dash. Again, I rescanned the errors, and found the same top 5 codes that I listed above.
Is there something more major going on here with the computer?
View 5 Replies
I have a 2007 L.L. Bean Edition Forester. The cruise light is flashing and check engine light is solid. I am well into my retirement age and nearest dealer is about 2 hours away. Is this something that local mechanic can fix? He is very good, but not Subaru schooled. I'm afraid to drive it now.
View 2 Replies
I have a 2005 Subaru Outback with 179,000 miles on it. My engine and cruise control lights flash on and off....have been doing this for 6 months now....intermittently. My mechanic said the he cleared the computer and to wait and see if it happens again. He said that it might be the catalytic converter. The car runs fine whether or not the lights are flashing.
View 3 Replies
My 2005 Subaru Legacy 2.5i - the engine light is on and the cruise control light is blinking. This happened once before and it went away after I recapped the fuel cap. However, this time it did not work. The car is running ok.
View 4 Replies
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
View 10 Replies
I have a 2006 2.5 limited turbo outback wagon. Recently the engine light came on not flashing..the cruise control light is flashing. I live in a very remote area over a hour away from a dealer ship..and having problems finding someone with a diagnostic tool..Am I damaging my car by driving it still..I did just prior to the lights coming on filled the tank and after checking the cap I realized I did not tighten it as I should have.
View 6 Replies
On my 2007 Subaru Forester (100k miles) the CEL light is on and my cruise control light is blinking (cruise control does not work in this condition). Computer scan indicated front O2 sensor failed and my mechanic replaced it. No joy. Computer scan reported 0 data from EGR valve--replaced it. No joy.
View 2 Replies
I bought my Subaru in 2004 with 14,000 miles on it. The check engine light began coming on soon thereafter. The Subaru dealer has replaced my catalytic converter (the so-called problem) -- 3 TIMES up to 85,000 miles. The check engine has continued to come on and it goes off since then. Mostly, it's on, but now and then, it goes off. I bought my own diagnostics kit because I got tired of taking it in every time the light came on. I'm told it's the usual problems plus they usually have me get the oxygen sensor repaired. I've also been told to make sure my gas cap is tightly closed. Still the check engine light continues to come on and now and then it goes off (it's currently "on").
View 4 Replies
My car will drive fine, then @ 60 mph or above sometimes it will sputter and the check engine light will blink on. I brought it to my mechanic and plugged it in. Miss-fire on some spark plugs. They replaced all spark plugs and wires. The car is sill doing the same thing. My mechanic plugged it in again and now just a miss fire on #2 plug. (even after new wires and plug) Only seems to happen once the car is warmed up. If left sitting for 15 hrs the check engine light goes off completely. Only to come on again, after driven 25 or more miles. What could be wrong?
View 10 Replies
When I turn the key all the way over, I hear only one click, and no engine sound. Playing with park or neutral positions do nothing. Battery and connections are good. I am getting a raw fuel smell out of the tail pipe after it finally starts. The check engine light intermittently comes on, by now it is mostly on.
My guesses are: fuel pump/relay problems, starter/connection problems.
View 7 Replies
On the way home from purchasing this 2.5i Premium the BRAKE light started flashing when I got to 40mph. - yes, the emergency brake was off. Car was roaring like the brake was on-ablut 5 mi. to home. When I drove it back to dealer/service to get a few minor "We owe" things done, same thing happened again when up to 40mph. This was reported to service and car was driven by service manager. They reported a bad wheel bearing front R, and later in day found out rear R wheel bearing also bad. Yes, to be replaced..
View 19 Replies
Last week, the brake, traction control, cruise, and check engine lights all came on my dash. All but check engine were flashing. The car seemed to be driving fine but cruise would not engage. I drove it to a local mechanic who checked the battery and alternator and reset the computer. He said there was nothing wrong with the car. The next day the lights started flashing again so I made an appt to take it to another garage. This place said my gas cap needed to be replaced (hence the check engine light) and that my vehicle dynamic module was busted. My dilemma is that since picking the car up 4 days ago, and driving roughly 200 miles since, the lights haven't come back on. My current plan is to wait a bit and see if they do but I'm wondering if there's a chance that the VDM is ok.
View 19 Replies
I have a 2000 Subaru Outback. The check engine light has been coming off and on for the past couple weeks, but today the light started flashing. The car is running a little funny - not accelerating well and shaking when I start it. What's wrong with it?
View 4 Replies
I have a 2011 Legacy Sedan with 40K miles. Three weeks ago, I drove the car 25 miles in 90+degree heat on the highway. I parked at a store, did not use the electronic parking brake and when I returned to the car 5 minutes later and started it, the dashboard BRAKE light was flashing. The brake was not engaged. I tried to engage and release it, but it would not engage, when I pushed the button the car 'chirped'. I drove the car home and garaged it. The next morning (after a cooler evening) the light no longer flashed. At that time I was able to engage and release the electronic parking brake and it worked as designed.
A similar sequence has occurred on four different occasions. When I start a cool car, no light. When I start the car after it's been run for a while, I'm getting the flashing light.
I've checked the brake fluid and it's fine. I've checked the OBD and it shows no codes.
View 1 Replies
I was in cruise control at 50 and pressed and held the increase speed button to pass a car and once i got to 55 and still holding it the check engine light flashed twice a second until i released the increase speed button. Are you not suppose hold that button? Could this be APR related? I also noticed that the speed doesn't matter, it could be at any speed just hold it for like 5 seconds...
View 4 Replies
I have an '05 I bought 3 years ago and any time it sits outside and gets rained on, the VSC/check engine light comes on when I start it and it doesn't go away for 2-3 days at a time. The frustrating part is that any time this happens, I get the E3 error with the cruise control even though there's not a drop of water to be found anywhere.
View 6 Replies
I was driving slowly with cruise control on when the check engine light came on, a few restarts and it still didn't go away. All fluid levels are OK, no other errors show up on start-up or driving and the car drives fine on both ICE and EV modes.
I'm bringing the car in first thing tomorrow. I called my usual Lexus guy and he didn't know what the problem could be either. I'm a bit freaked out, to be honest. Wish I had an OBD dongle to use with Carista.
View 4 Replies
I have a 2005 f-150 street boss with 79000 mile, and it is shooting off going down the road, and the check engine light is flashing. The first time I started it back up and it would idle fine, but the throttle wouldn't do any thing. After setting about 15 min. I started it up and it ran good. I checked the codes and it had a p2104 Throttle actuator control system forced idle. It happened again with my wife. This time when I checked the codes it had the p2104 and a p2112 throttle actuator control system stuck closed code. What could be the problem, or a troubleshooting guide I could use to try and diagnose it.
View 6 Replies
