Subaru - Legacy :: 2004 - Engine Light Comes On Along With Flashing Cruise Control
Jul 13, 2012
My mechanic can't find the problem. Engine light comes on. Along with the flashing cruise control. His diagnostic doesn't show him the exact problem as the voltage changes. He has checked everything related, changed out the bank 2 sensor 1 oxygen sensor, but can't find the problem. I don't know the diagnostic code. But he says that it doesn't give him an exact code. Can only the dealer do this? Car runs fine.
View 10 Replies
Advertisement
Had an issue with "check" engine light turning on and "cruise" control light flashing, intermittently. Dealer said we had dirty oil contaminating some solenoid valves in the system but we had just done an oil change and do so every 3-5K (car has 170K). They recommended switching around the sensors and doing an "oil flush" with another oil change. The warning light problem hasn't recurred, in the past month, since we started giving the gas cap a few extra turns after a fill-up. We're getting ready to buy a new car and don't want to give what might be a serious problem over to the next owner.
View 6 Replies
I have a 2005 Subaru Outback with 179,000 miles on it. My engine and cruise control lights flash on and off....have been doing this for 6 months now....intermittently. My mechanic said the he cleared the computer and to wait and see if it happens again. He said that it might be the catalytic converter. The car runs fine whether or not the lights are flashing.
View 3 Replies
I just bought a 2006 Subaru forester with 130K miles. Recently, the check engine light came and at the same time the cruise control started flashing. I brought it to the mechanic who said I had a bad catalytic converter. The car seems to be running just fine and now a day later the engine light is off.
View 3 Replies
My 2005 Subaru Legacy 2.5i - the engine light is on and the cruise control light is blinking. This happened once before and it went away after I recapped the fuel cap. However, this time it did not work. The car is running ok.
View 4 Replies
I have a 2006 2.5 limited turbo outback wagon. Recently the engine light came on not flashing..the cruise control light is flashing. I live in a very remote area over a hour away from a dealer ship..and having problems finding someone with a diagnostic tool..Am I damaging my car by driving it still..I did just prior to the lights coming on filled the tank and after checking the cap I realized I did not tighten it as I should have.
View 6 Replies
On my 2007 Subaru Forester (100k miles) the CEL light is on and my cruise control light is blinking (cruise control does not work in this condition). Computer scan indicated front O2 sensor failed and my mechanic replaced it. No joy. Computer scan reported 0 data from EGR valve--replaced it. No joy.
View 2 Replies
Last week, the brake, traction control, cruise, and check engine lights all came on my dash. All but check engine were flashing. The car seemed to be driving fine but cruise would not engage. I drove it to a local mechanic who checked the battery and alternator and reset the computer. He said there was nothing wrong with the car. The next day the lights started flashing again so I made an appt to take it to another garage. This place said my gas cap needed to be replaced (hence the check engine light) and that my vehicle dynamic module was busted. My dilemma is that since picking the car up 4 days ago, and driving roughly 200 miles since, the lights haven't come back on. My current plan is to wait a bit and see if they do but I'm wondering if there's a chance that the VDM is ok.
View 19 Replies
engine light and flashing cruise control switch--computer says replace bank one---so I replace with factory catalytic converter----six months later light comes back on with flashing cruise control switch and computer asking me to replace bank one---So I use computer to shut light off----four weeks later light comes back on----called dealer they said "we usually replace both banks"---I found it most painful paying for dealer supplied catalytic converter even when I was under the impression that it would keep light off.---This is my wife's car and she is not really buying the piece of black electrical tape I placed on dash over check engine light.---Am I dealing with a bad oxygen sensor ?
View 5 Replies
My 2010 Subaru Outback recently surprised the hell out of me by simultaneously turning on the brake warning light, the traction control light, the check engine light and (just for a bonus!) disabled my cruise control while flashing the cruise control light. I pulled over, quickly surmising that all of those systems could not have failed at 70 MPH without instantaneous death to either me or the vehicle. Both apparently still being alive, I tried turning the car on an off to reset the lights. No go. Subaru was not going to miss this chance to get me to the dealership! (who I had avoided to this point!) As I was far away from home and the car being very healthy, it seemed, I decided to drive on. I proceeded to put a couple of hundred more miles on the car before I got back to town.
My car had 39,000 miles on it, 3,000 miles beyond the warranty end. I learned that I have an error code of P0171, "Fuel Trim Malfunction (Air/Fuel too lean)". So I guess I'm wondering about a few things...why would this sensor set off every light on my dashboard and disable my cruise control? Seems a bit overblown for running a bit lean. My gut tells me Subaru has a sensor/software problem they are not owning up to. I'm a big fan of conspiracy theories and this really smells like one...
Second, jeez, I'm only 3K miles over warranty, don't you think they'd cut me some slack. I mean I love my Subaru, or did anyway, until this happened. Now it's just another POS car that breaks for no apparent reason...
View 10 Replies
I've got a 2006 B9 with about 64,000 miles. Just a bit ago my check engine and ABS light came on, along with my cruise light flashing.
After researching a little bit on the forums and couldn't find an answer, I took it into the dealer, to which I was told that there was a bad oil pressure sensor for the right-hand side of the motor. I had them replace it out, and less than 20 miles down the road, the same lights appeared on my instrument cluster, and I took it back to the dealer. They informed me that there was now a bad sensor on the left hand side that would be another $380. I scheduled an appointment for later next week, and had them reset the error.
On the same day, about 2 hours later the lights reappeared on my dash, and I took the car over to a local parts store, where I used their scanner and the car now spit the following errors:
Camshaft position actuator A - Bank 1 timing over advan.
Camshaft position actuator A - Bank 2 timing over advan
Cam/crankshaft pos. correlation sensor A - Bank 2
Cam/crankshaft pos. Correlation sensor A - Bank 1
Camshaft position actuator A bank 1 timing over - advan
Camshaft position adctuator A bank 2 timing over -advan
Cam/crankshaft pos correlation sensor A - bank 1
I reset the codes, and waited another day for the lights to reappear on the dash. Again, I rescanned the errors, and found the same top 5 codes that I listed above.
Is there something more major going on here with the computer?
View 5 Replies
I have a 2007 L.L. Bean Edition Forester. The cruise light is flashing and check engine light is solid. I am well into my retirement age and nearest dealer is about 2 hours away. Is this something that local mechanic can fix? He is very good, but not Subaru schooled. I'm afraid to drive it now.
View 2 Replies
On the way home from purchasing this 2.5i Premium the BRAKE light started flashing when I got to 40mph. - yes, the emergency brake was off. Car was roaring like the brake was on-ablut 5 mi. to home. When I drove it back to dealer/service to get a few minor "We owe" things done, same thing happened again when up to 40mph. This was reported to service and car was driven by service manager. They reported a bad wheel bearing front R, and later in day found out rear R wheel bearing also bad. Yes, to be replaced..
View 19 Replies
I have a 2011 Legacy Sedan with 40K miles. Three weeks ago, I drove the car 25 miles in 90+degree heat on the highway. I parked at a store, did not use the electronic parking brake and when I returned to the car 5 minutes later and started it, the dashboard BRAKE light was flashing. The brake was not engaged. I tried to engage and release it, but it would not engage, when I pushed the button the car 'chirped'. I drove the car home and garaged it. The next morning (after a cooler evening) the light no longer flashed. At that time I was able to engage and release the electronic parking brake and it worked as designed.
A similar sequence has occurred on four different occasions. When I start a cool car, no light. When I start the car after it's been run for a while, I'm getting the flashing light.
I've checked the brake fluid and it's fine. I've checked the OBD and it shows no codes.
View 1 Replies
My engine and cruise control lights keep flashing....This happens intermittently (been going on like this for several months). I took it to my mechanic and he cleared the computer...was fine for awhile...but happening again. Mechanic said that if it happened again, it might be the catalytic converter. I hope not b/c this is a very expensive part to replace!!! Is my mechanic correct or could it be something else?
View 3 Replies
I just returned from a 4K trip through 7 states and my cruise control will go batty and make you pull over and re-boot the car. Basically I am cruising down the interstate with cruise control on. When I come into a town I will either pull the cruise lever forward or step on the brakes to disengage it.
The traffic comes to a stop or slows to a crawl for a short period of time. Once the traffic starts to move again and we are back to highway speeds I can no longer use the cruise control because it is intermittently flashing on the dash as a malfunction. The only time it doesn't do this is when I am slowing down if I turn the power off to the cruise control system.
I stopped in the middle of my trip at two different dealers and there were no codes stored. One dealer charged me a diagnostic the second didn't after I showed him my receipt from the day prior from the other dealer but then he wanted to sell me a brand NEW MFD.
View 8 Replies
I bought my Subaru in 2004 with 14,000 miles on it. The check engine light began coming on soon thereafter. The Subaru dealer has replaced my catalytic converter (the so-called problem) -- 3 TIMES up to 85,000 miles. The check engine has continued to come on and it goes off since then. Mostly, it's on, but now and then, it goes off. I bought my own diagnostics kit because I got tired of taking it in every time the light came on. I'm told it's the usual problems plus they usually have me get the oxygen sensor repaired. I've also been told to make sure my gas cap is tightly closed. Still the check engine light continues to come on and now and then it goes off (it's currently "on").
View 4 Replies
So I'm driving along with everything fine till I pull into a neighbors driveway to drop off some stuff. As I pull in, the check engine light suddenly comes on and the cruise control light starts blinking. As I have a scangauge II always connected, I put the car in park and check the code. It comes up as P0000. I get on my Droid III and google it - all I see is "null code" so I clear the codes and everything is fine. I figure "that's odd, but whatever". I drive home (about 1000 feet) and park and shut the car off and go inside to mull this over.
I go back out to check out the scangauge again and it requires starting the car to read out the codes. The car won't start. The battery is fine, and in fact it does the "rurrr rurrr rurr" strongly for 10 times before I figure it's not starting. I wait about 30 seconds and try again - same thing. I wait about an hour or two and try again and it starts this time right away, but then stalls right away. Start again and manually give it some gas and it keeps idling weakly. I'm able to back out and drive a short distance and come back without a stall. I let it sit for the weekend (no shops open anyway) and start it monday morning with my AAA card out... and it starts fine and runs fine all day. I basically forget about it.
About a week and a half later, I'm driving along a country highway at 55 Mph, and the same thing happens. Check engine light, cruise control light blinking and the cruise actually cuts out so I'm losing speed suddenly. I run the scangauge again and same code. The car keeps running fine though, I'm able to drive it back (w/out cruise control) the 5 miles home. Nothing out of the ordinary.
I go inside and google this some more, and there's some posts about the Scangauge causing this - but I've been using it for about 4 years w/out this happening. That said, about 2 months ago, there was a recall, and they flashed the ECU with some update so maybe that changed something, but still - worked for months before this happened. I had to get to work etc so I just cleared the code again, and so far 3 days without a recurrence. Currently I'm thinking about waiting to see if it happens again and going to Autozone and have them read the code to see if it really is the Scangauge not reading the code right or whatever...
View 3 Replies
My car will drive fine, then @ 60 mph or above sometimes it will sputter and the check engine light will blink on. I brought it to my mechanic and plugged it in. Miss-fire on some spark plugs. They replaced all spark plugs and wires. The car is sill doing the same thing. My mechanic plugged it in again and now just a miss fire on #2 plug. (even after new wires and plug) Only seems to happen once the car is warmed up. If left sitting for 15 hrs the check engine light goes off completely. Only to come on again, after driven 25 or more miles. What could be wrong?
View 10 Replies
I have a 2007 subaru outback ll bean addition with 67,000 miles. For the past year and a half my gas pedal has intermittently become unresponsive. The engine is running just fine but the check engine light and cruise control light start blinking and boom-no gas. After turning off the engine, the car won't start until the gas pedal has magically started working again. The dash lights continue to blink for several starts but then stop.
Prior to this problem, I have noticed that sometimes the console lights for the radio and AC blink and sometimes go dark at which point the controls are ineffective. As if this wasn't enough, just yesterday when trying to start the car, the engine was having trouble turning over with a rapid clicking noise. It eventually started but now the seat belt buckle alarm is out of whack and the speedometer displays "ER U1."
View 10 Replies
I'm on a road trip and was taking off this morning when my CEL, vehicle dynamics control light came on steadily, with a flashing brake light. It's Sunday and no repair shops are open and I need to drive from CO to S. Cal today. Is it safe to travel? From what I've seen, it could be a problem with the gas cap or ABS is disabled. Haven't had cruise control light come on (yet), but haven't tried driving anywhere.
View 4 Replies
