Camry :: 1994 - Won't Start - No Spark - Headlight Fuse Blowing?
Sep 10, 2015
I've been trying to work out why my 94 Camry isn't starting, and was hoping I could run a few things by you all and see if you think I'm headed in the right direction. So, here's the situation so far.
No leading-up issues of any kind. Just passed a (real) PA inspection and runs great. The car was parked just overnight, running fine the day before. The next day, it wouldn't start at all. Strong turn-over. No attempt to start. I tested a working spark plug by connecting it to the car (pulled out), and then connecting the threads to the negative terminal of the battery. While turning over, there was no spark. I then pulled the distributor cap and rotor. It appears some oil (definitely engine oil) had gotten inside from a previous known leak. The rotor contact was not super clean and looked to have some burnt up oil on it. I cleaned up all the contact points and reassembled. Nothing. Took the cap back off and tested the coil with an ohmmeter, which was all within spec. I have not tested individual terminal from the distributor, because a) I'm not entirely sure of a good way to do this and b) I doubt all four cables went bad at the same time, and if some were firing, it should be attempting to start, no? I suspect it's an issue from the distributor or before.
I had read that a coil with good ohmmeter readings may still be bad, so I ordered a new one. Should be here tomorrow.
Is there anything else I should test or look into? Oh, and is it weird that the headlight fuse keep blowing when I attempt to start the car? Does that give any clues as to the source of the problem?
View 13 Replies
Advertisement
94 camry. 4 cylinder. Coil is located on the strut housing along with the ignitor. The car was running, but overheating.
The last time it ran, it overheated badly, but was parked right away. Fans never came on.
The radiator was leaking, so that was replaced. And since the fans hadn't come on, the temp sensor for the fans, in the bottom of the rad was also replaced.
Now it won't start. It cranks over nicely, and acts like it is missing spark or fuel.
It has spark. Determined by pulling the coil wire from the center of the distributor and checking there.
I used spray starting fluid by pulling the tube from the end of the throttle body and spraying in there. The spray starting fluid should have at least caused a cough or two, if not a short start and run then die... if fuel delivery was the problem.
I have tried it with the temp switch on the manifold connected, and then disconnected. Also tried jumping that connector, so I don't think that temp switch is the problem. (It's the temp switch that has the green connector.)
I am assuming the ignitor and coil are good, otherwise I would not be getting a spark from there.
View 12 Replies
I have had this car for sum yrs never had any problem a couple months back while driving it would just shut off. Well come to find out my ign fuse would be blowing. I would replace it and it would start up and run just fine. Since then my daughter owns the car and it happened again and she replaced the fuse and it started up fine but while out of town it just shut off and now even if you replace the fuse it just blows. Just as you turn the key, it blows. So i did sum research and replaced the ignition switch. Tryed to start it and it still blows so im at my wits end. If I knew what every component that fuse ran , i could figure it out by process of elimination. I have the Chilton book but i still can't seem to find what all components that one ign fuse runs. It is a 94 grand am 3.1 v6....
View 7 Replies
I got in my 2009 Sonata this morning, started it and turned on the headlights. The headlights turned on momentarily and then turned off. The 20 amp headlight fuse blew. I cleaned the battery ground on the fender and the battery terminals. I also cleaned the connection between the battery terminal connector and the negative cable. I put everything back together and installed a new 20 amp fuse. I turned the lights on. They lit momentarily and then, predictably, blew the fuse again. Curiously enough, the "passing lights",which are just the high beams on another position on the headlight switch, still work.
View 2 Replies
I purchased a 94 Ford Explorer 4x4 4.0L w/ Automatic transmission with Overdrive. Great work truck, but I am finding that these had a lot of wiring problems. First thing that messed up with me is the backup lights wouldn't work. Then the dash lights and parking lights stopped working (Still no fuses where bad). Then about 2 weeks later, I was on my way home when It just died like someone had turned the switch off, I pulled off the side of the Interstate, and after checking my fuses/Relays under the hood.
I found that the EEC Fuse (30AMP-BIG Fuse) had blowed, I didn't have one and the truck wasn't off the road good, So I wrapped a small wire around the fuse to see if I could start it and get it out of the road better, It started right up, but soon as I pulled it off the road it died again, and I found that it melted the EEC Relay, I went to the parts store and got a new relay and fuse and put them in, It blows the fuse as soon as I put it in, with the switch off or on. I just need to know what things will cause this so I can check them out one by one, until I find the one that is causing this problem, cause It run great up till this happen.
Only other thing I may need to let you know, Is when I bought it, the key switch would start it, The guy had put a push button starter switch that you push to start it with the key on, I unhooked it, and it started fine with the key for a while then it stopped again, so I had to hook the push button back up and had been using it until it stop running with me.
View 1 Replies
I get a call from my mother saying their 1994 Toyota Camry 2.2L car won't start. I went over there today and the first thing I check was the spark. I hooked my spark tester and had my dad crank the engine over. No spark. So I removed the distributor cap and tested the resistance on the primary and secondary sides of the coil. The secondary side was low. So I went and got a new coil, installed it and it still wouldn't start. I checked the spark again and it had spark, but still wouldn't start. I then proceeded to check the fuel pressure. I hooked up my pressure tester to fuel filter, with the included adapter, and had my dad turn the ignition switch to ON position. No pressure. Then I had him try and start the engine, the pressure jumped up to 41 PSI. I then sprayed a little gas into the throttle and the engine would try to start. I'm stuck.
View 5 Replies
94 Camry, 4 cylinder. 204,000 miles. New fuel pump last year. Timing belt replaced 30K ago. Plugs and plug wires, as well as distributor cap and rotor, about 2 years old. New ignition coil about 300 miles ago. Generally very well maintained and in good shape. Today it died on the NJ Turnpike, 200 miles from home; started missing and it got progressively worse over the span of about 30 seconds to the point that the motor died. Towed to local Pep Boys (I know, but it was the only choice on a Saturday and I don't know the local area).
Mechanic says no spark but was unable to fix it. As things now stand the nearest Toyota dealer is scheduled to move the car to their shop on Monday. All the dash lights come on, including chimes and such. It will crank like a champ but will not fire up. I know this isn't giving you all much to go on, but I'm wondering if what happened could be related to the coil. Is it likely to have failed? Would replacing an old coil cause anything else to break down in the distributor?
View 10 Replies
I have a 1996 camry and the break light don't come on non of them. I change the switch under the break pedal and it didn't work. I change the fuse but when I did so it spark and blew the fuse. Is there a reason for this? where should i go next with this issue.
View 1 Replies
Have replaced distributor, spark plugs, coil, and still have very weak, erratic spark. Plugs getting plenty of fuel, won't start. What else I should do?
View 7 Replies
Sons 94 ranger 4.0 4x4 Auto 185k got him to work yesterday but would not start to bring him home. No spark, checked with timing light, and no fuel pressure. Searched and read alot of tips from Pawpaw so I tried a few things with no luck. Swapped the relays around, inspected coil pack and plugs. CEL was not on and goes out while cranking. I have a OBD scan tool but this truck must be too old or I need finding plug. Crank sensor maybe?
View 7 Replies
Every 3 or 4 days my 2000 Camry 4Cyl Std Tranny keeps blowing out the 30A Buss Fuse in the under hood fuse box. What this fuse runs and what could be the problem. I don't think my Fan Motors are running could this cause the Fuse to pop.
View 11 Replies
2002 F150 5.4L. Keeps blowing fuse in location #30 which is a 30a fuse for the following:
Passive anti theft transceiver
Cluster
Ignition Coils
Powertrain control module relay
Coil on plugs
Radio noise capacitor
ECC diode
Could this be a grounding spark plug wire?
View 4 Replies
My truck keeps blowing fuse 28 in the inside fuse box. This fuse belongs to the ignition relay, and only blows when I go to start the truck. It is intermittent
View 14 Replies
2001 F-350 diesel. Out of nowhere, I start the truck and there's no turn signals. Fuse is blown so I replace it. It immediately blows. Tail lights work. No turn signal, brake lights, or hazards. I haven't hooked up a trailer or done anything abnormal recently. Only the #1 fuse (20Amp) is blown. Pulled bulbs and they work fine. Inspected wiring under and near lights. NOTHING! Any way to localize a short?
View 2 Replies
2002 F450 7.3 Turbo
Ok first problem : Starter Motor fuse kept blowing and I spent weeks trying to figure it out. No luck. so wired up a push button just to get the truck started, its a work truck so it was needed asap.
2nd problem : he truck stopped starting completely. Wont start in Park or neutral and after a NEW STARTER (because I thought the solenoid on the starter was bad I replaced it) Everything work correctly for one start with the key. After the second time trying to start it blew the starter fuse again. So I tried the straight wiring to starter. still nothing. I was wondering if there are any shims or anything at the transmission housing to correctly position the starter. I am thinking that maybe the gear is stuck or gets stuck sometimes. when I straight wire the starter it does nothing but the wire gets hot so I know its pulling.
View 3 Replies
I have an electrical problem with the rear brake lights on my 03 Camry. The fuse keeps blowing the instant I step on the brake. I replace it and it blows immediately. So now i can't drive it because I have no brake lights. I'm thinking there is a short somewhere, where to start my troubleshooting?
View 4 Replies
Working on my buddys 2003 camry, wont start, has air and spark and not getting fuel. replaced fuel pump already. If you hit it with a quite a bit of starting fluid it will fire up for a few moments and then die out, its got half tank of gas. The whole start of this is he ran out of gas and since then wont start.
View 7 Replies
Just bought a 1994 Camry Station Wagon, 84,000 km (53,000 miles) in very good condition. The two pre-owners used to keep car in garage inside the house, I keep the Camry out on the street.
Currently, I am experiencing the following problem: When it is cold outside (this is 20 to 25 degrees F), the car would not start the other morning. Everything inside the car is working (i.e. lights, radio, fan, sunroof etc.), a sign that battery is in good shape. Before buying the car, the owner replaced all the expendable parts you can imagine. Once it is getting warmer, the car would start perfectly well.
In the Consumer Guide I read the following about starting problems in the trouble spots section (referring to the 1992-1996 Camry series): "Hard starting: Hard starting after cold soak is due to ignition-coil voltage leaking to an inappropriate ground." All models, not a specific year.
On this thread I just found a comment posted on Jan. 31, 2004 by "yotatechie04", saying that - obviously - a similar problem occured to him on a 1999 model, and he found it had to do with "oil density".
Question: Is hard starting - for example after a cold night - a well known problem to 1994 model? What about the hint regarding "ignition-coil voltage leaking" and "oil density". What can be done?
View 14 Replies
I am new to Toyotas and recently inherited a 94 Camry. When the door opens a chime starts and does not go off until the door is shut. Looking at a wiring diagram it appears that only the courtesy light operates off the door switch.
View 4 Replies
In Jan my 94 Toyota Camry started having issues with starting- for instance, I would run an errand for 10 minutes get back in the car and it wouldn't start. However, this tended to be random. When this problem happened more often I took it in and they said I needed a new starter so I got one (Feb) and didn't have any issues for a month, but then began to have the same issue on and off again. I took my car back in for the second time and they said it must have been a bad starter. They gave me ANOTHER new starter (Apr) and my issues continued soon after. I took it back in and they didn't have an answer for me other than the starter was good. Took it to another mechanic and he had the car for two days and could not find ANY ISSUE with the car. I let it brush over during the summer months because I never had this issue (June-Aug) and now that it's gotten cold again I'm having this problem.
Few things to note: -Anytime I have this issue I'll hit the starter with a hammer and it will ALWAYS start. This has been the case since January.-It ALWAYS starts in the morning and when I get back in my car after working all day. However, if I were to run errands in the morning or at night it would not start with the stop and go. -This only happens in the cold months -They tested the newest starter and they say there's nothing wrong with it.-Within the past two years I've had MANY things replaced on this car and any shops I've taken it to say it's a great car with no issues they can find.
View 10 Replies
I brought the car home last night and shut it off. This morning went out and engine will crank but doesn't show any signs of fuel or spark. Removed one plug and grounded it to block while someone cranked it. No spark. I dumped a little fuel in the cylinder just to see if I could get it to cough or something, but nothing. I tried looking for blown fuses under hood and under dash but I haven't noticed anything out of the ordinary. I pulled out all relays and tapped them and reinstalled. I tried disconnecting the battery to reset ecu and that didn't work either. There are some relays marked that I don't recognize.
View 12 Replies
