My 2002 jeep grand Cherokee Laredo 4x4 is shifting hard from first to second. It has 120,000 miles on it. Should I do a filter and fluid change or just work with the bands?
View 3 RepliesMy wife says our 2002 Grand Jeep Cherokee very rarely hesitates as it moves from first to second gear (once every week at most). I've never felt the problem, but she says its happens when from a dead stop into 2nd gear. And she said there are no other times when the vehicle hesitates (fine in every other gear). No other weird noises and the power seems fine. Its an automatic transmission and I've had the fluid and filter changed recently. What it is? Transmission? It is due for some new spark plugs... any chance it could be that?
View 4 RepliesThe Accent has been working great recently until the other day when I got in to go to work and now it suddenly shifts very hard into 2nd. And sometimes 3rd.
This problem seems to come and go. Sometimes it will shift smoothly. Other times it will have to reach super high rpm and I will have to let off the gas and slowly accelerate to get it to shift. This seems to happen throughout all the gears and it does not make any difference if overdrive is turned on or off. Also reverse works just fine.
I checked the fluid and it is at the proper level. It does seem to be a little dirty (not burnt) so I am planning on changing the transmission fluid, but something tells me that is not going to solve this issue. It seems like an electrical issue to me. What it could be?
There are no codes at all on the car. Don't know if it matters but the car just turned over to 100k miles. I've been reading on here about all the problems the automatic trannys have in this car but 100k seems a bit early to have any serious transmission problems.
I have a 1999 Jeep Grand Cherokee Laredo. Some of the gears are intermittently "sticking". When I get up to 60 m.p.h., it's supposed to shift into the next gear, but sometimes it won't and the vehicle starts lurching as it comes up against the "shifting wall". Other times it won't downshift, so I leave a stop light in 2nd or 3rd gear. The lurching only occurs for the gear at about 60 m.p.h., unless I put the gear selector into "2", then it sometimes lurches there too. Several mechanics, including a transmission specialist at a local Jeep dealership (who charged me for 2 hours of "diagnostic time"), couldn't determine what is wrong. I did a transmission fluid flush, but that didn't work.
View 1 RepliesI was experiencing a slight slip in the transmission first thing in the morning when the temps were below 60 degrees in my 2002 Jeep Grand Cherokee (42RE). Per recommendations of many of the regulars on this forum to combat such an issue, I added a can of Berryman's B-12 Chemtool to the fluid. I drove it a couple times and everything seemed fine. It sat for a week or so, went to drive it tonight, and now the check engine light has come on and the transmission is slipping badly.
I don't know if they have changed anything with that stuff or what, but I just wanted to give a heads up that this may not be such a hot idea anymore, for whatever reason. I will try changing the filter and top up with some fresh ATF+4 (and probably drain and refill a few times) and hope for the best. I don't have a code reader right now, so I can't pull the codes and don't want to drive it to the auto parts store the way it is now, but am pretty sure they are related to the slip.
I have a 2002 Jeep Grand Cherokee with 207,000 miles that has recently begun stalling while driving. Typically stalls at rest or when coming to a stop, and for a time it would re-start without issue. More recently it won't start readily after stalling, but will eventually start with enough key-turning persistsence. The check engine light comes on only after stalling and not restarting (but was not on previously), and often shuts off after a few miles of smooth running. I took it to my local mechanic who ran the computer codes and reported a malfunctioning cam shaft position sensor (i question if this was the casuality of other problem), which they thought was the source of the stalling, but after replacement it is stalling more than ever. It seems like the local mechanic group won't diagnose anything in this high mile Jeep without a computer code and I am reluctant to bring it back.
What is the cause of the stalling / starting issue? I may be way off but was concerned about a clogged fuel filter or fuel injection problems.
Vehicle Details : 2002 Jeep Grand Cherokee Laredo 4.0L inline 6 207,000 miles. Regular maintenance, most miles highway (2 owners) All parts stock
2002 Jeep Grand Cherokee. When letting off gas I feel a strong vibration (slight vibration when maintaining speed) in the front of vehicle. What is causing this?
View 3 Replies2002 grand cherokee... Just took her in on Friday to have valve cover and oil pan leaks fixed, and within an hour of picking it up today the automatic transmission won't get out of 1st gear… rpms rising and can't exceed about 29 mph. Straight 6 engine. Any chance the mechanic messed something up, like a throttle cable or something, or is this just terrible karma?
View 11 RepliesI have a 1998 Gr Cherokee with an automatic tranny. It is slow to shift when cold and the overdrive shifting works reasonably well but I have been told by a reputable mechanic that the tranny needs a new tranny filter at over $1000. My latest check of the tranny fluid and the level and quality indicates both are good. Should I replace the tranny filter?
Also, for the same above vehicle, when I put the vehicle into a moderately hard turn (right and left), the front wheels audibly click and you can feel the click vibration in the steering wheel when happening.
2002 Jeep Grand Cherokee. None of my tail lights or break lights are working. Turn signals, back up lights and license light work fine. Fuses all seem good. What could be happening?
View 4 RepliesMy 2002 Jeep GC (4.7 HO) is losing about a quart of oil every 1,000 miles. I've replaced the PCV elbow and this didn't work at all. There are no leaks underneath or anywhere else I can find. I never have blue exhaust either. I'm completely at a loss.
View 5 RepliesSo I noticed when it started getting cold that my Jeep emits this extremely high pitched whistling sound and I can't figure out what's going on. I've taken it to two mechanics and both said it was a belt that needed to be replaced so I had the belt replaced and the noise persisted. I've noticed a few things about the noise, it only happens when it is approximately 30 degrees outside or lower; only while the car is idling (when I accelerate the noise goes away immediately); It only happens after I've gone above approximately 30mph; The noise will go away after I've gone through a series of idling and accelerating; and stops immediately once I turn the car off. The Jeep is almost up to 150,000 miles.
View 4 RepliesI thought my transmission was not going into 2 gear, but it is. But it ain't going into 1st gear. Just found out today.
View 2 RepliesI have a 5 speed 99 Jeep Wrangler and when the car is running, it's extremely hard to put the car into first gear from a standstill. However, once it's in gear, shifting is fairly normal but still offers a little resistance. I feel like I have to wiggle it into gear. When putting the car in reverse from a standstill, the gears grind terribly.
Once the car is off, shifting is still difficult until I put it in reverse. Somehow, this "fixes" the problem and everything shifts smooth as a dream until I start the engine and then it's a 50/50 shot until it eventually fails later on.
So, I bought an used 2006 Hyundai Azera Limited few days ago. It's clean title and has 86k miles on it now.
After three days from the purchase date, my car starts causing transmission problems, hard shifting from 2nd to 3rd gear only. It's getting worse now...
Now, what should I do? ...
Have a 2000 expedition with 84,000 miles. Tranny seems to shift hard from first to second gear. Its been 24,000 miles since my last dealer tranny service. Thinking of getting a new service now before the recommended 30,000 manual recommendation. Whats happening?
View 6 RepliesI have an '03 AWD, automatic Santa Fe and it started shifting really hard into 2nd gear when going uphill recently. It also seems to take a while to shift into 2nd from 1st, but it doesn't bang like it does when downshifting.
In other threads on this site is seems like either the throttle position sensor or shift solenoids may be responsible for this. What's causing it, and how to go about fixing it?
I have a 2006 GS RWD the transmission started acting weird 4 month ago went to many workshops and no codes were found in the computer and my problem is that when i am moving in the car for more than half an hour and stop the car seems hard and jerking while shifting to 2nd gear and if i put it in tiptronic it go to 5th gear immediately it seems ok when the transmission is cold so what do you think it has got 125000 miles on it and what is the normal temperature for the transmission so i can test it with mini vci...
View 7 RepliesJust curious if there are any other 2010 owners with any difficulty shifting gears in their manual transmission camrys? I noticed during my test drive that I grinded my way into 2nd once... I thought it might have just been my nervousness with a new clutch at the time. However, I've since put 300 miles on the car and I still have trouble putting it into second gear on a daily basis. Sometimes it grinds a bit, and sometimes it catches or a half second before it pops in. All the gears OTHER than 2nd gear go in like butter as you would expect with a new transmission. I'm not new to a clutch... this is at least my 4th car with a stick, so I don't think I'm doing anything out of the ordinary when shifting.
It reminds me of some older (100,000+ mile Nissan) cars I've had in the past... the syncromesh was wearing out and it would grind going into second or third, so I put in some RedLine MTL and got a little more life out of the transmission... but there shouldn't be a need for that kind of thing on a car with less than 1000 miles on it?!
1999 Jetta MK4 with only 124k miles on it. Everything is fine with the car except when the car shifts from 2nd to 3rd it is jerky/violent/forceful everything else is good with car except check engine light is on but I don't really care about that and I'll go check with autozone to see what the code is. I am able to feather the gas when I know its going to shift and I can make the shift pretty smooth. My question to all the experts is does this mean that this tranny is on its last leg or does it still have a lot of life left in it. My old Cabriolet did it for years and never was a problem.
View 5 RepliesThird owner with about 81k, sometimes when I go to shift into sixth it seems like there is something stopping me about half way into normal position. Normally I have to go back to neutral and then try again. I don't have this issue with the other gears.
second question, I've noticed under deceleration mostly or going slow over bumps that I can hear a tin style rattle. Now the last couple days when I start the car with or without AC running there is a constant rattle making me think that whatever was rattling over bumps is about to make a run for it when I hit a big bump or something.