I have a 2005 Jeep Liberty with about 129K. The car overheated and resulted in changing the head gasket and piston rings. Now the car will not start with all six spark plugs installed. It will only start and run for a short period time with three spark plugs on the driver side installed.
View 19 RepliesOkay, so I've been hearing this strange sloshing noise in my Jeep Liberty 2005. It happens when I start off from a stop and usually around 15mph. It seems to be coming from the front of the vehicle (engine). And I'm not the only one that has heard it so I'm not crazy.
View 3 RepliesI have a 2005 jeep liberty 3.7L with 60,000 miles on it. The engine light when on 2 weeks ago and gave a p300 code. the dealership replaced coil and plugs, I believe. Then would start rough when cold, the engine light would blink for about 10 seconds then remain on. the car runs just fine except when cold....first minute of starting it. they checked for head gasket problem, and cant seem to find the problem. They told me that this could just be something that happens. I don't believe that. I have no loss of power, no hesitation. Runs fine 99% of the time
View 19 RepliesOver the past month or so I've noticed that my 2005 Jeep Liberty Limited has started to make a creaking noise when it's a little off balance, such as driving down and uneven drive-way. I believe it's coming from the back?
View 4 RepliesI have a 2005 Jeep Liberty. It recently started making a noise that I think is most accurately described as a groan/squeal. It only happens at low speed, < 20MPH, and happens more often the lower the speed. It also seems more likely to happen when the vehicle is turning. I haven't noticed any other problems with the car. The brakes and serpentine belt were recently replaced.
The brakes were replaced because they were starting to get old, looked corroded, and were starting to squeal when braking. The serpentine belt was replaced because it had a crack in it and was under warranty after being replaced for the same reason only 10 months ago. I don't believe that the noise is related to the brakes as the noise has occurred many times when the brakes were not being applied and it does not appear to occur any more or less frequently when they are applied
I got a new-to-me Jeep Liberty 2005 in February. The check engine light came on after a few weeks. Our mechanic replaced the catalytic converter twice. After the second replacement it went out after we drove for a while, but after the second one it never went out. We are now using high-test gas (to prevent carbon buildup?), but that hasn't worked either. I need to pass the emission test soon.
View 6 Replieswe have a 2005 Jeep Liberty. It has about 150000 miles and every few days it makes a sound like a guitar string breaking. sometimes, while we are driving, other times as we wait on a red light and sometimes after the car is turned off. What could be causing this?
View 7 RepliesI have a 04 3.7L V6 Jeep Liberty with about 114K miles on it. It started happening recently that when I turn the key nothing happens. I have to put my foot on the brake, shift thru the gears, back to Park, take my foot off the brake, and then the car will start. Not quite sure where to start...
View 3 RepliesThe car doesn't start, makes a click thats it. When I had it towed to my place, I noticed oil was leaking from the bottom. My tow truck guy thinks the motor's completey blown, I'm hoping it's just the starter and the oil gasket. Battery is fine, I am going to check for error codes in the morning. The car has 157,000 miles and has never been in an accident. The original owner told me the car just stopped on them. What to look for to see if the motor's completely blown or if it's something less serious.
View 19 RepliesI have a very well maintained 2005 honda odyssey with 150,000 miles on it. It typically gets 22 m.p.g. It started using an unusual amount of gas - was getting 12 m.p.g. Took it to the mechanic and turned out the gas pump was cracked. We replaced the gas pump and the gas line, and it was getting 14 m.p.g. Took it to another mechanic, and he said that the spark plugs were the problem as they were not official Honda spark plugs (we replaced them at around 110,000 miles). So we installed the official Honda spark plugs, but still no good. I have visited several mechanics and no one seems to know.
View 7 RepliesMy engine seems to misfire when I first start out and then runs smoothly. The first mechanic got a random misfire from the diagnostic and replaced all the cylinder coils which worked for about a week. The second mechanic ran a diagnostic which said random misfire and he said it was a loose spark plug. This worked for 4 days then it started misfiring again. There's no violent shaking or backfiring. I don't know much about cars but it seems odd that it doesn't keep misfiring. It's a 2006 jeep Liberty with 87,000 miles...
View 9 RepliesI drive a 2005 Jeep Liberty with about 96,000 miles on it. A couple weeks ago, the Jeep had some trouble starting. It would crank and turn over and then sputter out. I tried it again and it did the same thing. After letting it sit for a couple minutes, it started and ran fine. No warning lights or anything on the dashboard and nothing that seemed unusual. A couple days later, my wife noticed a small pool of pink fluid on the floor of the garage where my Jeep parks.
So I took the Jeep in to get it looked at. They said there was a leak in the coolant line as well as the pinion system, both of which they repaired. Since then, the Jeep has done this 3 more times, usually from a warm start. If it's been sitting for a few hours, it starts without a problem. But if I'm running errands, then the third time I try to start it, it will fail until I let it sit for a couple minutes. Then it will finally start up. What it could be before I take it back to the mechanic?
Just replaced the spark plugs and coils yesterday, today it gives P0113 code, Intake air temperature (IAT) sensor - high input Wiring open circuit/short to positive, ground wire defective, IAT sensor, ECM...
View 3 RepliesI have an interlock installed in my 2002 Jeep Liberty Sport. I've been having electrical problems in it ever since it was installed. Prior to it being installed the jeep wasn't mine, it was my grandfathers, and he says it really wasn't driven for a while consistently but it didn't have any electrical problems before the interlock was put in. I'm not sure if this is accurate or not because I'd never driven it prior to the installation. Either way, now I believe I have a short in the electrical somewhere in the system. I'm not sure how to proceed, other then to check the fuses. The battery IS currently dead, but it wasn't.
I was able to start the car and get it down the road, hoping the alternator would charge the battery (the lights were out, none came back on) After a little bit of driving down the road I drove back into my driveway because I was scared to drive without headlights, and shut the car off. It hasn't started back up and now none of the lights or anything are working at all. We've tried jump starting the car, thinking maybe the battery was dead or the alternator went out, but the cables just started smoking and getting really hot. I really need to know how to proceed to find this short, will I have to look at all the wires in the car? Or is it possible to just use the fuse box? My knowledge of electric in a car is very limited, though I do know the basic mechanics.
I am changing my own spark plugs for the first time. I have a spark plug wrench, dielectric grease, anti-seize compound etc.
I have a Haynes manual for my 2002 Toyota Corolla. The book was written before Irridium plugs were used. Should I tighten the spark plugs to the same torque specifications as regular plugs? The book says 158 inch pounds. How do I know I have tightened them to the right amount?
How do I avoid cross threading the spark plugs? What happens if you cross thread the spark plugs (assuming the car seems to be running fine)? Would I need a new engine or expensive repair when it is time to replace the spark plugs again?
04 intrepid cranks but won't start no spark at the plugs 2.7v6 could it be the pcm...
View 2 RepliesRecently replaced head on my 95 civic 1.6 Vtec, i had to replace the head gasket a few years ago so i know what to do. My problem now is that it will not start and has no spark to the plugs, i have new plugs, wires, rotor and cap, even tried a new distributor but took it back since it changed nothing. I pulled a plug wire, removed the plug and plugged it into the wire, turned the engine over and no spark.I've checked voltage to the distributor with ignition switch on and as far as i can tell it's getting voltage to the distributor. But when i try to crank it the engine turns over but will not start. It is getting gas, i took the fuel rail off with the injectors and checked for flow. I've taken timing cover off a couple of times to make sure all timing settings were as they should be. I even went ahead installed a new ignition switch which made no difference. Waste of time and money. I've checked several times to make sure all electrical connections are good. I really hope this turns out to be a simple fix but right now i'm at a loss. ECM maybe?
View 4 RepliesI just put an '86 5.0 engine from an F150 2wd pickup in my '87 truck of the same model. The motor was running when pulled but when I set in the '87, it won't run. I've replaced coil, distributor assembly, plugs, wires, throttle body, checked timing etc. I've got spark through the plugs and fuel in the cylinder but with no luck. Don't know where to turn next.
View 3 RepliesI have a 1967 Cutlass. She ran great yesterday. Today she won't start. I have spark coming out of the coil but no spark going to the plugs. Plugs and plug wires test good as well.
View 8 RepliesI have rough idle problem after changing spark plugs, fuel filter and battery. There was no rough idle problem before this work was done. What could be wrong. Once the speed is above 20 mph it seem to run fine but at stops it vibrates and seem like it may stall!
View 6 RepliesMy 2004 honda accord will not start, there is no power to the spark plugs or to the coils.
View 3 Replies