Why my key would not turn in the starter, although an hour previously and up to yesterday it has always worked just fine. Again, this morning, the key turned just fine. Is this a warning that I'm heading towards disaster?
View 10 RepliesTrying to track down an issue (annoyance) I'm having with my 02 7.3 4x4 excursion. When I get in the truck and turn the key (after waiting for glow plugs) the starter doesn't actually turn over for 1-3 seconds and sometimes up to 5. When the truck does turn over everything works perfect it's just an annoying delay.
View 13 RepliesI have a 2009 Jeep Liberty with 43,000 miles which many times in the morning, the car won't start. I hear for just a brief moment the starter motor turn on for less than half a second then turn off. I take the key out and try again. It takes a few times for it to run. I have tried different keys and once it has been started for the day, it usually is not an issue until the next morning.
View 2 RepliesI was driving to work and lost all power (during rush hour) I was able to coast to a exit. Had it towed home, when I turn the key the starter engages but nothing after that, the engine will not turn over. I checked the battery and has a full 12 volts.
I removed the belt and front plugs to see if I could manually turn the engine over but it will not budge. How can I tell if this engine is really locked up or if maybe something else is happening?
3.1 V6 engine .....
My starter clicks once when i turn the key, yet when i brought it in to have it tested it passed twice. I took one of the spark plugs out and pulled on the belt thinking maybe some antifreeze got in a cylinder and saw the piston moving up and down so i its not seized.
View 1 RepliesI have an '87 Mazda B-2000 pickup. How to turn off the EGR light? I think it comes on at set intervals when it wants you to check the EGR system.
View 1 RepliesI have a 1998 Accord EX 4-cylinder that will not start. When I turn the key the starter does not engage. The green key indicator on the instrument panel looks like it recognizes the key security chip.
When I checked for voltage at the starter solenoid coil wire I found about 9.0 volts without turning the key. When I turned the key I got a little over 11 volts. I disconnected the wire to the solenoid coil and measured 0 volts from the coil wire to the battery BUT 9.0 volts from the tab on the solenoid valve to the battery. It makes me think something is shorted to the frame of the starter.
After the CRV has been idle overnight, when I turn the key to start the car, NO sound comes from the starter -- not a pop, not a clunk, not a whir, not a wheeze. All the interior electricals work fine (radio, dashboard lights, etc.). If I repeat the process 3 or 4 (or 5 of 6) times with increasing panic, I sometimes hear a fizzing sound (sort of like frying bacon) for half a second before the starter engages and the engine turns over. Naturally, I can't reproduce the problem at the dealer, who rightly doesn't want to commit to any repairs (especially after the dealership dropped a screw into the engine at 35K miles and had to buy us a new motor!). Other CRV owners appear to have encountered this problem, but the on-line forums are sickeningly devoid of answers. Tracing the problem from ignition switch to starter, what is the likelihood that this is a defective relay in the ignition switch? A defective relay somewhere else? A defective starter solenoid? Or just a worn out starter? How to make the diagnosis?
View 4 RepliesReplaced starter after which when i turn key to on position starter will engage and actually start engine; turn to accessory and starter will engage but wont start engine. Checked double checked and so on installation. And then exchanged for another rebuilt starter with same results. the reason for replacing the starter in the first place was during the winter went out to start to let motor run fur a while which it did. Went to move before completely warmed up and killed engine starter never made another sound. 1978 gmc 6000....
View 9 RepliesI have a 1998 Dodge Caravan with just over 50,000 miles on it. This summer It started having this issue where when I turned the key, all I got was a click, and then nothing. The starter wouldn't turn over, but all other electronics seemed to be working properly. If I continued to try turning the key (2 or 3 times) eventually the starter would engage and the car would start right up. Assuming a bad connection somewhere I cleaned the battery posts, and a couple other connections I could get to, and the problem seemed to go away. About a month later the same issue started up again, and I was able to fix it the same way.
About a month and a half ago, I went to start my car, turned the key, and NO click. After turning the key a couple times the car would start as before. Then the next time I tried to start the car I again got nothing. On the third try the starter turned over, but only a few times before it died (and it sounded like it was really struggling to turn over too). The fourth time I turned the key the car started right up. This new behavior continued for about a week and then I took it into the shop.
At the shop they first started by cleaning all the connections, which did nothing. Next they put in a new starter which also didn't fix the problem. On the off chance the new starter was bad, they tried a second new starter, and again the problem continued. Finally they pulled out the wiring harness and found 3 "Bad wires" which they replaced. The then also concluded that the bad wires were causes the starter to short out, and that is why the two new starters they tried didn't work. They gave me a new starter, and that in conjunction with the new wires seemed to fix the problem.
Now, every few weeks, I'll go to turn the key, and all I'll get is a click again. The second time i turn the key, however, the car will start right up. This issue maybe happens more when its cold in the morning, but it hasn't happened enough for me to be sure. The clicking issue doesn't bother me that much because the car always starts, but I'm worried that the problem will just get worse again. Did my mechanic actually fix the problem I had? Or am I going to need to take it back in to the shop in a couple of months and put another new starter in? Also, I have had my battery tested three times throughout all of this, and it always comes back fine.
As the title states, I have a 2002 Mazda B3000 series Pickup and while everything is working great, the a/c is driving me insane!
Here's how it goes:
- Start the car, turn on the A/C, hear a click
- As I drive, after 10-20 minutes, the A/C would just either switch to (what I think is) vent; it blows humid, warm air.
- Another way to turn it off is to accelerate quickly; Note: these two scenarios are sometimes inconsistent
- Sometimes, it would occur, while other times it would just randomly turn itself off
- A solution I've found is to switch over to vent, leave it on there for a few minutes, then switch back to A/C; works for another 10-20 minutes
What I have done to fix it is to replace the freon (even though, it was never really empty; still isn't empty) and have replaced the fuse associated with the A/C.
My son's mazda 6 will turn over but not start. the things I have done:
1. replace crank sensor
2. replace cam shaft sensors
3. it has spark
4. fuel pump works
5. sprayed starting fluid in still will not start.
What else should I check? Security system?
I have a 2003 Mazda B2300 pickup that sometimes won't start. When you turn the key all the way, it won't do anything, no sounds no nothing. However, if you try it a few more times it will eventually fire up and run normally. Last Friday, I must have tried to turn it on about a dozen times but nothing happened. So I tried the old hammer on the starter motor technique and it fired up immediately.
So I thought it must be the starter motor. But since then it's been turning on normally, except once when I turned the key and it did nothing. The battery is good, I replaced that about 8 months ago, and the battery cables look good. I'm hesitant to throw a new starter in. Could it be something cheaper, like a relay or some other electrical problem? Or could it be the starter and its on its way out?
I have a 2000 Mazda B4000 with 2 little problems I don't know anything about. First is when I go to start the truck it takes a long time to turn over. A friend of mine said that a valve is not maintaining fuel pressure so the fuel is not sitting ready for the starter when I go to start up. But if i engage the key for a few seconds and time it right it will turn over easily (apparently allowing the fuel pressure to build to the appropriate level). Is this a little valve or gasket or something I can replace to maintain the pressure?
Second, when I'm coming from a stop or accelerating out of a slow roll there is a 'shudder' or 'shiver' in the drivetrain that almost feels like the shift from 1st to 2nd is just kinda lumpy. It also happens if I come to an abrupt stop, so gearing down into 1st. It doesn't feel like something that is getting worse, but I don't want it to be causing damage or have my driveshaft snap or something.Other than that this truck seems really well maintained by the previous owner, and a mechanically inclined friend of mine said everything else looks.
Developed a problem that I'm trying to research a bit to see if there is a common problem. Haven't really seen too much info yet, other than a potential clutch switch that will continue to display "depress clutch!" That's not my problem.
I don't drive this thing more than once a month or so. But occasionally I'll drive it to work for week or less.
Basically, every once in a while I'll try to start the engine and the starter will engage and turn the engine for about 1/2 second and then stop. All lights on the dash stay on. I'll reset the key, and it will usually then start normally on the next try. Sometimes it does the same thing on the second attempt.
Battery is 100% topped up, as it stays on a battery tender. Battery load test shows great. Connections are tight and clean.
The other day I cleaned the main B+ terminal on the starter, made sure the terminal jamb nut was tight and cleaned; then assembled the terminal and torqued. Removed, cleaned and re-torqued the top bolt on the starter. Cleaned and re-tightened the main grounds. Also cleaned the solenoid connection and made sure it fit back on securely.
Was fine for about 6 starts then it did the same thing again.
The last work I did on the car was a clutch upgrade (myself)...literally almost a year ago. I've driven it about...500 or less miles since. So I'd have assumed bad starter connections, but I think I've ruled those out. I didn't drop the subframe, just the transmission. the problem did start pretty much immediately after that job and hadn't done it at all before that job.
So what other interconnects are in the system to control the starter? Relays, control modules, switches, sensors...I'm sure all of the above. Something is allowing the starter to turn for 1/2 second and then drops it.
Perhaps the battery is dropping below voltage while cranking and something is aborting the start?
I haven't really done much diagnosing other than a simple load test on the battery. I haven't taken voltage readings under cranking, voltage drops across wires or voltage readings at terminals yet. Ugh..I really just don't feel like it. Maybe I'll just dump the car into the Pasquotank River.
Not that it really matters, but I've also installed an APR K04, full exhaust, Carbino intake...I don't know what else. But it was all done quite a while ago, by me. This second clutch I've done seems to have been the thing that triggered this particular problem.
I have a 96 toyota camry that won't start. when i turn the key, the starter clicks but doesn't turn. I replaced the starter and it works fine (as does the one i took out). the battery was obviously checked and is charged. When I hook up the starter to the leads and its not in the engine it doesn't turn (in other words, its not a locked engine). I replaced one of the fuses in the starting relay and it didn't make a difference. So the problem is between the battery and the starter - the starter isn't getting enough power (if i take it to an autoparts store it works when hooked up to their system but doesn't work (but makes a click) when hooked up to the car.
View 3 RepliesI have a 2006 Santa Fe with 137K miles on it. Has been best car I ever owned, but have recently experienced a strange issue where it won't start, meaning I put the key in the ignition, turn it to the right and nothing, not even a click on the starter. I have found if I move the shifter around from P to R to D, etc. and then try it again it will start. Is there a safety interlock switch in the shifter that could be going bad and is therefore not satisfied/happy when I try to start the car? Or could the ignition hardware where I insert the key be the issue.
View 1 RepliesMy Nissan sentra will start on the coldest day, but now that it's getting warmer it sometimes won't start! Turn the key and I have power to everything, but engage the starter and nothing! Not even a click! Try and try and eventually it starts. What could cause this??
View 7 RepliesI have a 2000 Chevy S10 (4-cylinder, rear wheel drive, the most basic model). A few months ago, the truck wouldn't start. The starter clicked a single time when I turned the key, and the lights on the radio came on, but nothing else happened. Several hours later, I attempted to start the truck again, and it started just fine. I disconnected the battery and found some corrosion on the positive connection (not that bad), and I assumed it was because of a bad connection.
I cleaned it and haven't had any problems since....until last night. The truck once again wouldn't start at a gas station. One click from the starter but nothing else happened. I cleaned out the battery connection again, and the positive terminal was again slightly corroded, but it wasn't that bad. The truck started after I cleaned out the connection and it got me home, but wouldn't start again after I shut it off. Can a bad battery cause repeated corrosion or possibly be the problem? I'm hoping it's just the battery, but I don't want to get a new one until I'm sure...
I own an 85 toyota pick up. It has a 86 electrical system with a 95 engine. To date, this truck has run like a top until I got in the other day and turning the key nothing happened. That is to say, the starter did not turn or kick out. I had the starter tested and it is fine, I tested the starter relay and the neutral position switch. All the wiring checks out fine except for one That comes off the starter relay in the fuse box under the hood.
This wire seems to be a ground for the coil side of the relay. In my books, it should go to a clutch /start switch that I can't find. When I follow the wire it goes from the fuse box into the right side of the engine compartment into the fender area then runs toward the cab but I do not find its color combination going into the computer. I had this same problem with a 86 truck before and never found the problem.
My neighbor has a 2008 Grand prix V8 that won't turn over. When the ignition is turn on the starter does not turn and then the horn honks once, you hear clicking sounds in the engine compartment and inside the car and the service display goes through each system indicating that it needs service. We unsuccessfully tried jumping the battery.
View 1 Replies