Jeep - Liberty :: 2009 - Starter Motor Turn On For Less Than Half A Second Then Turn Off
Aug 19, 2011
I have a 2009 Jeep Liberty with 43,000 miles which many times in the morning, the car won't start. I hear for just a brief moment the starter motor turn on for less than half a second then turn off. I take the key out and try again. It takes a few times for it to run. I have tried different keys and once it has been started for the day, it usually is not an issue until the next morning.
View 2 Replies
Advertisement
I have a 04 3.7L V6 Jeep Liberty with about 114K miles on it. It started happening recently that when I turn the key nothing happens. I have to put my foot on the brake, shift thru the gears, back to Park, take my foot off the brake, and then the car will start. Not quite sure where to start...
View 3 Replies
I drive a 2005 Jeep Liberty with about 96,000 miles on it. A couple weeks ago, the Jeep had some trouble starting. It would crank and turn over and then sputter out. I tried it again and it did the same thing. After letting it sit for a couple minutes, it started and ran fine. No warning lights or anything on the dashboard and nothing that seemed unusual. A couple days later, my wife noticed a small pool of pink fluid on the floor of the garage where my Jeep parks.
So I took the Jeep in to get it looked at. They said there was a leak in the coolant line as well as the pinion system, both of which they repaired. Since then, the Jeep has done this 3 more times, usually from a warm start. If it's been sitting for a few hours, it starts without a problem. But if I'm running errands, then the third time I try to start it, it will fail until I let it sit for a couple minutes. Then it will finally start up. What it could be before I take it back to the mechanic?
View 2 Replies
Ford F150 truck, when starting, the starter will turn over strongly for half a second then just abruptly makes a loud noise and stops. It won't ever fully crank. Is this just a bad starter?
View 2 Replies
I have a Toyota 87 pickup that have been working great for the longest time. Now there is a problem and I need to fix it. It is a problem with the ignition switch I think but I am not sure. When I put the key in and turn it to 1st position I can hear the electrical system turn on, as in the little hums and noises that the electrical system does on a car this age. The next position where the starter motor would engage is however silent and non working. If I where to have a bad battery this is where the relay would go tic-tic-tic but there is no sound what so ever. So Im thinking maybe bad switch, or bad relay? How do I test this the easiest. Toyota got a r22 in it.
View 9 Replies
I have 98 f150 with 4.6 starter went so I put a new one on wich was a hassle and it tries to turn but just wont as if the motor is seized. I had been hear a loud howling sound from what I think is the ac unit and the ac line burst after trying to start. Would a bearing or something with the AC be enough to stop the engine from turning over? Or could it maybe be a wire connection problem? To me it sounds like a starter trying to start a seized motor but I cant see that my motor would be out it only has 190 000km and the oil looks good. but we couldn't turn the motor over with a ratchet? The truck had been getting gutless. I am stuck...
View 4 Replies
I have a 2010 Yaris 1.3 motor. Sometimes when I turn the ignition on it seems to keep wanting to start?
meaning it sounds like the starter motor isn't disengaging when the motor turns over, its been back to teh dealer twice now, someone suggested a relay?
I am taking it back again tonight for the auto sparkie to look at. The last time it did this I had to manually turn the car off to stop it turning over.
View 1 Replies
when u turn the key it starts to turn over for half a sec then stops. when u stop it sounds like the starter is still spinning. battery is good. it use to do it some times but if she tried a couple times it would start. could it be where the wires go in or the whole thing? could it be somthing else besides the starter?
View 6 Replies
I have a 2009 Jeep Liberty Sport 4X4 with 63,000 miles. There have been issues starting the car for about a year and a half.
It all started when a key was inserted into the ignition about a year and a half ago and a click would just be heard after the key was turned to the start position. Usually it started after the key was removed and inserted again. Sometimes it would take a few tries but most of the time it would start right up on the try one.
After 10 months, the battery was replaced after the vehicle had to be jump started. Shortly after, I had a Viper 5901 remote starter installed in the vehicle by a reputable store. The issue seemed to go away and thought the issue was fixed. The vehicle now was started from the remote control 90% of the time.
The issue started to become worse about 2 months ago. It would take more than 15 tries to start and to temporarily relieve the issue; it can be started on the 3rd or 4th try by rocking the vehicle. The starter was replaced two weeks ago by a reputable auto mechanic at my request. I went to a camp the day after for a week and most of the time it just sat in the hot sun except for short errands sporadically throughout the week.
I then went on a week vacation and the car sat in the driveway. I came back and the car didn’t have any power. The battery read 1.2 volts. It was jump started and then I went to work. At the end of the work day, I tried to start the vehicle and just heard the click. After rocking the vehicle, it started right up.
I was curious to why the battery was that low and so I hooked up a meter inline from the battery terminal to the disconnected red wire. Please find the results below:
-Entire top of the fuse box was removed of fuses, relays, etc. – read 0.20A empty – it sounded like the fuse box clicked when the circuit was completed. Not quite sure what was plugged in to draw that much current.
-The fuse box was reconstructed except for a few fuses – read 0.24A
-M13 fuse was connected and current increased to 0.64A (0.40A increase from previous)M13 – 20A fuse for Cabin Compartment Node (CCN)/Wireless Control Module (WCM)/Multifunction Control Switch.
-M12 fuse was connected and current increased to 1.67A (1.03A increase from previous)M12 - 30A fuse for Radio/Amplifier
-Viper fuse was connected and current increased to 1.73A (0.06A increase from previous)
I guess it come down to a few questions:
-What could be the reasoning the vehicle does not start consistently? Is it due to the battery or something else?
-What would draw a ¼ Amp without any visible connections on the top of the fuse box?
-Why would fuse M12 take so much current without a key in the ignition?
-Anything else I should look for?
View 9 Replies
I have a 2010 F150 with 39,000 miles. This morning the truck started fine. I ran in to get something came back out and the truck had died. I tried to restart it and nothing. When you turn the key forward the starter spins and wont stop until u turn the key off. The truck never tried to fire. The motor tuned over and over but nothing. is there a starter relay? A solenoid?
View 2 Replies
Trying to track down an issue (annoyance) I'm having with my 02 7.3 4x4 excursion. When I get in the truck and turn the key (after waiting for glow plugs) the starter doesn't actually turn over for 1-3 seconds and sometimes up to 5. When the truck does turn over everything works perfect it's just an annoying delay.
View 13 Replies
I was driving to work and lost all power (during rush hour) I was able to coast to a exit. Had it towed home, when I turn the key the starter engages but nothing after that, the engine will not turn over. I checked the battery and has a full 12 volts.
I removed the belt and front plugs to see if I could manually turn the engine over but it will not budge. How can I tell if this engine is really locked up or if maybe something else is happening?
3.1 V6 engine .....
View 7 Replies
Jumped in the truck this evening to go to the store and when I stared it up the left turn signal was blinking. Lifted the arm as usual to cancel and it does not cancel. Cannot get the left signal off unless I hold the turn signal up for the right signal. The right signal does not activate, but the left does go out as long as I hold the arm up. Let go and the left starts blinking again. Tried driving around to see if it would cancel and no luck. The bulbs are all good. I checked the relays in the fuse panel and they are good. Dang thing just won't shut off. It is a 2011 F150 SCREW Platinum w/5.0.
View 4 Replies
My starter clicks once when i turn the key, yet when i brought it in to have it tested it passed twice. I took one of the spark plugs out and pulled on the belt thinking maybe some antifreeze got in a cylinder and saw the piston moving up and down so i its not seized.
View 1 Replies
Why my key would not turn in the starter, although an hour previously and up to yesterday it has always worked just fine. Again, this morning, the key turned just fine. Is this a warning that I'm heading towards disaster?
View 10 Replies
i stared my jeep today and when i was driving it wont go pass 45m and doesnt wanna accelerated...
View 5 Replies
I recently installed a new car stereo in my 05 CRV to replace the factory unit which had a broken CD player. Everything appeared to go fine, but I noticed at night that when the Head Light switch was turned on, only the top half of the dash lights would turn on, the lights for the AC/Heater failed to light, and the PRNDD1D2 lights which work fine in the day (sans the drive light not working, but that's been the case for a year now) would turn off. I've checked the fuses and found no blown ones, although the fact that the top half of the dash lights still turn on made a blown fuse seem less likely.
The lights that are left on will still dim/brighten when the dimmer knob is turned, and I noticed that if I pull the small lights fuse the dash lights don't work, but the PRNDD1D2 lights remain lit even with the headlights on. I've tried removing and re installing the factory stereo to see if there was a short in the new wiring harness, but that changed nothing. As is the car is still drivable, as the top half of the dash lights is enough to make all the gauges readable, but it's still a bit annoying. Any clues as to what I've done, and is there a reasonably cheap fix to the problem?
View 2 Replies
I have Jeep Liberty 2002 with 100300 miles. I having starter problem and the starter was replaced with a new one. Still I am having the same problem, the car can only re-start 30 minutes or more after I shut it off. The mechanic stated that he does not know what it is causing the problem.
View 11 Replies
2003 Jeep Liberty Sport, 156 K miles, Check engine light has been on for months now. First occurrence was when driving, and car started to knock as though I was shooting 50 cal machine guns. Stopped vehicle, shut off, and upon restart, engine ran smooth. Now, almost every time after engine has been running a while, and I am going on a down slope, the check engine light starts to blink, and engine starts to miss. Took to my mechanic, and so far, I have been told and have replaced, Fuel pump, Spark plugs, coils, and wires, cam sensor. Latest and most recent with promise that this has to be it, I replaced engine computer.
View 16 Replies
My 2004 Liberty just started this a couple weeks ago. When sitting still, the AC blows hot air. It cools down nicely when you start moving. This makes traffic lights and people who don't go when the light turns green VERY annoying. While waiting, I can hear the compressor coming on and off. Thinking perhaps the radiator fan wasn't coming on, I looked at the radiator fan fuse, 40 amps, and it looks fine. I even checked it with an ohm meter. With the car sitting still, engine running and AC on, I don't think the radiator fan is going. Maybe one of these two relays?
Important details (or not)5 speed transmission125,000 miles"What color is the car?" Blue.Two wheel drive. (alas, it's a Jeep in style only)
View 7 Replies
My radiator fan is not turning on in my 2002 Jeep Liberty. The belts look fine and it turns by hand. My radiator overheated last summer but since has been fixed now my fan doesn't work, but hasn't overheated. No parts of the the radiator or fan were removed. We fixed a part in the water pump this past sunday and when we had the engine running for about 15 minutes, the fan did not turn on or even act like it was going to try. What the issue could be?
View 9 Replies
