Pontiac - Grandam :: 2000 - Sensors Going Haywire - Fixing Codes P0327 And P0336
Nov 4, 2011
I have a 2000 Pontiac grand am coupe GT with the 6 cylinder engine. It has been a very good car to me. I really like it and it "fits" me well ... and yet... it is now testing me. About a year ago the check engine light came on. The codes were P0327 and P0336 for bad Knock sensor and Crank sensor respectively. The were both replaced multiple times, the light still stays on... and the codes are still coming up. I have have been to different experts, and after the computer resets... there they are again. (someone even thought that the computer needed updated codes for those sensors... so he installed them.. with no better results). The code P1189 for an oil switch is now coming up too.Here in California, the car cannot pass smog with the check engine light on... so I'm not able to re-register it, and I don't think I can sell it for much because no one can register it now. So, what this can be? Is there some common thread between all these sensors (or a recall of some kind) that would explain this? My fear is that the computer will have to be changed at about $1000. My even greater fear is that that will still not solve the problem.
View 2 Replies
Advertisement
Could these Knock sensor low input codes be caused by a failing battery? My battery was dead 2 days ago. I charged it and it has been starting but today after starting a couple of times in a row these codes came up. I've never had any codes before and it was running fine. It is a 2002 Suburban with the 6.0 engine.
View 11 Replies
I have a 2000 grand am Gt with 3400 motor it started up just fine went to turn around in the drive way the dash lights came on where the ABS sensor is bad, but if u shut it off and started it back up they would go out so i shut it down and went to start it back up and all it does is click, so i thought it was the starter and replaced it, still only clicks. I called GM dealership they said more then likely it is the plastic piece the ignition switch goes in to so i just replaced it and does the same thing.
View 8 Replies
So, starting about 2 months ago my car started starting kind of hard and the CEL came on. It would crank for a few seconds, start to turn over but sound like it was going to sputter out, but ultimately turn over. It seemed to be exacerbated the longer the car sat between times running. I let the car sit for about a week while I was waiting for parts to come in to change out my front brakes, and now it won't start.
I hooked up my newly acquired OBD II reader and got the following DTCs:P0130 - O2 Sensor Circuit Malfunction Bank 1 Sensor 1P0130 P - Same, P for PendingP0336 - Crankshaft Position Sensor A CKT Range/PerformanceP0340 - Camshaft Position Sensor A Bank 1 Circuit Malfunction
Based on my limited understanding, I would think something having to do with the last two codes would be why the car isn't starting, but it seems like it could also easily be something else not directly indicated by those codes. So what I'm wondering is, do I need sensors replaced, or is there something else that needs to be replaced on the car. The car has ~130k on the odo.
View 3 Replies
My wife has a 2000 Pontiac Grand Am, as seen above. The car recently started having issues, especially when cold, where the RPMs will rise when in gear but the car will not accelerate. It happened from 25 mph and lower while in a subdivision as well as around 45 mph on city streets. I have a feeling this is a transmission issue, but don't have much experience when it comes to transmissions.
View 6 Replies
I m having trouble figuring out why the radiator fans wont turn on, Even when the ac is turned on it still doesn't turn on, I changed the coolant temp senser. still nothing, i also ran a whire from the battery to the fan and they both turned on. I also stitched around relays and checked fused still nothing. 2000 pontiac grand am 2.4L engine 4dr auto trans.
View 14 Replies
I have just replaced an almost new oxygen sensor on my 2000 Grand Am. After about 40 miles, the check engine light came back on again. I have not had a chance to check it, but I assume it is the oxygen sensor again. What am I missing?
View 1 Replies
My wife's 2000 grand am 2.4L engine is acting really funny. this is the first problem we've had with it. i was driving it to pick up my kids from school. on the way i stopped and got some gas from the marathon then drove about 5minutes and it started running really ruff lose of power wouldn't go above 30mph seemed like the transmission took longer to shifter to.
i made it to the school as i was about 2 1/2 blocks away. got my kids check the oil and it was really low so i got 2 quarts as it was a gas station in walking distance. i thought it was a lil better but i started driving it and it had the same results. i got it home about a 10minute trip regularly and parked it.
the next day day it ran then stumbled hard. and every time i tried to start it got the same think was like a lock up. it did crank but when it tried to start it stumbled or locked up. i pulled the plugs had some wet threads oil was on the first on and the threads and around the spark plug b4 i pulled it out.
2 of the other plugs had red stuff on them not on the threads though. here are some pictures also i will show a vid of what its doing. i did a compression test and here are the numbers starting with the first one with oil on threads.
190-194-200-190+ compression test with cold engine.
Also smoked puffed up not sure from where yet..
View 19 Replies
The Change Oil light was illuminated for a short time on my 2000 Grand Am. This morning, on the way to get the oil changed, the Service Vehicle Soon light came on also. After the oil change, the Change Oil light went off, but the Service Vehicle Soon light stayed on. I stopped by my mechanic, who doesn't like to change oil, since it does pay enough, and he said that there was something else that they should have done to reset this other light. He said it was in the manual, but I don't find it. How to turn it off?
View 4 Replies
I have a 2000 Grand AM cylin. Recently I was driving when my car started to shake violently. I drove it to the side of the road to a parking lot then it died. I started it up again and is ran but shacking a lot again. Once I got home, 3 blocks away the car died again. I tried to start it again but it would only turn but not start the engine. I have checked the gas pump, motor mounts, oil and anti freez for oil. I did check the timing chain but I don't know much on how it should be.
View 2 Replies
My check engine light started blinking on my 2000 grandam se last night and it was missing bad and now it wont start what is it.
View 13 Replies
Was driving on the highway and all of a sudden my mph gauge just drops and my car slows down. This is the first time it happened and it didn't do it again after I got off the highway. Other things it has been doing: eating gas, shifting hard, and doesn't want to get up to speed. Not sure if they are related to this new problem or not.
View 2 Replies
I have a 2000 V6 3400 engine. I had the intake gaskets repaired with the "good metal ones" according to the mechanic I had do the job. Cost me $600. Car still has coolant leak it overheats every 3 days or so. Leaves no puddles under car when parked. Can smell coolant when stopping at stop light or stop sign or when parking car. No obvious coolant running down or pooling on the engine. Sometimes it seems like smell is coming from heat vents but no wet spots on carpet or liquid coming out of vent. Took to mechanic again and he said it was the head gasket leaking. Wants $1100 to fix it. Don't have the money. Was wondering if any of these additives you can get at Autozone Etc. may work. It wouldn't be my first choice but financially it's about all I can do right now.
View 2 Replies
I replaced the ignition key lock cylinder on my 2000 Pontiac Grand Am SE. I performed the re-learn process by cranking the engine over, then releasing to the ON position for about 9 minutes. During the 9 minutes the SECURITY light blinked the whole time, then at the end it went solid for a few seconds, then off. On the next cranking cycle I was able to start the engine and thought all was good. But now when I open the door the car beeps as if the key is left in the ignition and the automatic locks are disabled with the door opened.What is the problem and how do I fix it?
View 1 Replies
Just bough a new (to me) Touareg yesterday...2008, 75k miles, good service history. Drove home from the dealer no problems. Driving that same night (last night) the CEL comes on. Ok, I've had VWs before, CELs don't really make me panic.
Get home and scan the car and it comes back with P0327 (knock sensor 1 circuit low) and P0441 (evaporative emissions system incorrect purge flow).
I have a feeling it's got less than premium gas in it....I'm gonna throw some octane booster in the remaining 1/2 tank and see what happens. Anything else I should do?
View 5 Replies
I have a 2000 Pontiac Montana 3.4L V6. I keep getting code p0341 cam shaft sensor (replace), and code p0443 P0443....EVAP Emission Control System Purge Control Valve Circuit. I was getting p0441...Evaporative Emission Control System Incorrect Purge Flow (but I replace Canister Purge Valve that up top center right). I have also replace spark plugs and wires because it didn't seam to have any power.
(After I replace both the cam shaft sensor and purge valve) Now it does have good power but if I am moving at very low speed either stopping or starting it will almost die sometimes and sometimes it does die. If it actually dies it seams to give both the P0341 & p0443 codes but if it doesn't die and code light comes on after resetting it, it is just the p0443 code.
View 1 Replies
I have a 97 F350 5.8 with E40D trans. I bought the truck with it shifting hard thinking maybe a simple filter/fluid change would fix it. It may have worked a little but did not fix the issue. There were 3 or 4 codes that I have already cleared up with new parts. I am still getting a 327 (something with EGR?) and 629 (Converter clutch control circuit failure). These show up in KOEO and KOER self test. The O/D does not flash ( bulb does work).
Parts that have been replaced: VSS, MLPS, new connector going into solenoid pack (tabs were broken), TPS. Removed the trans wiring harness and there is no damage or loose connections. When I replaced the solenoid connector I noticed there was some trans fluid in the connection. I cleaned it the best I could and reinstalled with dielectric grease.
The truck runs fine and shifts in and out of every gear fine its just shifting hard. If I unhooked the battery it will shift perfect for 5-10 minutes but then the hard shifting returns.
The only other thing I can find with my research is maybe the solenoid pack needs replaced. I figured if I take it somewhere they are going to want to rebuild/replace transmission. It seems like it can't be something very major since it will shift fine when reset...
View 4 Replies
Last night when I was driving home, I noticed that all of my "night lights" were off. The lights on the speedometer, gas gauge, gear shift, etc. did not seem to be working, but all of my system warning lights (Traction, Brake, etc) seemed to be fine. I tried to turn the car on and off a few times and also tried fiddling with the lights manually. Nothing seemed to be working.
View 4 Replies
This is on a 2004 Pontiac Grand AM.
The old GM ABS light problem. The lights were on a month ago and the left front hub was replaced, the light went out. They just came back on all of a sudden (coincided with the temperature dropping to 15F). The next day they were out. Then the next day they came back on. I couldn't get a code read with the basic scan tool.
Where should I start? I'm thinking of cleaning the speed sensor connectors and reseating with dialectic grease. Maybe they're dirty or a bit brittle due to age and the cold?
View 10 Replies
I have a 2004 Pontiac Grand Am with about 130k miles on it. For some reason my car has been dying lately. It did this a few times so the obvious thing was to buy a new battery- oct 2011. Everything was good for a couple months but I recently went on a trip for the weekend and when I came home the car was dead. I jumped it and everything was good until this week. I had a work conference and left wednesday at 8am. When I got home Friday at 5pm the car was dead again. I had an alternator test done before but could it be the alternator? I love my little car and would like to get a couple more years out of her!!!
View 7 Replies
Have a 2004 Grand am that was having some problems starting:
1) The last 10 times it would start cold, but it would take about 5-10 seconds of turnover before actually starting.
2) After it started, it would start fine the rest of the day.
Now it will not start at all. Today is the coldest day of the year so far... 43 degrees. It tries to turn over. The security light came on once, but did not come on again (i know that's a common problem). (note: I have not seen it in person, but will later today). Either fuel or spark.
My thought: either fuel pump, fuel pump relay, sensor, wires/plugs, etc.
View 1 Replies
