Since dec 31 my Nav screen goes black while driving, they only way i can bring it back is by shuting down and restarting the engine. But keeps doing it. Took it to deal they said they rebooted whole navi system but still doing it.
View 13 RepliesI'm finding the nav. system on my o7 limited tribeca hard to use. First of all, I can't figure out how to turn it off. It seems to always require a destination, and the only thing I can do to avoid it binging and trying to redirect me is to turn the sound off. Any way to tell the computer "I don't need direction to this trip"? Also the only time I've tried to use it, thr route it took me on used only surface streets, even though the freeway and a tollroad were nearby and I had entered "allow tollroads".
View 30 Replies2008 Subaru trebeca suv with only 62000 miles, when going up a slight incline in drive you feel quite a shudder like you were driving over small bumps on the road. This is my daughters vehicle so she phoned about 400 miles from were I live & told me what I said above. I told her it sounds to me like the torque converter is not unlocking. And if it is the converter not unlocking would that be a very expensive repair ?
View 1 RepliesRight now it doesn't chance background shade when at night time, it always stays white.
How to change so that it automatically changes to black when in night time ?
Having issues with the back-up camera? It only works about half the time. It either stays on the radio or gives me a black screen. I called the dealer and was told they have not gotten any other complaints
View 1 RepliesScreen go black, radio shut off, then reset itself while driving over and over again. Have the car parked and radio stays on after you pull the key and set the alarm. And the final piece, the alarm goes off three times no lights flashing then stops sitting in a garage, not outside. Is this a short ? I have two brand new batteries, new starter new altenator.
View 8 RepliesJust picked up an '05 with the Nav/ML. Everything seems to work, but the navigation screen is painfully slow to update while driving. Sometimes I will be several blocks (1/4 - 1/2 mile) before it catches up with where I actually am. This doesn't seem normal, but figured I'd ask here... is this normal?
View 12 RepliesWhen driving on a highway, the navigation map goes into a split screen, showing info on upcoming exits. For some reason, the screen does not show major highway exits. For example, when driving to work I pass the Mass Turnpike exit which is exit 22. But the exit screen ignores this exits and goes from exit 21 directly to exit 23. It does not seem to recognize exit 22. I noticed this is true for all major highways such as I95 and I495. I'm not sure if this is controlled through one of the setup options, but I can't find anything on it.
View 2 RepliesI had my headlights on last night and while I was driving through a few small tunnels my dashboard and Navigation lights went so dim....basically black.....I could barely see anything on them. What is this and how can I fix it?
View 11 RepliesI've had my ISF for almost a year now but I'm just now noticing that the navigation screen on my 08 does not darken the colors when the headlights come on. The map still shows up bright white and can be distracting.
Is there a setting I am missing somewhere to change this to black with orange accents instead when the headlight low beams are on, or is it just supposed to be white on the map view all the time? My wife has a 2014 ES and it does this automatically. Come to think of it, every other car I've had that had navigation did this automatically. I tried searching but couldn't find any threads on this already.
I was heading to the gym tonight and noticed that when I had my headlights on the nav screen stays white and does not go into the dark mode it is supposed to with the headlight on. I pressed the display button and there was no indication that there was an option to go back and fourth between day and night mode as usual . Only the option to adjust brightness and contrast. I do have the option to turn off the screen but this is annoying.
View 6 RepliesWe have a 2006 B9 Tribeca we purchased used in April. We have had no problems until September when the "puddle lamps" (small lamps under the doors) shorted out and made smoke go into the cabin of the car. Called Subaru dealer and found out there was a recall notice for this problem.Made an appt. and problem was fixed. Now...in the last two weeks though, there have been a dozen instances where the car will not start.It will crank over two/three times and quit. It never fires up and runs.I never know how many times I have to do this before it WILL start. Right now,it has not started since last night. Side note....there is now a strange noise coming from the heater fan box as well. Second side note.When I turn the key to start it,the "Info Center" display dims.
View 1 RepliesI have a 2016 LX570 with 5,000 miles on the odometer. This morning the navigation screen is blank and the radio does not work. Took the truck to the dealer, they said Lexus is aware of the problem but does not have a solution. They will call me back when Lexus figures out what is wrong. No offer to give me a loner with a functional navigation unit.
View 3 RepliesI recently purchased a B9 Tribeca I had it completely checked out, brakes, engine everything. Everyone told me it was fine, this past Friday/Saturday was our first freeze and snow. I went to get into the car around noon, so it had warmed up to maybe 40 by then, and I put my foot on the brake pedal and it didn't feel right at all. Thinking I was imagining things I put it into reverse and took off the emergency brake, and realized rather quickly I had no brakes. quickly put it back into park and popped the hood. My brake fluid was full (right below the max line), I let the car sit there and pumped the brake pedal for like 2 minutes. After it made it all the way to the floor it eventually came back to where it should be and appeared to work just fine. I drove the car without any problems with the brakes for the rest of the day. My question is should I get the brakes checked out again, or is there something specific I should have them check so I don't have to worry about the brakes next time it freezes.
View 5 RepliesI own a 2006 Subaru Tribeca with 125,000 miles. It has been well maintained and a great vehicle. On a recent long distance trip, after driving about 7 hours, going 70mph, the car started to buck and the accelerator stopped responding. It continued to lose speed as I pulled off the side of the highway. I turned the car off and restarted it and attempted to drive it but it wouldn't go over 10-15 mph. I didn't have any check engine lights. Called AAA and had the car towed 4 hours to our final destination. The mechanic has had the car for 4 days and can not find the cause of the event. I have a 22 hour drive back home in a month and I am extremely concerned. Did some research and have found others have had the problem but had codes come up. Research says it could be throttle pedal position sensor/ pedal assembly.
View 12 RepliesSo, I had heard this was happening frequently and now my navigation screen has stopped responding to touch inputs.
It looks like my Lexus platinum extended warranty has paid it's self off!
For those that have had the entire central control module replaced by Lexus with (I assume a refurbished/manufactured) one, have they held up? Are the repaired units anymore robust than the originals?
My car is an 2008, has the weak connections to the touch screen been addressed in the later vehicle builds?
My Santa Fe is only 2 months old, and the Navigation System/CD/Radio froze up on me already. I just had a blue screen with Hyundai written on it. I couldn't turn it on or off, or push any buttons. Nothing worked. I called the Nav System hotline number on the front of the manual, and the guy told me to try reset. I told him I already did. He said he talked to another guy who had this problem, and he just kept pushing the reset, and finally it worked. Well I must have tried a dozen times, and finally it worked. The time it worked I pushed the button while it was off, then again just as it was starting up (always just came back to blue screen before) but this time it worked.
P.S. A pen did not work, I had to use a large paper clip, and you can actually hear a "ting" and the screen goes blank, then tries to start back up (and hopefully does).
I change my own pads as a good lifetime warranty with free replacement from Autozone is great!
But with the Tribeca... I changed the front rotors just like all my other cars over the years.. and now there is pretty severe pulsation when trying to brake... I've checked the rotors and pad replacement twice now and all looks perfect.
I searched this pulsation issue and saw on a Jaquar site that you can ruin the ABS on some cars when you don't drain excess fluid as you push the piston back to install then new thicker pads..
Is this an issue for B9? I don't see it anywhere... I'm ready to bring it in the shop.. the pulsation ONLY happens when braking and gets more severe when stopping from progressively higher speeds...
I have Subaru B9 Tribeca 2006. Week ago started the following problems - after starting up, engine is shaking (rough idle) for a few (20-30) seconds and then it's OK. Then I got Check Engine, Cruise and ABS lights on. Diagnose shows mistake in 1st cylinder. changed spark plug, air filter, checked all connections, cleaned injector and throttle. Lights went out and engine was working as new. but the second day car had rough idle again....
View 1 RepliesI've got a 2006 B9 with about 64,000 miles. Just a bit ago my check engine and ABS light came on, along with my cruise light flashing.
After researching a little bit on the forums and couldn't find an answer, I took it into the dealer, to which I was told that there was a bad oil pressure sensor for the right-hand side of the motor. I had them replace it out, and less than 20 miles down the road, the same lights appeared on my instrument cluster, and I took it back to the dealer. They informed me that there was now a bad sensor on the left hand side that would be another $380. I scheduled an appointment for later next week, and had them reset the error.
On the same day, about 2 hours later the lights reappeared on my dash, and I took the car over to a local parts store, where I used their scanner and the car now spit the following errors:
Camshaft position actuator A - Bank 1 timing over advan.
Camshaft position actuator A - Bank 2 timing over advan
Cam/crankshaft pos. correlation sensor A - Bank 2
Cam/crankshaft pos. Correlation sensor A - Bank 1
Camshaft position actuator A bank 1 timing over - advan
Camshaft position adctuator A bank 2 timing over -advan
Cam/crankshaft pos correlation sensor A - bank 1
I reset the codes, and waited another day for the lights to reappear on the dash. Again, I rescanned the errors, and found the same top 5 codes that I listed above.
Is there something more major going on here with the computer?
According to the navigation manual (attached), the navigation screen should go to the home screen within 5 seconds. But my IS never goes to the home screen without pressing the home button, but it always shows the full screen map. I tried many different things including "Auto Screen Change" setting but nothing seems to work.
2015 IS250 AWD
Nebula Gray/Stratus Gray