The timing belts keep slipping on my car. I replaced the belts but it keeps happening. I went to readjust the belts today and noticed the pulley looks off. I know it needs to be replaced but given that it's the bott one under the radiator hose I'm not sure if it's one that I can easily do myself or if it would be better to have a mechanic do it.
147213874510541690085.jpg
1040x1857 841 KB
I've got my sister's 1995 Dodge Neon with the 2.0L SOHC. While driving it recently I heard a horrible squeaking noise then a ZZZZZZzzzzzz sound. I immediately pulled over. The check engine light came on, and I shut the car off. Coolant was all over the place leading me to believe the water pump failed. I had it towed to my house, and now I will have it towed to the shop to get fixed. I would like to have them repair the timing belt and water pump. However, I am afraid that the valves were beaten to a pulp and now I will need a new engine. I was only going 35 mph when it happened. What are the odds that my valves were smashed up, and is there anything I can do to check them before I pay for a timing belt/water pump repair?
View 19 RepliesI brought my 2004 VW Touareg V6(83k miles) to the dealer for a recall on the ignition call and much to my surprise, was presented with a diagnosis of a $6,000 problem! The dealer told me that the computer read some codes which say that the timing chain is stretched and needs to be replaced. They said it will take 4-5 days and should be done asap so it doesn't "go out", because if it does, it's an even more expensive problem. I took the car to another VW repair shop and they asked me if I heard any noised when I start it cold (like pebbles in a bucket). I have not had any problems like that at all, so they said I shouldn't worry until I start getting symptoms. They also said there is no recommended point (like 90,000 miles) when VW recommends the change, so it really shouldn't be a common problem. I want to do the right thing, but I don't want to rush into an expensive repair if it isn't necessary.
View 1 RepliesMy 1995 Legacy is slipping in reverse while backing up an incline. On level ground it seems fine. I Changed the fluid, but it's still doing it. Forward gears seem fine. It's an automatic transmission.
View 1 RepliesThe car has about 142,000 miles. Is the clutch on this car adjustable? My repair files indicate it was "adjusted" a couple times, $40 each time. Now I think I might need a new one: it seems to be slipping, making some noise in 3rd, and in 5th.
View 2 RepliesThe timing belt broke on my aveo, destroying the engine. I replaced the engine with a used one. Now I get the car back on the road and the automatic transmission won't shift from 3rd gear into 4th. Is it possible this problem was caused when the new engine was installed, or the transmission was damaged when the timing belt broke?
View 4 RepliesI was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesI have a 2007 Gen II with 133,000 miles and am using Amsoil synthetic oil and an extended life filter, changing oil every 10,000 miles. What is the frequency for changing belts, hoses, and timing belt? Other than a faulty latch on the rear lid, I have experienced ZERO problems with the car and would like to keep it so.
View 6 RepliesI have a 2000 Dodge Caravan SE 3.3L. The timing chain recently broke. So I replaced the timing set, cover, water pump, camshaft sensor, and oil pan. The timing is all aligned. It starts right up, but then stalls. Unplugged the front three spark plugs to see if one of those were the problem, and then it ran better and didn't stall out.
View 3 RepliesI have a 79 toyota pick up, that will not run. the engine turns but does not start. It has spark, though not the best should start. The carb is old but there is gas in the engine when i try to start. compression in all the cylinders is fine. A friend thinks maybe the timing chain jumped a tooth. I cant find the bright link on it so im having trouble knowing if that is the problem. What it could be?
View 5 RepliesI drive a 2005 toyota mini-van. Lately the engine has started sounding strange. it has been sounding like a tiny diesel engine or like a go-kart. There are no lights on on the dash, I have not noticed any changes in fuel consumption, acceleration etc. and the temperature is normal. Is this a timing issue? is my car about to die? what are the repair costs?
View 5 RepliesI drive a 2002 F-150 (4.2L) with 150K miles. A noise similar to the belts slipping started up the other day but stopped when I drove the truck for a short distance. So I thought slipping belts was the problem but the noise started up again even after driving several miles. The noise only comes on intermittently and not all the time. In fact, it never comes on when a mechanic is looking at it so they think I am hearing things.
I had the belt changed out and the mechanic said he thought the water pump was going out. So I had that changed out. He had the alternator checked out and it was good. The truck runs fine but the noise still comes and goes. It sounds like a high pitch vibration or like something is rubbing against something else but only periodically. What it could be?
I have a 2001 jag stype v8 with 180k miles. I bought the timing kit and aligned the camshafts correctly but it still idling rough and sounding like a diesel truck. What still maybe the problem?
View 19 RepliesSo I had oil leaking out of my starter so I ended up pulling it and replacing a gasket behind the flywheel... Now the car didn't run because the timing was off by a lot so I jumped a few teeth on the timing chain. Now I have a bunch of white smoke and the car lacks power. It will stall going reverse out of my driveway unless I rev it high. The engine itself has less then 5k miles on it as it's rebuild so I don't think it's a head gasket if it was running fine before I pulled the flywheel off. The idle sounds fine and feels smooth but puffs white smoke. I used a timing gun and adjusted it, and seems on point but now I'm stumped. What could it be? 1972 Honda n600...
View 19 RepliesI have a 2005 Chrysler Sebring. In December the timing belt failed while I was driving down the road. I had the dealership I purchased the car from replace the timing belt as well as the water pump while they were at it. Ever since I have had and issue with it vibrating at idle. At first it was making a whining noise as well. I took it back and they told me that they had installed the belt too tight. Afterwards I still had an idle issue although the vibration was a little different. I also could distinctly hear the belt hitting the casing a few times.
I took it back again and they stated that the belt had been put on too loose. So now they have adjusted the belt again and it I am no longer having the whining or belt hitting the casing. But I still have an idle issue. It has changed again and is kind of a pulsing vibration. I can feel it in the brake pedal when I am at stops. I seem to hear the pulsing while driving as well but this may be from my new tires as well.
During this whole readjustment process they have not mentioned actually checking the timing. Just the belt tension itself. When I first reported the idle issue after they put the timing belt and water pump on they told me that it could not be related to timing and that it had to be an ignition issue. But I asked a work associate who used to work as a mechanic and he stated that it would be a timing issue.
I am going to contact the dealership and ask them to check the timing belt again. I never had this idle issue before the new timing belt.
So I have multiple issues that all seem to stem from a power steering leak. According to the dealership, the PS pump is leaking fluid onto the serpentine and timing belts causing them to swell. This in turn has something to do with the AC compressor not working but they wouldn't give me details. When I looked at the clutch wheels on the AC compressor, there seems to be a good amount of rust in between the two wheels. I can't say that I trust the dealership because the original owner was bought out by a larger group that is known to just say "replace everything". I usually do most of my own work on my 95 Tacoma, so I'm no stranger to import v6 motors.
View 4 RepliesI have a 2004 Honda Element and when the AC compressor cycles on it makes a high pitched noise similar to a drive belt slipping. The AC is still cold and the noise is not overwhelming (yet). I know this vehicle has a serpentine belt and that doesn't appear to be making any noise. The only noise is when the compressor is running.
Is there a belt that drives the compressor (other than the serpentine)? And, is this something that I should get fixed ASAP or can it wait until my next oil change? Meaning, if I wait until the oil change (under 1,800 miles) will hurt anything?
The seat belts in a Subaru WRX have been replaced with 4 Point Racing Harnesses. The air bag light now stays on. Does this mean the air bags are inoperable or will they still deploy in case of an accident?
View 2 RepliesOne of my headlights has stopped working on my 1999 Subaru. Do I need to replace the entire headlight assembly or is it just a bulb? Approximately how much should it cost to fix? 1999 Subaru Legacy sedan
View 10 Replies I drive a 2000 Subaru Legacy and the radiator fan does not always come on. This sometimes makes the car run hot but has not (yet) put it into the "danger zone" overheating. It seems to happen if the car is in stop and go traffic and it's hot outside. If I'm driving down the highway or the weather is cool it doesn't happen.
I checked the fuses (yes, even the ones under the hood) and they are all fine. I am just curious if there is a sensor that could be the problem or if it is more likely the thermostat. It didn't quite fit the descriptions I found for thermostat but I'm a broke college student trying to keep an old car on the road, not a Subaru mechanic
I'm in the middle of doing a timing belt and as I was slipping the new belt on my crankshaft moved! To my horror my timing mark erased after I used some brake parts cleaner to blow off the area. What can I do to get that bolt back to TDC?
2003 Passat 1.8t