Toyota :: 1989 Truck Will Not Go Into Gear And Started Smoking While Being Towed
Mar 30, 2013
89 toyota truck 4x4... A few weeks ago I had my truck in 4wd and was reversing, I stopped and tried to go into first gear. I found that the shifter would not engage, I can move the shifter around 360 degrees with nothing catching. I checked under the shifter boot and thought it may be the bushing that is shot. To feel safer anyway I decided to have a friend tow me to pavement and have AAA tow me into town, as I live 7 miles down a curvy mountain road off grid. As i was being towed out today the truck started spewing black smoke from about where the shifter is underneath the truck. Freaking out, we stopped the tow and i coasted back down the hill into the driveway.
View 10 Replies
Advertisement
I have a 90 celica, and while I driving today, the engine started smoking. I pulled over and took a look. The smoke was coming from behind the smoke and air filter area. I let it sight for about 2 hours and drove it back home and it wasn't smoking. Both times, it was on the road for about 20 minutes. I got a buddy of mine to take a look and he said that it was caused from the coolant boiling(I didn't think coolant coils boil). And it rained for a week straight, and I haven't driven it since it started raining. Could that have anything to do with it?
View 6 Replies
My car has 343,000 miles and runs great. It has recently started smoking, but only does it when the engine is cold. I've heard that it could be the rings, and to buy an additive that I could add to the oil. I go through about a half a quart for every 500 miles. I'm not expecting the car to last forever, but I was wondering if it would be beneficial to buy the additive.
View 13 Replies
2000 Excursion 4x4 v10 auto. Pulling the boat last weekend up the driveway from the lake and the truck started smoking under the hood at the top of the drive. Jump out and saw a fire under the pass floorboard. Go the hose and put it out in 30 sec. Thought i blew a trans line and it sprayed on the cat. Took it to the shop and he said lines are good it's not leaking. He said it is possible that the trans over heated and built up pressure and blew it out past the front seal.? What happened or how to prevent it from happening again?
View 13 Replies
All week the truck was acting like the clutch was slight depressed when first taking off and then today i was driving and the underside of truck started smoking like crazy and slowly lost all the gears could put it in any gear and nothing just was acting like it was being revved. does this mean clutch is bad?
View 10 Replies
I have 2007 Camry V6 XLE. Over the past year we have had at least 5 incidents of the car not going into gear when first started. This includes reverse when leaving garage and drive when out in parkig areas. Toyota claims they have no records of any other claims for this issue. It even happened at the Toyota lot when we were waiting for service to be done during oil change. All fluid levels have been checked and they were good. They suggested we leave car with them so they could try to get it to do this. This has all happened over the last year. We have about 47K miles on vehicle and purchased new.
View 2 Replies
Went to a road course for the first time on Sunday. After about 10 laps the car started smoking bad from the exhaust. The smoke was thick and white. There were professional drivers present (driving school) as well as a lexus service manager there looking at the car after the run. The smoke was thick but without that sweet smell of coolant. This was the hardest the car has ever been run but also maintained normal oil and coolant temperatures. After a bit of resting the smoke cleared up and never came back, my drive home was 2 hours long and car still seems ok. Engine sounds good, oil very clean, what could it have been? I have no cats so its going to be more obvious than normal.
View 14 Replies
I parked my 2003 f150 about 8wks ago, and at that time the blower had been running only on high then not at all, then only on high again.
As I need it to pull the boat up north next week, I purchased and changed the resistor. When I started it up the blower motor wouldn't run and eventually it started to smoke, so I pulled the wire connector to the motor.
Where I can find a procedure for motor testing, and removal as I think this is probably where I'm headed with this. There seems to be utube videos on everything else but not this. I may just have to go out and purchase a Hains or Chilton manual but I'm Scottish and always look for the free route first.
View 7 Replies
My '06 Ford F-150, 4.6 V8 is smoking when I start it up occasionally. The smoke color is blue. The only mod is flowmaster exhaust. Bad injector, sticking valve......
Where would you start? I am all for supporting a local mechanic but financially I do not have the money to gamble. Once I can pinpoint the problem I will take it to them to fix.
View 5 Replies
I just bought a 2002 echo recently and it started smoking blue. The car has 135000 miles which seems low to me to be blowing smoke so soon. I grew up around cars since my dad was a mechanic so I checked the compression on a cold engine. Cyl. 1 was 117psi, cyl. 2 was 134, cyl.3 was 127 and cyl. 4 was 117. I realize they are low but the car is blowing a pretty good amount. The car drives pretty good overall and seems to have power, i drove it on the freeway a few times and did 80mph fairly easy. I was wondering if this could possibly be valve stem seals gone bad? I will check the pcv valve as well. I really like the car and have read a lot of good things about the echo.
View 14 Replies
2007 f350. About 2 weeks ago my truck started smoking really bad, and I took it in to have it diagnosed. It was 4 injectors that were bad, so I had them replace all 8 and also install a bullet proof oil cooler. From the moment I got the truck back, it did not seem to idle as well as it used to, and over the next week, it began to blow a good amount of white smoke and run very rough.
But the weird thing is when I took it back to the shop to have it diagnosed, the minute I pulled into their driveway, it ran perfect, and they were unable to pull up anything. The next morning, I started my truck for work and as I drove down the street, the truck ran extremely rough, and seemed to be running in 2 cylinders. I shut the truck down, restarted it and it ran a little better, as I limped it back to the shop.
View 6 Replies
2002 Diamante, Passenger side seatbelt became stuck and started smoking after the door was "slammed" shut. Need to know if this can be fixed or am I going to have to ride in the back seat?
View 1 Replies
I just bought a used Toyota Avalon with 135,500 miles on it. They sold it because it was smoking and didn't know what was wrong with it(they were an old retired couple). They were the only owners and it has never been driven hard or abused.... Anyway. I read online that unhooking the vacuum hose from the pcv valve may make it stop smoking. I unhooked it and plugged the vacuum hose and they were right. It stopped smoking after I got the rest of the oil out of the hose. I thought maybe the old pcv valve was messed up so I got a new one and hooked it back up but then smoking was back. So I am getting too much blow by in it for sure. I don't think the valve seals are leaking because as soon as I unhooked the vacuum from the pcv valve the smoking stopped. I drove it for 2 days with no smoke whatsoever. What could be causing the blow by to be so strong? It was strong enough to spit oil out of the pcv valve without the vacuum hose sucking it out(there was oil on the engine).
The check engine light is also on so I hooked it up to a computer at an auto parts store and it said I had a misfire on 2 cylinders(2 and 6). So I changed all the spark plugs and re-hooked it to the machine. This time I only got an error code for cylinder 2. Each plug has a coil so I switched the coil from cylinder 4 to cylinder 2 to test if maybe the coil was bad, but it still gave me a misfire on cylinder 2 only. I even swapped the plug from 2 to 4 to make sure the new plug wasn't bad. Still a misfire on cylinder 2. It is still smoking(ONLY WHEN VACUUM HOSE IS ON PCV VALVE) and check engine light is still on and error code says cylinder 2 misfire.
View 19 Replies
A few weeks back my rear drivers side wheel started smoking severely...when I stopped you could smell the brake material, feel the heat coming from the wheel, and lots of smoke. I speculated it was the parking brake that got hung up. I jiggled that cable around and then went around the block - no issue. Note: I did not leave the parking brake on.
It happened again a week later, but not as bad. I took it into the dealer today. They said heat was evident as it burned off a sticker on the disk or caliper hsg area. They have not determined yet if it is parking brake or caliper?
View 14 Replies
My truck hasn't run for over a year and no one seems to be able to tell me why. The fuel pump supposedly has 10 lbs of pressure, it has new fuel pump relay, new throttle body, and probably more new things (can't remember exactly). It will start up normally and then it will act like it's not getting fuel and within seconds die. If I keep my foot on the gas and kind of pump it (I know it's EFI) it will try to keep running, but will die, and it really gets rough toward the end like the whole engine's going to fall out. The truck has 300K+ on it but the engine was replaced about 10,000 miles ago. It still has a lot of original equipment.
View 14 Replies
My '04 T-Reg will not start/crank. As a result, I cannot get the car into neutral to get it towed. I researched my problem and it could be anything from a new KESSY Module needed to a Steering Column. How do I get the car into neutral so it does not have to be dragged onto the flatbed? I read another thread on this and one thought was there was a white spring loaded switch under the trim near the gear selector. I got the trim off but cannot find the switch or get this damn truck into neutral.
View 1 Replies
I have 89 buick Century custom cpe had it out on the highway last night and the Batt light started to flash intermittently. after a little while it calmed down. Had it out running around today and no problem. what should I check besides the battery terminals?
View 4 Replies
I have a 89 f-150 xlt with what i believe is the m5od (4 speed with O.D) transmission and the 5.0 motor, the trans has been whining since I've owned the truck and it started popping out of reverse on me a couple months ago, now i have to slam it into gear to make it go anywhere even when I am going down the road! The clutch is fine but the trans is hanging up, anyways i have a granny gear transmission a buddy of mine gave me out of an 85 f150 that had the inline 6 if i take the bell housing off of my transmission can i put the internal slave cylinder on that transmission? Will it work or will i have to find a way to put an external slave cylinder on it?
View 9 Replies
The other day I was driving down the road on a long, flat section and all of a sudden my truck started missing out of the blue. Ever since it started missing it hasn't stopped. The truck is an '89 Ranger, 2.3l, 5 spd. The plugs and wires were replaced last year along with the timing belt and fuel pump. It has been running great since then until now. I thought maybe it might be a clogged fuel filter so I replaced that but it didn't work. Also, it doesn't miss all the time. It doesn't miss when its idling or if you are going down the road while it is missing and slowly release the gas pedal it reaches a point while you are letting the pedal up where it will even out. It definitely seems like it is an "under load missing" scenario. Also, the Check Engine Light is not on. Where should I start looking?
View 4 Replies
I have a 1989 F250 4x4 with a 1990 460 EFI under the hood. As I was driving All of the sudden as i finished turning a corner the truck died. No Spudder like it ran out of fuel but more like someone had turned the key off.
I tried to restart it but i kept it short i was near other houses and it was 3am in the morning. On my way to work, I popped the hood, thinking okay we had a bad rain storm. Moisture in the Cap and rotor. Well went to pop it off Distributor is lose, oh joy. But the cap was dry but i did take out the rotor to clean the tip off and the cap too.. Still nothing when I tried to start it again.
I am getting ready to check for spark from the coil *hoping it just a lose coil wire*.. But would the Computer taking a vacation for life cause this.?
View 10 Replies
I have a 1997 GMC Safari van with 175,000 miles on it. One month ago it wouldn't start. It would crank and crank but just not fire. When I turn the key I can hear the fuel pump start. I have other transportation available, so I just tried it a couple of times a day with the same result. Some history: about 5 months ago I had the fuel pump replaced. Finally I gave up and had it towed to the shop that had replaced the fuel pump. After it was unloaded from the flatbed, the mechanic tried to start it and it started normally. Since it started, I had an oil change done and had them check all the connections. Afterwards it started normally. I drove it for a few days with no problem and then one morning the same problem- cranking but not starting. Being stubborn, and with tight finances, I tried to start it every day for a week. Same symptoms. Finally today I had it towed to a different mechanic recommended by a friend. Of course, when it was unloaded from the flatbed it started right up. Any theories?
View 2 Replies
