I have a 2008 Camry 4 LE. My turn blinkers and reverse lights have stopped working and i'm 90% its a bad relay. I have checked all fuses and they are good. I just have a problem locating the relay. I think i saw it right above the fuse box under the dash in the driver side but i'm not 100% sure.
View 11 RepliesIf there is a fuse...or a switch that could have went bad ( and if fuse which fuse box )...
View 1 RepliesI have a '08 Camry SE. My A/C stopped working out of no where, Why it has stopped. There are no warning lights or anything, my fan blows cool but not cold. I tried adding freon but it is still the same.
View 6 RepliesMy taillights, reverse lights and brake lights all stopped working! What the problem is. The fuses are fine and the bulbs are good too. How to fix this or what I should look for to try to fix it?
View 1 RepliesMy reverse lights do not work and it is not due to the bulbs. Guy at autozone said it is the neutral safety switch. Does this sound correct? And I have done work on my truck myself, is this a difficult fix?
View 6 RepliesI have an '06 Camry, which has lost all power functionality. The follow items just stopped working
1. Key fob -- keyless entry and alarm stopped working
2. high beam doesn't come on when headlight is on. However, when headlight is off, it comes on--go figure
3. Power door lock also does not work, even from driver side door. Have to lock all doors manually
4. Interior lights don't come on when door is open.
The battery in my LX died, as a result my radio stopped working and my seat heater lights were flashing.
After replacing the battery radio is all good. Passenger side seat heater and ventilator no longer turns on (going to check the fuses tonight).
But the driver's side is very peculiar. At first it was working as expected then all of a sudden the light started flashing but the cooling / heating still works. Even with the system off those the lights flash and sometimes there is heat when the system is off.
This doesn't seem like a fuse issue in this case, seems like a relay.
What is the common cause of brake light failure? I drive a 2005 F150 Lariat 4X4. When i started the lights flickered until they completely stopped working. To me it seems like a short, is there a specific, common place where a wire is not properly mounted or rubs on something?
View 1 RepliesOur 2015 Prius 4 with 8,900 miles just suddenly stopped chirping and turning the lights off upon locking. The courtesy lights also no longer work (the lights worked last night as I approached the car but not tonight. The locking chirp/beep worked 3 hours ago but not now. Also headlights no longer go out after double clicking lock on either of the 2 fob.)
View 13 RepliesThe reverse light has stopped working on my MKIV TDi. Done all the usual things I can like bulbs/fuses.
View 2 RepliesI'm having Dodge Neon 2000 manual transmission. Suddenly the reverse gear stopped working (others working). I got it towed to my regular mechanic (used to charge comparatively lower than other local shops) and he said one of the shifter cable is broken and other one is stretched. Need too replace them. Is it worth it? (It's an old car and recently I've been spending a lot on this).
View 1 RepliesI have a 98 4door 4x4 auto. Reverse stopped working a year ago. The forward speeds work perfectly. I hate to have to rebuild the entire trans. I've been driving it some, being careful where I park, but getting tired of it. My question is do you have to pull and take the trans all the way apart to fix this?
View 7 RepliesI have had 2 transmissions brought to me, both complaining of no reverse. The first belongs to my nieghbor, its an 2005 F-150 4wd. He says last week it made a loud "POP" noise and reverse stopped working. This is a truck he uses for his work and its got 337K on it. A remanufactured transmission was installed at 70K.
The fluid in this transmission was very dark and dirty. I doubt it had been changed since the reman transmission was installed. Once I got the transmission apart, I found the reverse band was worn and broken. This is cast band, so it would make a rather loud "POP" when it breaks.
The sungear bushing was worn and grooved and scored the snout on the direct drum. The Over drive band was burned and pitted.
Since this is a remanfactured transmission the case is painted gray, the paint is blistering from heat. The torque converter has been so hot the paint blistered and the metal was rusting.
The sealing rings on the pump stator had cut mild grooves into the reverse drum and the snap ring that holds the intermediate one way clutch on the reverse drum was bent and about to fail.
The over drive servo snap ring was broken, which seems to be common on these trucks. The aftermarket replacement snap ring is hardened to resist breaking and is black in color
This transmission will be rebuilt with new gaskets, seals, clutches, both bands and reman torque converter. The overdrive band and low/reverse band will be upgraded with new bands that have a high carbon friction material, that will resist burning, installing a spiral snap ring and replacing the direct drum and sun gear.
The second transmission that lost reverse is from a 2006 F150 4wd. The owner of this truck removed the transmission himself and brought it to me. I am told the truck has a lift kit and larger tire. The residual fluid is clean and bright red. The owner has a drain plug installed in the pan, so I can assume the fluid is changed regularly.
Once I got the transmission part, the only damage I found was a broken reverse band. It appears this band has been broken for a while since 2 of the fingers on the band that would still engage were worn to the metal and and the friction material is burned. The band surface on planetary gear was slightly scored. Everything else in the transmission shows very little wear.
This transmission will be rebuilt with new gaskets, seals, clutches, both bands and reman torque converter. The overdrive band and low/reverse band will be upgraded with new bands that have a high carbon friction material, that will resist burning. Also installing a spiral locking ring on the intermediate one way clutch.
Everything was working fine until I started messing with camera settings in the service menu today . Now when I shift into reverse, it says "system not ready". Will not let me parallel park or reverse park now. I tried to reset the settings but maybe I don't know how to "save" settings.
View 5 RepliesMy 2010 gti reverse lights are not working when my buddy told me they didn't work i didn't believe him. Now i see they are not working...
View 9 RepliesMy reverse lights aren't working. I assume the trunk cable assembly is fine, as all my trunk opening and latching works and there is no viable damage to the cable. I figured the bulbs were burned out but I pulled the trunk liner today and at least one of the bulbs looks intact. I don't see any fuse listed for reverse lights.
View 2 RepliesChecked the bulbs, checked the connection....What is going on here. Is there a switch in the transmission or some crap that must have gone bad?
In good news. I have my rear fogs wired so that both sides work. ...the reverse lights stopped working like a week ago. So a crap rear fog install is not to blame.
Are you on the trailer life website as well? I think I've seen you there. I noticed you had a Touareg too. Do you pull a Touareg behind a Motorhome? I was wondering if the Treg can be used as a tow vehicle.
View 4 RepliesMy PRND123 isn't working on my 03 Montana. I replaced the neutral safety switch still no go. The reverse lights come on. When shifted out of park the doors lock and when put back in park they unlock. I checked some fuse the are for the nss and there good. Any wiring diagram for it?
View 4 RepliesI have a 2004 Prius, with both the brake and reverse lights not working (right & left). Already replaced all bulbs and checked fuse...No luck.
View 3 RepliesI recently noticed that both reverse lights on my wife's 2010 Santa Fe are dead.
It's odd that both bulbs would burn out at the same time. So I checked them and they're both good. The bulbs are not burnt out.
What should I check next?
I looked up the fuses in the owner manual, checked those, and everything looks good there. There is a relay as well. I swapped that with a similar relay in the fuse box, but that made no difference either.
I suspect it's the reverse switch on the transmission. Ours is a manual transmission. How to locate and access that reverse switch?