I have a 90 Celica GTS thats a 5 speed, and the last month or so when going at slow speeds and turning, it almost sounds like tires rubbing bad on the fenders. But they are clearly not. There is also some resistance too when turning. I've checked the PS fluid and its full and not leaking.
View 2 Replies1990 Corolla 4AFE - 4cyl , auto, running well...without prior symptoms, now starts (4-5 times) and idles roughly (no moisture in the air) ....seems to me to be fuel..... I know it could be many things - but i have to travel to the car ( not much time last night) .....It doesn't rev clean, sounds choking and very slow especially in drive/rev....not as sharp misses. Start with the fuel filter ? Can the fuel pump go quickly ?or does it go slowly. injectors? I'll check for coil arcing tonight, and the strength of the exhaust (Cat is 23 yrs old.....Vinny?) IAC? ..... Dist cap, wires and plugs are good...
View 4 RepliesIt sounds like a huge, happy cat in a tunnel when turning right and accelerating at the same time. It's an echoing whirring/purring sort of sound. What it could be? It also clunks in the rear with slight vibration. Could this be caused by an issue with the rear suspension or the engine mounts or something else?
Also, the locks seem to be possessed. When I try to unlock all the doors by pulling up on the driver's lock, the rest of the doors either unlock perfectly or lock harder, i.e.,all the passenger locks slam down and cannot be retracted. Sometimes the locks will either lock and unlock or lock and lock harder on their own while I'm driving.
It is a '90 Nissan Maxima. I just replaced my drivers side axle (cv joint was clicking), and now my car vibrates at highway speeds when turning right. I am pretty sure I seated the axle correctly....could it be a bad axle? I heard that turning the axle 90 degrees and reinstalling may work? I got a new axle (Empi brand).
View 2 RepliesI have a 2005 Subaru forester. It's got 127k and when I turn at slow speeds (like from a stop sign onto a main road) it shakes/vibrates. I called into Vox Pop when a mechanic was on the air last week and he said to check the serpentine belt. We did and it isn't loose/rotting, etc. What this might be?
View 6 RepliesI have a 2012 gti with 29k miles. Now I changed to coil overs for a shot amount of time however I shortly went back to stock for comfort. For the past few thousand miles I have been getting this creaking sound when turning left parked or slow speeds. I thought it might be strut mounts but its only left and isn't a clunking. I have three videos of the sounds so you can see what I'm talking about. I have heard of the infamous cv boot problem but if you look at the last video you can see the Cv boot looks in good shape..
Squeaking (my car)
Cv boot condition
All - I've got a 2010 LR D4 (UK Spec) and within the past two weeks it has developed a strong shudder and skipping when I am turning at slow speeds. It is worst when I am backing up and turning the wheel (like when backing out of a parking spot). It feels like the problem is coming from the left rear side of the vehicle, but it is a noticeable, strong shudder and skipping.
I have taken it into my local dealer for service, but they have not yet been able to identify the problem.?
I have a 2010 LS460 AWD with 42k miles and notice when I am making a medium to wide angle turn at parking lot speeds the front wheels make an intermittent metallic clicking/ticking noise that can be clearly heard when the windows are down and stereo is off. The noise can be heard when turning in either direction, driving forward or in reverse, and both accelerating and slowing down. Doesn't seem to happen when I'm turning the steering wheel while the car is stationary. Dealer suspects noise is due to dry contact areas between pads, calipers, and anti rattle springs and wants to perform a brake service for $330 before they're willing to investigate further (car still under warranty till end of the year). If noise is brake-related shouldn't it only occur when I'm applying the brakes? What should I do?
View 7 RepliesI have a 2003 Jetta Wagon with 49000 miles on it. I noticed that when turning at slow speeds (like taking turns in a parking lot) I hear a klunk coming from the area of the left front wheel, and I think I feel it through the steering wheel. Yesterday I was going around a hairpin turn at a shopping mall and heard two clunks. Driving straight it doesn't happen.
View 8 RepliesNoticed my 5 week old MK7 GTI is making squeaky noises on the driver's side when turning left at slow speeds. What this could be? Occurs intermittently, not all the time. This is a leased vehicle, would this be covered by warranty?
View 7 Replies2011 Hyundai sonata. My issues is that there seems to be a snapping/brushing noise when turn my wheel either left or right within under 5 MPH. Some people at work stated it could be the CV bolt? Not sure if that is correct, or something else. I am 117K miles, never have replaced anything suspension related.
View 11 RepliesI have had the habit of manually shifting down to slow my 2005 GX since new. Only have 55,000 mi so not really a high mileage or worn out yet.
Now the other day there was a resistance moving into or out of a gear (can't remember which) at a time where I needed to get moving so used some extra oomph to try to complete the change and seemed to have a resistance ..... and then felt what I guess was something plastic break.
Now the selector does not stay in 4th when moved left but springs back to "D". Also feels as if the spring resistance is less. All seems looser.
What am I looking at for repair and what is really amiss? Where is a diagram to see the broken parts and how to access it? ---- Part #?
When I turn the key in the ignition, almost nothing happens. There is no resistance when turning the key. Accessory power works (interior overhead lights, dash back lighting, door open sound) but no dash lights or headlights (just the front passenger parking light comes on). Tried to get a jump but nothing happened, not even the headlights came on. Haven't tried push start yet. I suspect an issue with the ignition switch, but I found another thread that suggested it could also be traced to certain fuses.
View 3 RepliesI have a 90 gts celica, which the motor went in it, so i put a 93 5sfe into it. I took the old distributor out of the 90 5sfe and put it into the new motor. I wasn't getting any spark. So i replaced the distributor with a known good one. No spark. replaced the coil and igniter, no spark still.
View 10 RepliesJust acquired a 1990 celica gt at a steal lol and needing some troubleshooting answers. tonight was the first night we really had drove it, but my husband drove it to work which is an hour away and he noticed that when he comes to a stop the oil pressure light comes on. as soon as he starts to go again it goes off. the engine does not make any noises other than the typical 2200 lifter chatter and it does not leak oil.
We plan on doing an oil change so we are not sure if that could just be the issue or if it's something else. we had this issue with a dodge ram we had and it ended up being the oil pressure sending unit. he took the one off the car and it did need some tightening up but however when he put it back on the issue was still there.
We do not believe it's any low compression as the car cranks fine and normal with no rising of the cranking as you would get for a cylinder with low compression. we aren't really sure about the bearings because well that's not one of those things easily tested but the engine doesn't make a noise which I know at times you won't have one.
90 GTS - Manual Transmission. 5SFE
I have a vibration that rattles the cab of the car during start up. But if you get out, lift the hood and listen, you cant hear anything. Its only in the cab where you can even tell there's something not right. The motor runs great and seems very smooth to the touch and visually.
The vibration does seem to go down as the car warms up..... Somewhat....You can hear the vibration when driving and go down through slight dips in the road. Kinda like hitting the rumble strips on the side of the hwy.When I release the clutch and under power the vibrations go away. Under deceleration the vibrations are loud.After weeks of research, both TN and the web, I have done all this so far.
Changed Plugs, wires, cap. All four engine mounts were taken out, inspected, and 3 of the 4 were replaced from a donor car. All 4 looked good anyways....
Swapped harmonic balancer/pully from a donor car.
Compression check. 196 200 200 208
Cleaned IAC valve.
Pulled off exhaust manifold and verified CAT isnt broken.
Inspected exhaust from front to back and cant find anything.
Replace timing belt, tensioner bearing and idler bearing while I was in there.
Took both fan belts off and ran car to see if maybe power steering or AC, but car still rattled even though they weren't turning.
Did head gasket while building this car up because it was leaking oil from the front return tube area.
I have a question about when my truck is in 4 wheel drive. I've read a lot of posts but couldn't find specific answers to these questions: When I take a left turn theres quite a bit of resistance and a little hopping. Also when turning in reverse its almost like the truck is getting hung up and a with resistance, something doesn't seem right. Could any of this be if only one hub is engaging? Also, when i just manually lock the hubs, I only noticed that the passenger side axle spins when I manually turn the front drive shaft.
Also this is the first time I've used the 4 wheel drive. And I recently replaced front axle u joints, as well as a double cardan joint rebuild, only issue w/ that is that is i forgot to mark the orientation where the front driveshaft bolts onto the the transfer case...so it's either on the right way or a 180 from how it was before, because I could see the original pattern.
2000 4x4 7.3 long bed ext cab, 159k
I recently took the engine apart and got the head resurfaced after the head got warped. New thermostat, waterpump, timing belt, serpentine belt, power steering belt, and gaskets for all sorts of stuff. After reassembling the engine everything worked fine. No strange noises. Only problem i am having now is that the cooling fan switches on really late, when the needle is 3/4 of the way towards H, sometimes even a little later. Fan is working as when i disconnect the cooling fan switch(bottom of radiator) and the fan does kick on. ECT was also replaced and nothing seems to work. I did replace the switch and the fans failed to kick on, unfortunately i got it from Autozone.This is a 1990 Celica GTS with the 5SFE 2.2L
View 8 RepliesI have a 1990 GTS with a transplanted 1996 S5HE 2.2 motor. This summer I started getting overheating issues and I believe my water pump is dying.
Here's the symptoms; car will run nice and cool on the freeway doing 70 with the tach turning at 3.5k. As soon as I get off the freeway and RPMs drop the coolant temp will spike almost into the red. Accelerating from the stop will drop the temp but it will hover near the high end of the middle till I get back on the freeway or RPM's go back up.
It does the same thing when climbing hills or when the engine is under load. It did it bad this summer when it was hot out and I was running the AC. Bad enough that it boiled over a couple times. The radiator is brand new and just based on the symptoms I'm thinking water pump.
When I put my key in the ignition, I cannot turn the key. I tried putting a small amount of WD40 in the ignition and turning the wheel back and forth while trying to start, but all that did was make my key greasy and my wheel lock up. I've tried getting a new key made from Lowes and Home Depot, but their keys are too wide and will not fit in the keyholes. The only thing I am down to is replacing the ignition switch completely but I'd rather do that as a last resort because my car has had a big problem every week (alternator gone, new wheels, new master cylinder, new rotors/brakes). I haven't explored yet? And also, if it comes down to replacing the ignition switch, how would I do that without being able to turn the key?
View 2 RepliesI just got a 1990 toyota celica and it turns over but dont start. its getting fuel up to the motor. i got it from a friend that gave up on it and he got it from a guy that replaced the 2200 with a 2000 engine. everything looks to be connected but i dont know where to start.
View 1 Replies