Dodge - Ram :: 2002 - Lost All Power Steering?
Dec 31, 2015
I have a 2002 Dodge Ram 1500 Truck. The other day, I lost all power steering, and traced it to a loose hose connection, which let all of the fluid out. I tightened the connection, refilled the reservoir, and then bled by turning lock to lock several times. when I am sitting still, or low speed parking, it feels like there is no power steering. If I am rolling, even a little bit, it is as normal, and engine speed does not seem to affect the problem, as I have raced the engine at low ground speed, and it is still really stiff. When driving, turns are easy in both directions. The way the effort required does not change with engine speed confuses me.
View 5 Replies
Advertisement
I bought my van in 2011 from my dad's former employer. It was a fleet vehicle and wasn't in the greatest of condition when I bought it. In 2012 I was told that I had a leak in my oil pan from a mechanic. I never ended up getting it fixed for various reasons. A few months ago, I lost power steering in my van and have been driving since without it. My dad wanted to see if anything could be done to fix it and found out the van is completely rusted underneath and ended up puncturing a hole in the bottom when he tried to jack the thing up. I am really hoping to get a (new) used car but don't have the money right now. I was wondering though how long would you expect I could "survive" with my car like this?
View 16 Replies
I have had various issues with my car over the years but on my way home last night my car just died coming down the interstate. It didn't make any noise, it simply kicked off the cruise, the battery light and oil light came on, and I lost gas and power steering. The security light did not come on and my car's forgotten who I am often enough I know how to do the key relearn by heart. My service engine soon light stays on because I no longer have a catalytic converter. When I turn the key over I smell gas (which I can only assume means there's not an issue with my fuel system), everything turns (alternator, belts, etc.) but it doesn't fire.
I had someone suggest that it could possibly be the EGR valve, but when I went to investigate, turns out there isn't one installed on my engine, where it should be there is a metal plate bolted to the "hole". In the past my ignition control module had to be replaced about every 11 months, so I had two and carried the spare in my car. This stopped happening when we finally replaced the entire coil pack. My car has always idled rough (I'm assuming I can attribute this to the lack of EGR valve).
Over the past two weeks it just seemed to get a little worse, it was making noises when accelerating when the car was cold, almost like a whining and the engine was idling hard. When looking for the non-existent EGR valve I did discover my air filter was ridiculously dirty and the air intake is full of oil. The oil was low but not enough to make the engine seize. I know that's a lot of information but was trying to be as clear as possible about previous issues and what I have ruled out. I did read that it could possibly be the CPR, but didn't know and I need it running again.
View 3 Replies
My 02 Ex V10 suddenly lost its power steering. And I mean completely, so it was a bitch to get it home. There are no leaks and the reservoir is full. It makes no noise at all when I try and turn the wheel, so it does not even sound like the pump is working at all. Does this sound like the pump or the gear box? Is there an easy way to tell before I just order the pump and hope that is the problem?
View 2 Replies
Ive got an 02 2wd escape with the v6. Its been an excellent truck until here recently. The wife has had a weird problem twice now, that I have been unable to reproduce. She says the check engine light and low oil light come on and she loses power steering. Shutting it off and restarting fixes the issue.
Took a 400 mile road trip with it last weekend and never had an issue. Only thing I noticed , the readiness meters never went ready. Even after that trip, It still shows a systems not ready code.
Tonight the wife had the issue again. Shutdown and restart fixed it. Battery cables are clean and tight, several grounds were freshly cleaned a couple months ago.
View 1 Replies
My 2004 Caravan lost power to windshield washer motor and headlights, after checking under fuse box, I swapped over the relay marked headlights washer , still nothing. I disconnected the power module at the front of the fuse box by removing four torx head screws. Removed it by rocking it a it out towards the front of the van. I cleaned the terminals and replaced it. Seems to have solved the problem .
View 1 Replies
I lost a hose in the driver side front wheel well this morning while pulling RV to a campground. By the time I got there and got the RV disconnected, I lost all power steering. I reconnected the hose using a zip tie and have a friend bringing me fluid to refill reservoir.
Is my pump toast now? Can I refill the reservoir and prime the lines and be good to go?
View 14 Replies
Driving home from movies tonight, I lost power steering and power brakes and the pump started growling. Looked in the reservoir and it was all foamed up. Within the last 20k mi I have flushed the system and refilled with power steering fluid. No apparent leaks at this time. And happened like someone flipped a switch. Fine one turn, nothing the next. What are the chances this is a fluid issue and not a mechanical one? Start with flushing system and adding Mercon V? Or is it likely pump is damaged?
View 7 Replies
So I have a 1999.5 F350 diesel and the fuse panel under the steering wheel is acting up. I was driving my truck home the other night and I lost power and my truck shut off. I have had a problem in the past with the #30- 30 amp fuse ( controls the PCM and glow plugs from my understanding) that is under the steering wheel, I replaced the fuse and everything started working normally again. Until the other night when my truck shut off, so I replaced the fuse the truck drove again for 20 feet died again, I was able to hold the #30 fuse and allow my truck to start up again but would eventually killed the PCM and shut off again and would not start up due to what I believe the fuse location shorting it out and killing the power to the PCM preventing me from starting it up again.
I had my truck towed home and charged the battery and it started up fine the next morning. If I push on the #30 fuse my truck the shorts out and kills the power, I do not know if this is normal? The fuse is sitting loose in the fuse holder is there anyway making it fit tighter to prevent it from being so loose? I have read every other post online about the problems and tried everything they have recommended but still can not figure out what was wrong with my truck. I disconnected the fuel filter heater, and also the wastegate solenoid to see if that would prevent the truck from shorting out if I pushed the fuse it did not work.
What the problem could be causing the #30 - 30 amp fuse to be shorting out preventing everything from working? Or how to test the fuse panel and all the relays?
View 5 Replies
Last year I did some major work on my 02. Painted it, new injectors, 38R, and once it was back together, the transmission went south in a month. Got a Ford reman HD4R100. Shortly after the install, when in reverse, the torque convertor would lock up when you stepped on the throttle. As soon as you let off the throttle, it would disengage. Thinking it was a tranny issue, got another one from Ford. This one has been in the truck for about 9 months. And it seemed fine until about a month ago. It started doing the torque convertor lockup thing in reverse like the last one, but not as often.
Then last weekend it did it every time I put it in reverse. Then yesterday, while pulling away from a traffic light, there was a loud bang, and lost power in the transmission. Once stopped, I found out it has manual 1st and 2nd, but nothing else. No drive, overdrive, or reverse. I personally believe something electrical led to these issues, and ultimately, the transmission failure. I know the truck is not stock, but I do not run it hard very much. When it went bang yesterday, I was not being hard on it. Where to look at what is causing this?
View 14 Replies
Comming back from hunting today my truck suddenly lost power and stepping on the accelearator had no effect at all. We were on the highway thru the mountains but on a fairly level stretch for a few miles. Managed to pull the truck and toy hauler over and the engine was running fine but stepping on the accelerator had no effect. The check engine light came on every time I stepped on the throttle and went out when I released it. It started fine but no throttle response. Switched around a bunch of relays and checked the fuses and still nothing.
Not liking my parking spot i tried to see if it would move down the road at an idle but it would not. Then I thought to try it in 4 wheel low and as the shoulders were soft it wouldn't move forward so tried reverse and went back a foot, forward again and moved a foot and a half. did this several times and all of a sudden the throttle responded, took it out of 4 wheel and it ran fine all the way home. What would have caused this? I was ready to call a tow truck which would have been several hundred dollar bills for where we were and with the trailer
View 14 Replies
So after hitting a pothole, it would seem like half the engine lost power, after some searching around, i found that i would most likely be the harness inside the valve cover that has lost connection.
Its the right side, so i would need to take of the turbo pipe, and probably something else to get to it.
Since i'm doing this job, what to check out along the way? I want my 7.3 to be as reliable as possible.
I will probably ask some questions along the way, it can be a challenge sometimes to own a car that not many mechanics are familiar with, but as i have read online, this should be a very straight forward fix.
Can the harness be upgraded so it doesn't happen again? Its an 02
View 14 Replies
Truck is 2002 2WD 4.7L Durango and around 164K
I am looking to replace the intermediate steering shaft as it making noise it seems they are common to this problem due to a weak U joint. The problem I have is I can track the correct part. Here is what I have research so far:
Have found this one 55351246AA but it says it will not fit.
Also found the Dorman 425-257 but it says is for 4WD but it reference to this OE part numbers: 55351208AA, 55351208AB, 55351246AA
Have try the Dodge parts website but that is even more confusing. I have already replace the ball joints, wheel bearings and inner and outer tie rods and this is the last part that needs to be replaced if I can track the correct one.
View 3 Replies
I just replaced a serpentine belt on a 2004 chevy Impala. Now the power steering will loose some of its "power". I at first loosened the bolt on the tensioner not knowing how to properly make it release, then tightened the bolt back after realizing my error. I know it did not move though.
View 5 Replies
Was driving on interstate and car started to loose power. Replaced battery and before I could make it home car started to loose power again (lost power steering and power brakes). Charged battery, replaced alternator, and now car starts fine but there are issues.
1) VGRS, VCS, and AFS lifts are on.
2) Steering wheel is 90 degrees off.
Car ran fine before alternator/battery replacement.
View 1 Replies
I have a 2002 F250 Super Duty. Was driving it and it started to lose power and shut off. Then wouldn't start like out of fuel. No engine light no codes. Truck has 155k on it. So just because I replaced fuel pump. Truck runs but not right it's ruff no power kinda back fires in exhaust. I check wires and plugs under valve covers all seems ok. I ran truck and pulled each injector loose and engine would stumble. As in they are working. I replaced cps. Just because still the same. Then the truck started running right. But the truck runs but has knock but knock goes away and truck has full power. Yes oil is full and I change it regularly. The problem is off and on like electrical.
View 7 Replies
I have a 2010 Elantra 4dSD 2.0 DOHC. 61, 522 miles on it.
I have had no issues with the car until about 2 weeks ago. Suddenly the EPS light came on and I lost power steering. Upon pulling over and restarting the car the problem went away. I went about a week, and suddenly it did it again. Restarted car, went away, still does this intermittently.
I took it to the dealer, they found the following codes:
EPS - Electronic Power - C1259 - Steering Angle Sensor Electrical
EPS - Electronic Power - C1290 - Torque Sensor Main Signal Fault
EPS - Electronic Power - C1604ECU(Brake System) Hardware error
EPS - Electronic Power - C2400 - Motor
ABSESC - ABS/ESC - C1202 - Wheel Speed Sensor Front - LH Invalid/No Signal
ABSESC - ABS/ESC - C1208 - Wheel Speed Sensor Front - LH Invalid/No Signal
ABSESC - ABS/ESC - C1211 - Wheel Speed Sensor Front - LH Invalid/No Signal
They reset the codes, and EPS Reflash. Recalibrated EPS. They told me if the problem comes back I would need a new steering column ($1500+). This seems a bit strange to me for an intermittent issue. It would almost seem to me that if multiple sensors are effected that they are receiving bad data from somewhere. Could the ABS sensors be causing this problem with bad data? I've also heard a failing battery could cause this type of issue.
View 2 Replies
I've lost all power steering about a week ago. I checked all the lines the return is bring fluid up from the pump and the res is flowing into the pump.
A) should I replace pump?
B) look into other things that could be causing the issue?
View 9 Replies
Recently had battery problem on the Passat. I had to have the car jumped and the stereo was on. Now I have no power at all to the stereo, everything else seems to work fine. I checked fuse panel, no blown fuses. Is there a separate fuse or breaker for the Monsoon system.
View 2 Replies
2009 Mazda 3 Since a nasty cold snap in Northeast, instrument panel has gone crazy. The meter showing RPM's works but 0 on the speedometer- dead. Gauges have been all on for a couple weeks. Just noticed now the power steering is gone. All lights seem to work normally and heat/defrost works. Radio works. Haven't noticed if odometer is working or not.
View 3 Replies
While driving a mountain road (hwy 17) going downhill this morning I lost power braking and power steering and a got the following error message on the display
TRANSMISSION P LOCK MECHANISM
PARK CAR ON FLAT SURFACE AND APPLY BRAKES
I was able to stop the car on a flat area. I turned the ignition off and then restarted the car and the power steering and brakes came back, but the red triangle remained. I drove to the Toyota dealership and left the car for service.
View 12 Replies
